3M测试片法在膜法水处理技术中的应用

采用3M测试片法测定膜法水处理系统的细菌总数,找出双膜系统的微生物污染环节,并采用正交实验筛选出适宜的杀菌剂种类、杀菌剂加入量和杀菌时间。实验结果表明：3M测试片法的测定结果数据准确可靠,且操作简便,节省时间,可以替代常规的平皿培养法用于评价膜的微生物污染情况;某炼化公司双膜系统的反渗透膜已受到微生物的污染,确定的适宜杀菌条件为杀菌剂Trsea 380、杀菌剂加入量50 mg/L、杀菌时间2.0 h,在此条件下杀菌率可达100%。     

TiO2光催化法降解空气中的苯

以紫外灯为光源,采用P25型TiO₂光催化降解空气中的苯。为保证TiO₂的高分散性、增加其在铝板上的附着牢固性,加入了聚乙烯醇和硅溶胶,这在一定程度上增加了催化剂对光能的利用率,但也造成了催化剂活性的降低。实验结果表明：苯的光催化降解反应属一级动力学反应;苯降解率随初始苯质量浓度的增加而减小,随反应面积的增大而增大,在253.7 nm波长光源下的降解效果优于365.0 nm;苯降解所得的气相产物主要为CO₂和CO;随使用次数的增加,催化剂失活现象逐步显现;双氧水对催化剂的再生效果优于去离子水。     

Recycling of calcium fluoride sludge as ceramic material using low temperature sintering technology

The Chinese integrated circuit industry has been transformed from a small state-owned sector into a global competitor, but chip manufacturing produces large amounts of calcium fluoride sludge (CFS). The current treating method is landfill in China. In order to solve the problem of unavailable landfill sites and the dissolved CFS polluting water sources, CFS was tested as a component for a ceramic product made with sodium borate, sodium phosphate, and waste alumina using a low temperature sintering technology. The ceramic was characterized by X-ray diffraction (XRD), microstructure, compressive strength. XRD and microstructure analyses verified that CFS was transformed into Na₂Ca(PO₄)F as an inert crystalline phase in ceramic, which is enclosed by the borophosphate glass liquid phase. Toxicity characteristic leaching procedure and corrosion resistance tests verified that fluorine from CFS was solidified in the inert crystalline phase, which did not release to cause secondary pollution. This novel technology produces high-performance ceramic as a construction material, in accordance with the concept of sustainable development.     

Influence of environmental factors on net N2 and N2O production in sediment of freshwater rivers

Denitrification is an important N removal process in aquatic systems but is also implicated as a potential source of global N₂O emissions. However, the key factors controlling this process as well as N₂O emissions remain unclear. In this study, we identified the main factors that regulate the production of net N₂ and N₂O in sediments collected from rivers with a large amount of sewage input in the Taihu Lake region. Net N₂ and N₂O production were strongly associated with the addition of NO₃ ^?-N and NH₄ ⁺-N. Specifically, NO₃ ^?-N controlled net N₂ production following Michaelis–Menten kinetics. The maximum rate of net N₂ production (V _max) was 116.3 μmol N₂-N m^?2 h^?1, and the apparent half-saturation concentration (k _m) was 0.65 mg N L^?1. N₂O to N₂ ratios increased from 0.18?±?0.03 to 0.68?±?0.16 with the addition of NO₃ ^?-N, suggesting that increasing NO₃ ^?-N concentrations favored the production of N₂O more than N₂. The addition of acetate enhanced net N₂ production and N₂O to N₂ ratios, but the ratios decreased by about 59.5 % when acetate concentrations increased from 50 to 100 mg C L^?1, suggesting that the increase of N₂O to N₂ ratios had more to do with the net N₂ production rate rather than acetate addition in this experiment. The addition of Cl^? did not affect the net N₂ production rates, but significantly enhanced N₂O to N₂ ratios (the ratios increased from 0.02?±?0.00 to 0.10?±?0.00), demonstrating that the high salinity effect might have a significant regional effect on N₂O production. Our results suggest that the presence of N-enriching sewage discharges appear to stimulate N removal but also increase N₂O to N₂ ratios.     

