Behavioral aspects of sperm competition in cuttlefish, Sepia officinalis (Sepioidea: Cephalopoda)

Sexual selection studies in cephalopods indicate that sperm competition is a central feature of their mating systems, yet this has not been studied experimentally in any detail. In 1998 we staged 20 matings of the cuttlefish, Sepia officinalis L., in the laboratory. Males rapidly initiated mating in the “head-to-head” position, with no apparent courtship. Mating lasted an average of 10 min (range 7 to 14 min). For the first 6 min (on average 63% of the mating duration), the male flushed strong jets of water directly at the female's buccal membrane, which sometimes resulted in the expulsion of parts of spermatangia placed there in recent matings. Then, in a single discrete movement that lasted an average of only 14 s, the male's modified fourth left arm – the hectocotylus – wrapped around a single large bundle of spermatophores (ca. 150 to 300) and transferred them to the female's buccal membrane. For the remainder of the mating (average 3 min, range 1.5 to 5.0 min), the hectocotylus repeatedly broke the spermatophores open, and manipulated them, so that sperm were released and many spermatangia were attached along the ventral buccal membrane, near the paired seminal receptacles. Approximately 140 spermatangia were attached in rows 3 to 5 deep around the ventral buccal membrane in a single mating; the rest were usually discarded during mating. Histology revealed that each of the seminal receptacles consists of a series of sperm storage bulbs connected by a central duct, which leads to a single pore at the surface of the buccal membrane. Baseline data on sperm motility were obtained, but the mechanism by which sperm enter the seminal receptacle remains unknown. Females seemed to initiate termination of mating, then males guarded their mates temporarily. These results, combined with other recent laboratory experiments, provide evidence that sperm competition may be a major feature of the mating system of S. officinalis. Received: 4 January 1999 / Accepted: 18 May 1999     

Ammonia emission from grassland and livestock production systems in the UK

Emissions of ammonia were measured from livestock excreta and fertilisers applied to grass swards, from grazed paddocks, from decomposing grass herbage and from an animal house containing dairy cows. Emissions from urine, dung, slurry and fertilisers were determined using a system of wind tunnels with each tunnel covering an area of 1 m(2). Emissions from grazed swards were determined using a micrometeorological mass balance method. From the results of these measurements, together with other published information, an inventory for ammonia emissions has been calculated for grassland and livestock production systems over the UK as a whole. It is estimated that emissions from grassland and cattle and sheep production amount to about 230 kt NH(3)-N annually, while emissions from pig and poultry production amount to about 40 kt and 80 kt NH(3)-N, respectively.     

Distribution of fission products in dust samples from the region of Thessaloniki, Greece, after the Chernobyl nuclear accident

The distribution of the fission products (95)Zr, (95)Nb, (103)Ru, (106)Ru (determined through (106)Rh), (125)Sb, (129m)Te, (134)Cs, (137)Cs, (140)Ba, (140)La, (141)Ce and (144)Ce has been determined in dust samples from the region of Thessaloniki, Greece, after the nuclear accident at Chernobyl. The samples studied also included (110m)Ag, not belonging to the products of (235)U fission. Samples showing higher concentrations of radionuclides also show a higher content in clay minerals, whereas samples having low concentrations of radionuclides usually contain large amounts of quartz and feldspars. Desorption and leaching experiments using solutions of chlorides of sodium, potassium, calcium and magnesium (0.5 N), as well as distilled and tap water, were also performed. Sodium and potassium chloride solutions were found to be efficient in desorbing and/or leaching of caesium and ruthenium isotopes to an extent of about 30%.     

