几种阴阳离子对磷钨酸光催化降解甲基橙的影响

以磷钨酸为光催化剂,在紫外灯照射下,对甲基橙溶液进行光催化降解,考察了几种阴阳离子对磷钨酸光催化降解甲基橙溶液的影响。结果表明：Mg^2＋、Ca^2＋、NO3^-、SO4^2-和CO3^2-均对催化活性有促进作用,其中Mg^2＋和Ca^2＋仅有微弱的促进作用;NO3^-和SO4^2-随着浓度的增加促进作用也有所增加;CO3^2-则随着浓度的增加促进作用呈下降趋势;Mn^2＋、Al^3＋和Cl^-对光解反应存在较强的抑制作用,且Al^3＋和Cl^-随着其浓度的增加,抑制作用增强。     

活性炭多维电极法处理活性染料模拟废水的机理研究

以活性嫩黄K-4G染料模拟废水为处理对象,探讨了多维电极系统处理活性染料废水时色度、COD降解的效果和机理。结果表明,活性炭多维电极法对染料废水的处理效果优于单纯电解法和单纯活性炭吸附法;氧化和还原作用对染料的色度和COD去除效果相差不大;增大处理系统中溶液的循环流量可显著改善活性炭多维电极系统对COD和色度的去除效果。     

试用平炉尘制备中温变换催化剂

利用钢铁厂平炉尘制备中温变换催化剂,制备成本低,工艺简单,活性达到部颁标准,具有明显的经济效益.     

废水中有机物生物降解性数据库系统的研究

在全面分析废有机物生物降解性数据库系统的需求状态及特点的基础上,采用软件工程的方法,面向用户完成了该数据系统的系统分析和系统设计,为系统的进一步全面实施奠定了基础。     

SW型脱硫剂脱硫性能的研究

以硫酸烧渣为主要原料制备ＳＷ型脱硫剂,并对其脱硫性能进行了研究,对半水煤气、葡萄酒厂污水处理产生的沼气和焦炉煤气、水煤气中的Ｈ２Ｓ进行了工业脱硫试验,经半年以上运行证明,可使其Ｈ２Ｓ含量从３０００－５０００ｍｇ／ｍ＾３降为２０ｍｇ／ｍ＾３以下（符合国家标准）,当脱硫剂工作硫容达３０％时可返回硫酸生产中,再生周期一般为３个月,其主要性能达到国内外同类产品水平。     

Stability of 6:2 fluorotelomer sulfonate in advanced oxidation processes: degradation kinetics and pathway

Perfluorooctane sulfonate (PFOS), a widely used mist suppressant in hard chrome electroplating industry, has been listed in the Stockholm Convention for global ban. 6:2 Fluorotelomer sulfonate (6:2 FTS) acid and salts have been adopted as alternative products in the market, but no data about their abiotic degradation has been reported. In the present study, the degradability of 6:2 FTS potassium salt (6:2 FTS-K) was evaluated under various advanced oxidation processes, including ultraviolet (UV) irradiation, UV with hydrogen peroxide (H₂O₂), alkaline ozonation (O₃, pH = 11), peroxone (O₃/H₂O₂), and Fenton reagent oxidation (Fe²⁺/H₂O₂). UV/H₂O₂ was found to be the most effective approach, where the degradation of 6:2 FTS-K followed the pseudo-first-order kinetics. The intermediates were mainly shorter chain perfluoroalkyl carboxylic acid (C₇ to C₂), while sulfate (SO₄ ^2?) and fluoride (F^?) were found to be the final products. The high yields of SO₄ ^2? and F^? indicate that 6:2 FTS-K can be nearly completely desulfonated and defluorinated under UV/H₂O₂ condition. The degradation should firstly begin with the substitution of hydrogen atom by hydroxyl radicals, followed by desulfonation, carboxylation, and sequential “flake off” of CF₂ unit. Compared with PFOS which is inert in most advanced oxidation processes, 6:2 FTS-K is more degradable as the alternative.     

