Carbon accumulation through ecosystem recovery

A market has emerged for carbon sequestered through reforestation. The opportunity to restore ecosystems through this market rather than establish plantations is demonstrated by an Australian case study. In the state of Queensland there are vast areas that have been cleared relatively recently and could be restored to ecosystems with high resilience and important biodiversity values with appropriate management. In order to foster opportunities for carbon accumulation through ecosystem recovery spatially explicit information on sequestration rates, management recommendations, and clear definitions of ancillary biodiversity benefits need to be defined.     

Observations on the influence of water and soil pH on the persistence of insecticides

Abstract

The pH‐disappearance rate profiles were determined at ca. 25°C for 24 insecticides at 4 or 5 pH values over the range 4.5 to 8.0 in sterile phosphate buffers prepared in water‐ethanol (99: 1 v/v). Half‐lives measured at pH 8 were generally smaller than at lower pH values. Changes in half lives between pH 8.0 and 4.5 were largest (>1000x) for the aryl carbamates, carbofuran and carbaryl, the oxime carbamate, oxamyl, and the organophosphorus insecticide, trichlorfon. In contrast, half lives of phorate, terbufos, heptachlor, fensulfothion and aldicarb were affected only slightly by pH changes. Under the experimental conditions described half lives at pH8 varied from 1–2 days for trichlorfon and oxamyl to >1 year for fensulfothion and cyper‐methrin. Insecticide persistence on alumina (acid, neutral and basic), mineral soils amended with aluminum sulfate or calcium hydroxide to different pH values and four natural soils of different pH was examined. No correlation was observed between the measured pH of these solids and the rate of disappearance of selected insecticides applied to them. These observations demonstrate the difficulty of extrapolating the pH dependent disappearance behaviour observed in homogeneous solution to partially solid heterogeneous systems such as soil.     

Solid Absorbent Method for Sampling and Analysis of Nitrogen Dioxide in Ambient Air

A sampling and analysis system was developed for measuring concentrations of nitrogen dioxide in ambient air. Copper shot was found to be an effective absorbent for collecting samples at ambient levels. The analytical system was based on the desorption of the sample from the copper by heating in a hydrogen carrier stream. The desorbed sample was then determined by a combination of catalytic pyrolysis, which converted it to ammonia, and a Coulson Conductivity Detector. Data are presented showing overall recovery, effects of storage of collected samples, results for 24-hour sampling and interferences. Studies indicated the feasibility of the method for short time sampling as well as for 24-hour sampling periods. The detection limit was shown to be as little as 100 ng NO₂ in laboratory studies. This solid absorbent method provides a simple, convenient, and compact means for air sampling.     

A Strategy for Reduction of Particulate Emissions in the Boston Area

Initial implementation plans provided for particulate reduction largely through the imposition of emission limitations on industrial processes, large steam generators, and solid waste disposal, requiring, in turn, application of control equipment for compliance. In many urban areas, this approach is not adequate to achieve the secondary air quality standards so that a more general strategy must be employed. Such strategy may include restrictions on fuel burning, combustion equipment, maintenance programs, utility steam distribution, etc. The potential abatement achievable through such strategies is described using Boston as a case study. Cost and technical factors associated with each strategy are discussed.     

Gas-phase reaction of (E)-β-farnesene with ozone: Rate coefficient and carbonyl products

The gas-phase ozonolysis of (E)-β-farnesene was investigated in a 3.91 m³ atmospheric simulation chamber at 296 ± 2 K and relative humidity of around 0.1%. The relative rate method was used to determine the reaction rate coefficient of (4.01 ± 0.17) × 10^?16 cm³ molecule^?1 s^?1, where the indicated errors are two least-squares standard deviations and do not include uncertainties in the rate coefficients for the reference compounds (γ-terpinene, cis-cyclooctene and 1,5-cyclooctadiene). Gas phase carbonyl products were collected using a denuder sampling technique and analyzed with GC/MS following derivatization with O-(2,3,4,5,6-pentafluorobenzyl) hydroxylamine (PFBHA). The reaction products detected were acetone, 4-oxopentanal, methylglyoxal, 4-methylenehex-5-enal, 6-methylhept-5-en-2-one, and (E)-4-methyl-8-methylenedeca-4,9-dienal. A detailed mechanism for the gas-phase ozonolysis of (E)-β-farnesene is proposed, which accounts for all of the products observed in this study. The results of this work indicate that the atmospheric reaction of (E)-β-farnesene with ozone has a lifetime of around 1 h and is another possible source of the ubiquitous carbonyls, acetone, 4-oxopentanal and 6-methylhept-5-en-2-one in the atmosphere.     

