高效氨氧化菌群富集、驯化及其动态变化规律分析

利用选择性培养基对氨氧化菌群进行了连续驯化,得到了氨氮去除效率稳定的氨氧化菌群。采用平板菌落计数法结合聚合酶链式反应-变性梯度凝胶电泳(PCR-DGGE)技术考察了氨氧化菌群在连续传代过程中数量及群落结构的动态变化,并考察了pH值、碳源(HCO3-)浓度和氨氮浓度等因素对氨氧化菌群去除氨氮效率的影响。结果表明,通过连续驯化,氨氧化菌的比例由最初的1.8%提高到了31.3%。在碳源浓度为1.5 mg/L,NH4+-N初始浓度为200 mg/L,pH值为8的条件下,菌群对氨氮的去除率达99%以上。     

填埋场中亚硝酸还原酶测定条件的优化

填埋垃圾中的含氮化合物经一系列生物脱氮作用,最终使得填埋场中的氮素得以消减,在这一过程中亚硝酸还原酶起着十分重要的作用。以填埋场中的填埋垃圾为研究对象,在土壤亚硝酸还原酶测定方法的基础上,对亚硝酸还原酶活性测定条件进行了优化。结果表明,填埋垃圾中的亚硝酸还原酶活性测定的最优条件为:垃圾样品风干温度25℃,2mL的1%NaNO2溶液和2.5 mL的1%葡萄糖溶液,抽气5 min,置于25℃的培养箱中培养24 h。优化后的测定条件相对标准偏差(RSD)小于1.27%,表明该方法具有较高的灵敏度和精密度。     

Determination of antibiotics in sewage from hospitals, nursery and slaughter house, wastewater treatment plant and source water in Chongqing region of Three Gorge Reservoir in China

Sewage samples from 4 hospitals, 1 nursery, 1 slaughter house, 1 wastewater treatment plant and 5 source water samples of Chongqing region of Three Gorge Reservoir were analyzed for macrolide, lincosamide, trimethoprim, fluorouinolone, sulfonamide and tetracycline antibiotics by online solid-phase extraction and liquid chromatography-tandem mass spectrometry. Results showed that the concentration of ofloxacin (OFX) in hospital was the highest among all water environments ranged from 1.660 μg/L to 4.240 μg/L and norfloxacin (NOR, 0.136-1.620 μg/L), ciproflaxacin (CIP, ranged from 0.011 μg/L to 0.136 μg/L), trimethoprim (TMP, 0.061-0.174 μg/L) were commonly detected. Removal range of antibiotics in the wastewater treatment plant was 18-100% and the removal ratio of tylosin, oxytetracycline and tetracycline were 100%. Relatively higher removal efficiencies were observed for tylosin (TYL), oxytetracycline (OXY) and tetracycline (TET)(100%), while lower removal efficiencies were observed for Trimethoprim (TMP, 1%), Epi-iso-chlorotetracycline (EICIC, 18%) and Erythromycin-H₂O (ERY-H₂O, 24%). Antibiotics were removed more efficiently in primary treatment compared with those in secondary treatment.     

可用于水体污染控制的氨氮转化菌筛选及部分降解特性的实验研究

从南京禄口水产养殖基地淡水鱼塘取淤泥作为分离菌株的土源,采用选择性富集培养法,从中分离到能以硫酸铵为氮源的菌株7株,对7个菌株进行氨氮降解实验,它们氨氮转化率分别为14.8%、19.7%、53.4%、94.2%、29.1%、63.5%和41.7%,其中AN-4菌株的转化率最高且生长良好。通过AN-4菌株16S rRNA基因序列分析以及生理生化方法,鉴定此菌株为克雷伯氏菌属(Klebsiellasp.)。对菌株AN-4转化氨氮的特性及温度、pH值、氨氮初始浓度和菌株接种量对其氨氮转化率的影响研究,结果表明,菌株AN-4降解氨氮的最适条件为:温度为30℃和pH值为8.0;当氨氮初始浓度为30mg/L时,AN-4菌株在24 h内的氨氮降解率可达85%以上,且能耐受高达200 mg/L的氨氮浓度;AN-4活化菌液浓度为108cfu/mL,当接种量为3×106cfu/mL时,AN-4菌株在24 h内的氨氮降解率为87.75%。综合上述结果,符合淡水养殖水环境条件,说明AN-4菌株适合在水产养殖中应用,为将菌株AN-4应用于水产养殖环境修复提供了理论依据。     

污水深度处理流程对污染物去除效果评价方法

城市污水再生处理流程大多采用几种深度处理单元组合而成,由单个处理单元对污染物的去除效果来准确评价组合流程整体的处理效率对于工艺方案的确定和实际运行具有重要意义。在对处理过程中污染物浓度分布变化分析的基础上,建立了污水深度处理流程污染物去除效果的评价分析方法,并根据3种常用再生处理单元的实验结果,以总大肠菌群为例,评价了混凝沉淀过滤与生物活性炭和超滤联用处理流程对总大肠菌群的去除效果,计算结果表明,这种评价分析方法是准确可行的。     

Copper ultrastructural localization, subcellular distribution, and phytotoxicity in Hydrilla verticillata (L.f.) Royle

