Comparison of the toxicogenetic potential of sewage sludges from different treatment processes focusing agricultural use

Environmental Science and Pollution Research - A problem that has been dragging in recent decades is the final disposal of the waste produced in the wastewater treatment process. In addition to its...     

Environmental remediation processes by zero valence copper: reaction mechanisms

Environmental Science and Pollution Research - Recent studies have shown Cu(0) as a promising material for the removal of organic and inorganic pollutants. However, there is no review addressing...     

Development of hybrid processes for the removal of volatile organic compounds,plasticizer, and pharmaceutically active compound using sewage sludge,waste scrap tires,and wood chips as sorbents and microbial immobilization matrices

Environmental Science and Pollution Research - This study evaluated the reutilization of waste materials (scrap tires, sewage sludge, and wood chips) to remove volatile organic compounds (VOCs)...     

Evaluation of the effectiveness of red mud-supported catalysts in combination with ozone and TiO<Subscript>2</Subscript> in the treatment of solution containing benzene,toluene, and xylene

Ozone and a Fe²⁺/TiO₂-based catalyst were examined in the degradation of a synthetic solution of benzene toluene and xylene (BTX) in an advanced oxidation process (AOP). The catalyst beads were made from the slurry waste of aluminum production process, by inserting the TiO₂ content and subsequent calcination. The reduction of the BTX concentration load was monitored by the reduction of chemical oxygen demand (COD) and BTX concentration. Different levels were used on factors: pH, time of treatment, initial concentration of BTX, and percentage of TiO₂. The process was conducted in a bubble column reactor with the insertion of catalyst beads. A response surface methodology technique (CCD) was used to build a model based on COD reduction results. The model was optimized using the normal-boundary intersection (NBI) algorithm to maximize COD reduction and minimize the variance attributed to the process. Optimization led to COD reductions of 80% in 2 h of experiment. Correlation analysis of coefficient models from experimental data R²_adj was 0.9966, showing a good fit of model data. In the optimized conditions, the possible increase of the biodegradability ratio of the BTX solution, through the biochemical oxygen demand (BOD) and COD, was also analyzed. Under pre-treatment conditions, the BOD/COD ratio was 0.13. After the treatment, it increased to 0.56.

Open image in new window

Graphical abstract ?

     

Effect of the Incorporation of Lysozyme on the Properties of Jackfruit Starch Films

Jackfruit starch based biodegradable films containing lysozyme were characterized for their antimicrobial activity, thickness, solubility, water vapor permeability and mechanical properties. The biodegradable films had good appearance and antimicrobial activity against Micrococcus lysodeikticus. The thickness of the biodegradable films were not affected by the variation in pH, but the addition of lysozyme increased the thickness, the thickest films being those with the highest lysozyme concentrations. The variation in pH of the filmogenic solutions affected the solubility of the biodegradable films, water solubility being greatest at pH 7.0 and with the highest lysozyme concentration. The permeability of the biodegradable films was increased by incorporating lysozyme. The lysozyme concentration and pH variation caused changes in the mechanical properties. The addition of 8% lysozyme increased the tensile strength and Young’s modulus for all the pH values studied. With respect to the release of antimicrobial activity, the diffusion of lysozyme was shown to follow Fickian transport mechanism.     

Storm water contamination and its effect on the quality of urban surface waters

We studied the effect of storm water drained by the sewerage system and discharged into a river and a small reservoir, on the example of five catchments located within the boundaries of the city of Poznań (Poland). These catchments differed both in terms of their surface area and land use (single- and multi-family housing, industrial areas). The aim of the analyses was to explain to what extent pollutants found in storm water runoff from the studied catchments affected the quality of surface waters and whether it threatened the aquatic organisms. Only some of the 14 studied variables and 22 chemical elements were important for the water quality of the river, i.e., pH, TSS, rain intensity, temperature, conductivity, dissolved oxygen, organic matter content, Al, Cu, Pb, Zn, Fe, Cd, Ni, Se, and Tl. The most serious threat to biota in the receiver came from the copper contamination of storm water runoff. Of all samples below the sewerage outflow, 74 % exceeded the mean acute value for Daphnia species. Some of them exceeded safe concentrations for other aquatic organisms. Only the outlet from the industrial area with the highest impervious surface had a substantial influence on the water quality of the river. A reservoir situated in the river course had an important influence on the elimination of storm water pollution, despite the very short residence time of its water.     

