Monitoring of Seasonal Vegetables for Pesticide Residues

Market samples (60) of six seasonal vegetables were monitoredduring 1996–1997 to determine the magnitude of pesticidalcontamination. The estimation of insecticide residuesrepresenting four major chemical groups i.e. organochlorine,organophosphorous, synthetic pyrethroid and carbamate, was doneby adopting a multiresidue analytical technique employingGC-ECD and GC-NPD systems with capillary columns. The testedsamples showed 100% contamination with low but measurableamounts of residues. Among the four chemical groups, theorganophosphates were dominant followed by organochlorines,synthetic pyrethroids and carbamates. About 23% of the samplesshowed contamination with organophosphorous compounds abovetheir respective MRL values. More extensive studies coveringdifferent regions of Haryana state are suggested to get a clearidea of the magnitude of vegetable contamination with pesticideresidues.     

Accumulation of metals in the soil of an overland flow wastewater treatment system

Accumulation of Co, Cu, Cr, Mo, Ni, Pb and Zn was evaluated in a soil profile of an overland flow system used for the post-treatment of urban wastewater. A pilot version of the overland flow system received urban wastewater from five up-flow anaerobic filters filled with bamboo (Bambusa tuldoides) rings. The anaerobic effluent was applied as feed over 18 months at rates varying from 7 to 28 L min(-1), to a vegetated slope length covered with Tifton 85 (Cynodon) sp. grass. Soil and plant samples were collected in triplicate from the top to the bottom of the slope. In addition, the soils were sampled at the depths 0-20 and 20-40 cm. The metal concentrations found in the overall system were compared to those obtained in a control area located at the beginning of the slope onto which nothing was applied. A month of monitoring the urban wastewater of Limeira City (S?o Paulo State, Brazil) showed a drastic change in metals concentration due to the irregular discharge of industrial waste. This irregular discharge introduces Cr, Cu, Ni, Pb and Zn into the system used to treat domestic wastewater. The mass balance indicates the accumulation of metals in the soil and the translocation to the plants; also that they could be evapotranspirated, percolated and discharged.     

The influence of metallurgy on the formation of welding aerosols

Recent research has indicated that insoluble ultrafine aerosols (ie., particles whose physical diameters are less than 100 nm) may cause adverse health effects due to their small size, and that toxicological response may be more appropriately represented by particle number or particle surface area. Unfortunately, current exposure criteria and the associated air-sampling techniques are primarily mass-based. Welding processes are high-temperature operations that generate substantial number concentrations of ultrafine aerosols. Welding aerosols are formed primarily through the nucleation of metal vapors followed by competing growth mechanisms such as coagulation and condensation. Experimental results and mathematical tools are presented to illustrate how welding metallurgy influences the chemical aspects and dynamic processes that initiate and evolve the resultant aerosol. This research suggests that a fundamental understanding of metallurgy and aerosol physics can be exploited to suppress the formation of undesirable chemical species as well as the amount of aerosol generated during a welding process.     

Isotopic characterisation of lead deposited 1989-2001 at two upland Scottish locations

The isotopic composition of lead collected with grass samples taken over the period 1989-2001 from plots at two upland locations (Glensaugh in north east and Hartwood in central Scotland) has been determined using thermal ionisation mass spectrometry. Although marked reductions in lead concentrations in grass were observed at Glensaugh in the initial three years, subsequently concentrations have remained relatively constant (1-3 microg g(-1)) in all plots to the present day. The one exception was a roadside plot at Hartwood which showed a large reduction from 1.0 microg g(-1) in 1999 to 0.2 microg g(-1) in 2000 following the abolition of petrol lead in the UK at the beginning of 2000. The total concentrations at this plot were consistently lower than those found at plots away from road traffic but exposed to the prevailing wind direction. The 206Pb/207Pb ratio increased steadily at all the plots throughout the period of the study indicating the reducing influence of petrol lead but the changes were not as great as might be expected with the decrease in the use of leaded petrol. Assuming the collected lead had only two sources, petrol lead and a diffuse background "industrial" lead, the proportion of petrol lead was only in the range 17-69% for roadside samples and 0-39% in other samples. A substantial proportion of deposited lead, therefore, now has its origin other than in petrol. Mixing curves indicate that whereas the lead deposited at Glensaugh could be defined by only two end members, that at Hartwood needs more than two components in the mixture. The results also suggest that although petrol lead has been eliminated, traffic is still a source of lead and another source defined as "traffic lead" should be considered.     

