Use of biosurfactants from urban wastes compost in textile dyeing and soil remediation

A compost isolated humic acid-like (cHAL) material was pointed out in previous work for its potential as auxiliary in chemical technology. Its potential is based on its relatively low 0.4gL(-1) critical micellar concentration (cmc) in water, which enables cHAL to enhance the water solubility of hydrophobic substances, like phenanthrene, when used at higher concentrations than 0.4gL(-1). This material could be obtained from a 1:1 v/v mixture of municipal solid and lignocellulosic wastes composted for 15 days. The compost, containing 69.3% volatile solids, 39.6% total organic C and 21C/N ratio, was extracted for 24h at 65 degrees C under N2 with aqueous 0.1molL(-1) NaOH and 0.1molL(-1) Na4P2O7, and the solution was acidified to separate the precipitated cHAL in 12% yield from soluble carbohydrates and other humic and non-humic substances. In this work two typical applications of surfactants, i.e., textile dyeing (TD) and soil remediation by washing (SW), were chosen as grounds for testing the performance of the cHAL biosurfactant against the one of sodium dodecylsulfate (SDS), which is a well established commercial synthetic surfactant. The TD trials were carried out with nylon 6 microfiber and a water insoluble dye, while the SW tests were performed with two soils contaminated by polycyclic aromatic hydrocarbons (PAH) for several decades. Performances were rated in the TD experiments based on the fabric colour intensity (DeltaE) and uniformity (sigmaDeltaE), and in the SW experiments based on the total hydrocarbons concentration (CWPAH) and on the residual surfactant (Cre) concentrations in the washing solution equilibrated with the contaminated soils. The results show that both cHAL and SDS exhibit enhanced performance when applied above their cmc values. However, while in the TD case a significant performance effect was observed at the surfactants cmc value, in the SW case the required surfactants concentration values were equivalent to 25-125xcmc for cHAL and to 4-22xcmc for SDS. The vis-a-vis comparison of the two surfactants gave the following results: in the TD case the cHAL biosurfactant at 0.4gL(-1) yields good colour intensity and equal colour uniformity as SDS at 5gL(-1), in the SW case cHAL was found to enhance CWPAH by a factor of 2-4 relative to SDS with one soil, whereas with the other soil the two surfactants behaved similarly. The Cre data, however, showed that both soils absorbed by far more SDS (68-95%) than cHAL (12-54%). The results point out intriguing technological and environmental perspectives deriving from the use of compost isolated biosurfactants in the place of synthetic surfactants.     

Acoustic analysis of blast waves produced by rapid phase transition of LNG released on water

Massive offshore and onshore storage of fuel have led the international community to raise questions about the hazards on the surrounding installations and people. Among the possible accidental scenarios when cryogenic gas as liquefied natural gas (LNG) is spilled on water at a very fast rate, the phenomenon of rapid phase transition (RPT) may occur: large amounts of energy are released during phase transition which can generate explosions. The related consequences should be added to the possible consequences of fire in terms of flash fire, fireball, pool fire, and vapour cloud explosion for confined and congested geometry surrounding the release point.In this paper, the analysis of RPT of LNG has been studied from the point of view of blast wave production, through ab initio acoustic analysis for monopole source. Maximum overpressures, as calculated at the source point and along the blast pathway are compared with results of large scale experiments. Safety distances are given for the sake of comparison with threshold distances reported in the open literature.     

Impact of sublethal doses of 2,4-D, simulating drift, on tomato yield

Tomato is considered one of the most sensitive crops regarding 2,4-D drift. In many cases, such susceptibility has led to important restrictions in the use of 2,4-D based products. Field experiments were carried out for two consecutive years in tomato, by applying sublethal doses of 2,4-D (ranging from 0.42 to 13.44 g a.i. ha(-1)) directly to plants, at different stages of growth, as a simulation of eventual drifts to the crop. The range of rates was based on the assumption of a 0.0625-2.0% drift level of a 1 L ha(-1) of the most common formulated herbicides. For this crop, the range of rates between 0.42 and 13.44 g a.i ha(-1) applied at the beginning of flowering caused a linear crop reduction. On the other hand, rates < or = 13.44 g a.i. ha(-1) applied after full development of fourth truss stage or latter had no effect on crop yield or development. For tomato, tolerance to 2,4-D strongly increases with plant age.     