The fate of metal contaminated sediments in Foundry Cove, New York

The distribution of heavy metal contaminated sediments in Foundry Cove, a freshwater embayment of the Hudson River, was examined twelve years after the discharging of wastes from a battery factory had ceased. Concentrations of Cd, Ni and Co were measured in surficial sediments (top 5 cm) and seven detailed depth profiles. Comparison with earlier surveys showed that metal levels of surficial sediments have been considerably reduced throughout the cove. Evidence suggests that this reduction may be largely due to burial rather than transport of metals out of the cove or a redistribution (via sediment resuspension and redeposition) within the cove. This is suggested by the presence of a peak in metal concentrations at a depth of several centimetres in depositional environments, a calculation showing the loss of waterborne cadmium to be much less than the amount of cadmium lost from the surficial sediment, and the absence of increased pollution in the cleaner parts of the cove. Despite improvement, metal levels remain extremely high, including a persistent 'hot-spot' with levels higher than 10 000 ppm Cd.     

Effects of distillery waste on the performance of Cicer arietinum L

The impact of distillery effluent in various concentrations (1, 2.5, 5, 10, 25, 50, 75 and 100%) on the seed germination, Speed of Germination Index, growth behaviour, leaf area, biomass, net primary productivity, pigment content, reproductive capacity, seed output, seed weight, seed density and the seed protein content of Cicer arietinum L. plants was investigated. The percentage and speed of germination of seeds were increasingly retarded with increase in effluent concentration and at 100% concentration there was no germination. The seedlings exhibited maximum shoot length at 5% concentration and maximum root length at 2.5% concentration. The values of root and shoot lengths, leaf area, biomass, net primary productivity, pigment content, reproductive capacity, seed output, seed weight, seed density and seed protein content in pot plants exhibited a gradual increase from the control up to 5% concentration and decreases at higher concentrations. The very high BOD load and the presence of excessive concentrations of soluble salts could be responsible for the toxicity of the effluent. The effluent at up to 5% concentration was, however, beneficial for the overall growth parameters studied and can thus be used as a liquid fertilizer.     

Electrochemical oxidation of bisphenol A. Application to the removal of bisphenol A using a carbon fiber electrode

Leachate samples with a high strength of ammonium-nitrogen (NH4+-N) were collected from a local landfill site in Hong Kong. Two experiments were carried out to study (1) the inhibition of microbial activity of activated sludge by NH4+-N and (2) the chemical precipitation of NH4+-N from leachate as a preliminary treatment prior to the activated sludge process. The experimental results demonstrated that the efficiency of COD removal decreased from 97.7% to 78.1%, and the dehydrogenase activity of activated sludge decreased from 9.29 to 4.93 microg TF/mg MLSS, respectively, when the NH4+-N concentration increased from 53 to 800 mg/l. The experiment also demonstrated that the NH4+-N in the leachate can be quickly precipitated as MgNH4PO4 x 6H2O after addition of MgCl2 x 6H2O + Na2HPO4 x 12H2O. The NH4+-N concentration was reduced from 5618 to 112 mg/l within 15 min when a molar ratio of Mg2+:NH+:PO4(3-) = 1:1:1 was used. The optimum pH to reach the minimum solubility of MgNH4PO4 x 6H2O was found to be in the range of 8.5-9.0. Attention should be given to the high salinity formed in the treated leachate by using MgCl2 x 6H2O + Na2HPO4 x 12H2O, which may affect microbial activity in the following biological treatment processes. Using two other combinations of chemicals [MgO + 85%H3PO4 and Ca(H2PO4)2 x H2O + MgSO4 x 7H2O] could minimise salinity generation after precipitation, while they were less efficient for NH4+-N removal.     

The sensitivity of surface waters of Great Britain to acidification predicted from catchment characteristics

Using a combination of soil, land use and geological information, a map of Great Britain has been derived which indicates the sensitivity of surface waters to acidification. For the geological information, a slightly modified version of an available map was used which indicated the sensitivity of groundwaters to acidification. For soils, 1-km databases of soil information for England and Wales and for Scotland were employed to map the soil sensitivity as determined by buffering capacity. The derived soils map was modified to take account of agricultural liming in arable and managed grassland areas using the ITE Land Classification. The final map of surface water sensitivity was obtained by using a geographic information system overlay procedure which enabled each combination of soil and geology sensitivity to be uniquely defined. The final sensitivity classification was based upon expert knowledge and the experience of a similar sensitivity mapping exercise for Wales.     

