介质阻挡放电联合催化臭氧化降解甲苯

采用介质阻挡放电区后结合MnOx/Al2O3/发泡镍去除甲苯,考察甲苯进气方式、臭氧产生方法及湿度对甲苯与O3同时去除的影响。结果表明,O3是等离子体区后催化降解甲苯的主要物种,介质阻挡放电联合催化臭氧化可实现甲苯及O3的同时高效去除。输入电压为9.0 kV时,甲苯的去除效率达92.8%,在80 min内O3的去除效率维持在99%以上。水蒸气对催化剂催化分解臭氧的活性没有直接的影响,O3浓度较高时湿度对甲苯降解效率的影响很小。GC-MS分析结果表明,甲苯降解的主要气相副产物有烷烃、酸、酮和含苯环有机物,提出了甲苯的降解途径。     

3种浮床植物系统对富营养化水体净化效果研究

研究了风车草(Cyperus alternifolius)、菖蒲(Acorus calamus)和富贵竹(Dracaena sanderiana)3种浮床植物系统对富营养化水体净化效果,试验共持续35 d。结果表明,在水温24～30℃条件下,风车草和菖蒲生长良好,生物量大,而富贵竹生长较差,生物量增加少;3种植物对NH_4~+-N的去除率分别为76.8%、85.5%和53.6%,对TN的去除率分别为69.1%、66.2%和54.4%,对TP的去除率分别为76.9%、84.6%和61.5%,对PO_4~(3-)-的去除率分别为91.7%、91.7%和75%,对真实色度有明显的去除效果;3种植物对氮磷和真实色度去除效果与对照之间均达到显著差异(P0.05),自然沉淀是浊度去除的主要原因,植物吸收同化作用是NH_4~+-N去除的主要途径,植物吸收是溶解性磷去除的主要途径。试验表明,风车草和菖蒲对富营养化水体中氮磷和真实色度有较好的去除效果,可作为富营养化水体治理的优良物种而推广使用。     

地下渗滤系统处理农村生活污水的研究

在天津武清区一村落构建了2个并行的地下渗滤系统,考察了其对农村生活污水的处理效果。该系统水力负荷为10 cm/d,处理能力为50 t/d。填充介质选用土壤、陶粒、炉渣和两种自然有机质,按5∶2∶2∶1的比例配置的人工土层。结果表明地下渗滤系统对污水中各种主要污染因子均有一定的去除效果,在进水COD和C/N较低的不利条件下,COD、总磷、氨氮、总氮、悬浮物均得到有效去除,出水中各项污染指标平均浓度均达到《城镇污水处理厂污染物排放标准》中的一级A标准;具体到不同的污染指标,添加了不同有机质的2个并行系统的处理效果也有所不同。总体上看,地下渗滤系统作为农村生活污水的处理设施有很好的应用前景。     

液相色谱-质谱法测定水中氨基甲酸酯类农药及其代谢物

建立了直接测定水中10种氨基甲酸酯类农药及其代谢物的超高效液相色谱-质谱分析方法。该方法对水样无需进行富集处理,水样过滤后就可以直接测定。实验结果表明:测定液中各氨基甲酸酯类农药及其代谢物的质量浓度与离子对峰面积在质量浓度0.5～1 000.0μg/L内具有良好的线性关系;方法检出限为0.1～5.0μg/L;加标回收率91%～103%;相对标准偏差为2%～5%。该方法具有简便快捷、灵敏度高的特点。     

Tracking nitrogen losses in a greenhouse crop rotation experiment in North China using the EU-Rotate_N simulation model

Vegetable production in China is associated with high inputs of nitrogen, posing a risk of losses to the environment. Organic matter mineralisation is a considerable source of nitrogen (N) which is hard to quantify. In a two-year greenhouse cucumber experiment with different N treatments in North China, non-observed pathways of the N cycle were estimated using the EU-Rotate_N simulation model. EU-Rotate_N was calibrated against crop dry matter and soil moisture data to predict crop N uptake, soil mineral N contents, N mineralisation and N loss. Crop N uptake (Modelling Efficiencies (ME) between 0.80 and 0.92) and soil mineral N contents in different soil layers (ME between 0.24 and 0.74) were satisfactorily simulated by the model for all N treatments except for the traditional N management. The model predicted high N mineralisation rates and N leaching losses, suggesting that previously published estimates of N leaching for these production systems strongly underestimated the mineralisation of N from organic matter.     

