SCR脱硝系统烟道内流场优化

为了改善选择性催化还原法(SCR)催化剂上游烟气的流场、温度场和浓度场分布,基于CFD仿真分析技术,建立了整个脱硝系统三维模型,并通过优化导流板及整流格栅,使得速度标准偏差、浓度标准偏差、温度偏差、速度偏转角以及压降等性能指标都满足设计要求,在满足脱硝效率和氨逃逸率前提下,大大降低了烟气对催化剂层的冲刷,保证催化剂的使用寿命。最后,为了合理布置吹灰器,对优化结构下粉尘颗粒在烟道内的运动情况进行了仿真分析研究,为设计提供了依据。     

响应面法优化黄粉虫幼虫处理餐厨垃圾饲养条件的研究

研究了黄粉虫幼虫处理餐厨垃圾的方法。首先在饲养温度、饲料含水量和饲养密度等条件下进行单因素实验,然后,以利用率为指标,运用响应面法优化了黄粉虫幼虫处理餐厨垃圾的饲养条件,结果表明,最佳饲养条件为饲养温度26.7℃、饲料含水量14.5%、饲养密度4.1头/cm2。在此饲养条件下,黄粉虫对餐厨垃圾利用率理论值为38.72%,实际餐厨垃圾利用率为38.88%,相对误差为0.41%,说明利用黄粉虫幼虫处理餐厨垃圾具有较好的效果。     

3种喹诺酮类抗生素在骆马湖饮用水源地沉积物上的吸附特征

为探究喹诺酮类抗生素(QNs)在饮用水源地的吸附特征,2019年6月于江苏骆马湖饮用水源地采集沉积物样品,用5种动力学方程拟合沉积物对诺氟沙星(NOR)、环丙沙星(CIP)和氧氟沙星(OFL)的吸附动力学过程,并用Langmuir和Freundlich模型拟合以上3种QNs的吸附热力学过程,分析了pH、水土比和不同Na~+、Ca~(2+)、Mg~(2+)、Al~(3+)浓度对吸附过程的影响。结果表明:骆马湖沉积物对3种QNs的吸附在8h达到平衡,准二级动力学方程和Langmuir模型能更好地描述3种QNs的吸附动力学和热力学过程。酸性条件下,3种QNs的吸附效果更好,且在pH=5时平衡吸附量最大。平衡吸附量随着水土比的上升而下降。Na~+对吸附的抑制作用不明显,Ca~(2+)和Mg~(2+)的抑制作用较强,而Al~(3+)对吸附表现为促进作用。应在枯水期和南水北调时期加强对骆马湖饮用水源地(尤其是东北部)QNs污染的关注。     

基于改进灰色模型的管壁蜡沉积厚度预测研究

为对含蜡原油管道中的蜡沉积厚度进行准确预测,在函数cot(x2)变换的基础上,结合平移变换思想,利用cot(x2+c)变换建立新的改进GM(1,1)模型。以现场管道结蜡数据和室内环道结蜡数据为例,对比改进GM(1,1)模型、基于函数cot(x2)变换建立的GM(1,1)模型及传统GM(1,1)模型之间的预测精度,并分析平移量c对改进GM(1,1)模型预测精度的影响。结果表明:改进GM(1,1)模型的预测精度最高,其次是基于函数cot(x2)变换建立的GM(1,1)模型,而传统GM(1,1)模型的预测精度最低;随着平移量的增大,改进GM(1,1)模型的平均相对预测误差呈现出先减小后增大的趋势,因此合理的平移量有助于模型精度的提高。应用改进GM(1,1)模型来预测管道蜡沉积厚度是可行的,该方法可为含蜡原油管道蜡沉积厚度的准确预测提供参考和借鉴。     

燃煤烟气低温SCR脱硝中试研究

低温选择性催化还原(SCR)脱硝是国内外脱硝技术研发的热点,但目前主要集中在实验室小试范围,无法完全反映催化剂在实际烟气中的运行状况。在30 t/h循环流化床燃煤锅炉脱硫除尘装置后建设了2 000~5 000 m3/h的SCR脱硝中试装置,经系统研究发现,中试使用的蜂窝式催化剂对SO2和NO具有很强的吸附能力,且反应温度、喷氨速率和气体空速均会影响催化脱硝效率。为期5 d的连续运行实验结果表明,催化剂的脱硝效率一直稳定在30%~50%,并未发现明显的失活,这证明设计除雾除尘器、较大的混合器、混合器与反应器间较长的管路均有利于缓解催化剂因SO2、H2O和飞灰中的碱性金属导致的失活。     

