呼和浩特城区冬季近地面挥发性有机物污染特征初步研究

挥发性有机物(VOCs)是环境空气监测的主要目标污染物。本文运用罐采样-三级冷阱预浓缩-中心切割-气相色谱(FID)/气质联用法对人群主要活动的近地面不同高度、不同时间段及不同区域的呼和浩特冬季大气环境中挥发性有机物进行定性定量分析。发现典型天气情况下,呼和浩特城区冬季近地面挥发性有机物组分中烷烃和芳香烃占比较高,城区西侧所监测点位挥发性有机物总量(TVOCs)浓度高于其他区域,且其浓度在高度和时段上存在明显差异。     

Metabolic uncoupler, 3,3′,4′,5-tetrachlorosalicylanilide addition for sludge reduction and fouling control in a gravity-driven membrane bioreactor

• Effects of metabolic uncoupler TCS on the performances of GDMBR were evaluated. • Sludge EPS reduced and transformed into dissolved SMP when TCS was added. • Appropriate TCS increased the permeability and reduced cake layer fouling. • High dosage aggravated fouling due to compact cake layer with low bio-activity. The gravity-driven membrane bioreactor (MBR)system is promising for decentralized sewage treatment because of its low energy consumption and maintenance requirements. However, the growing sludge not only increases membrane fouling, but also augments operational complexities (sludge discharge). We added the metabolic uncoupler 3,3′,4′,5-tetrachlorosalicylanilide (TCS) to the system to deal with the mentioned issues. Based on the results, TCS addition effectively decreased sludge ATP and sludge yield (reduced by 50%). Extracellular polymeric substances (EPS; proteins and polysaccharides) decreased with the addition of TCS and were transformed into dissolved soluble microbial products (SMPs) in the bulk solution, leading to the break of sludge flocs into small fragments. Permeability was increased by more than two times, reaching 60–70 L/m²/h bar when 10–30 mg/L TCS were added, because of the reduced suspended sludge and the formation of a thin cake layer with low EPS levels. Resistance analyses confirmed that appropriate dosages of TCS primarily decreased the cake layer and hydraulically reversible resistances. Permeability decreased at high dosage (50 mg/L) due to the release of excess sludge fragments and SMP into the supernatant, with a thin but more compact fouling layer with low bioactivity developing on the membrane surface, causing higher cake layer and pore blocking resistances. Our study provides a fundamental understanding of how a metabolic uncoupler affects the sludge and bio-fouling layers at different dosages, with practical relevance for in situ sludge reduction and membrane fouling alleviation in MBR systems.     

Diffusive gradients in thin films using molecularly imprinted polymer binding gels for in situ measurements of antibiotics in urban wastewaters

• Selective molecularly imprinted polymer (MIP) binding gel was prepared. • MIP-DGT showed excellent uptake performance for antibiotics. • In situ measurement of antibiotics in wastewaters via MIP-DGT was developed. • The MIP-DGT method was robust, reliable, and highly sensitive. Urban wastewater is one of main sources for the introduction of antibiotics into the environment. Monitoring the concentrations of antibiotics in wastewater is necessary for estimating the amount of antibiotics discharged into the environment through urban wastewater treatment systems. In this study, we report a novel diffusive gradient in thin films (DGT) method based on molecularly imprinted polymers (MIPs) for in situ measurement of two typical antibiotics, fluoroquinolones (FQs) and sulfonamides (SAs) in urban wastewater. MIPs show specific adsorption toward their templates and their structural analogs, resulting in the selective uptake of the two target antibiotics during MIP-DGT deployment. The uptake performance of the MIP-DGTs was evaluated in the laboratory and was relatively independent of solution pH (4.0–9.0), ionic strength (1–750 mmol/L), and dissolved organic matter (DOM, 0–20 mg/L). MIP-DGT samplers were tested in the effluent of an urban wastewater treatment plant for field trials, where three SA (sulfamethoxazole, sulfapyridine, and trimethoprim) and one FQ (ofloxacin) antibiotics were detected, with concentrations ranging from 25.50 to 117.58 ng/L, which are consistent with the results measured by grab sampling. The total removal efficiency of the antibiotics was 80.1% by the treatment plant. This study demonstrates that MIP-DGT is an effective tool for in situ monitoring of trace antibiotics in complex urban wastewaters.     

表面活性剂对焦化污染土壤中多环芳烃淋洗修复研究

异位土壤淋洗是一种高效修复污染土壤技术。以孝义市某焦化厂污染土壤为研究对象,采用批处理实验,探究表面活性剂曲拉通-100(TX-100)、吐温80(TW80)、烷基糖苷(APG)作为淋洗剂对土壤中16种多环芳烃(PAHs)的淋洗效果,并以TW80为代表,考察了淋洗剂浓度、淋洗时间、pH以及淋洗方式对污染土壤中PAHs的去除效果。结果表明,TW80、TX-100和APG对土壤中16种PAHs的总去除率分别为25.67%、18.89%和16.77%。TW80作为淋洗剂,3环PAHs的去除率低于高环(3环)PAHs,主要与焦化污染土壤中以3环PAHs为主有关;高环PAHs随着环数的增加,去除率降低。焦化污染土壤中PAHs的去除在240min达到平衡;大部分PAHs去除率随TW80浓度的增加而增大;pH可不作调整;在TW80用量相同情况下,建议采用单次淋洗。     

