核电营运安全文化主体考

提出并论述了核电营运单位是核电安全文化的主体 ,核电营运单位是核电安全的全面的法定负责者 ;阐明了核电营运安全文化的特性 ;介绍了核电安全文化的考核 ,重点说明了以WANO关于核电厂综合性能指标量化的考核。     

应用模糊数学评价和预测海河的水质状况

本文应用模糊数学的方法评价１９９１－１９９６年的海河水质状况,并建立高锰酸盐指数的灰色预测模型。     

Occurrence of arsenic in brown rice and its relationship to soil properties from Hainan Island, China

The acquaintance of arsenic concentrations in rice grain is vital in risk assessment. In this study, we determined the concentration of arsenic in 282 brown rice grains sampled from Hainan Island, China, and discussed its possible relationships to the considered soil properties. Arsenic concentrations in the rice grain from Hainan Island varied from 5 to 309 μg/kg, with a mean (92 μg/kg) lower than most published data from other countries/regions and the maximum contaminant level (MCL) for As_i in rice. The result of correlation analysis between grain and soil properties showed that grain As concentrations correlated significantly to soil arsenic speciation, organic matter and soil P contents and could be best predicted by humic acid bound and Fe-Mn oxides bound As fractions. Grain arsenic rises steeply at soil As concentrations lower than 3.6 mg/kg and gently at higher concentrations.     

潞城市大气PM10中化学元素分布特征

利用ICP-AES分析了潞城市采暖期和非采暖期4个不同功能区PM10样品中16种化学元素,对不同元素的时空分布特征进行了研究,并采用富集因子和主成分分析初步研究了潞城市PM10中元素的主要来源.结果表明,潞城市PM10中重金属污染较为严重,且各元素在采暖期的平均浓度均明显高于非采暖期.PM10中Ca、V、Cr、As、N...     

微波消解-自动电位滴定法测定生活垃圾中的氯含量

建立用微波消解技术处理城市生活垃圾样品,以自动电位滴定法测定城市生活垃圾中的氯含量.讨论微波消解条件、自动电位滴定仪工作参数、酸度及干扰情况,并对城市生活垃圾中的氯含量进行测定,相对标准偏差＜2.5%,回收率为97%～102.5%.     

一株耐铜细菌的鉴定及富集特性的研究

从铜矿污染区的土壤中分离纯化得到一株耐铜菌株USTB-E,最高耐受浓度为560 mg/L,通过形态观察,生理生化鉴定及16S rDNA序列分析技术鉴定出此菌株为假单胞菌。该菌的最适生长温度为35℃,pH为6.0,渗透压为0.3%。为了研究该菌耐铜机理,实验对铜离子富集机理进行了动力学研究,研究结果表明,USTB-E菌对...     

絮凝剂产生菌B-7的培养条件优化及生长动力学研究

从成都市土壤中筛选分离了1株具有稳定高效的微生物絮凝剂产生菌B-7。考察了碳源、氮源、温度、培养时间、pH等多种因素对絮凝剂（MBF-7）絮凝效果的影响。实验结果表明,该菌株产絮凝剂的最佳培养条件为：碳源为淀粉,氮源为硫酸铵,培养时间为72 h,初始pH为7.0,温度为30℃,对0.4%高岭土悬浊液的絮凝率达到91.3...     

三维电极-好氧生物法联合处理酸性染料废水模拟研究

采用电解-好氧生物法联合处理酸性大红G模拟废水,三维电解反应器填料为活性炭与玻璃珠混合物,平板电极材料为石墨,通过正交实验确定的最佳实验条件为：电解时间150min,活性炭／玻璃珠体积比为2：1,槽电压20V、pH为5、Na2SO4投加量1．5g／L,进水初始浓度2000mg／L。此时COD去除率及色度去除率分别可达49．78％和81．45％,废水BOD,／COD由0．12提高到0．42。电解后的废水采用生物接触氧化法处理12h后,出水COD为48mg／L,色度120倍,达到综合污水排放二级标准。     

The important role of microwave receptors in bio-fuel production by microwave-induced pyrolysis of sewage sludge

Microwave receptor plays an important role in the microwave pyrolysis of sewage sludge in view of its significant influence on the yield and property of bio-fuel products. The yield and the chemical compositions of bio-fuels (gases and oils) obtained from sewage sludge mixed with different receptors (graphite, residue char, active carbon or silicon carbide) were investigated in this study by Gas Chromatography (GC), Gas Chromatography-Mass Spectrometry (GC-MS), and Fourier Transform Infrared Spectroscopy (FTIR). The results showed that the use of silicon carbide gave rise to the highest final temperature of 1130 °C, resulting in the highest yield of gas fraction (up to 63.2 wt.%). The low heating rate (200 °C/min) which was attributed to the addition of residue char promoted condensation reactions and resulted in an increase in solid yield. The existence of active carbon could prolong the resistance time of volatiles in the hot zone owing to its porous structure, generating the maximum concentration of H₂ + CO (60%) in the pyrolysis gas. When graphite was used, the final low temperature favoured the cyclization of the alkenes, giving rise to a higher concentration of mononuclear aromatics in the pyrolysis oils. The model established in this study revealed that the quantity and quality of the products obtained from the microwave pyrolysis highly depended on the process conditions, which were influenced by the receptor significantly.