Feasibility of incorporating waste grass clippings (Lolium perenne L.) in particleboard composites

This study investigated some of the important physical (thickness swelling) and mechanical (modulus of rupture, modulus of elasticity and internal bond) properties of single-layer particleboard panels made from eucalyptus (Eucalyptus camaldulensis Dehn.), waste of grass clippings (Lolium perenne L.) and combinations of the two. The chemical properties (pH, holocelluse and alpha cellulose contents, and water, alcohol-benzene and 1% sodium hydroxide solubilities) of the raw materials were also determined. Panels with a 6:94 ratio of grass-to-eucalyptus particles had the required mechanical properties for interior fitments including furniture and general uses. Boards manufactured with 100% grass clippings exhibited the lowest quality. The overall panel properties improved with a lower percentage of grass clippings added. Based on initial results, it also appears that grass should compose no more than 13% to achieve acceptable panel properties for interior fitments and general uses.     

The modelling of a hybrid combined cycle with pressurised fluidised bed combustion and CO2 capture

This study investigates the possibility of capturing CO₂ from flue gas under pressurised conditions, which could prove to be beneficial in comparison to working under atmospheric conditions. Simulations of two hybrid combined cycles with pressurised fluidised bed combustion and CO₂ capture are presented. CO₂ is captured from pressurised flue gas by means of chemical absorption after the boiler but before expansion. The results show a CO₂ capture penalty of approximately 8 percentage points (including 90% CO₂ capture rate and compression to 110 bar), which makes the efficiency for the best performing cycle 43.9%. It is 5.2 percentage points higher than the most probable alternative, i.e. using a natural gas fired combined cycle and a pulverised coal fired condensing plant separately with the same fuel split ratio. The largest part of the penalty is associated with the lower mass flow of flue gas after CO₂ capture, which leads to a decrease in work output in the expander and potential for feed water heating. The penalty caused by the regeneration of absorbent is quite low, since the high pressure permits the use of potassium carbonate, which requires less regeneration heat than for example the more commonly proposed monoethanolamine. Although the efficiencies of the cycles look promising it will be important to perform a cost estimate to be able to make a fair comparison with other systems. Such a cost estimate has not been done in this study. A significant drawback of these hybrid cycles in that respect is the complex nature of the systems that will have a negative effect on the economy.     

Assessment of total urban metabolism and metabolic inefficiency in an Irish city-region

This paper aims to measure product and waste flows in an Irish city-region using the principles of metabolism and mass balance. An empirical indicator to measure resource efficiency, using a ratio of waste disposal as a function of product consumption, was developed and it was found that total materials metabolic inefficiency fell by 31% from 0.13 in 1996 to 0.09 in 2002. The paper concludes by analyzing the strengths and weaknesses of this indicator and its potential application in the field of sustainable consumption and resource efficiency as well as making suggestions to improve and strengthen the indicator.     

LEHR superfund stormwater runoff and putah creek mercury issues

Stormwater runoff from the University of California, Davis/U.S. Department of Energy Laboratory for Energy‐Related Health Research (UCD/US DOE LEHR) Superfund site located on the University of California campus in Davis, California, has been found to contain over 500 ng/L of total recoverable mercury, which is about ten times the California Toxics Rule criterion. This stormwater runoff is discharged to Putah Creek, which is Clean Water Act Section 303(d) listed as impaired for excessive mercury bioaccumulation in edible fish. A discussion is presented on the potential impact of the mercury in stormwater runoff from LEHR leading to excessive bioaccumulation of mercury in Putah Creek fish. The mercury in the stormwater runoff is derived from former flooding of the soils near the creek, which contains mercury derived from abandoned upstream mercury mines located in the Coast Range Vaca Hills to the west of LEHR. The implications of this situation for implementing a Total Maximum Daily Load (TMDL) to control mercury in stormwater runoff to Putah Creek are presented. © 2009 Wiley Periodicals, Inc.     

A Novel Method to Capture and Analyze Flow in a Gross Pollutant Trap Using Image-Based Vector Visualization

A novel method is developed to capture and analyze several experimental flow regimes through a gross pollutant trap (GPT) with fully and partially blocked screens. Typical flow conditions and screen blockages are based on findings from field investigations that show a high content of organic matter in urban areas. Fluid motion of neutral buoyant particles is tracked using a high-speed camera and particle image velocimetry (PIV) software. The recorded fluid motion is visualized through an image-based, line integral convolution (LIC) algorithm, generally suitable for large computational fluid dynamics (CFD) datasets. The LIC method, a dense representation of streamlines, is found to be superior to the point-based flow visualization (e.g., hedgehog or arrow plots) in highlighting main flow features that are important for understanding litter capture and retention in the GPT. Detailed comparisons are made between the flow regimes, and the results are compared with CFD data previously obtained for fully blocked screens. The LIC technique is a useful tool for identifying flow structures in the GPT and areas that are subjected to abnormalities difficult to detect by conventional methods. The novel method is found to be useful both in the laboratory and in the field, with little preparation and cost. The enhancements and pitfalls of the LIC technique along with the experimentally captured flow field are presented and discussed.     

