工业烟气氨法-络合法同时脱硫脱硝

在脱硫脱硝喷淋装置上采用氨法-络合法处理工业烟气。考察了吸收液pH、Fe(Ⅱ)EDTA浓度、初始烟气浓度、液气比对烟气同时脱硫脱硝效果的影响。实验结果表明:吸收液的酸碱度通过影响Fe(Ⅱ)与EDTA的络合形式进而影响NO去除率;SO_2去除率主要受吸收液pH和初始SO_2质量浓度的影响;当吸收液pH大于8、吸收液Fe(Ⅱ)EDTA浓度大于0.100 mol/L、初始SO_2质量浓度小于1 500 mg/m3、初始NO质量浓度为1 200 mg/m3时,SO_2去除率均在95%以上,NO去除率为54%;当液气比由1 L/m3增大至4 L/m3时,有效脱硫时间和有效脱硝时间分别增长了7 min和4 min。     

高铁酸盐处理有机废水的研究进展

综述了高铁酸盐去除水中藻类、细菌、烃类衍生物、药品、农药、染料等有机污染物的国内外最新研究进展,并对高铁酸盐的高效利用进行了探讨。高铁酸盐可破坏藻类和细菌细胞的完整性,将大分子芳香烃衍生物氧化为低毒的小分子中间体,将小分子链烃衍生物矿化,破坏药品、农药及染料的不饱和双键。无机矿物在溶液中负载高铁酸盐或将高分子有机物与固体高铁酸盐混合造粒,将是高铁酸盐高效利用领域的研究热点。     

TiO2载体对Mn-Ce/TiO2催化剂脱硝活性的影响

以TiO₂为载体,选取过渡金属元素Mn为活性组分,稀土金属元素Ce为活性助剂,采用分步共混法制备了Mn-Ce/TiO₂催化剂（活性组分负载量16%）,系统研究了TiO₂载体的晶型和晶粒尺寸对催化剂脱硝活性的影响。实验结果表明：分别以锐钛矿型和金红石型TiO₂为载体制备的催化剂,其低温脱硝活性相差不大,活性组分均以无定型态高度分散于载体中,以金红石型TiO₂为载体制备的催化剂中部分TiO₂转变为锐钛矿型;以不同晶粒尺寸TiO₂载体制备的催化剂的低温脱硝活性相差较大,比表面积较大、晶粒尺寸较小的TiO₂载体制备的催化剂,其脱硝活性低于晶粒尺寸较大的TiO₂载体制备的催化剂。     

环境污染物导致氧化应激的关键信号通路及其检测方法

环境污染物能够以多种途径进入生物体内,在体内产生含氧自由基等活性氧物质,并通过多种信号通路及酶反应引起氧化应激,造成生物体内的脂质过氧化、蛋白质损伤、DNA表达改变、酶失活等,从而引发心血管疾病、风湿类疾病、感染及癌症等的发生。本文对环境污染物致氧化应激产生的原因、涉及的信号通路及酶反应、造成的危害,以及常见的基于细胞模型的氧化应激检测方法进行了综述,期望为评价环境污染物和检测氧化损伤提供参考。     

珠江三角洲4种淡水养殖鱼类重金属的残留及食用风险评价

为全面了解珠江三角洲淡水水产品中重金属污染现状,评估其生态风险与食用安全,于2014年8月至2015年8月采集罗非鱼、草鱼、乌鳢及鳜鱼主要养殖鱼类样品共计57份,采用原子荧光光谱仪(AFS),电感耦合等离子体质谱(ICP-MS)仪进行分析测定,并采用单因子污染指数(Pi)、重金属污染指数(MPI)、每周可耐受摄入量(PTWI)以及食入健康风险指标(Ri总)分别评估其污染程度、食用安全性与健康风险。结果表明,样品中Cr、Ni、Cu、Zn、As、Cd、Hg、Pb的含量范围分别为0.020~3.240,0.020~0.800,0.110~1.100,0.190~19.970,0.030~1.480,nd~0.606,0.003~0.118,0.040~0.803 mg·kg-1(湿重),Cr、As、Cd、Pb在水产品中超标率大小依次为As(7.0%),Pb(7.0%),Cd(5.3%),Cr(1.8%)。Pi结果表明,目前珠江三角洲养殖水域水产品中Cu与Zn残留处于正常范围内,Cr和Hg有少量样品为轻度污染,Pb、Cd与As存在重度污染样品,所占比例为2.86%、6.02%和5.74%。MPI结果显示不同水产品污染程度为乌鳢>鳜鱼>罗非鱼>草鱼,总体上各种水产品MPI依然处于较低的水平;食用安全性结果显示,目前成人每周摄入水产品是安全的,但乌鳢Cr,罗非鱼As含量较高分别达到PTWI的37.76%和19.51%,表明水产品中Cr、As残留可能存在一定的食用安全隐患。健康风险模型结果显示,所有样品均未超过国际辐射防护委员会(ICRP)的推荐的最大可接受水平(5×10-6a-1)。综合分析珠江三角洲淡水养殖主要水产品可知,其尚未出现明显的污染安全问题,但As与Cr等元素的潜在风险值得进一步关注。     