稻秆负荷与pH对稻秆厌氧发酵产酸系统启动过程的影响

为探讨稻秆负荷（即稻秆VS/污泥VSS）与发酵pH对稻秆厌氧发酵产酸系统启动过程产挥发性脂肪酸（VFAs）效果的影响,利用厌氧搅拌罐反应系统考察在不同的稻秆负荷（0.556、0.945、1.334和1.724 g/g）和不同的发酵pH（8.0、9.0和10.0）启动运行条件下的产酸性能,并分析了系统启动过程产酸与稻秆主要成分降解之间的关系。实验结果表明,VFAs浓度随稻秆负荷提高而增大,随发酵pH的升高而降低;发酵18 d时,发酵pH为9.0时,稻秆负荷1.334 g/g的产酸效果最好,VFAs浓度与稻秆产酸量分别为4 385.10 mg/L和2.19 gVFAs/g稻秆,此时半纤维素、纤维素和酸性洗涤木质素降解率分别为32.69%、22.53%和6.40%;稻秆负荷为0.945 g/g条件下,VFAs浓度在pH为8.0时达到最高值4 409.51 mg/L,此时稻秆降解量也最多,半纤维素、纤维素和酸性洗涤木质素降解率分别为28.60%、47.32%和22.69%。研究表明,稻秆负荷与发酵pH通过影响稻秆半纤维素、纤维素和木质素的降解影响稻秆厌氧发酵产酸的进程和效果。     

铜铈掺杂六铝酸盐的脱硝性能

用共沉淀法制备用于脱除NO的六铝酸盐催化剂LaMxAl12-xO19(M =Cu,Ce,CuCe).用XRD、H2-TPR和BET对催化剂进行了结构和物性表征.用微型催化反应装置考察了催化剂在CO选择性催化还原NO中的活性.结果表明,Cu离子易于进入六铝酸盐晶格内,形成完整的六铝酸盐结构.Ce离子不易于进入六铝酸盐晶格内,主要以CeO2的形式存在.在CO+ NO条件下,3种催化剂都表现出较好的脱硝活性,LaCuCeAl10O19中由于Cu离子与Ce离子间产生协同作用,该催化剂的脱硝活性有所增加.加入SO2后,3种催化剂都有不同程度的失活现象发生,其中LaCuAl11O19催化剂受SO2中毒影响最严重,LaCuCeAl10O19催化剂的脱硝活性在三者中最好.     

海绵铁还原耦合活性炭吸附-微波再生技术降解甲基橙

采用海绵铁(s-Fe0)还原耦合活性炭(GAC)吸附-微波(MW)再生技术降解甲基橙(MO)溶液,重点考察了s-Fe0投加量、粒径、微波功率等因素对MO去除效果的影响。结果表明,s-Fe0投加剂量为15.0 g/L、粒径为3～5 mm、超声波功率为200 W,反应1 h,MO的去除率为94.2%。其次,采用GAC吸附-MW再生技术(800 W,照射1 min)循环处理上述脱色后的MO废水。结果表明,GAC吸附可有效降低废水的生物毒性及残留的染料、TOC和总铁离子浓度,且MW辐射可有效再生吸附饱和的GAC颗粒。因此,s-Fe0还原耦合GAC吸附-MW再生技术可以有效降解MO染料,具有处理效果好、实现资源循环利用等优点。     

预处理-超滤-反渗透工艺深度处理炼油厂污水

采用预处理-超滤-反渗透工艺深度处理某炼油厂污水场的二沉池出水。预处理单元出水COD为40mg/L,ρ(NH3-N)为1mg/L,SS为6.3mg/L,能够满足超滤-反渗透系统的进水要求。超滤单元进水压力在0.04~0.08MPa波动,反渗透单元进水压力在0.92~1.12MPa波动,运行均稳定,化学清洗周期均可超过一个月。预处理-超滤-反渗透工艺产水回用于二级脱盐装置脱盐水补水的成本为每吨产水2.04元,低于企业现有的新鲜水每吨3.45元的费用。该优质产水取代新鲜水回用,每年可为企业节约100多万元。     

二氧化钛纳米管光催化降解水中百草枯

二氧化钛纳米管被用于光催化氧化水体中的百草枯,对光催化反应条件、常见Fe3+离子的干扰情况和百草枯光催化降解动力学规律进行了研究。结果表明,浓度为25 mg/L的百草枯溶液,在二氧化钛纳米管(TNT)1.0 g/L,H2O20.5 mL/50 mL,pH=5.0的最优光催化氧化条件下,经过30 min反应可以被100%从水体中去除,表现出非常高的光催化降解效率;动力学方程拟合表明,百草枯光催化氧化反应符合拟一级动力学规律,动力学方程为ln(C0/C)=1.0267t-0.1282,反应速率常数K为1.0267 h-1;双氧水存在时常见的Fe3+能够进一步提高百草枯光催化降解率;该光催化反应体系对低浓度百草枯废水有很好的处理效果,预示着光催化氧化技术适合地表或地下水体中百草枯的去除。