Laboratory experiments were conducted to investigate copper (Cu) subcellular distribution and toxicity in Hydrilla verticillata. Fronds were subjected to different concentrations (15, 75, and 150 μM) of Cu for 7 days. Cu grains were found in cell walls, plasmodesmata, and within the nuclei and chloroplasts using the autometallographic technique. Subcellular fractionation of Cu-containing tissues indicated that in leaves subjected to high Cu concentrations, 59–65 % of the element was located in the cell wall fraction, followed by cell organelles (21–30 %) and the soluble fraction (10–14 %). The levels of K, P, Zn, and Mg declined under all Cu concentrations, but Ca, Mn, and Fe contents reached their peak at 15 μM Cu and decreased thereafter. F _v/F _m, F ₀, and F _m fell significantly in line with the decrease in pigment content. Cu exposure also caused significant damage to the chloroplasts, mitochondria, and nuclei, including disintegration of the chloroplasts and vacuolization of the mitochondria and nuclei, all of which suggested that Cu hastened plant senescence. The Cu maximum permissible concentration for H. verticillata was 10 μM, which was less than the existing general water quality standard. This suggested that H. verticillata could be used to assess Cu phytotoxicity.     

磁性埃洛石对水溶液中盐酸土霉素的吸附

采用一种简便的方法对埃洛石纳米管进行加磁,得到的磁性埃洛石纳米管（MHNTs）利用x射线衍射仪（XRD）、透射电子显微镜（TEM）、振动样品磁强计（VSM）和原子吸收光谱仪（AAS）进行表征,结果表明,MHNTs具有很强的磁性性能（Ms=34．02emu／g）以及较低损失磁性粒子的性能。制备的MHNTs作为吸附剂吸附水溶液中的盐酸土霉素,并且探索反应温度、溶液pH和起始浓度等对MHNTs吸附盐酸土霉素性能的影响。研究表明,Langmuir等温线模型更优于Freundlich等温线模型,其动力学的研究结果利用拟二阶方程能够很好地进行说明。此外,MHNTs作为吸附剂经过3次的重复使用吸附能力没有明显的降低。     

不同类型生物活性滤床对诺氟沙星的去除

诺氟沙星作为一种抗生素广泛应用于人类日常生活,并大量进入水体环境,给水环境质量和生态系统安全带来隐患。研究了由3种不同填料组成的水平流和复合垂直流生物活性滤床对诺氟沙星的去除效果,结果表明,在水力负荷为0．1m^3／（m^2·d）、进水诺氟沙星浓度为392．11—686．17μg／L（平均浓度为500．97μg／L）条件下,复合垂直流滤床对诺氟沙星去除效果普遍好于水平潜流滤床,以沸石为填料的复合垂直流生物活性滤床对诺氟沙星的去除效果最好,平均去除率为80．61％,说明选择合适填料和合适类型的生物活性滤床可以作为去除诺氟沙星的一种有效方法。     

厌氧-局部循环供氧生物膜技术处理农村污水

通过模拟农村生活污水水质和间歇进水特点,利用“厌氧-局部循环供氧生物膜”技术,研究该工艺对有机物、氮、磷的去除效果.厌氧池和局部循环供氧池有效容积比为1∶1.6,曝气装置位于局部循环供氧池中间底部,环形导流板将局部循环供氧池分隔成中间好氧区和四周缺氧区,斜管沉淀池前置到厌氧池与局部循环供氧池之间,出水端设置循环水池.装置连续稳定运行12个月,平均进水量为140 L/d,生物反应区HRT为1.3d.监测结果表明,出水COD、BOD、NH3-N、TN和TP平均浓度分别在40.31、3.38、2.69、11.98和0.75 mg/L,达到了国家城镇污水处理厂污染物排放指标(GB-18918-2002)中的一级排放标准.研究表明,厌氧-局部循环供氧技术是一种适合农村分散污水处理的新工艺,可有效减轻农业面源污染.     

Recycling of organic materials and solder from waste printed circuit boards by vacuum pyrolysis-centrifugation coupling technology

Here, we focused on the recycling of waste printed circuit boards (WPCBs) using vacuum pyrolysis-centrifugation coupling technology (VPCT) aiming to obtain valuable feedstock and resolve environmental pollution. The two types of WPCBs were pyrolysed at 600°C for 30 min under vacuum condition. During the pyrolysis process, the solder of WPCBs was separated and recovered when the temperature range was 400-600°C, and the rotating drum was rotated at 1000 rpm for 10 min. The type-A of WPCBs pyrolysed to form an average of 67.91 wt.% residue, 27.84 wt.% oil, and 4.25 wt.% gas; and pyrolysis of the type-B of WPCBs led to an average mass balance of 72.22 wt.% residue, 21.57 wt.% oil, and 6.21 wt.% gas. The GC-MS and FT-IR analyses showed that the two pyrolysis oils consisted mainly of phenols and substituted phenols. The pyrolysis oil can be used for fuel or chemical feedstock for further processing. The recovered solder can be recycled directly and it can also be a good resource of lead and tin for refining. The pyrolysis residues contained various metals, glass fibers and other inorganic materials, which could be recovered after further treatment. The pyrolysis gases consisted mainly of CO, CO(2), CH(4), and H(2), which could be collected and recycled.