The modelling of a hybrid combined cycle with pressurised fluidised bed combustion and CO2 capture

This study investigates the possibility of capturing CO₂ from flue gas under pressurised conditions, which could prove to be beneficial in comparison to working under atmospheric conditions. Simulations of two hybrid combined cycles with pressurised fluidised bed combustion and CO₂ capture are presented. CO₂ is captured from pressurised flue gas by means of chemical absorption after the boiler but before expansion. The results show a CO₂ capture penalty of approximately 8 percentage points (including 90% CO₂ capture rate and compression to 110 bar), which makes the efficiency for the best performing cycle 43.9%. It is 5.2 percentage points higher than the most probable alternative, i.e. using a natural gas fired combined cycle and a pulverised coal fired condensing plant separately with the same fuel split ratio. The largest part of the penalty is associated with the lower mass flow of flue gas after CO₂ capture, which leads to a decrease in work output in the expander and potential for feed water heating. The penalty caused by the regeneration of absorbent is quite low, since the high pressure permits the use of potassium carbonate, which requires less regeneration heat than for example the more commonly proposed monoethanolamine. Although the efficiencies of the cycles look promising it will be important to perform a cost estimate to be able to make a fair comparison with other systems. Such a cost estimate has not been done in this study. A significant drawback of these hybrid cycles in that respect is the complex nature of the systems that will have a negative effect on the economy.     

Daily performance at work: feeling recovered in the morning as a predictor of day‐level job performance

This study examined the state of being recovered in the morning (i.e., feeling physically and mentally refreshed) as a predictor of daily job performance and daily compensatory effort at work. Ninety‐nine employees from public service organizations completed a general survey and two daily surveys on pocket computers over the course of one workweek. Hierarchical linear modeling showed that being recovered in the morning was positively related to daily task performance, personal initiative, and organizational citizenship behavior and negatively related to daily compensatory effort at work. Relationships between the state of being recovered and day‐specific job performance were moderated by job control. For persons with a high level of job control, the relationship between being recovered and daily performance was stronger. Copyright © 2008 John Wiley & Sons, Ltd.     

Uptake of some selected aquatic pollutants in semipermeable membrane devices (SPMDs) and the polar organic chemical integrative sampler (POCIS)

The uptake characteristics of semipermeable membrane devices (SPMDs) and polar organic chemical integrative samplers (POCISs) were examined for mono, di and tributyltin, triphenyltin, pyrene, benzo[a]pyrene, 4-tert-butylphenol, 4-n-nonylphenol, PCBs 77 and 153, PBDE 47, lindane, triclosan and DDT. Exposure in a flow through system continued for 28 days with samplers removed every 7 days in order to study the relevant uptake kinetics. Uptake remained linear for POCISs with sampling rates (Rs) of up to 0.2 L d(-1). For SPMDs uptake varied from linear to approaching equilibrium with Rs values of up to 14 L d(-1). 7 out of 9 results for SPMDs could be explained by an empirical model (nonylphenol and lindane were exceptions). None of the four organo-tin compounds studied were detected in POCISs and only tributyltin was accumulated significantly by SPMDs. The establishment of these sampling rates allows the calculation of time weighted water concentrations for several important contaminants. Using presented methods, sampling rates and exposure conditions, theoretical detection limits for selected compounds by SPMDs were between 11-68 pg L(-1), which is well below the environment quality standard proposed for those compounds that are included in the European Water Framework Directive.     

Assessing coastal waters of American Samoa: territory-wide water quality data provide a critical “big-picture” view for this tropical archipelago

The coastal waters of American Samoa’s five high islands (Tutuila, Aunu’u, Ofu, Olosega, and Ta’u) were surveyed in 2004 using a probabilistic design. Water quality data were collected from the near-shore coastal habitat, defined as all near-shore coastal waters including embayments, extending out to 1/4 mile off-shore. Hydrography and water column samples were collected, and water quality data were compared to the Territorial water quality standards for pH, dissolved oxygen (DO), Enterococcus, chlorophyll a, water clarity, total nitrogen, and total phosphorus. All station measurements for pH, DO, and Enterococcus satisfied the local water quality standards, although some fraction of the Territory could not be assessed for either DO or Enterococcus. With respect to chlorophyll a, 66 ± 18% of Territory coastal waters complied with the standard, while 34 ± 18% failed to comply with the standard. For water clarity, 54 ± 18% of the Territorial waters complied with the standard while 42 ± 7% failed to comply. Territorial waters satisfied the standards for total nitrogen and phosphorus 72 ± 17% and 92 ± 10%, respectively. These data provide the first “big-picture” view of water quality in the near shore region around the high islands of American Samoa. While the picture is encouraging, these data suggest emerging water quality concerns.     

Attempts to probe the ozone layer and the ultraviolet-B levels of the past

To get a proper perspective on the current status of atmospheric ozone, which protects the biosphere from ultraviolet-B (UV-B; 280-315 nm) radiation, it would be of value to know how ozone and UV-B radiation have varied in the past. The record of worldwide ozone monitoring goes back only a few decades, and the record of reliable UV-B measurements is even shorter. Here we review indirect methods to assess their status further back in time. These include variations in the Sun's emission and how these affect the atmosphere, changes in the Earth's orbit, geologic imprints of atmospheric ozone, effects of catastrophic events such as volcanic eruptions, biological proxies of UV-B radiation, the spectral signature of terrestrial ozone in old recordings of star spectra, and the modeling of UV-B irradiance from ozone data and meteorological recordings. Although reliable reconstructions do not yet extend far into the past, there is some hope for future progress.     

