调节细胞通透性促进天蓝色链霉菌蓝色素生物合成

在天蓝色链霉菌分批发酵中，36h时一次加入20mg/L的青霉素，色素浓度和分泌率分别提高了26．2％和39．2％；与一次性添加青霉素相比，分多次添加可使色素浓度再提高9％，但分泌率没有明显变化。DMSO浓度为6g/L时，色素浓工和分泌率较对照分别提高了20．5％和50％；2－50g/L的DMSO对菌体生长没有影响。36h时lg/L的吐温80，色素浓度和分泌率分别提高了16．9％和37．5％，60h时加入0.2g/L浓度的SDS，色素浓度较对照基本相当，但分泌率却提高了16．1％。图4表1参7     

Phytoplankton photosynthetic adaptation to high frequency light fluctuations simulating those induced by sea surface waves

In order to test the ability of phytoplankton to adapt to the high frequency light fluctuations induced by sea surface waves, the green alga Dunaliella tertiolecta was grown under both steady and fluctuating (0.1, 1.0 and 10 Hz) illuminations. The latter conditions reproduced those fluctuations experienced by phytoplankton in the upper photic layer. For each culture, photosynthesis versus irradiance were measured under four incubation frequencies (steady, 0.1, 1.0 and 10 Hz fluctuating illuminations). Results indicated that growth rates were similar for algae grown under steady light and 10 Hz fluctuating light (0.26–0.33 d^–1). Cells grown at 0.1 and 1.0 Hz showed lower growth rates (0.17–0.26 d^–1). Chlorophyll a and b were significantly higher under 0.1 and 10 Hz frequencies than under steady illumination; at 1.0 Hz, there were no significant differences with steady light. No changes in carotenoids were evidenced at any frequency tested. Photosynthetic measurements showed that algae grown under steady illumination had higher photosynthetic efficiency and capacity when incubated under steady and 0.1 Hz fluctuating light. Photosynthetic characteristics of algae grown under 0.1 Hz illumination did not show any clear responses to fluctuating light. Algae grown under 1.0 or 10 Hz had higher photosynthetic efficiency and capacity than those grown under steady illumination, when incubated under 1.0 and 10 Hz light. This suggests that microalgae grown under high frequency illumination (1.0 and 10 Hz) can adapt their photosynthetic characteristics to the rapidly fluctuating light regime experienced during growth, and that algae grown under steady conditions respond better to steady or slowly fluctuating (0.1 Hz) light. Such an adaptation provides a means of probing the photosynthetic responses of phytoplankton to vertical mixing.Contribution to the program of GIROQ (Groupe interuniversitaire de recherches océanographiques du Québec)     

海洋酸化与重金属、有机污染物和人工纳米颗粒的联合毒性效应研究进展

由于大量人类活动的影响,大气CO_2浓度持续增加,其中约1/3被海洋吸收,导致表层海水pH值降低和碳酸盐平衡体系波动,即"海洋酸化"现象。污染物的海洋环境效应一直是全球环境科学领域研究的热点。在实际环境中,海洋酸化往往与污染物共同存在并作用于海洋生态系统,且海洋酸化极有可能改变污染物的海洋环境行为从而影响其毒性效应。但现有研究大多针对海洋酸化或者污染物单独作用下的毒性效应展开,对海洋酸化与污染物的联合毒性效应的研究不足、亟待加强。为此,综述了近年来海洋酸化与典型污染物(重金属、有机污染物)及新型污染物(人工纳米颗粒)的相关文献,重点阐述了海洋酸化对污染物环境行为的影响和海洋酸化与污染物对海洋生物的联合毒性效应,指出当前的研究不足,并对未来的研究方向进行了展望。     

炉渣用于深层过滤的试验研究

将炉渣用作深层过滤的床层过滤,在油田水处理中具有良好的应用前景。通过对炉渣滤料的物性测定,对流体力学性能、过滤性能及反洗性能的研究,获得了有关炉渣滤料的粒径分布、床层孔隙率、密度、吸水率等物性参数,以及清洁滤料床层阻力与速度的关系曲线和流化曲线,过滤条件下床层阻力随时间的变化关系和悬浮物脱除率随时间的变化曲线,炉渣床层的反洗曲线。结果表明：炉渣表面粗糙,有棱角,吸附表面积大,孔隙率大,过滤效果好;炉渣滤料密度小,反洗效果较好,反洗用水量只是过滤水量的５％左右;同时,炉渣作为滤料用于深层过滤,不仅来源广泛,而且属废物利用。     

臭氧氧化降解苊的中间产物分析

苊属于EPA优先污染物名单上的物质,其在染料、化工等行业有着广泛的应用.它具有水溶性低、易蓄积、难生物降解的特点.臭氧氧化法可以对其有效的降解,但是过量的臭氧也难以实现对苊的矿化,在苊浓度下降的同时将生成中间产物.中间产物包括多种含一个苯环的酯和直链的酸、醇、酯等.     