Means to improve the effect of in situ bioremediation of contaminated soil: an overview of novel approaches

Different aspects of bacterial degradation of organic contaminants in soil, and how to improve the efficiency and reproducibility is discussed in this review. Although bioremediation in principle includes the use of any type of organism in improving the condition of a contaminated site, most commonly bacteria are the degraders and other organisms, such as soil animals or plant roots, play a role in dissemination of bacteria and, indirectly, plasmids between bacteria, and in providing nutrients and co-substrates for the bacteria active in the degradation process. There are a number of different procedures that have been tested more-or-less successfully in attempts to improve reliability, cost efficiency and speed of bioremediation. The methods range from minimal intervention, such as mere monitoring of intrinsic bioremediation, through in situ introduction of nutrients and/or bacterial inocula or improvement of physico-chemical conditions, all the way to excavation followed by on site or ex situ composting in its different varieties. In the past the rule has been that more intervention (leading to higher costs) has been more reliable, but novel ideas are continuously tried out, both as a means to come up with new truly functional applications and also as a line of studies in basic soil microbial ecology. Both approaches generate valuable information needed when predicting outcome of remediation activities, evaluating environmental risks, deciding on cleaning-up approaches, etc. The emphasis of this review is to discuss some of the novel methods for which the value has not been clearly shown, but that in our view merit continued studies and efforts to make them work, separately or in combination.     

Cadmium contamination in orchard soils and fruit trees and its potential health risk in Guangzhou, China

This study examines cadmium (Cd) contamination in orchard soils and fruit trees in Guangzhou, China, and assesses its potential health risk. Soils and tissues samples of three species of fruit trees were collected from three orchards. The average soil Cd concentration was 1.27, 1.84 and 0.68 mg/kg in orchards I, II, and III, respectively. The carambola (Averrhoa carambola) accumulated exceptionally high concentrations of Cd (7.57, 10.84, 9.01 and 2.15 mg/kg dw in root, twig, leaf and fruit, respectively), being 6.0-24 times and 4.0-10 times the corresponding tissue Cd in the longan (Dimocarpus longan) and wampee (Clausena lansium), respectively. Furthermore, all Cd concentrations (0.04-0.25 mg Cd/kg fw) of the fruits exceeded the tolerance limit of cadmium in foods of PR China (0.03 mg/kg fw). Our results indicate that the carambola tree has high Cd accumulation capacity and might be a Cd accumulator; and its fruit, among the three species of fruits studied, also poses the highest potential health risk to local residents.     

Heavy metal and Pb isotopic compositions of aquatic organisms in the Pearl River Estuary, South China

The accumulation of trace metals in aquatic organisms may lead to serious health problems through the food chain. The present research project aims to study the accumulation and potential sources of trace metals in aquatic organisms of the Pearl River Estuary (PRE). Four groups of aquatic organisms, including fish, crab, shrimp, and shellfish, were collected in the PRE for trace metal and Pb isotopic analyses. The trace metal concentrations in the aquatic organism samples ranged from 0.01 to 2.10 mg/kg Cd, 0.02 to 4.33 mg/kg Co, 0.08 to 4.27 mg/kg Cr, 0.15 to 77.8 mg/kg Cu, 0.17 to 31.0 mg/kg Ni, 0.04 to 30.7 mg/kg Pb, and 8.78 to 86.3 mg/kg Zn (wet weight). High concentrations of Cd were found in crab, shrimp and shellfish samples, while high concentration of Pb was found in fish. In comparison with the baseline reference values in other parts of the world, fish in the PRE had the highest elevated trace metals. The results of Pb isotopic compositions indicated that the bioaccumulation of Pb in fish come from a wide variety of food sources and/or exposure pathways, particularly the anthropogenic inputs.