Population dynamics of the barnacle <Emphasis Type="Italic">Chthamalus montagui</Emphasis> at two spatial and temporal scales in northern Spain

This study describes spatial and temporal patterns of variability in population parameters in the barnacle Chthamalus montagui Southward in three localities of northern Spain and evaluates whether density-dependent settlement may regulate population dynamics. The sampling design considered two spatial scales, localities and sites within localities, and two temporal scales, years and six month intervals. Density, amount of free space, mortality, growth rate and magnitude of settlement (both absolute and per unit of free space) were obtained from photographs of permanent quadrats and from direct counts in the field. The number of settlers in scraped and untouched quadrats was used to estimate the importance of the presence of conspecifics in settlement. Significant variation at the two spatial and temporal scales was found for most parameters. Large spatial and temporal variations in adult mortality rate, density, and settlement were observed. Patterns of mortality were not consistent with differences in density among localities. Differences in settlement among localities were maintained through time. We suggest that magnitude of settlement is regulated by persistent features such as topography or local water circulation. We assume that early post-settlement mortality does not differ among localities. In the absence of differential mortality, settlement determines average population density within localities. Within localities, settlement was independent of density and free space. No consistent evidence was found on preferential settlement at the vicinity of conspecifics. The main conclusion is that density-dependent settlement is not relevant for the regulation of the populations of C. montagui in the northern Spain. Regulation might occur by density-dependent processes within the adult fraction of the population and/or the larval phase before settlement.     

Intra-specific variability in the response of maize to arsenic exposure

The response of maize (Zea mays L.) to inorganic arsenic exposure was studied, at the seedling stage under hydroponic conditions, preliminarily in sixteen lines (fourteen hybrids and two inbred lines) and then, more deeply, in six of these lines, selected by showing contrasting differences in their sensitivity to the metalloid. The results indicated that (i) maize is rather tolerant to arsenic toxicity, (ii) arsenite is more phytotoxic than arsenate, (iii) roots are less sensitive than shoots to the metalloid, (iv) a great accumulation of non-protein thiols (probably phytochelatins), without substantial effect on the glutathione content, is produced in roots but not in shoots of arsenic-exposed plants and (v) maize is able to accumulate high levels of arsenic in roots with very low translocation to shoots. The study, thus, suggests that maize, for its very low rate of acropetal transport of arsenic from roots to shoots, may be a safe crop in relation to the risk of entry of metalloid in the food chain and, for being an important bioenergy crop capable of expressing high levels of arsenic tolerance and accumulation in roots, may represent an interesting opportunity for the exploitation of agricultural useless arsenic contaminated lands.     

Toxicity of atmospheric particle-bound PAHs: an environmental perspective

Atmospheric polycyclic aromatic hydrocarbons (PAHs) are environmental pollutants that represent a risk not only to humans, but to all living organisms. High-molecular weight PAHs are more toxic than lighter relatives, and also have a higher tendency to bind onto air particles (i.e., particle matter, PM). PM is a major constituent of air pollution. Adequate assessment of the biological impact of PM requires the analysis, not only of the effects on human health, but also on the environment. Since the aquatic systems work as a natural sink to these air pollutants, assessing the effects of particle-bound PAHs on aquatic organisms may further characterize its potential aquatic toxicity, also providing simple and low-cost alternative assays to investigate PM biological effects in vivo. We review the current scientific literature, addressing the atmospheric PAHs fate, transformation and deposition, pertinent particle-bound PAHs toxicity data, and the potential aquatic toxic burden. Conceptual and experimental procedures that could improve future investigations and risk assessments are also considered.     

Dechlorane plus and possible degradation products in white stork eggs from Spain

The occurrence of the emerging chlorinated flame retardant Dechlorane Plus (DP) and three of its possible degradation products was investigated in white stork eggs from two colonies in Spain. The average DP concentrations were 401 pg/g wet weight (w.w.) for the urban/industrial colony and 105 pg/g w.w. for the rural colony. One possible degradation product, anti-[DP-1Cl], was found in approximately 10% of the samples. No significant stereoisomer enrichments were detected in any colony based on the average anti-DP fractional abundances found which agrees with previous studies in herring gulls. The relationship between DP and PBDE contents in both colonies was explored leading to different scenarios, i.e. no correlation was found in the urban colony but they were statistically correlated in the rural colony. To the best of our knowledge, this is the first study to report DP in a species from a terrestrial food web, and also to report a DP degradation product in biota.     

Predominance of BDE-209 and other higher brominated diphenyl ethers in eggs of white stork (Ciconia ciconia) colonies from Spain

Polybrominated diphenyl ethers (PBDEs) are ubiquitous pollutants for which there is still a lack of knowledge about the environmental behavior and fate of the higher brominated congeners (octa- to deca-BDEs). In this study, the PBDE content and congener profiles in failed eggs from two colonies of white stork (Ciconia ciconia) in Spain were studied. The average total PBDE concentration was 1.64ng/g (wet weight, w.w.) for the rural colony and 9.08ng/g (w.w.) for the urban colony. Higher brominated BDEs dominated the congener profiles of both colonies. Of particular interest was the determination of BDE-209 as the dominant congener accounting for 44.1% and 38.6% of the total PBDE content in the rural and urban colonies, respectively. BDE-202, considered an indicator of BDE 209 debromination, was detected in 83% and all of the samples from rural and urban colonies, respectively. The observed congener profile in which BDE-207>BDE-208>BDE-206 does not correspond to any known technical PBDE mixture and is evidence for possible BDE-209 degradation.     