城市生活垃圾渗透系数测试研究

采用常水头测渗实验，对不同压实密度和水力梯度下的新鲜垃圾与陈垃圾的渗透系数进行测试，根据达西定律求得渗透系数值。由于垃圾的不均匀性、小颗粒的运动和大孔隙沟道流的形成和改变，实验初始阶段渗透系数值先增大至峰值，然后缓慢降低直至趋于稳定。实验稳定后，新鲜垃圾压实密度为0．75—0．95t／m^3时，渗透系数值约为1．26E-03～1．43E-03cm／s。陈垃圾在压实密度分别为1．2和1．4t／m^3时，渗透系数为8．29E-04和1．35E-04cm／s。     

Optimum conditions for Al13 polymer formation in PACl preparation by electrolysis process

This paper introduces a new and effective method for preparation of PACl-electrolysis process. A series of PACl with high content of Al13 polymer was successfully prepared by electrolysis process. The amount of Al13 polymer formed in electrolysis process was found to be highly influenced by current density (di), the distance between the electrodes, electrolysis time and the stirring rate of the electrolyte. For the AlT (total aluminum concentration) of 2.0 M PACl obtained by electrolysis process, the optimal di and distance between the electrodes were 1.1 Adm(-2) and 10 mm respectively. The optimum circulating rate was 5.5 l h(-1). Because of the inhomogeneous pH between the surface of cathode and the bulk solution, the electrolysis process has the advantage to form more Al(OH)4- as precursor of Al13 polymer. At the optimum condition, Al13 polymer accounted for above 70% of AlT (PACl of AlT=2.0 M and B=2.0), which was much higher than that of PACl prepared by other method.     

Removal of alachlor from water by catalyzed ozonation in the presence of Fe2+, Mn2+, and humic substances

The effects of Fe(II), Mn(III) and humic substances on the catalyzed ozonation of alachlor, an endocrine disruptor were investigated. Results revealed that small amounts of Fe(II), Mn(II), and humic substances could enhance the ozonation of alachlor, but larger amounts of them would retard the oxidation. These results were successfully identified by an electron paramagnetic resonance (EPR) spectroscopy spin-trapping method that could quantify hydroxyl radicals. The production of hydroxyl radicals was obviously increased with the increasing of Fe(II) concentration, which contributed to enhance ozonation at low concentrations. But the excess Fe(II) consumed some of the radicals when it was added at a higher concentration (1.5 mg/L). However, no obvious radicals were observed when a different amount of Mn(II) was used, and the catalytic ozonation of alachlor by Mn(II) mainly followed the mechanism of "active sites created on the surface of MnO2." The radical pathway was followed when alachlor was ozonated with different concentrations of humic substances because of its radical initiating, promoting, and inhibiting effects.     

混凝法处理废乳化液的研究

采用聚合硫酸铁（PFS）和聚合氯化铝（PAC）处理废乳化液，适宜的pH范围为pH≤8，在废乳化液CODcr为7000－35000mg/L时，PFS较佳投加量为0.46-0.56g/L,PAC较佳投加量为1.5-3.5g/L,CODcr去除率均可达94％以上。出水经分析表明，PFS和PAC混凝对废乳化液中的脂类和羧酸盐均有较好的效果，并且B／C由0.12分别提高到0.58和0.55，大大改善废乳化液的可生化性。     

添加剂升温烧蚀法在制备新型介孔水环境净化材料中的应用

首次探索了一种破坏式造孔与有机复合相结合的新方法以制备介孔复合水环境净化材料,使最终产品成为一种具有广谱孔结构分布的复合环境材料。详细介绍了该方法的第二步工艺即添加剂升温烧蚀法,在优化后的最佳条件下,产品的孔径得到了进一步扩大,其中部分孔道直径可达至介孔级,同时材料的表面得到了进一步活化。经此步工艺后,所制备的中间产品染料吸附量是原材料的194倍,是酸洗刻蚀后产品的122倍;24h吸湿率是原材料的38倍,是酸洗刻蚀后产品的19倍。