Distribution of Chlorinated Organic Pollutants in Harbor Sediments of Livorno (Italy): A Multivariate Approach to Evaluate Dredging Sediments

Dredging is a very important procedure for harbor management. InItaly the guidelines for the offshore dumping of dredged materials are issued by the Ministry of Environment. Theydescribed a few steps of dredging activities, such as thesampling strategy, but do not deal with limits or guide-valuesfor the chemical, physical and biological composition of theresulting sediments. The quality of dredged materials is mainlydependent on the presence of inorganic and organic pollutants.In particular, polychlorinated biphenyls (PCBs) and organo-chlorinated pesticides are seen as a high priority inmarine environment by international organizations because oftheir persistence, toxicity and bioaccumulation capacity.In this article the presence of some PCBs and organo-chlorinatedpesticides in sediment samples collected from the harbor ofLivorno (Northern Tyrrhenian Sea) was investigated. Theconcentration of HCHs, Aldrin, Chlordanes, DDEs, DDTs, and PCBsin 12 representative sites ranged between <1 g kg^–1and 95, 19, 32, 35, 107, and 111 g kg^–1, respectively.The application of univariate and multivariate statisticaltechniques, such as linear regression analysis and principalcomponent analysis, to the experimental data showed a differentdistribution of PCBs in the two sediment layers. On thecontrary, the vertical distribution of the other investigatedpollutants was more homogeneous and affected by randomvariability. The multivariate approach was an important tool to establish more rational criteria for the management of dredged materials.     

Preliminary air pollution monitoring in San Miguel, Buenos Aires

Passive diffusion samplers were employed in San Miguel(Buenos Aires Metropolitan Area) for a preliminary airpollution monitoring. The highest loads were observedin downtown, compared with an urban background site.Total suspended particulate matter (TSPM) varied from0.257 to 0.033 mg cm^-2 month^-1; dust was examinedfor particle nature and size distribution. A similartrend was observed for nitrogen dioxide (NO₂) andTSPM spatial distribution, suggesting that traffic isthe major pollution source. Sulphur dioxide (SO₂)values were low and rather homogeneous. Levels for theinvestigated pollutants are below EPA's guide linevalues. Geographic (flat area, near to Rio de LaPlata) and climatologic factors (rainfalls andvariable wind directions) contribute to disperse pollutants.     

Application of intrawell testing of RCRA groundwater monitoring data when no upgradient well exists

A statistical quality control approachto detect changes in groundwater quality from aregulated waste unit is described. The approachapplies the combined Shewhart-CUSUM control chartmethodology for intrawell comparison of analyteconcentrations over time and does not require anupgradient well. A case study from the U.S.Department of Energy's Hanford Site is used forillustration purposes. This method is broadlyapplicable in groundwater monitoring programs wherethere is no clearly defined upgradient location, thegroundwater flow rate is exceptionally slow, or wherea high degree of spatial variability exists inparameter concentrations. This study also indicatesthat the use of the Data Quality Objectives (DQO)process can assist in designing an efficient andcost-effective groundwater monitoring plan to achievethe optimum goal of both low false positive and lowfalse negative rates (high power).     

An Evaluation of Selenium Concentrations in Water, Sediment, Invertebrates, and Fish from the Republican River Basin: 1997–1999

