Iron improving bio-char derived from microalgae on removal of tetracycline from aqueous system

Novel magnetic carbonaceous bio-char was hydrothermal prepared from microalgae under different loadings of iron and its structures and surface chemistry were characterized with Fourier transform infrared (FTIR), X-ray photoelectron spectroscopy (XPS), scanning electron microscopy (SEM), and nitrogen adsorption-desorption isotherm (BET). The morphology of bio-char changed from sheet to particle as iron loading increased and its surface area also increased. When 3.0 g of dried microalgae and 6.0 mmol iron salt ((NH₄)₂SO₄·FeSO₄·6H₂O) were mixed and treated, the obtained bio-char possessing the highest amount of oxygen-containing functional groups resulted in the best adsorption performance on tetracycline (TC). This adsorption process was fitted to Langmuir adsorption isotherm and the maximum adsorption capacity was 95.86 mg/g, which is higher than other bio-char reported. The iron loading contributed to the higher adsorption capacity of bio-char, which may be due to three factors, the high surface area, more hydrogen bonding, and bridging effects of the structural Fe for TC. Our data suggest that bio-char may have more important role in stabilization of pollutants in the environment.     

Simultaneous separation of apigenin,luteolin and rosmarinic acid from the aerial parts of the copper-tolerant plant Elsholtzia splendens

Elsholtzia splendens is a copper-tolerant plant species which grows on copper deposits in China. The generation of a valuable E. splendens biomass on specific contaminated sites has become one of the promising phytotechnologies. The simultaneous separations of apigenin, luteolin, and rosmarinic acid yielded in the ethyl acetate extracts of the flowering aerial parts was achieved by the use of a macroporous resin, polyamide, and silicagel columns during chromatography. Chemical identification confirmed the structures based on the spectra of FTIR, NMR, and HPLC/ESI-MS. The isolated compounds of purity above 98.3 % were evaluated for their in vitro cytotoxic activities against human cancer cell lines including A549 (non-small lung), A431 (skin), and Bcap37 (breast). Among these compounds, luteolin and apigenin presented the best cytotoxic activities against A549, A431, and Bcap37 cells and, therefore, both could be the valuable products for the post-harvest processing of E. splendens biomass.     

污泥膜覆盖好氧发酵堆体流场模拟及应用研究简

运用Gambit软件建立了污泥好氧发酵堆体的多孔介质模型,通过自行设计的实验装置获得了堆体的通风粘性阻力系数和惯性阻力系数以及功能膜压差与透气量之间的关系,用Fluent软件分析了堆体不同截面形状及底部通风管数量对堆体通风均匀性的影响,为确定合理的通风管数量及截面几何形状提供理论依据。对上海奉贤区城镇污水厂污泥处理工程发酵仓进行堆体流场模拟,确定堆体采用小拱形截面形状,堆高2 m,宽8 m,底部设置4条通风管,实际运行效果良好。     

MCM-41介孔分子筛的合成及其对铜离子的吸附性能简

以微硅粉为硅源,CTAB和PEG-6000为模板剂,合成MCM-41介孔分子筛。采用XRD、N₂吸附-脱附曲线、FTIR以及TEM表征了其结构、比表面积、孔径分布及晶体形貌,并且以该样品为吸附剂,对含Cu²⁺的溶液进行了静态吸附实验。结果表明,以微硅粉为硅源成功合成了具有典型六方排列孔道结构的MCM-41,其比表面积为869.5 m²/g,孔容为0.97 cm³/g,平均孔径为3.3 nm;溶液pH为5~6时,MCM-41对Cu²⁺的去除效果最好;MCM-41对Cu²⁺的最大吸附吸附容量36.3 mg/g;MCM-41对Cu²⁺的吸附性能符合Langmuir吸附方程的特征。动力学研究表明,该过程符合准二级动力学模型。     

水生植物酸碱预处理对厌氧发酵联产氢气-甲烷的影响简

采用酸碱预处理乌梁素海典型沉水植物龙须眼子菜和挺水植物芦苇,通过厌氧发酵动力学分析、还原糖变化及微观结构解析,研究酸碱预处理对水生植物厌氧发酵联产氢气-甲烷的影响。实验结果表明,酸碱预处理后水生植物厌氧发酵联产氢气-甲烷两阶段累积产气量、氢气及甲烷含量均显著提高,酸处理效果优于碱处理。采用0.5 mol/L HCl预处理龙须眼子菜效果最佳,最大氢气、甲烷含量分别达42.65%和52.82%,产氢气速率为4.118 mL/h,产甲烷速率最高达14.199 mL/h。芦苇经1 mol/L HCl预处理效果最佳,最高氢气、甲烷含量分别为32.22%和65.26%。扫描电镜微观结构分析表明,酸碱预处理可显著破坏芦苇、龙须眼子菜的纤维素结构,有效增加植物与微生物接触面积,有利于厌氧发酵联产氢气-甲烷工艺的快速启动和稳定运行。     