Concentrations of toxic heavy metals and trace elements in raw milk of Simmental and Holstein-Friesian cows from organic farm

Concentrations of toxic heavy metals (cadmium (Cd), lead (Pb)) and major nutritional and trace elements (Ca, Mg, P, Cu, Fe, Mn, Se, Zn) were analyzed in the milk of Simmental (n?=?20) and Holstein-Friesian (n?=?20) cows from an organic farm. Elements were determined using inductively coupled plasma emission atomic spectrometry. The conducted research showed that the milk of Simmental cows was characterized by the more advantageous mineral composition and lower concentration of noxious heavy metals compared to the milk of Holstein-Friesian cows. In the milk of Simmental cows, significantly lower concentrations of Pb and Cd (P?<?0.001) and Cu (P?<?0.05) and significantly higher concentrations of Fe and Mg (P?<?0.05) as well as nonsignificantly higher concentrations of Ca, Mn, and Se were found. In the milk of both breeds, very low Cu concentrations were recorded. The higher-than-recommended concentration of Pb in milk was also found. In the milk of both breeds, the significant positive correlations between concentrations of the following elements were observed: Pb–Cd, Pb–Se, Cd–Se, Cd–Mn, Zn–Cu, Zn–P, Ca–P, Ca–Mg, and Mg–P. The correlations between other elements within each of the analyzed breeds separately were also found.     

Biodegradation of Kupferschiefer black shale organic matter (Fore-Sudetic Monocline, Poland) by indigenous microorganisms

This study provides the first evidence for the direct biodegradation of persistent organic matter extracted from the organic-rich polymetallic black shale ore Kupferschiefer, one of the most important sources of metals in the world. It was demonstrated that an enriched community of indigenous heterotrophic microorganisms isolated from black shale grown under aerobic conditions could utilize shale organic matter as the sole carbon and energy source. Colonization of shale organic matter was observed. The main biodegradation intermediates and products such as phosphonic acid dioctadecyl ester and isoindole-1,3 were detected in the aqueous phase of cultures. The bacterial community showed the ability to PAH biodegradation, assimilation of organic acids and esters as well as lipase activity. The intracellular accumulation of phosphorus by bacteria during growth on organic matter was confirmed. Strains within the genus Pseudomonas were found to dominate the bacterial population at the end of the experiment. The results of this study confirm that indigenous bacteria are likely to play a role in the biotransformation of black shale and can influence the geochemical cycles of ancient organic carbon in the deep terrestrial subsurface. This process may also occur in tailings ponds containing black shale, and cause the mobilization of potentially toxic compounds to the soil and groundwater.     

The importance of the location of sodium chlorite application in a multipollutant flue gas cleaning system

In this study, removing sulfur dioxide (SO2), nitrogen oxides (NO(x)), and mercury (Hg) from simulated flue gas was investigated in two laboratory-sized bubbling reactors that simulated an oxidizing reactor (where the NO and Hg(0) oxidation reactions are expected to occur) and a wet limestone scrubber, respectively. A sodium chlorite solution was used as the oxidizing agent. The sodium chlorite solution was an effective additive that enhanced the NO(x), Hg, and SO2 capture from the flue gas. Furthermore, it was discovered that the location of the sodium chlorite application (before, in, or after the wet scrubber) greatly influences which pollutants are removed and the amount removed. This effect is related to the chemical conditions (pH, absence/presence of particular gases) that are present at different positions throughout the flue gas cleaning system profile. The research results indicated that there is a potential to achieve nearly zero SO2, NO(x), and Hg emissions (complete SO2, NO, and Hg removals and -90% of NO(x) absorption from initial values of 1500 ppmv of SO2, 200 ppmv of NO(x), and 206 microg/m3 of Hg(0)) from the flue gas when sodium chlorite was applied before the wet limestone scrubber. However applying the oxidizer after the wet limestone scrubber was the most effective configuration for Hg and NO(x) control for extremely low chlorite concentrations (below 0.002 M) and therefore appears to be the best configuration for Hg control or as an additional step in NO(x) recleaning (after other NO(x) control facilities). The multipollutant scrubber, into which the chlorite was injected simultaneously with the calcium carbonate slurry, appeared to be the least expensive solution (when consider only capital cost), but exhibited the lowest NO(x) absorption at -50%. The bench-scale test results presented can be used to develop performance predictions for a full- or pilot-scale multipollutant flue gas cleaning system equipped with wet flue gas desulfurization scrubber.     

Fate of PBDEs during food processing: Assessment of formation of mixed chlorinated/brominated diphenyl ethers and brominated dioxins/furans

The aim of this study was to evaluate effects of food processing on PBDE levels, in particular influence of heat treatment on degradation of PBDEs, including possible formation of chlorinated diphenyl ethers or brominated dioxins/furans as degradation products. It was shown that PBDEs heated in the presence of chlorine (from either organic or inorganic sources) formed mixed chlorinated/brominated diphenyl ethers. However, no PCDEs were formed in the presence of lipids. Lipid medium increased stability of PBDEs exposed to UV irradiation. Profile of congeners formed in result of the debromination reaction was significantly different than profiles observed by some other authors in aliphatic organic solvents. Grilling processes increased concentrations (calculated on the fresh product basis) of the studied compounds by 4–8/22–34% for electric/coal grill, respectively. Depending on the congener and on the applied heat treatment, PBDE mass in pork meat after grilling dropped by 26–53%. No detectable quantities of either brominated dioxins or furans were formed during thermal processing of food containing typical levels of PBDEs.