The Republican River Basin of Colorado,Nebraska, and Kansas lies in a valley which contains PierreShale as part of its geological substrata. Selenium is anindigenous constituent in the shale and is readily leached intosurrounding groundwater. The Basin is heavily irrigated throughthe pumping of groundwater, some of which is selenium-contaminated, onto fields in agricultural production. Water,sediment, benthic invertebrates, and/or fish were collected from46 sites in the Basin and were analyzed for selenium to determinethe potential for food-chain bioaccumulation, dietary toxicity,and reproductive effects of selenium in biota. Resultingselenium concentrations were compared to published guidelines orbiological effects thresholds. Water from 38% of the sites (n = 18) contained selenium concentrations exceeding 5 g L^-1, which is reported to be a high hazard for selenium accumulation into the planktonic food chain. An additional 12 sites (26% of the sites) contained selenium in water between 3–5 g L^-1, constituting a moderate hazard. Selenium concentrations in sedimentindicated little to no hazard for selenium accumulation fromsediments into the benthic food chain. Ninety-five percent ofbenthic invertebrates collected exhibited selenium concentrationsexceeding 3 g g^-1, a level reported as potentially lethal to fish and birds that consume them. Seventy-five percent of fish collected in 1997, 90% in 1998, and 64% in 1999 exceeded 4 g g^-1selenium, indicating a high potential for toxicity andreproductive effects. However, examination of weight profilesof various species of collected individual fish suggestedsuccessful recruitment in spite of selenium concentrations thatexceeded published biological effects thresholds for health andreproductive success. This finding suggested that universalapplication of published guidelines for selenium may beinappropriate or at least may need refinement for systems similarto the Republican River Basin. Additional research is needed todetermine the true impact of selenium on fish and wildliferesources in the Basin.     

A Watershed-based Cumulative Risk Impact Analysis: Environmental Vulnerability and Impact Criteria

Swine Concentrated Animal Feeding Operations (CAFOs) have received much attention in recent years. As a result, a watershed-based screening tool, the Cumulative Risk Index Analysis (CRIA), was developed to assess the cumulative impacts of multiple CAFO facilities in a watershedsubunit. The CRIA formula calculates an index number based on: 1) the area of one or more facilities compared to the area of the watershed subunit, 2) the average of the environmental vulnerability criteria, and 3) the average of the industry-specific impact criteria. Each vulnerability or impact criterion is ranked on a 1 to 5 scale, with a low rank indicating low environmental vulnerability or impact and a high rank indicating high environmental vulnerability or impact. The individual criterion ranks, as well as the total CRIA score, can be used to focus the environmental analysis and facilitate discussions with industry, public, and other stakeholders in the Agency decision-making process.     

The extraction of aged polycyclic aromatic hydrocarbon (PAH) residues from a clay soil using sonication and a Soxhlet procedure: a comparative study

A sonication method was compared with Soxhlet extraction for recovering polycyclic aromatic hydrocarbons (PAH) from a clay soil that had been contaminated with tar materials for several decades. Using sonication over an 8 h extraction period, maximum extraction of the 16 US EPA priority PAH was obtained with dichloromethane (DCM)-acetone (1 + 1). The same procedure using hexane-acetone (1 + 1) recovered 86% of that obtained using DCM-acetone (1 + 1). PAH recovery was dependent on time of extraction up to a period of 8 h. The sonication procedure showed that individual PAH are extracted at differing rates depending on the number of fused rings in the molecule. Soxhlet extraction [with DCM-acetone (1 + 1)] over an 8 h period recovered 95% of the PAH removed by the sonication procedure using DCM-acetone (1 + 1), indicating that rigorous sonication can achieve PAH recoveries similar to those obtained by Soxhlet extraction. The lower recovery with the Soxhlet extraction was explained by the observed losses of the volatile PAH components after 1-4 h of extraction. The type of solvent used, the length of time of extraction and extraction method influenced the quantification of PAH in the soil. Therefore, the study has implications for PAH analyses in soils and sediments, and particularly for contaminated site assessments where the data from commercial laboratories are being used. The study emphasizes the importance of establishing (and being consistent in the application of) a vigorous extraction, particularly for commercial laboratories that handle samples of soil in batches (at different times) from a single site investigation or remediation process. The strong binding of PAH to soil, forming aged residues, has significant implications for extraction efficiency. This paper illustrates the problem of the underestimation of PAH using the US EPA method 3550, specifically where a surrogate spike is routinely employed and the efficiency of the extraction procedure for aged residues is unknown. The implications of this study for environmental monitoring, particularly where numerous batches of samples from a single site assessment or remediation program are submitted to commercial laboratories, is that it would be advisable for these laboratories to check their existing method's extraction efficiencies by conducting a time course sonication extraction on their particular soil to determine the optimum extraction time.