突变灰盖鬼伞过氧化物酶降解刚果红的响应面法优化分析简

酶法降解偶氮染料刚果红是一个复杂的过程,受温度、pH、酶量、刚果红浓度和双氧水浓度显著影响。为研究各因素及因素间交互作用对刚果红降解影响,提高刚果红的降解率,分别使用单因素法和响应面分析法对刚果红降解条件进行了优化。单因素实验结果显示灰盖鬼伞过氧化物酶降解刚果红的最适条件为：pH 5.0、32℃、酶量4.98 U、双氧水0.1 mmol/L、刚果红20 mg/L,此时刚果红最高降解率为34.84%。然后选双氧水浓度、刚果红浓度和灰盖鬼伞过氧化物酶量作为3个因素,通过中心组合设计实验,用响应面法对刚果红降解进行优化分析,最后得到一个拟合度良好的二次多项方程模型（R²=0.9900）。方差分析结果显示,刚果红浓度和酶量是影响最显著的因素,双氧水与酶以及染料与酶之间的交互作用极显著。响应面分析优化后的反应体系为：双氧水浓度0.15 mmol/L,刚果红浓度为27.21 mg/L,酶为2.0 7 U,在此条件下,刚果红降解率达58.13%。     

复合钙基固硫添加剂对煤固硫与燃烧的影响

利用程序升温燃烧反应技术,考察了高岭土复合的Ca O、Fe2O3-Ca O、Co O-Ca O添加剂对无烟煤的燃烧以及固硫的影响。实验发现,这些添加物质对煤的裂解产物的燃烧都具有促进作用,除了Fe2O3-Ca O-高岭土复合添加剂对煤焦的燃烧有一定阻碍作用之外,其余都具有对煤焦燃烧的促进作用,尤以Co O-Ca O-高岭土复合添加剂的效果最为显著。高岭土复合的硫酸钙本应具有较高的热稳定性,但受到高温下煤焦与CO的还原而分解,所以添加对煤焦具有明显催化燃烧作用的氧化钴,因减少了还原性气氛,稳定了硫酸钙产物而促进了固硫。     

兰坪铅锌矿区不同污染梯度下优势植物的重金属累积特征

对兰坪铅锌矿区污染程度不同的3个样地(云南松林、魁蒿群落和马桑灌丛)进行植被调查,选择其中9种共有的自然生长的优势草本植物为研究对象,测定了土壤及植物体的重金属含量。结果显示,3个样地土壤Cu、Cd、Pb和Zn等4种重金属含量均表现为马桑灌丛>魁蒿群落>云南松林;植物体内重金属积累呈现出随着土壤污染程度增加而增加的趋势;所选择的9种植物均不符合超富集植物的标准,依据不同的耐性机制将9种植物分为3类,野棉花能较强吸收土壤中重金属,并转移到地上部分,属于富集型植物;西南金丝梅、倒提壶、长籽柳叶菜、魁蒿、翻白叶和四脉金茅吸收的重金属主要积累在根部,属于根部囤积型植物;尼泊尔蓼和中华山蓼体内重金属含量较低,属于规避型植物。讨论了利用这些植物进行矿山治理。     

改性壳聚糖复合凹凸棒土絮凝油漆废水

将壳聚糖、阳离子淀粉和二甲基二烯丙基氯化铵(DMDAAC)进行三元接枝共聚,制备了三元接枝改性壳聚糖(CTS-DMDAAC-CS),通过红外光谱和扫描电镜对其结构进行了表征。并且将三元接枝改性壳聚糖与凹凸棒土进行优化复配,对油漆废水进行了絮凝实验,得出了当pH=12,沉降时间为20 min,复合絮凝剂投加量为0.2 g,三元接枝共聚物∶凹凸棒土=1∶10时,该复合絮凝剂对油漆去除率最佳能够达到89.3%,并且絮凝效果好,是一种新型绿色环保的有机-无机复合絮凝剂。     

臭氧氧化—包埋菌流化床生物处理组合工艺深度处理煤气化废水

采用臭氧氧化—包埋菌流化床生物处理组合工艺对煤气化废水进行深度处理。实验结果表明：当臭氧的质量浓度20 mg/L、臭氧进气流量1.5 L/min、臭氧通气时间30 min、包埋菌流化床水力停留时间24 h时,臭氧氧化工序的COD去除率达到30.0%~40.0%,总酚去除率达到100.0%;包埋菌流化床工序的COD去除率达到60.0%以上,氨氮的去除率大于95.0%;经组合工艺处理后,出水COD<60 mg/L,ρ（氨氮）<1.0 mg/L,ρ（总酚）未检出,色度小于50倍,达到GB8978—1996《污水综合排放标准》中的一级排放标准。