The Effect of Masterbatch Addition on the Mechanical, Thermal, Optical and Surface Properties of Poly(lactic acid)

There has been considerable interest in the use of the biodegradable polymer poly(lactic acid) (PLA) as a replacement for petroleum derived polymers due to ease of processability and its high mechanical strength. Other material properties have however limited its wider application. These include its brittle properties, low impact strength and yellow tint. In an attempt to overcome these drawbacks, PLA was blended with four commercially available additives, commonly known as masterbatches. The effect of the addition of 1.5 wt% of the four masterbatches on the mechanical, thermal, optical and surface properties of the polymer was evaluated. All four masterbatches had a slight negative effect on the tensile strength of PLA (3–5% reduction). There was a four fold increase in impact resistance however with the addition of one of the masterbatches. Differential scanning calorimetry demonstrated that this increase corresponded to a decrease in the polymer crystallinity. However there was an associated increase in polymer haze with the addition of this masterbatch. The clarity of PLA was improved through the addition of an optical brightener masterbatch, but the impact resistance remained low. The glass transition and melting temperatures of PLA were not affected by the addition of the masterbatches, and no change was observed in surface energy. Some delay in PLA degradation, in a PBS degradation medium at 50 °C, was observed due to blending with these masterbatches.     

The contemporary cement cycle of the United States

A country-level stock and flow model for cement, an important construction material, was developed based on a material flow analysis framework. Using this model, the contemporary cement cycle of the United States was constructed by analyzing production, import, and export data for different stages of the cement cycle. The United States currently supplies approximately 80% of its cement consumption through domestic production and the rest is imported. The average annual net addition of in-use new cement stock over the period 2000–2004 was approximately 83 million metric tons and amounts to 2.3 tons per capita of concrete. Nonfuel carbon dioxide emissions (42 million metric tons per year) from the calcination phase of cement manufacture account for 62% of the total 68 million tons per year of cement production residues. The end-of-life cement discards are estimated to be 33 million metric tons per year, of which between 30% and 80% is recycled. A significant portion of the infrastructure in the United States is reaching the end of its useful life and will need to be replaced or rehabilitated; this could require far more cement than might be expected from economic forecasts of demand for cement.     

A note on the effectiveness of the house-arrest alternative for motivating DWI offenders to install ignition interlocks

Introduction

The effectiveness of ignition interlocks at reducing drunk driving has been limited by the ability of driving-while-intoxicated (DWI) offenders to avoid court orders to install the devices.

Methods

In a pilot program in New Mexico, four Santa Fe County judges imposed home confinement (via electronic monitoring bracelets) on offenders who claimed to have no car or no intention to drive. Interlock installation rates for Santa Fe County were compared with all other counties in New Mexico over a 2-year program and 2-year post-program period.

Results

During the two program years, 70% of the drivers convicted of DWI in Santa Fe County installed interlocks, compared to only 17% in the other counties, but when the program was terminated, the Santa Fe installation rate fell by 18.8 percentage points.

Summary

Mandating the alternative sanction of house arrest led to the highest reported interlock installation rate for DWI offenders.

Impact on Industry

Impaired driving is a substantial expense to employers, particularly when it bars driving that interferes with employment. Interlocks provide a method of protecting the public while permitting the offender to drive sober. This study was directed at increasing interlock use by DWI offenders.     

Evaluation of Caging Designs and a Fingernail Clam for Use in an In Situ Bioassay

Two cage designs and fingernail clams(Sphaerium fabale) were evaluated for theirsuitability for use in in situ bioassays toassess the ecological condition of a stream andpredict ecological recovery potential. One design(referred to as tray design) was a modified plastictray about one-fourth full of small gravels andcovered with 1 mm fiberglass mesh. The second design(referred to as tube-plates) consisted of shortplexiglass tubes about one-third full of small gravelsand attached horizontally to a plexiglass plate. Oneend of each tube faced into the current; both endswere covered with mesh. Cages containing clams weredeployed at reference and impacted (test) sites forperiods of 70 to 135 d. Growth and survival were theprimary endpoints evaluated, but the tube-platesallowed isolation of individual clams so that natalityalso could be evaluated as an endpoint. Results ofbenthic macroinvertebrate surveys, performed foranother study, were included to help validate bioassayresults. Both cage designs yielded good quantitative,site-specific results for clam survival and growth;results for natality, though, were less conclusive. Clam survival and growth results were in good generalagreement with the results for the benthicmacroinvertebrate community surveys. At a site wherethe macroinvertebrate community was the mostdepauperate, clam mortality was always rapid. At asite where the condition of the macroinvertebratecommunity was only slightly less impacted than themost impacted site, clam growth was almost alwayssignificantly lower than at reference sites. Survivalof clams was significantly reduced in <25 d at thissite in some trials, but in other trials there waslittle mortality. At a minimally impacted site, clamsurvival was similar to that found at reference sites,and differences in clam growth were not detectableuntil after 40 to 50 d of exposure. The tube-platedesign was easier to use, allowed more flexibility inselection of response parameters, and required lesshandling time of test animals, thus, this was thepreferred design. Our results demonstrated thateither in situ bioassay design can be used toaugment monitoring and assessment programs. Their useas a predictor of ecological recovery, however,requires further evaluation.     

Adaptation Scenarios of Agriculture in Poland to Future Climate Changes

This paper demonstrates the ability of Polish agriculture to adapt to predicted climate change according to GISS and GFDL scenarios. Both climate-change scenarios will significantly affect farming conditions in Poland through water deficit, shifts in planting and harvesting seasons, changes in crop yields and crop structure. Neither scenario seems to endanger the self-sufficiency of Poland as long as preventative measures are taken. Moreover, the realization of GISS creates the possibility of a surplus in production. It must be emphasized that regardless of the scenario, the adaptation of agriculture to an expected climate change cannot be handled by the farming community itself.