Reducing ammonia emissions from laying-hen houses through dietary manipulation

Feed additives can change the microbiological environment of the animal digestive track, nutrient composition of feces, and its gaseous emissions. This 2-yr field study involving commercial laying-hen houses in central Iowa was conducted to assess the effects of feeding diets containing EcoCal and corn-dried distillers grain with solubles (DDGS) on ammonia (NH3), hydrogen sulfide (H2S), and greenhouse gas (CO2, CH4, and N2O) emissions. Three high-rise layer houses (256,600 W-36 hens per house) received standard industry diet (Control), a diet containing 7% EcoCal (EcoCal) or a diet containing 10% DDGS (DDGS). Gaseous emissions were continuously monitored during the period of December 2007 to December 2009, covering the full production cycle. The 24-month test results revealed that mean NH3 emission rates were 0.58 +/- 0.05, 0.82 +/- 0.04, and 0.96 +/- 0.05 g/hen/day for the EcoCal, DDGS, and Control diet, respectively. Namely, compared to the Control diet, the EcoCal and DDGS diets reduced NH3 emission by an average of 39.2% and 14.3%, respectively. The concurrent H2S emission rates were 5.39 +/- 0.46, 1.91 +/- 0.13, and 1.79 +/- 0.16 mg/ hen/day for the EcoCal, DDGS, and Control diet, respectively. CO2 emission rates were similar for the three diets, 87.3 +/- 1.37, 87.4 +/- 1.26, and 89.6 +/- 1.6 g/hen/day for EcoCal, DDGS, and Control, respectively (P = 0.45). The DDGS and EcoCal houses tended to emit less CH4 than the Control house (0.16 and 0.12 vs. 0.20 g/hen/day) during the monitored summer season. The efficacy of NH3 emission reduction by the EcoCal diet decreased with increasing outside temperature, varying from 72.2% in February 2009 to -7.10% in September 2008. Manure of the EcoCal diet contained 68% higher ammonia nitrogen (NH3-N) and 4.7 times higher sulfur content than that of the Control diet. Manure pH values were 8.0, 8.9, and 9.3 for EcoCal, DDGS, and Control diets, respectively. This extensive field study verifies that dietary manipulation provides a viable means to reduce NH3 emissions from modern laying-hen houses.     

Improving the activity of Mn/TiO2 catalysts through control of the pH and valence state of Mn during their preparation

In this study, the authors investigated the influence of the valence state of Mn on the efficacy of selective catalytic reduction using a Mn-based catalyst. The nitrogen oxides (NOx) conversion rate of the catalyst was found to be dependent on the type of TiO2 support employed and on the temperature, as the catalyst showed an excellent conversion of > 80% at a space velocity of 60,000 hr(-1) when the temperature was above 200 degrees C. Brunauer-Emmett-Teller, X-ray diffraction, and X-ray photoelectron spectroscopy analyses confirmed that catalyst displaying the highest activity contained the Mn4+ species and that its valence state was highly dependent on the pH during the catalyst preparation.     

Physicochemical properties of chars at different treatment temperatures

In this study, the physicochemical properties of the char of Indonesian SM coal following heat treatment at various temperatures were evaluated using X-ray photoelectron spectroscopy (XPS), Fourier-transform infrared spectroscopy (FT-IR), scanning electron microscopy (SEM), and morphological and specific surface area analysis. Based on these analyses, heat treatment of coal was determined to be the most effective in increasing the coal rank. In the XPS analysis, the C-O and C-O-C groups and quaternary-N species were found to be of a lower grade coal when the pretreatment temperature decreased, meanwhile the C-C group and pyridinic species increased. In the FT-IR analysis, the collapse of the C-O and C-O-C group was observed due to the collapse of the ether group. In SEM and Brunauer-Emmett-Teller (BET) analysis, a decrease in the ether group was shown to be accompanied with the formation of micropores.     

几种不同处理方法对活性炭表面化学性质的影响

活性炭表面官能团的种类和数量决定了活性炭的表面化学性质,而化学性质决定了活性炭的表面吸附特性。使用5种常见的处理方法处理活性炭,采用Boehm滴定法,XPS对活性炭进行表征,通过单因素实验系统地考察了活性炭表面含氧官能团及碱度随处理条件的变化,同时通过碱度变化讨论了部分处理方法对于原活性炭表面灰分的去除。结果表明:在处理液150 mL、20℃、200 r/min条件下:50 g活性炭经0.01～5 mol/L HCl处理4 h,活性炭表面碱度降低范围63.2%～76.5%,灰分去除效果好,低浓度的盐酸就能达到较好的灰分去除效果,活性炭表面没有形成大量的含氧官能团;在HNO3浓度1～12 mol/L、处理时间1～8 h、活性炭量25～75 g条件下处理后总碱度降低显著,灰分去除效果优于HCl处理,HNO3氧化作用使活性炭表面形成了大量含氧官能团,总酸度、羧基、内酯基、酚羟基含量均相对于原活性炭增加明显;在H2O2质量浓度5%～20%、处理时间0.5～4 h、活性炭量25～75 g条件下处理后碱性灰分去除不好,活性炭表面没有形成大量含氧官能团,H2O2处理引起活性炭表面化学性质变化较小;在NaOH浓度0.1～2 mol/L、处理时间1～8 h、活性炭量25～75 g条件下处理后碱度增加明显,酸度减小明显,羧基、酚羟基含量降低。50 g活性炭在微波功率100～500 W、处理时间2～10 min、载气流量600～1 400 mL/min条件下经微波处理后,微波热效应导致含氧官能团分解,总碱度增加,总酸度下降,羧基含量、内酯基含量降低,酚羟基含量因条件的不同而变现出不同的变化。     