A method of detecting carbonyl compounds in tree leaves in China

Background, aim, and scope  

Carbonyl compounds have been paid more and more attention because some carbonyl species have been proven to be carcinogenic or a risk for human health. Plant leaves are both an important emission source and an important sink of carbonyl compounds. But the research on carbonyl compounds from plant leaves is very scarce. In order to make an approach to the emission mechanism of plant leaves, a new method was established to extract carbonyl compounds from fresh plant leaves.     

医疗废物焚烧处理核心技术的开发及应用

国内已建成的医疗废物焚烧设施目前普遍存在进料系统不稳定、玻璃结渣和高浓度HCl气体的排放的问题。这些技术难点已成为医疗废物焚烧处置行业发展的瓶颈。本文介绍了可解决上述问题的"可调节医疗废物恒流量进料技术"、"医废焚烧防玻璃结渣技术"和"含高浓度氯化氢医废尾气处理技术"三项医疗废物焚烧处理核心技术的主要特点及技术指标与应用实例。     

秦皇岛市天然矿泉水水质特征及开发利用前景研究

秦皇岛市天然矿泉水主要赋存在早太古代的花岗岩和变质岩的构造裂隙与风化裂隙之中,有锶、偏硅酸、锶及偏硅酸、锶溴及偏硅酸等4种类型。矿泉水水源地数量较多,水质优良,但开采程度较低,开发利用前景广阔。     

Tree bark as a passive air sampler to indicate atmospheric polybrominated diphenyl ethers (PBDEs) in southeastern China

The different barks were sampled to discuss the influence of the tree species, trunk circumference, and bark thickness on the accumulation processes of polybrominated diphenyl ethers (PBDEs) from air into the bark. The results of different PBDE concentrations indicated that barks with a thickness of 0–3 mm collected from weeping willow, Camphor tree, and Masson pine, the trunk circumferences of which were 100 to 150 cm, were better PBDEs passive samplers. Furthermore, tree bark and the corresponding air samples were collected at Anji (AJ), Hangzhou (HZ), Shanghai (SH), and Wenling (WL) to investigate the relationship between the PBDE concentrations in bark and those in air. In addition, the significant correlation (r ²?=?0.906; P?<?0.05) indicated that atmospheric PBDEs were the principle source for the accumulation of PBDEs in the barks. In this study, the log K _BA (bark–air partition coefficient) of individual PBDE congeners at the four sites were in the range from 5.69 to 6.79. Finally, the total PBDE concentration in WL was 5 to 20 times higher than in the other three cities. The result indicated that crude household workshops contributed a heavy amount of PBDEs pollution to the environment, which had been verified by the spatial distribution of PBDEs levels in barks collected at Wenling (range, 26.53–1317.68 ng/g dw). The good correlation between the PBDE concentrations in the barks and the air samples and the variations of the PBDE concentrations in tree barks collected from different sites reflected that the bark could be used as a passive sampler to indicate the atmospheric PBDEs.     

Hazardous substances in indoor dust emitted from waste TV recycling facility

Various hazardous substances contained in waste TV sets might be released into environment via dust during recycling activities. Two brominated flame retardants (BFRs), polybrominated diphenyl ethers (PBDEs), and tetrabromobisphenol A (TBBPA), and five kinds of heavy metals (Cu, Pb, Cd, Cr, and Ni) were detected in indoor dust collected from two workshops (TV dismantling workshop and subsequent recycling workshop). PBDEs concentrations in dust from waste wires recycling line (722,000 ng/g) were the highest among the studied sites, followed by those in manual dismantling–sorting line (117,000 ng/g), whereas TBBPA concentrations were the highest in manual dismantling–sorting line (557 ng/g) and printed circuit board (PCB) recycling line (428 ng/g). For heavy metals, Cu and Pb were the most enriched metals in all dust samples. The highest concentration of Pb (22,900 mg/kg) was found in TV dismantling workshop-floor dust. Meanwhile, Cu was the predominant metal in dust from the PCB recycling line, especially in dust collected from electrostatic separation area (42,700 mg/kg). Occupational exposure assessment results showed that workers were the most exposed to BDE-209 among the four PBDE congeners (BDE-47, BDE-99, BDE-153, and BDE-209) in both workshops. The hazard quotient (HQ) indicated that noncancerous effects were unlikely for both BFRs and heavy metals (HQ?<?1), and carcinogenic risks for Cd, Cr, and Ni (risk?<?10^?6) on workers in two workshops were relatively low.