高效率颗粒物微物理模型简介与重污染过程应用分析

中国细颗粒物(PM2.5)导致的空气污染和雾霾天气问题越来越突出,在低层对流层中很多地方都有显著的二次颗粒物生成过程,因此对颗粒物物理化学转化过程的研究具有重要意义,其转化过程对空气质量模式模拟和预报的准确性有重要影响。高效率颗粒物微物理(APM)模型经过近20多年的研究和发展,在全球化学传输模型(GEOS-Chem)、区域性气象和化学预报模型(WRF-Chem)通用地球系统模型(CESM-CAM5)等气象及环境空气质量预报模型中取得了很好的应用验证,能够在全球/区域等不同尺度对粒子生成、长大、凝聚、消除等微物理过程以及气溶胶光学厚度(AOD)、直接/间接辐射强迫等进行模拟。应用GEOS-Chem-APM模式模拟了2014年2月京津冀区域的重污染过程。结果显示,湿度模拟的准确性对其他物理和污染物浓度等模拟结果有重要作用;2月20—26日的重污染过程模拟结果与实际观测较为吻合,主要污染特点是较高的湿度(90%以上),同时,二次颗粒物和包裹了二次物种的一次颗粒物(黑碳/有机碳)是低能见度的最大贡献者。     

显色条件对纳氏试剂分光光度法测定水中氨氮的影响

氨氮是水质监测和评价的重要指标之一。本文探讨了纳氏试剂光度法测定水中氨氮时显色温度和显色时间对测定结果的影响,并从空白测定、显色速率及校准曲线等方面进行了分析,提出了对测定方法的改进建议。     

Risk assessment of heavy metals in road and soil dusts within PM2.5, PM10 and PM100 fractions in Dongying city, Shandong Province, China

15 road and 14 soil dust samples were collected from an oilfield city, Dongying, from 11/2009-4/2010 and analyzed by inductively coupled plasma-mass spectroscopy (ICP-MS) for V, Cr, Mn, Co, Ni, Cu, Zn, As, Cd and Pb within PM(2.5), PM(10) and PM(100) fractions synchronously. Metal concentrations, sources and human health risk were studied. Results showed that both soil and road dust exhibited higher values for Mn and Zn and lower values for Co and Cd for the three fractions. Mass concentration ratios of PM(2.5)/PM(10) and PM(10)/PM(100) for metals in road and soil dust indicate that most of the heavy metals tend to concentrate in fine particles. Geoaccumulation index and enrichment factors analysis showed that Cu, Zn and Cd exhibited moderate or heavy contamination and significant enrichment, indicating the influence of anthropogenic sources. Vanadium, Cr, Mn and Co were mostly not enriched and were mainly influenced by crustal sources. For Ni, As and Pb, they ranged from not enriched to moderately enriched and were influenced by both crustal materials and anthropogenic sources. The conclusions were confirmed by multivariate analysis methods. Principle component analysis revealed that the major sources were vehicle emission, industrial activities, coal combustion, agricultural activities and crustal materials. The risk assessment results indicated that metal ingestion appeared to be the main exposure route followed by dermal contact. The most likely cause for cancer and other health risks are both the fine particles of soil and road dusts.     

Chemical compositions and sources of atmospheric PM10 in heating, non-heating and sand periods at a coal-based city in northeastern China

Mass concentrations and chemical components (18 elements, 9 ions, organic carbon [OC] and elemental carbon [EC]) in atmospheric PM(10) were measured at five sites in Fushun during heating, non-heating and sand periods in 2006-2007. PM(10) mass concentrations varied from 62.0 to 226.3 μg m(-3), with 21% of the total samples' mass concentrations exceeding the Chinese national secondary standard value of 150 μg m(-3), mainly concentrated in heating and sand periods. Crustal elements, trace elements, water-soluble ions, OC and EC represented 20-47%, 2-9%, 13-34%, 15-34% and 13-25% of the particulate matter mass concentrations, respectively. OC and crustal elements exhibited the highest mass percentages, at 27-34% and 30-47% during heating and sand period. Local agricultural residuals burning may contribute to EC and ion concentrations, as shown by ion temporal variation and OC and EC correlation analysis. Heavy metals (Cr, Ni, Zn, Cu and Mn) from coal combustion and industrial processes should be paid attention to in heating and sand periods. The anion/cation ratios exhibited their highest values for the background site with the influence of stationary sources on its upper wind direction during the sand period. Secondary organic carbon were 1.6-21.7, 1.5-23.0, 0.4-17.0, 0.2-33.0 and 0.2-21.1 μg m(-3), accounting for 20-77%, 44-88%, 4-77%, 8-69% and 4-73% of OC for the five sampling sites ZQ, DZ, XH, WH and SK, respectively. From the temporal and spatial variation analysis of major species, coal combustion, agricultural residual burning and industrial emission including dust re-suspended from raw material storage piles were important sources for atmospheric PM(10) in Fushun at heating, non-heating and sand periods, respectively. It was confirmed by principal component analysis that coal combustion, vehicle emission, industrial activities, soil dust, cement and construction dust and biomass burning were the main sources for PM(10) in this coal-based city.     