Techniques for the stabilization and assessment of treated copper-, chromium-, and arsenic-contaminated soil

Remediation mainly based on excavation and burial of the contaminated soil is impractical with regard to the large numbers of sites identified as being in need of remediation. Therefore, alternative methods are needed for brownfield remediation. This study was conducted to assess a chemical stabilization procedure of CCA-contaminated soil using iron (Fe)-containing blaster sand (BS) or oxygen-scarfing granulate (OSG). The stabilization technique was assessed with regard to the feasibility of mixing ameliorants at an industrial scale and the efficiency of the stabilization under different redox conditions. The stability was investigated under natural conditions in 1-m3 lysimeters in a field experiment, and the effect of redox conditions was assessed in a laboratory experiment (10 L). The treatments with high additions of ameliorant (8% and 17%) were more successful in both the laboratory and field experiments, even though there was enough Fe on a stochiometric basis even at the lowest addition rates (0.1% and 1%). The particle size of the Fe and the mixing influenced the stabilization efficiency. The development of anaerobic conditions, simulated by water saturation, increases the fraction of arsenic (AsIII) and, consequently, As mobility. The use of high concentrations of OSG under aerobic conditions increased the concentrations of nickel (Ni) and copper (Cu) in the pore water. However, under anaerobic conditions, it decreased the As leaching compared with the untreated soil, and Ni and Cu leaching was not critical. The final destination of the treated soil should govern the amendment choice, that is, an OSG concentration of approximately 10% may be suitable if the soil is to be landfilled under anaerobic conditions. Alternatively, the soil mixed with 1% BS could be kept under aerobic conditions in a landfill cover or in situ at a brownfield site. In addition, the treatment with BS appeared to produce better effects in the long term than treatment with OSG.     

Net methylmercury production as a basis for improved risk assessment of mercury-contaminated sediments

Sediments contaminated by various sources of mercury (Hg) were studied at 8 sites in Sweden covering wide ranges of climate, salinity, and sediment types. At all sites, biota (plankton, sediment living organisms, and fish) showed enhanced concentrations of Hg relative to corresponding organisms at nearby reference sites. The key process determining the risk at these sites is the net transformation of inorganic Hg to the highly toxic and bioavailable methylmercury (MeHg). Accordingly, Hg concentrations in Perca fluviatilis were more strongly correlated to MeHg (p < 0.05) than to inorganic Hg concentrations in the sediments. At all sites, except one, concentrations of inorganic Hg (2-55 microg g(-1)) in sediments were significantly, positively correlated to the concentration of MeHg (4-90 ng g(-1)). The MeHg/Hg ratio (which is assumed to reflect the net production of MeHg normalized to the Hg concentration) varied widely among sites. The highest MeHg/Hg ratios were encountered in loose-fiber sediments situated in southern freshwaters, and the lowest ratios were found in brackish-water sediments and firm, minerogenic sediments at the northernmost freshwater site. This pattern may be explained by an increased MeHg production by methylating bacteria with increasing temperature, availability of energy-rich organic matter (which is correlated with primary production), and availability of neutral Hg sulfides in the sediment pore waters. These factors therefore need to be considered when the risk associated with Hg-contaminated sediments is assessed.     

Recent advances in mercury speciation analysis with focus on spectrometric methods and enriched stable isotope applications

This paper discusses some recent advances in spectrometric methods and approaches for mercury speciation analysis of environmental samples with focus on isotope dilution techniques for determination of mercury species' concentrations in gaseous samples and reaction rates in soils and sediments. Such analytical data is important inter alia in fundamental research on mercury biogeochemistry and for risk assessments of mercury-contaminated soils and sediments and for designing effective remedial actions. The paper describes how the use of enriched stable isotope tracers in mercury speciation analysis can improve the traceability and accuracy of results, facilitate rational method developments, and be useful for studying biogeochemical processes, i.e. rate of reactions and fluxes, of mercury species. In particular the possibilities to study and correct for unwanted species transformation reactions during sample treatment and to study "natural" transformations of species in environmental samples, or micro- and mesocosm ecosystems, during incubations are highlighted. Important considerations to generate relevant data in isotope tracer experiments as well as reliability and quality assurance of mercury speciation analysis in general are also discussed.     

Oxidation of trichloroethene over metal oxide catalysts: kinetic studies and correlation with adsorption properties

The performance of bulk chromium oxide is compared with that of a Mn commercial catalyst for the deep oxidation of trichloroethene (1000-2500ppmv, 55h(-1) space velocity) in air, in dry and wet (20000ppm of H(2)O) conditions, in terms of activity, selectivity and stability. Chromium oxide was found to be more active (on a catalyst weight basis), however its activity decreases continuously with time on stream. The presence of water increases its stability, the Mn catalyst showing the opposite behaviour. The effect of water on the Cr catalyst can be explained according to the Deacon equilibrium, as the presence of water tends to decrease the Cl(2) concentration, assumed to be responsible of the catalyst deactivation. Regarding to the selectivity, the Mn catalyst yields C(2)Cl(4), CCl(4) and CHCl(3) as organochlorinated by-products, whereas chromium oxide produces only trace amounts of CCl(4). Simple power-law kinetics expressions (first-order for Mn and zero-order for Cr) provide fairly good fits for the evolution of the conversion with the temperature. Furthermore, the kinetic behaviour of chromium oxide can be represented with a Langmuir-Hinshelwood model taking into account the chlorine inhibitory effect.