利用剩余活性污泥生产一次性可降解材料

为了缓解污水处理厂日益严重的污泥处置难题,实现剩余活性污泥的无害化、减量化、稳定化、资源化利用。采用SBR系统对剩余活性污泥进行10 d的驯化,加入4.0 g/L的乙酸钠作为发酵培养基碳源和前体物质,累积聚羟基烷酸酯(polyhydroxyalkanoates,PHA)。30℃好氧发酵10 h后,PHA积累达1 125 mg/L,占污泥浓度(MLSS)的质量分数为35.7%。然后经过离心、烘干、粉碎后模压成型加工成一次性使用的可生物降解材料。使用正交实验进行优化,结果表明:其最佳的物料配比和模压条件为:干污泥57%;稻草纤维20%;聚乙烯醇(PVA)19%;硬脂酸钡2%;氧化钙2%;最佳工艺条件为100℃,加热1.5 h,此时加工出来的产品具有最优的抗压强度和拉伸强度。以本方法制成的可生物降解花盆其所含细菌总数、粪大肠菌群、蛔虫卵死亡率均达到国标所规定的污泥农用生物安全要求;另外,试样中未检出病毒;其重金属含量也达到国标所规定的污泥农用标准;其可生物降解性能达到了可降解材料的要求。因而本研究制备的一次性使用可降解花盆具有较好的开发和应用价值。     

响应面优化CCl4增强超声降解左旋氧氟沙星模拟废水

利用响应面优化实验设计方法对CCl₄增强超声降解左旋氧氟沙星模拟废水的影响因素进行探讨和分析,考察了溶液初始pH值、超声功率、左旋氧氟沙星初始浓度的影响。应用Box-Behnken中心组合设计得到一个二次多项式数学模型,确定了US/CCl₄降解左旋氧氟沙星的优化条件:初始pH值6.8,超声功率189 W,左旋氧氟沙星初始浓度为5 mg/L时,左旋氧氟沙星的去除率达到最大(82.99%)。经实验验证, 实际值与模型预测值吻合性良好,偏差仅为0.036%。     

碱式硫酸铝溶液中SO42-的测定

建立了以铬黑T为指示剂,乙二胺四乙酸二钠反滴定过量BaCl₂的碱式硫酸铝溶液中SO₄^2-的测定方法。实验确定的操作条件为：待测试样稀释后ρ（SO_4^2-）为0.025 ~0.100 g/L,BaCl₂过量率为25%~100%,并且在加入BaCl₂前将试样煮沸,三乙醇胺加入量为0.10 L/L。该法回收率在98.90%~100.72%,相对标准偏差小于1%。测定方法准确,可靠,且操作简便、快速。     

Cadmium tolerance in six poplar species

Selection of poplar species with greater Cd tolerance and exploiting the physiological mechanisms involved in Cd tolerance are crucial for application of these species to phyto-remediation. The aim of this study is to investigate variation in Cd tolerance among the six poplar species and its underlying physiological mechanisms. Cuttings of six Populus species were cultivated for 10 weeks before exposure to either 0 or 200 μM CdSO₄ for 20 days. Gas exchange in mature leaves was determined by a portable photosynthesis system. Cd concentrations in tissues were analyzed by a flame atomic absorbance spectrometry. Subsequently, Cd amount per plant, bio-concentration factor (BCF) and translocation factor (T _f) were calculated. Nonenzymatic compounds and activities of antioxidative enzymes in tissues were analyzed spectrophotometrically. Cd exposure caused decline in photosynthesis in four poplar species including Populus cathayana (zhonghua 1). Among the six species, P. cathayana (zhonghua 1) displayed the highest Cd concentrations in tissues, the largest Cd amount in aerial parts, the highest BCF in aerial parts and T _f under Cd exposure. Under Cd stress, increases in total soluble sugars in roots but decreases in starch in roots, wood, and leaves of P. cathayana (zhonghua 1) were found. Induced O ₂ ^?? and H₂O₂ production in roots and leaves, and increases in free proline, soluble phenolics, and activities of antioxidative enzymes were observed in P. cathayana (zhonghua 1). Based on results of this pot experiment, it is concluded that P. cathayana (zhonghua 1) is superior to other five species for Cd phyto-remediation, and its well-coordinated physiological changes under Cd exposure confer the great Cd tolerance of this species.     

正交试验-硝酸微波消解-冷原子吸收法测定土壤中汞

应用硝酸微波消解土壤样品-冷原子吸收法测定土壤中的汞。通过正交试验,优化了土壤中汞的微波消解条件。并对干扰消除、方法精密度、加标回收、检出限进行了试验研究。在0～10μg／L范围内线性关系良好,方法测定下限为0．20μg／L,土壤中汞的检出限为0．005μg／g。该优化条件对汞含量为0．02—0．46μg／g的土壤样品,汞提取完全。建立了一种简便、成本低、干扰少、灵敏度高的方法。