城市生活垃圾渗透系数测试研究

采用常水头测渗实验，对不同压实密度和水力梯度下的新鲜垃圾与陈垃圾的渗透系数进行测试，根据达西定律求得渗透系数值。由于垃圾的不均匀性、小颗粒的运动和大孔隙沟道流的形成和改变，实验初始阶段渗透系数值先增大至峰值，然后缓慢降低直至趋于稳定。实验稳定后，新鲜垃圾压实密度为0．75—0．95t／m^3时，渗透系数值约为1．26E-03～1．43E-03cm／s。陈垃圾在压实密度分别为1．2和1．4t／m^3时，渗透系数为8．29E-04和1．35E-04cm／s。     

Optimum conditions for Al13 polymer formation in PACl preparation by electrolysis process

This paper introduces a new and effective method for preparation of PACl-electrolysis process. A series of PACl with high content of Al13 polymer was successfully prepared by electrolysis process. The amount of Al13 polymer formed in electrolysis process was found to be highly influenced by current density (di), the distance between the electrodes, electrolysis time and the stirring rate of the electrolyte. For the AlT (total aluminum concentration) of 2.0 M PACl obtained by electrolysis process, the optimal di and distance between the electrodes were 1.1 Adm(-2) and 10 mm respectively. The optimum circulating rate was 5.5 l h(-1). Because of the inhomogeneous pH between the surface of cathode and the bulk solution, the electrolysis process has the advantage to form more Al(OH)4- as precursor of Al13 polymer. At the optimum condition, Al13 polymer accounted for above 70% of AlT (PACl of AlT=2.0 M and B=2.0), which was much higher than that of PACl prepared by other method.     

Removal of alachlor from water by catalyzed ozonation in the presence of Fe2+, Mn2+, and humic substances

The effects of Fe(II), Mn(III) and humic substances on the catalyzed ozonation of alachlor, an endocrine disruptor were investigated. Results revealed that small amounts of Fe(II), Mn(II), and humic substances could enhance the ozonation of alachlor, but larger amounts of them would retard the oxidation. These results were successfully identified by an electron paramagnetic resonance (EPR) spectroscopy spin-trapping method that could quantify hydroxyl radicals. The production of hydroxyl radicals was obviously increased with the increasing of Fe(II) concentration, which contributed to enhance ozonation at low concentrations. But the excess Fe(II) consumed some of the radicals when it was added at a higher concentration (1.5 mg/L). However, no obvious radicals were observed when a different amount of Mn(II) was used, and the catalytic ozonation of alachlor by Mn(II) mainly followed the mechanism of "active sites created on the surface of MnO2." The radical pathway was followed when alachlor was ozonated with different concentrations of humic substances because of its radical initiating, promoting, and inhibiting effects.     

微囊藻毒素污染控制技术的研究进展

主要对水环境中微囊藻毒素污染的产生、毒性和去除方法进行了综述,在如何高效去除MCs方面具有重要意义.     

SiO_3~(2-)离子的加入对脉冲倒极电解合成PASiC的研究

探索了试验过程中SiO2 -3 离子团的加入对脉冲自动倒极电解法合成聚合氯化硅酸铝中Alb 含量的影响。通过试验确定了最佳摩尔比。在脉冲倒极周期和电解槽电流一定的情况下 ,当总铝AlT 与SiO2 -3 的摩尔比为 10∶1～ 2 0∶1时 ;在此合成条件下制备液中Alb 含量超过 80 % ;处理模拟水样最佳投药量为 :0 5～ 5mgAl2 O3 /L。在制备过程中 ,极化现象得到了极好的控制 ,电解槽电压和电流十分稳定     

Comparison of the effects of aluminum and iron(Ⅲ) salts on ultrafiltration membrane biofouling in drinking water treatment

Coagulation plays an important role in alleviating membrane fouling, and a noticeable problem is the development of microorganisms after long-time operation, which gradually secrete extracellular polymeric substances(EPS). To date, few studies have paid attention to the behavior of microorganisms in drinking water treatment with ultrafiltration(UF)membranes. Herein, the membrane biofouling was investigated with different aluminum and iron salts. We found that Al_2(SO_4)_3·18 H_2O performed better in reducing membrane fouling due to the slower growth rate of microorganisms. In comparison to Al_2(SO_4)_3·18H_2O,more EPS were induced with Fe_2(SO_4)_3·x18H_2O, both in the membrane tank and the sludge on the cake layer. We also found that bacteria were the major microorganisms, of which the concentration was much higher than those of fungi and archaea. Further analyses showed that Proteobacteria was dominant in bacterial communities, which caused severe membrane fouling by forming a biofilm, especially for Fe_2(SO_4)_3·x18H_2O. Additionally, the abundances of Bacteroidetes and Verrucomicrobia were relatively higher in the presence of Al_2(SO_4)_3·18 H_2O,resulting in less severe biofouling by effectively degrading the protein and polysaccharide in EPS. As a result, in terms of microorganism behaviors, Al-based salts should be given preference as coagulants during actual operations.     

浅析化学事故应急响应专线的发展

纵观国外同类化学事故应急咨询机构30多年的发展经验,结合化学事故应急响应专线的现状,提出了扩大化学事故应急响应专线的服务范围、加强化学事故技术支持体系的建设及加强与国内外同类机构的交流与合作等发展建议。     

无动力（微动力）除尘技术

无动力或微动力除尘工艺,打破传统的除尘原理,对运输转运系统进行高效除尘,成功地运用于昆钢龙山冶金熔剂矿白云石破碎系统、云锡大屯选厂、昆钢烧结厂等,投资少、除尘效果好、运行费用低。比传统的布袋除尘工艺节省投资约20％,大幅度地节约运行费用。     

危险化学品安全评价现状及对策

阐述了危险化学品安全评价的重要性,介绍了我国危险化学品生产企业的安全现状。详细分析了影响危险化学品生产企业安全评价有效性的各种因素,针对中国当前危险化学品安全评价中存在的主要问题,提出了改进对策措施。     

大连市夏季人体舒适度评价研究

以大连市1984年－2013年逐年7、8月的日平均温度、相对湿度及平均风速等气象数据为基础,基于模糊综合评价法,对大连市夏季人体舒适度现状进行分析与评价,得到结论如下：用模糊综合评判大连市气候舒适度最适合的评判标准为气温22℃、相对湿度70％和风速2 m／s;大连市总体气候舒适状况良好,夏季相对最舒适的时间段为第6旬（8月20日～8月31日）,最不舒适的时间段为第4旬（8月1日～8月10日）;由于大连市夏季经常伴有雷阵雨甚至暴雨天气以及湿度大等原因,使得炎热气温所造成的不舒适的天气状况常能得到改善,因此大连市夏季舒适程度所占比例较大。