A new approach to quantify the degradation kinetics of linuron with UV, ozonation and UV/O3 processes

The degradation of linuron, one of phenylurea herbicides, was investigated for its reaction kinetics by different treatment processes including ultraviolet irradiation (UV), ozonation (O₃), and UV/O₃. The decay rate of linuron by UV/O₃ process was found to be around 3.5 times and 2.5 times faster than sole-UV and ozone-alone, respectively. Experimental results also indicate overall rate constants increased exponentially with pH above 9.0 while the increase of rate constants with pH below 9 is insignificant in O₃ system. All dominant parameters involved in the three processes were determined in the assistant of proposed linear models in this study. The approach was found useful in predicting the process performances through the quantification of quantum yield (rate constant for the formation of free radical HOO⁻ from ozone decomposition at high pH), rate constant of linuron with ozone (k_O3,LNR), rate constant of linuron with hydroxyl radical (k_OH,LNR), and α (the ratio of the production rate of OH and the decay rate of ozone in UV/O₃ system).     

Anoxic-aerobic treatment of the liquid fraction of cattle manure

Cattle manure from a dairy farm was treated in order to reduce its pollution potential. The manure came from a farm with 120 cows kept in stables in a free stall barn. As pretreatment, the manure is usually filtered on the farm using a screw press separator with a 0.5 mm mesh. Approximately 70% of the total filtered volume passes through the screen, thus constituting the liquid fraction. This fraction, with a composition of around 64,500 mg COD/l, 5770 mg total-N/l and 800 mg total-P/l, was subjected to centrifugation followed by a two-step biological treatment (anoxic-aerobic) to reduce organic matter (COD), nitrogen and phosphorus compounds. Centrifugation led to the following removal efficiencies: 35% total solids, 60% COD, 75% total phosphorus and 20% total nitrogen (mainly organic nitrogen). With the subsequent anoxic-aerobic treatment, average removal efficiencies of 85% for COD, 90% for total phosphorus and 75% for total nitrogen were achieved.     

Aging and compressibility of municipal solid wastes

The expansion of a municipal solid waste (MSW) landfill requires the ability to predict settlement behavior of the existing landfill. The practice of using a single compressibility value when performing a settlement analysis may lead to inaccurate predictions. This paper gives consideration to changes in the mechanical compressibility of MSW as a function of the fill age of MSW as well as the embedding depth of MSW. Borehole samples representative of various fill ages were obtained from five boreholes drilled to the bottom of the Qizhishan landfill in Suzhou, China. Thirty-one borehole samples were used to perform confined compression tests. Waste composition and volume-mass properties (i.e., unit weight, void ratio, and water content) were measured on all the samples. The test results showed that the compressible components of the MSW (i.e., organics, plastics, paper, wood and textiles) decreased with an increase in the fill age. The in situ void ratio of the MSW was shown to decrease with depth into the landfill. The compression index, Cc, was observed to decrease from 1.0 to 0.3 with depth into the landfill. Settlement analyses were performed on the existing landfill, demonstrating that the variation of MSW compressibility with fill age or depth should be taken into account in the settlement prediction.     

Estimation of mass transport parameters of gases for quantifying CH4 oxidation in landfill soil covers

Methane (CH(4)), which is one of the most abundant anthropogenic greenhouse gases, is produced from landfills. CH(4) is biologically oxidized to carbon dioxide, which has a lower global warming potential than methane, when it passes through a cover soil. In order to quantify the amount of CH(4) oxidized in a landfill cover soil, a soil column test, a diffusion cell test, and a mathematical model analysis were carried out. In the column test, maximum oxidation rates of CH(4) (V(max)) showed higher values in the upper part of the column than those in the lower part caused by the penetration of O(2) from the top. The organic matter content in the upper area was also higher due to the active microbial growth. The dispersion analysis results for O(2) and CH(4) in the column are counter-intuitive. As the upward flow rate of the landfill gas increased, the dispersion coefficient of CH(4) slightly increased, possibly due to the effect of mechanical dispersion. On the other hand, as the upward flow rate of the landfill gas increased, the dispersion coefficient of O(2) decreased. It is possible that the diffusion of gases in porous media is influenced by the counter-directional flow rate. Further analysis of other gases in the column, N(2) and CO(2), may be required to support this hypothesis, but in this paper we propose the possibility that the simulations using the diffusion coefficient of O(2) under the natural condition may overestimate the penetration of O(2) into the soil cover layer and consequently overestimate the oxidation of CH(4).     