Zero valent iron mediated degradation of the pharmaceutical diazepam

Parameters that influence the zero valent iron mediated degradation of the pharmaceutical diazepam (DZP) were evaluated including the iron concentration and its pre-treatment, the effect of complexation with EDTA and oxic versus anoxic condition. It was observed that acid pre-treatment of iron particles is important for degradation efficiency and that H₂SO₄ is a better choice than HCl, resulting in higher degradation of DZP. Under oxic conditions, the degradation of DZP achieved 96% after 60 min using Fe⁰ (25 g L⁻¹) pre-treated with H₂SO₄ in the presence of EDTA (119 mg L⁻¹), while mineralization achieved around 60% after the same time. Under anoxic conditions, degradation occurred, however at lower extent, achieving 67% after 120 min. The addition of EDTA improved the treatment efficiency in 20% leading to 99% DZP degradation after 120 min. The first intermediates formed during DZP degradation were identified using LC/MS analysis and revealed the formation of mono- and di-hydroxylated products from DZP during Fe⁰/EDTA/O₂ degradation, which evidences that OH was the main oxidizing species formed in this process.     

The influence of a real job on upper limb performance in motor skill tests: which abilities are transferred?

To investigate whether the specificities of real jobs create distinctions in the performance of workers in different motor tests for the upper limbs, 24 participants were divided into two groups according to their specific job: fine and repetitive tasks and general tasks. Both groups reproduced tasks related to aiming movements, handling and strength of the upper limbs. There were no significant differences between groups in the dexterity and performance of aiming movements. However, the general tasks group had higher grip strength than the repetitive tasks group, demonstrating differences according to job specificity. The results suggest that a particular motor skill in a specific job cannot improve performance in other tasks with the same motor requirements. The transfer of the fine and gross motor skills from previous experience in a job-specific task is the basis for allocating training and guidance to workers.     

Comparison of the Effect of Plasticizers on PHBV—and Organoclay—Based Biodegradable Polymer Nanocomposites

The aim of this work was to evaluate the effect of different plasticizers on the morphology, crystallization, and mechanical properties of poly(hydroxybutyrate-co-hydroxyvalerate) (PHBV)/organomodified montmorillonite (OMt) nanocomposites. We investigated three different plasticizers: dioctyl phthalate (DOP), a commonly used additive in the polymer industry, and two natural and biodegradable plasticizers: epoxidized soybean oil (ESO) and triethyl citrate (TEC). The nanocomposites with 3 wt% OMt were obtained by melt processing in an internal mixer. The plasticizers were used alone or in combination with clay in a concentration of 10 wt%. X-ray diffraction and scanning electron microscopy results revealed a partially intercalated structure. The degree of crystallinity was higher for all of the samples compared to neat PHBV, although the melting temperature decreased with the use of plasticizers combined with OMt. The impact strength results were dependent on the interaction between the components of the system. Triethyl citrate was the most effective plasticizer due to its more pronounced interaction with the PHBV matrix, which yielded improvements in processing conditions and PHBV’s flexibility and impact properties.     

Arsenic contamination and speciation in surrounding waters of three old cinnabar mines

The impact of arsenic pollution in waters from the surroundings of three abandoned Hg mines in Northern Spain, as well as reaching the Caudal River, was evaluated. For assessing the factors controlling arsenic release, an extensive study based on the physicochemical characterization and multivariate statistical analysis of waters upstream and downstream each mine site was performed. Waters downstream of the La Soterra?a mine present the highest arsenic concentrations, up to 38.8 mg L(-1), coming mainly from the solubilisation of calcium, magnesium and strontium arsenates at a pH close to neutral. Although arsenic concentrations downstream of La Pe?a are markedly lower, these values remain too high, indicating that the encapsulation carried out in this spoil heap is insufficient. In addition, the high water flow in this point involves an extremely high input of arsenic to the surroundings (0.3 g s(-1)). Waters close to tailings from Los Rueldos suffer from acid mine drainage, provoking an important solubilisation of arsenic and heavy metals, a situation which is rapidly softened with distance. The study of arsenic speciation reveals the omnipresence of As(v) in waters from the three mines, whereas in La Pe?a low amounts of As(iii) were also detected. Different preservation methods for As speciation were compared, such as the addition of HCl, EDTA and the storage of samples without any additive, and no alteration of samples in any case up to nine months after the collection was observed. A study of seasonal variations of As and the main parameters affecting its concentration and speciation was completed throughout a year, showing no remarkable dependency with rainfall for any studied variable.     

Dynamics of metal tolerant plant communities' development in mine tailings from the Cartagena-La Unión Mining District (SE Spain) and their interest for further revegetation purposes

Mine tailings are typical elements in post-mining landscapes which usually have high heavy metal contents and are affected by intensive erosion processes, above all in arid and semiarid areas. Revegetation of these sites is considered a low cost and suitable technology to effect surface stabilization. Spontaneous plant communities that colonize tailings in Southern Spain showed different behavior depending on the pH: in neutral tailings the plant communities were formed by less number of plant species than in acid tailings but they had less seasonal variations, showing a stable development. This spontaneous vegetation, that is adapted to metal toxicity and to drought, allows reducing air borne and water erosion, and may mitigate the spread of the contamination to the nearby areas.