为了解观赏性植物对土壤重金属污染的修复效果,以开封市5种菊花(金皇后、墨菊、孔雀草、粉旭桃、玛格丽特菊)为研究对象,分析菊花以及土壤样品中镉(Cd)、铬(Cr)、铜(Cu)、铅(Pb)、锌(Zn)等5种重金属元素的含量,分析菊花对土壤重金属的富集、转移能力.采用单因子指数法、内梅罗综合指数法评价土壤环境质量,并采用模糊综合评价法进一步分析菊花带来的环境效益.结果表明,土壤中5种重金属的含量由大到小为:Zn Pb Cu Cr Cd,土壤重金属为轻度污染,且Cd对综合指数贡献最大;富集能力方面,所选菊花对5种重金属均能够富集;转移能力方面,金皇后的能力最强,其由强到弱的排序为Cr Cd Pb Zn Cu;环境效益分析,以开封菊花为例,2016—2018年开封菊花日滞尘量、日释氧量、日固碳量随着菊花的增多而增强. 相似文献
Environmental Fluid Mechanics - Stratification effects induced by density differences between the incoming flows are investigated at a medium-size stream confluence with a highly discordant bed.... 相似文献
• Washed MSWI fly ash was used as partial cement or sand substitute.• Sand replacing is beneficial for strength, while cement replacement reduces strength.• Cementing efficiency factor and mortar pore structure explain the strength results.• Health risk assessment was conducted for MSWI fly ash blended cement mortar.• CR and HI contributed by different exposures and heavy metals were analyzed. The strength of cement substituted mortar decreases with the increase in fly ash amount, whereas the strength increases when the fly ash is blended as sand substitute. A mortar with highest strength (compressive strength= 30.2 Mpa; flexural strength= 7.0 Mpa) was obtained when the sand replacement ratio was 0.75%. The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5% and 25%. The k values of fly ash used for sand replacement were all significantly above that used for cement substitution. The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar. For the mortar with the mass ratio of fly ash to binder of 0.5%, the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 10-7 and 0.06, respectively; these results were both lower than the threshold values, showing an acceptable health risk. The CR (9.89 × 10-5) and HQ (3.89) of the non-sensitive scenario for fly ash treatment exceeded the acceptable threshold values, indicating health risks to onsite workers. The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd, respectively. The CR and HQ from inhalation was the main route of heavy metal exposure. 相似文献
• Physical and chemical properties and application of peracetic acid solution.• Determination method of high concentration peracetic acid.• Determination method of residual peracetic acid (low concentration). Peroxyacetic acid has been widely used in food, medical, and synthetic chemical fields for the past several decades. Recently, peroxyacetic acid has gradually become an effective alternative disinfectant in wastewater disinfection and has strong redox capacity for removing micro-pollutants from drinking water. However, commercial peroxyacetic acid solutions are primarily multi-component mixtures of peroxyacetic acid, acetic acid, hydrogen peroxide, and water. During the process of water treatment, peroxyacetic acid and hydrogen peroxide (H2O2) often coexist, which limits further investigation on the properties of peroxyacetic acid. Therefore, analytical methods need to achieve a certain level of selectivity, particularly when peroxyacetic acid and hydrogen peroxide coexist. This review summarizes the measurement and detection methods of peroxyacetic acid, comparing the principle, adaptability, and relative merits of these methods. 相似文献
The sigma (SIG) coordinate system in ocean circulation simulation models results inevitably in horizontal pressure gradient error. This problem also emerges in models of deep lakes or reservoirs with the same characteristics of underwater terrain mutation. SIG coordinates reflect vertical relative stratification but cannot be used to calculate horizontal pressure gradient force in places with drastic topographic changes; this results in vertical water temperature and circulation errors. In deep lakes or reservoirs, differences in water density caused by the temperature difference between upper and lower water bodies is the primary cause of thermal stratification phenomena. Lake Mead was used as a case study on steep topography based on Environmental Fluid Dynamics Code (EFDC) model in this study. SIG coordinates result in close agreement between the calibrated temperature time series at the top and middle water layers, but disparity in the bottom water layer. The error emerges in the horizontal pressure gradient error due to the SIG coordinate transformation. Neither increasing the vertical resolution nor adjusting the horizontal viscosity coefficient resolve this error. We test the sigma-zed (SGZ) coordinate which combines Z coordinate and SIG coordinate as a replacement for the SIG coordinate to find that they effectively reduce the model’s runtime and simulation efficiency. The vertical temperature distribution in SGZ coordinate mode is more accurate than the distribution in SIG coordinate mode. The Navier-Stokes horizontal gradient and advection diffusion equation results under SIG coordinates are very sensitive to the pressure gradient. The replacement also enhances resolution near the thermocline, facilitates reclosing of the water bottom and the equal sigma surface, lends significant advantages in terms of vertical temperature in the simulation for local deep water with steep terrain, and shortens runtime for 0.14 h. SGZ mixed coordinates are recommended in the simulation of deep lakes or reservoirs wherein the underwater topography is large (with abundant continuous deep trenches or reefs).
Environmental Science and Pollution Research - Soil labile and recalcitrant carbon (C) and nitrogen (N) are strongly controlled by plant inputs and climatic conditions. However, the interrelation... 相似文献