Low-dose irradiation by electron beam for the treatment of high-SOx flue gas on a semi-pilot scale—Consideration of by-product quality and approach to clean technology

Attention has been focused on the treatment of lignite-fired flue gas in order to use lignite in an environmentally friendly way – (i) low-CO₂ emission, (ii) production of a valuable by-product, (iii) no discharge of wastewater, (iv) direct removal of SO₃ (strong toxicity), and (v) treatment of high SO₂ concentration. Based on these criteria, electron beam irradiation with ammonia injection was tested on a semi-pilot scale: 800 Nm³ h^?1 flow rate, 5500 ppm SO₂, 70 ppm NO_x, 22% flue gas moisture, and 75–80 °C at the reactor outlet.As an energy-saving measure, a low dose (5 kGy) of irradiation was applied: the problem lay in the by-product quality. It is considered that (NH₄)₂SO₃ and NH₄HSO₃ produced by thermal reactions are oxidized to form (NH₄)₂SO₄ (fertilizer) by an electron beam. However, not all reactions were complete because the by-product contained small amounts of H₂SO₄ and NH₂SO₃NH₄ (herbicide), so a vegetable pot test was performed to study the by-product quality: no adverse effect was observed. It is inferred from the pot test that slightly acidic soil may protect vegetables from disease and a small amount of NH₂SO₃NH₄ probably affects woody species and not herbaceous species.It is concluded that the electron beam system is noted as a multi-component pollution control process (removal of NO_x, SO₃, SO₂ and dioxins) and this system will contribute to environmentally friendly use of lignite as well as agricultural productivity via fertilizer supply.     

Effects of environmental illiteracy and environmental awareness among middle school students on environmental behavior

This study proposes and employs a structural model to examine the effects of environmental literacy, environmental awareness, environmental attitudes, and environmental behavior among middle school students in Eski?ehir on their purchase of environmentally friendly products. In the proposed structural model, environmental illiteracy and environmental awareness were the exogenous latent variables, while pro-environmental attitude, pro-environmental behavior, and the purchase of environmentally friendly products were the endogenous latent variables. The latent variable of environmental illiteracy did not have a statistically significant effect on environmental attitudes and purchase of environmentally friendly products, whereas environmental awareness had a positive effect on pro-environmental attitudes and the purchase of environmentally friendly products. These findings indicate that students with environmental awareness also develop positive attitudes toward the environment, and the presence of a positive attitude toward the environment leads them to display pro-environmental behaviors and adopt a positive attitude toward environmentally friendly products.     

Consumer attitudes on the use of plastic and cloth bags

This paper examines consumer attitudes and behavior on the use of plastic and cloth bags in Eski?ehir, Turkey. To this end, a structural equation model is proposed. Environmental consciousness regarding the use of plastic bags, social pressure, support for the banning of plastic bags, the intention to use cloth bags and behavior to reduce plastic bag use are employed as latent variables in the model. The intention to use cloth bags and the behavior to reduce the use of plastic bags are defined as endogenous latent variables in the structural model. In the conclusion of the study, it is identified that consumers who are environmentally conscious and feel under social pressure, tend to reduce the use of plastic bags and switch to using cloth bags.     

基于机器视觉的鱼类行为特征提取与分析

近年来,水污染问题备受关注。生物式水质监测成为目前国家环境保护工作的重要任务之一。为准确监测水质污染情况,本文以青鳉鱼(Oryzias latipes)为研究对象,采用非接触式的机器视觉监测技术,提取青鳉鱼的生理特征(呼吸频率)和运动特征(胸鳍和尾鳍的摆动频率),并分析这些特征与水质之间的关系。本文采用支持向量机(Support Vector Machine,SVM)准确提取鱼鳃,并根据鱼鳃呼吸面积大小变化计算出鱼的呼吸频率。基于形态学细化算法提取青鳉鱼骨架,求出胸鳍和尾鳍的摆动频率。结果显示:不同浓度铜离子暴露实验测得的青鳉鱼生理特征和运动特征与实际情况一致;通过对不同铜离子浓度下的毒性实验数据对比,发现了青鳉鱼的生理特征和运动特征会随不同的铜离子浓度发生相应变化,可以作为水质监测的评价标准。     

Determination of optimum polymeric coagulant in palm oil mill effluent coagulation using multiple-objective optimisation on the basis of ratio analysis (MOORA)

The main limitation of a conventional palm oil mill effluent (POME) ponding system lies in its inability to completely decolourise effluent. Decolourisation of effluent is aesthetically and environmentally crucial. However, determination of the optimum process parameters is becoming more complex with the increase of the number of coagulants and responses. The primary objective of this study is to determine the optimum polymeric coagulant in the coagulation–flocculation process of palm oil mill effluent by considering all output responses, namely lignin–tannin, low molecular mass coloured compounds (LMMCC), chemical oxygen demand (COD), ammonia nitrogen (NH₃-N), pH and conductivity. Here, multiple-objective optimisation on the basis of ratio analysis (MOORA) is employed to discretely measure multiple response characteristics of five different types of coagulants as a function of assessment value. The optimum coagulant is determined based on the highest assessment value and was identified as QF25610 (cationic polyacrylamide). On the other hand, the lowest assessment value was represented by AN1800 (anionic polyacrylamide). This study highlights the simplicity of MOORA approach in handling various input and output parameters, and it may be useful in other wastewater treatment processes as well.     

Pollution-induced community tolerance in benthic macroinvertebrates of a mildly lead-contaminated lake

Environmental Science and Pollution Research - Pollution-induced community tolerance (PICT) has been used to demonstrate effects of sediment contamination on microbes and meiofauna. Our study...