菲和镉单一及复合污染条件下在毛蚶体内的富集动力学研究

采用室内半静态双箱动力学模型实验,研究了菲和镉单一及复合污染条件下在毛蚶(Anadara subcrenata)体内的生物富集,通过对富集与释放过程中毛蚶体内菲和Cd的富集量进行非线性曲线拟合,获得了菲和Cd单一及复合污染条件下在毛蚶体内的吸收速率常数k1、释放速率常数k2、生物富集因子BCF、生物半衰期B1/2和平衡状态下最大富集量CA max等动力学参数。实验结果表明,菲和Cd在实验前期富集速率较高,8 d以后富集速率减缓,释放阶段与富集阶段相似。毛蚶对菲的BCF值为37.80,远大于Cd的BCF值13.12,且生物半衰期时间更长,菲更容易在生物体内富集。菲和Cd联合暴露条件下,在毛蚶体内的CA max和BCF值均大于单一作用,说明二者同时暴露时,毛蚶对菲和镉的吸收富集均有所增强。实验模型拟合度较好,输出值和实测值之间无显著性差异,拟合方程和拟合参数可信。     

Public participation in municipal solid waste source-separated collection in Guilin,China: status and influencing factors

Currently, China is facing critical problems regarding the management of municipal solid waste (MSW). The failure of existing pilot programs in implementing MSW source-separated collection highlights the need to analyze the factors significantly influencing public participation in this activity. To this end, a comprehensive analysis of MSW source-separated collection in Guilin, which is representative of wider areas located in inland China and with a GDP around the national average, was conducted. The research consisted of in-person interviews involving a questionnaire and theoretical analyses in terms of public perception, public awareness, public attitude, and willingness to pay. The analytical results identify the status of waste source-separated collection and influencing factors in implementation, and provides exercisable suggestions for decision makers in both China and more generally in industrializing countries to design promotion programs and education campaigns.     

Improvement of sludge dewaterability with modified cinder via affecting EPS

The relationship between the improvement of sludge dewaterability and variation of organic matters has been studied in the process of sludge pre-conditioning with modified cinder, especially for extracellular polymeric substances (EPS) in the sludge. During the conditioning process, the decreases of total organic carbon (TOC) and soluble chemical oxygen demand (SCOD) were obviously in the supernatant especially for the acid modified cinder (ACMC), which could be attributed to the processes of adsorption and sweeping. The reduction of polysaccharide and protein in supernatant indicated that ACMC might adsorb EPS so that the tightly bound EPS (TB-EPS) decreased in sludge. In the case of ACMC addition with 24 g·L^–1, SRF of the sludge decreased from 7.85 × 10¹² m·kg^–1 to 2.06 × 10¹² m·kg^–1, and the filter cake moisture decreased from 85% to 60%. The reconstruction of “floc mass” was confirmed as the main sludge conditioning mechanism. ACMC promoted the dewatering performance through the charge neutralization and adsorption bridging with the negative EPS, and provided firm and dense structure for sludge floc as skeleton builder. The passages for water quick transmitting were built to avoid collapsing during the high-pressure process.

Open image in new window

     

Application of treated wastewater and digested sewage sludge to obtain biodiesel from Helianthus annuus L. seeds oil

Waste from wastewater treatment plants (WWTP) for Helianthus annuus L. production may be a viable solution to obtain biodiesel. This study achieved two objectives: assess the agronomical viability of waste (wastewater and sludge) from the Alcázar de San Juan WWTP in central Spain for H. annuus L. production; use H. annuus L. seeds grown in this way to obtain biodiesel. Five study plots, each measuring 6 m × 6 m (36 m²), were set up on the agricultural land near the Alcázar de San Juan WWTP. Five fertilizer treatment types were considered: drinking water, as the control; treated wastewater; 10 t ha^?1 of air-dried sewage sludge; 20 t ha^?1 of air-dried sewage sludge; 0.6 t ha^?1 of commercial inorganic fertilizer. Soil, irrigation water, sewage sludge, crop development and fatty acid composition in achenes oil were monitored. The 20 t ha^–1 dose of sewage sludge proved effective to grow H. annuus L. with similar results to those grown with a commercial fertilizer. However, precautions should be taken when irrigating with wastewater because of high salinity and nutrient deficiency. Sunflower oil was composed mostly of linoleic and oleic acid. The remaining fatty acids were linolenic, estearic, nervonic, palmitoleic, and palmitic.     

CdIn2S4/复合材料的制备及光降解罗丹明B

利用高压静电纺丝技术,制得含有羧基的导电聚合物纤维(聚偏氟乙烯/苯乙烯-马来酸酐共聚物/纳米石墨),高温水热条件下在纤维表面制备CdIn2S4颗粒,得到CdIn2S4/导电聚合物纤维复合材料。运用扫描电子显微镜(SEM)、X射线衍射仪(XRD)、紫外-可见吸收光谱仪(UV-Vis)和热失重分析仪(TGA)对复合材料的结构进行表征。并利用350 W氙灯模拟太阳光进行光催化降解罗丹明B。结果发现,CdIn2S4/导电聚合物纤维复合材料的降解效率高于CdIn2S4粉体和Degussa P25 TiO2粉体,光催化降解3 h,罗丹明B的降解率为96.2%。