场开挖爆破粉尘粒度分布特征杨房沟水电站料∗

通过分析杨房沟水电站料场开挖爆破粉尘的粒度分布特征,为改进爆破降尘工艺提供粉尘粒度学依据。在料场爆破区、工作平盘、出入沟、最终边帮等处采集粉尘样品,采用激光粒度分布仪测试粉尘样品的分散度;以粉尘粒度分布数据拟合分布函数,表明爆破粉尘的粒度分布函数呈现对数正态分布特征;与经典的罗森·拉姆勒(Rosin?Rammler)分布函数模型对比分析表明,对数正态分布函数用于描述爆破粉尘的粒度分布更加准确。基于对数正态分布函数模型,厘定爆破粉尘粒度分布参数,分析TSP、PM10、PM5、PM2.5及PM1粉尘占全尘的比例,定量表达爆破粉尘粒度分布特征。结果表明：杨房沟水电站料场爆破粉尘具有显著的对数正态分布特征;离爆破中心距离越远,粒度分布范围越窄,对人体有害粉尘占比越大;建议采用爆破粉尘捕捉吸附技术、掺和湿润性抑尘剂的水雾喷洒等降尘措施。     

Determination of Steroid Estrogens in Wastewater Treatment Plant of A Controceptives Producing Factory

Steroid estrogens such as estrone (E1), 17β-estradiol (E2), estriol (E3), and 17α-ethynylestradiol (EE2) have been suspected to be the main contaminants, which can affect the endocrine system of animals. Many authors have investigated these chemicals in the domestic wastewater treatment plants (WTP). However, wastewater from industries producing steroid contraceptives has not got ample attention. From the environmental point of view, the four steroids are very significant because even very low concentrations (ng/L) can cause reproductive disturbances in human, livestock and wildlife. The main purpose of the present investigation was to develop an analytical method for the determination of the four steroid estrogens present in WTP of a pharmacy factory, mainly producing contraceptive medicine in Beijing, China. Analysis was performed by solid-phase extraction (SPE) system and liquid chromatography combined with tandem mass spectrometry (LC/MS/MS). The average recoveries from effluent samples ranged from 88% to 103% and the precision of the method ranged from 9% to 4%. Based on 0.5-L wastewater samples, the limit of quantification (LOQ) was determined at 0.7 ng/L for E1, 0.8 for E2, 0.9 ng/L for E3, and 0.5 ng/L for EE2 in influent, and 1.0 ng/L for E2 and EE2, and 2.0 ng/L for E1 and E3 in effluent. In the influent samples, average concentrations of 80, 85, 73 and 155 ng/L were determined for E1, E2, E3 and EE2, respectively, showing that they were removed in this WTP to the extent of 79, 73, 85 and 67%, respectively.     

VOCs在线监测远程质量控制可行性研究

地表水水质自动监测要求对主要监测指标具备远程质量控制功能,而对挥发性有机物（VOCs）在线监测没有明确要求。采用自行设计的标准溶液储存装置和一套吹扫捕集-气相色谱-氢火焰离子化检测器/电子捕获检测器（P＆C-GC-FID/ECD）在线监测系统对水中19种VOCs组分开展了远程标准溶液测试。结果表明,19种VOCs组分在线加标回收率为88.8%～103.8%,在线多点线性测试相关系数为0.995 9～0.999 7,连续16 d标准溶液测试的示值误差范围为-18.91%～21.91%;VOCs在线监测系统远程质量控制是可行的,可实时监控仪器性能,有效预警预报水质状况。     

石家庄市春季大气颗粒物的铅污染特征

为了解石家庄市2016年春季大气颗粒物的铅污染特征及来源,利用单颗粒气溶胶质谱仪(SPAMS),分析了大气中含铅颗粒的化学成分。结果表明: 研究期间大气环境中含铅颗粒数浓度共出现11次跳跃式升高,跳跃时间段内石家庄均处于轻度污染过程。从成分分析来看,含铅颗粒分为纯铅颗粒、Pb与K(Pb-K)、OC(Pb-OC)、Cl(Pb-Cl)、混合颗粒等八大类。观测结果表明:Pb-K颗粒最多,占到含铅颗粒的84.4%;其次为纯铅颗粒,占比为13.0%。与石家庄市污染源谱库比对进行来源解析,得到Pb-K颗粒主要来自生活垃圾焚烧源, 纯铅颗粒主要来自工业源。结合石家庄市大气污染源排放清单和后向气流轨迹分析,推测含铅颗粒可能来自市区西南方向某区县的生活垃圾焚烧企业。     

ClO2三相催化氧化处理硝基苯生产废水的试验

硝基苯(NB)生产废水中含有大量NB及其衍生物,对生物具有毒性,属难生物降解物质.采用ClO2三相催化氧化工艺对NB废水进行处理.结果表明,每升废水投加280、350 mg ClO2,废水在活性炭加载含铜复合金属氧化物的催化剂床层停留56min,NB和色度的去除率均达到95%以上,COD去除率达到90%以上.吨废水处理成本约为10.5元.     

荧光法研究DNA与蒽相互作用机理

利用荧光猝灭光谱和紫外-可见吸收光谱研究了体外DNA对蒽的荧光猝灭机理.结果表明,DNA的紫外-可见光谱没有发生红移现象,通过计算分析不同温度下的荧光猝灭常数和热力学参数,结合两种光谱分析可知DNA对蒽的荧光猝灭属于动态猝灭机理.