UV-Fenton体系预处理四氢呋喃废水实验研究

采用UV-Fenton体系预处理四氢呋喃废水,实验结果表明,pH值、反应时间、Fe2+和H2O2投加量等因素对处理效果有较大的影响。实验确定的最佳反应条件为:原水pH=5,Fe2+投加量2.5 mmol/L,H2O2投加量12 mmol/L,反应时间90 min,连续曝气,在此条件下,COD去除率可达85%左右。经UV-Fenton体系处理后,废水的B/C值由0.16增至0.47,可生化性提高,可满足后续生化处理的要求。     

电絮凝处理油田生化出水

为了减轻对后续处理中超滤膜的污染,采用电絮凝法处理油田生化出水,降低油田生化出水中的有机物含量。研究了电流强度、曝气时间和pH值对水中总有机碳（TOC）和浊度除去效果的影响以及pH值随曝气时间的变化趋势,通过红外光谱对絮凝处理前后水中总溶解固体进行了分析,优化了电絮凝的工艺条件。研究表明,当水流速度控制在50 mL/s,电流强度为2 A,500 mL絮凝出水的曝气时间为30 min时,整套絮凝工艺对TOC的去除率为48%,浊度去除率为42.9%,COD去除率为44%。     

Chemical forms and ecological risk of arsenic in the sediment of the Daliao River System in China

The chemical forms and ecological risk of As were characterized in the sediment of the Daliao River System (DRS), which has been affected by long-term intensive industrial, urban, and agricultural activities. Twenty-seven samples of surface sediment were collected and analyzed for total As content and that of its chemical forms. The results indicated that the average total As content in the sediment was 9.83 mg kg^− 1 but that the levels ranged from 1.57 to 83.09 mg kg^− 1. At the sites near cities, mining sites, and the estuary of the DRS, it is likely that adverse effects on aquatic organisms occur, due to As levels in the sediment that are often higher than the threshold effect level and occasionally higher than the probable effect level. A selectively sequential extraction indicated that the majority of As in the sediment was bound to Fe oxides (62.1%), with moderate proportions of residual As (19.8%), specifically adsorbed As (17.9%), and a low proportion of non-specifically adsorbed As (1.1%). In addition, the content of Fe in the sediment was positively and significantly correlated with the contents of amorphous and crystalline Fe oxide-bound As, confirming the crucial role of Fe oxides in immobilizing high amounts of As in superficial environments. The average molar ratio of As to Fe was 1.18 × 10^− 4 in the surface sediment of the DRS, similar to that of natural Fe oxides, but much lower than that of synthesized Schwertmannite. Therefore, the release of As under reduced and low pH conditions can cause serious problems for water resources and for living organisms.     

Chemical compositions and sources of atmospheric PM10 in heating, non-heating and sand periods at a coal-based city in northeastern China

Mass concentrations and chemical components (18 elements, 9 ions, organic carbon [OC] and elemental carbon [EC]) in atmospheric PM(10) were measured at five sites in Fushun during heating, non-heating and sand periods in 2006-2007. PM(10) mass concentrations varied from 62.0 to 226.3 μg m(-3), with 21% of the total samples' mass concentrations exceeding the Chinese national secondary standard value of 150 μg m(-3), mainly concentrated in heating and sand periods. Crustal elements, trace elements, water-soluble ions, OC and EC represented 20-47%, 2-9%, 13-34%, 15-34% and 13-25% of the particulate matter mass concentrations, respectively. OC and crustal elements exhibited the highest mass percentages, at 27-34% and 30-47% during heating and sand period. Local agricultural residuals burning may contribute to EC and ion concentrations, as shown by ion temporal variation and OC and EC correlation analysis. Heavy metals (Cr, Ni, Zn, Cu and Mn) from coal combustion and industrial processes should be paid attention to in heating and sand periods. The anion/cation ratios exhibited their highest values for the background site with the influence of stationary sources on its upper wind direction during the sand period. Secondary organic carbon were 1.6-21.7, 1.5-23.0, 0.4-17.0, 0.2-33.0 and 0.2-21.1 μg m(-3), accounting for 20-77%, 44-88%, 4-77%, 8-69% and 4-73% of OC for the five sampling sites ZQ, DZ, XH, WH and SK, respectively. From the temporal and spatial variation analysis of major species, coal combustion, agricultural residual burning and industrial emission including dust re-suspended from raw material storage piles were important sources for atmospheric PM(10) in Fushun at heating, non-heating and sand periods, respectively. It was confirmed by principal component analysis that coal combustion, vehicle emission, industrial activities, soil dust, cement and construction dust and biomass burning were the main sources for PM(10) in this coal-based city.