初级基质对降解菌Pseudomonas putida共代谢苯扎贝特的影响

通过对3,5-二硝基水杨酸(DNS)法测定还原糖含量各影响因素的筛选,优化确定了显色时间8 min,稳定时间10 min,最佳波长490 nm下进行吸光度测定的检测方法;分析分别以葡萄糖和麦芽糖作为外加碳源时,降解菌Pseudomonas putida B-31的生长情况和共代谢降解典型药物苯扎贝特(BZF)的过程。结果表明,降解菌只有在外加碳源的条件下才可正常生长,而且其在葡萄糖环境中生长得更好;拟合得到的葡萄糖、麦芽糖和BZF代谢动力学结果显示,葡萄糖对BZF去除的促进作用更为明显,同时从葡萄糖培养基中降解菌所提取的酶比活力要高于麦芽糖培养基,分析原因可能是葡萄糖所诱导的降解菌关键酶活力更强,而且还可能会产生不同的蛋白质点位。     

Positive matrix factorization as source apportionment of soil lead and cadmium around a battery plant (Changxing County,China)

Chemical compositions of soil samples are multivariate in nature and provide datasets suitable for the application of multivariate factor analytical techniques. One of the analytical techniques, the positive matrix factorization (PMF), uses a weighted least square by fitting the data matrix to determine the weights of the sources based on the error estimates of each data point. In this research, PMF was employed to apportion the sources of heavy metals in 104 soil samples taken within a 1-km radius of a lead battery plant contaminated site in Changxing County, Zhejiang Province, China. The site is heavily contaminated with high concentrations of lead (Pb) and cadmium (Cd). PMF successfully partitioned the variances into sources related to soil background, agronomic practices, and the lead battery plants combined with a geostatistical approach. It was estimated that the lead battery plants and the agronomic practices contributed 55.37 and 29.28 %, respectively, for soil Pb of the total source. Soil Cd mainly came from the lead battery plants (65.92 %), followed by the agronomic practices (21.65 %), and soil parent materials (12.43 %). This research indicates that PMF combined with geostatistics is a useful tool for source identification and apportionment.     

微生物絮凝剂与聚合氯化铝复配处理涂料废水的响应面优化

采用响应面分析法对聚合氯化铝(PAC)与污泥生产的微生物絮凝剂复配处理涂料废水的过程进行了优化,设定的响应值为COD和色度去除率。实验分别拟合了关于COD去除率和色度去除率的二次模型,根据响应值的分布情况,确定涂料废水的最佳絮凝条件为微生物絮凝剂浓度47 mg/L,PAC浓度39 mg/L,pH为8.2,CaCl2浓度0.38 g/L,搅拌速度210 r/min。最佳絮凝条件下,微生物絮凝剂对涂料废水中COD和色度的去除率分别达到77.6%和68.9%。     

二氧化钛脱除高温烟气中的氯化氢

HCl是城市垃圾焚烧产生的主要气体污染物之一。将一种新型脱氯剂TiO2引入到垃圾焚烧系统中,并与其他脱氯剂的性能进行比较。研究了不同脱氯剂使用量、不同反应温度和不同HCl气体浓度对TiO2、CaO和CaTiO3脱氯效果的影响。结果显示,TiO2能在高温(800~1 000℃)、高HCl浓度(1 303.6~1 629.5 mg/m3)下获得较好的脱氯效果。与传统的脱氯剂CaO相比,TiO2更适合于高温烟气脱氯,其在1 000℃时的氯容(36.3 mg HCl/g TiO2)几乎是相同情况下的CaO氯容(9.3 mg HCl/g CaO)的4倍。而CaTiO3的脱氯效果不但受到自身分解效率的影响,还受到TiO2和CaO脱氯效果的影响,其脱氯效果较差。     

Involvement of abscisic acid in regulating antioxidative defense systems and IAA-oxidase activity and improving adventitious rooting in mung bean [Vigna radiata (L.) Wilczek] seedlings under cadmium stress

In vitro experiments were conducted to investigate the effects of abscisic acid (ABA) and Cd on antioxidative defense systems and indole-3-acetic acid (IAA) oxidase during adventitious rooting in mung bean [Vigna radiata (L.) Wilczek] seedlings. The exogenous ABA significantly enhanced the number and fresh weight of the adventitious roots. CdCl₂ strongly inhibited adventitious rooting. Pretreatment with 10 μM ABA clearly alleviated the inhibitory effect of Cd on rooting. ABA significantly reduced superoxide dismutase (SOD), ascorbate peroxidase (APX), peroxidase (POD), and catalase (CAT) activities, as well as the levels of glutathione (GSH) and ascorbic acid (ASA) during adventitious rooting. ABA strongly increased IAA-oxidase activity during the induction (0–12 h) and expression (after 48 h) phases and increased the phenols levels. Cd treatment significantly reduced the activities of SOD, APX, POD, and IAA oxidase, as well as GSH level. Cd strongly increased ASA levels. ABA pretreatment counteracted Cd-induced alterations of certain antioxidants and antioxidative enzymes, e.g., remarkably rescued APX and POD activities, reduced the elevated SOD and CAT activities and ASA levels, and recovered the reduced GSH levels, caused by Cd stress. Thus, the physiological effects of the combination of ABA and Cd treatments were opposite of those obtained with Cd treatment alone, suggesting that ABA involved in the regulation of antioxidative defense systems and the alleviation of wounding- and Cd-induced oxidative stress.