Testing the capability of the chemistry transport model LOTOS-EUROS to forecast PM10 levels in the Netherlands

Since particulate matter has a direct and adverse impact on public health, a good air quality forecast is important. Several European countries presently use statistical forecasting models, which have their limitations, especially for PM10. An alternative approach is to use a chemistry transport model. Here, the ability of the chemical transport model LOTOS-EUROS to forecast PM10 concentrations in the Netherlands was investigated. LOTOS-EUROS models several PM10 components individually. For sulphate, nitrate and ammonium aerosol the evaluation against observations shows that the modelled annual mean concentrations are within 20% of the measured concentration and that the temporal correlation is reasonably good (R > 0.6). For sea salt the model tended to overestimate the measured concentrations. For elemental carbon the correspondence with black smoke observations was reasonable. However, total PM10 is seriously underestimated, due to unmodelled components (secondary organic aerosols, mineral dust) and missing sources. Therefore, a simple bias correction for four seasons was derived based on the years 2004–2006. The model was compared with the Dutch operational statistical model PROPART and ground-level observations. With bias correction, LOTOS-EUROS performed better than PROPART regarding the timing of events. The major flaw of LOTOS-EUROS was that high values (>50 μg m^?3) were still underestimated. Another advantage of LOTOS-EUROS over the statistical model was the more detailed information in space and time, which facilitates communication of the forecast to the general public.     

Solar driven nitrous acid formation on building material surfaces containing titanium dioxide: A concern for air quality in urban areas?

The photoenhanced uptake of nitrogen dioxide (NO₂) to the surface of commercially available self-cleaning window glass has been studied under controlled laboratory conditions. This material is one of an array of modern building products which incorporate titanium dioxide (TiO₂) nanoparticles and are finding increasing use in populated urban areas. Amongst the principal drivers for the use of these materials is that they are thought to facilitate the irreversible removal of pollutants such as NO₂ and organic molecules from the atmosphere and thus act to remediate air quality. While it appears that TiO₂ materials do indeed remove organic molecules from built environments, in this study we show that the photoenhanced uptake of NO₂ to one example material, self-cleaning window glass, is in fact accompanied by the substantial formation (50–70%) of gaseous nitrous acid (HONO). This finding has direct and serious implications for the use of these materials in urban areas. Not only is HONO a harmful respiratory irritant, it is also readily photolysed by solar radiation leading to the formation of hydroxyl radicals (OH) together with the re-release of NO_x as NO. The net effect of subsequent OH initiated chemistry can then be the further degradation of air quality through the formation of secondary pollutants such as ozone and VOC oxidation products. In summary, we suggest that a scientifically conceived technical strategy for air quality remediation based on this technology, while widely perceived as universally beneficial, could in fact have effects precisely opposite to those intended.     

Photodegradation of sulfonamide antibiotics in simulated and natural sunlight: Implications for their environmental fate

The photochemical fate of seven sulfonamides was investigated in matrices representative of natural water bodies under various light sources. Fundamental photolysis parameters such as molar absorption coefficient, quantum yield (QY) and first-order rate constants were determined. The photolysis decay rate was dependent on the protonation state of the molecule, pH of the water sample and dissolved organic matter. Natural organic matter was the most significant factor in the indirect photolysis of sulfonamides. Half-lives were in the range of minutes at 254 nm to days under natural sunlight. Under natural sunlight, all sulfonamides showed higher removal rates in natural waters implying that indirect photolysis is the predominant mechanism.