西宁市典型开放源颗粒物粒径组成特征分析

采用BT-9300S激光粒度仪分析了西宁市道路尘、扬尘、土壤尘、建筑尘4种典型开放源的粒径组成。结果表明,4种类型尘中大粒径颗粒物占主导地位,粒径大于10 μm颗粒占到全部颗粒的73.80%以上,可吸入颗粒物的含量仅占7.06%～26.20%;建筑尘的细颗粒物含量最高,粒径小于2.5、1 μm的颗粒含量分别为8.36%±4.25%、2.42%±1.02%;道路尘的细颗粒物含量最低,粒径小于2.5、1 μm的颗粒含量分别为2.30%±0.94%、0.73%±0.28%;4种类型尘的体积平均直径、面积平均直径、中位直径分别在37.70～87.99 μm、8.50～23.53 μm、28.95～74.98 μm之间,其中道路尘的3种粒径参数最大,建筑尘最小;开放源颗粒物的粒度分布曲线主要呈头长尾短的不对称单峰分布,累积频率曲线为两段式,存在较为明显的拐点。     

原子荧光法测定水中汞的原子化条件研究

分别采用热原子化原子荧光法(热汞法)和冷原子化原子荧光法(冷汞法)测定水中汞,比较了两种方法的检出限、线性相关系数、准确度和精密度的差异。冷汞法和热汞法的检出限分别为0.003和0.01μg/L,标准曲线相关系数分别为0.999 9和0.999 7,加标回收率范围分别为102%~106%和106%~113%。结果表明,冷汞法比热汞法具有更低的检出限,灵敏度和准确度也略优于热汞法。对于冷汞法,提高负高压有利于提高方法的灵敏度、准确度,并具有更低的方法检出限。     

Effect of Soybean Cultivation on Soil Collembola Community in Marshland of Sanjiang Plain,China

The Sanjiang Plain, the largest inland freshwater marshland in China, was extensive reclaimed into agricultural land. To assess the effects of marshland reclamation on Collembola, we investigated collembolan communities in a chronosequence of soybean plantations (2, 15, and 25 years) in Sanjiang marshland, Northeastern China. We found that: 1) the densities and species richness of Collembola were promoted after short-term (2 years) cultivation of soybean, but significantly decreased after medium-term cultivation (15 years); 2) the densities of epi-edaphic Collembola increased while the densities of hemi-edaphic Collembola decreased as the elongation of soybean cultivation; 3) compared with S0, two species of Collembola appeared while five species disappeared in S25. The changes of plant communities and the soil traits were supposed to be the key factors affecting the composition of soil Collembola. We thus suggest that original marshland should be saved for preserving high diversity and densities of Collembola in the Sanjiang Plain.

     

冻融循环作用下尾矿砂抗剪强度和变形特性研究

为探究冻融循环后尾矿物理力学特性的变化特征,使用高低温试验箱和应变控制式三轴剪力仪对处于不同初始条件下的尾矿砂进行不排水不固结试验,揭示了尾矿砂的抗剪强度参数、不同围压条件下的变形模量与冻融循环次数、含水率之间的关系。结果表明:相同含水率条件下,随冻融循环次数增加,尾矿砂黏聚力先减小后趋于稳定,内摩擦角先增大后减小,围压100 k Pa和200 k Pa时变形模量逐渐减小,围压300 k Pa时变形模量呈现先减小后缓慢增大的趋势;相同冻融循环次数条件下,随尾矿砂含水率增加,其黏聚力先增加后减小、内摩擦角不断减小;不同围压条件下变形模量在总体上均呈现出不断减小的变化趋势,围压200 k Pa时变形模量总的衰减量最大,100k Pa次之,300 k Pa最小。     

露天矿溜槽粉尘逸散规律试验研究

为探索露天矿用溜槽系统粉尘逸散的影响因素,阐明溜槽系统运输过程中粉尘的产生机理和运移规律,从而解决溜槽系统产生的粉尘污染问题,以抚顺西露天矿为研究背景,运用相似理论,建立溜槽模型,通过单因素试验和正交试验,分别研究物料粉岩质量分数、物料含水率、溜槽倾角对溜槽运行过程中粉尘质量浓度的影响。单因素试验结果表明,粉尘质量浓度随物料粉岩质量分数、溜槽倾角增大而逐渐增大,随含水率增大而逐渐降低,溜槽底部粉尘质量浓度受影响变化幅度较大,溜槽中部和上部变化较小。溜槽粉尘质量浓度分布规律为溜槽底部粉尘产生量最大,中部次之,上方最小。溜槽底部为粉尘污染防治重点区域。正交试验结果表明,物料含水率对粉尘逸散影响最大,其次是粉岩质量分数,溜槽倾角影响最小。     

Removal of arsenic(III,V) by a granular Mn-oxide-doped Al oxide adsorbent: surface characterization and performance

In order to remove arsenic (As) from contaminated water, granular Mn-oxide-doped Al oxide (GMAO) was fabricated using the compression method with the addition of organic binder. The analysis results of XRD, SEM, and BET indicated that GMAO was microporous with a large specific surface area of 54.26 m^2/g, and it was formed through the aggregation of massive Al/Mn oxide nanoparticles with an amorphous pattern. EDX, mapping, FTIR, and XPS results showed the uniform distribution of Al/Mn elements and numerous hydroxyl groups on the adsorbent surface. Compression tests indicated a satisfactory mechanical strength of GMAO. Batch adsorption results showed that As(V) adsorption achieved equilibrium faster than As(III), whereas the maximum adsorption capacity of As(III) estimated from the Langmuir isotherm at 25 °C (48.52 mg/g) was greater than that of As(V) (37.94 mg/g). The As removal efficiency could be maintained in a wide pH range of 3~8. The presence of phosphate posed a significant adverse effect on As adsorption due to the competition mechanisms. In contrast, Ca²⁺ and Mg²⁺ could favor As adsorption via cation-bridge involvement. A regeneration method was developed by using sodium hydroxide solution for As elution from saturated adsorbents, which permitted GMAO to keep over 75% of its As adsorption capacity even after five adsorption–regeneration cycles. Column experiments showed that the breakthrough volumes for the treatment of As(III)-spiked and As(V)-spiked water (As concentration = 100 μg/L) were 2224 and 1952, respectively. Overall, GMAO is a potential adsorbent for effectively removing As from As-contaminated groundwater in filter application.