Global Biomass Energy Potential

The intensive use of renewable energy is one of the options to stabilize CO₂atmospheric concentration at levels of 350 to 550ppm. A recent evaluation of the global potential of primary renewable energy carried out by Intergovernmental Panel on Climate Change (IPCC) sets a value of at least 2800EJ/yr, which is more than the most energy-intensive SRES scenario forecast for the world energy requirement up to the year 2100. Nevertheless, what is really important to quantify is the amount of final energy since the use of renewable sources may involve conversion efficiencies, from primary to final energy, different from the ones of conventional energy sources. In reality, IPCC does not provide a complete account of the final energy from renewables, but the text claims that using several available options to mitigate climate change, and renewables is only one of them, it is possible to stabilize atmospheric carbon dioxide (CO₂) concentration at a low level. In this paper, we evaluate in detail biomass primary and final energy using sugarcane crop as a proxy, since it is one of the highest energy density forms of biomass, and through afforestation/reforestation using a model presented in IPCC Second Assessment Report (SAR). The conclusion is that the primary-energy potential for biomass has been under-evaluated by many authors and by IPCC, and this under-evaluation is even larger for final energy since sugarcane allows co-production of electricity and liquid fuel. Regarding forests we reproduce IPCC results for primary energy and calculate final energy. Sugarcane is a tropical crop and cannot be grown in all the land area forecasted for biomass energy plantation in the IPCC/TAR evaluation (i.e. 1280Mha). Nevertheless, there are large expanses of unexploited land, mainly in Latin America and Africa that are subject to warm weather and convenient rainfall. With the use of 143Mha of these lands it is possible to produce 164EJ/yr (1147GJ/hayr or 3.6W/m²on average) of primary energy and 90EJ/yr of final energy in the form of liquid fuel (alcohol) and electricity, using agricultural productivities near the best ones already achievable and biomass gasification technology. More remarkable is that these results can be obtained with the operation of 4,000 production units with unitary capacity similar to the largest currently in operation. These units should be spread over the tropical land area yielding a plantation density similar to the one presently observed in the state of São Paulo, Brazil, where alcohol and electricity have been commercialized in a cost-effective way for several years. Such an amount of final energy would be sufficiently large to fulfill all the expected global increase in oil demand, as well as in electricity consumption by 2030, assuming the energy demand of such sources continues to grow at the same pace observed over the last two decades. When sugarcane crops are combined with afforestation/reforestation it is possible to show that carbon emissions decline for some IPCC SRES scenarios by 2030, 2040 and 2050. Such energy alternatives significantly reduce CO₂emissions by displacing fossil fuels and promote sustainable development through the creation of millions of direct and indirect jobs. Also, it opens an opportunity for negative CO₂emissions when coupled with carbon dioxide capture and storage.     

A saprobic index for biological assessment of river water quality in Brazil (Minas Gerais and Rio de Janeiro states)

Based upon several years of experience in investigations with macrozoobenthos in rivers in the states of Minas Gerais and Rio de Janeiro, a biological assessment system has been developed to indicate pollution levels caused by easily degradable organic substances from sewers. The biotic index presented here is aimed at determining water’s saprobic levels and was, therefore, named the “Saprobic Index for Brazilian Rivers in Minas Gerais and Rio de Janeiro states” (ISMR). For this purpose, saprobic valences and weights have been established for 122 taxa of tropical macrozoobenthos. Investigations were carried out in little, medium sized and big rivers in mountains and plains. Through ISMR, a classification of water quality and the respective cartographic representation can be obtained. Data collection and treatment methods, as well as the limitations of the biotic index, are thoroughly described. ISMR can also be used as an element to establish complex multimetric indexes intended for an ecological integrity assessment, where it is essential to indicate organic pollution.     

A model of area fidelity,nomadism, and distribution patterns of loggerhead sea turtles (<Emphasis Type="Italic">Caretta caretta</Emphasis>) in the Mediterranean Sea

Sea turtle tagging carried out in Italy in the period 1981–2006 resulted in 125 re-encounters of loggerhead turtles (Caretta caretta) after a mean of 2.5 years, from different marine areas in the Mediterranean. At first finding, turtles ranged 25–83 cm of curved carapace length. Data were analyzed according to size, area, habitat type, season, in order to provide indication of movement patterns. When integrated with other information, results indicate that: (1) a part of turtles in the oceanic stage show a nomad behavior with movements among different oceanic areas; (2) another part show fidelity to an oceanic area; (3) turtles in the neritic stage show fidelity to neritic areas, and once settled to one area, change to other neritic areas is unlikely; (4) nomad oceanic turtles are significantly larger than sedentary ones, and also larger than turtles found in neritic areas; it is hypothesized that these could be Atlantic turtles that eventually leave the Mediterranean; (5) ecological transition from oceanic to neritic habitats occurs at a wide range of sizes, and some turtles may have a very brief oceanic stage; (6) turtles in the oceanic stage are more likely to recruit to neritic areas close to their oceanic areas than to distant ones; (7) part of turtles from some Mediterranean nesting beaches might frequent a relatively limited area range, including both oceanic and neritic areas; (8) in most of the Mediterranean, latitudinal seasonal migrations are unlikely. A general model of movement patterns of loggerhead turtles in the Mediterranean is proposed.     

Photocatalytic degradation of microcystin-LR in aqueous solutions

In this work, the photocatalytic degradation of aqueous microcystin-LR was studied using TiO₂ and ZnO as photocatalysts. The process was optimised and characterised at the bench scale (200 mL); both semiconductors exhibited a high degradation capacity at reaction times of 1 min (degradation greater than 95%). The transient species that were observed indicate that the degradation occurs via the multiple hydroxylation and elimination of the labile peptide residues of the molecule. When photocatalysis was applied in a continuous treatment system (20–50 L), the photocatalytic process exhibited a high degradation efficiency, which resulted in residual microcystin-LR concentrations that were less than 1 μg L^?1 (C₀ = 5 μg L^?1).     

PCDD/Fs and PCBs in ambient air in a highly industrialized city in Northern Italy

Ambient air samples were collected in five locations around a polychlorobiphenyl (PCB) production plant in a highly industrialized city in the north of Italy, for the analysis of polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs) and PCBs.PCDD/F atmospheric concentrations were lower than those generally detected in urban areas, while PCB concentrations were higher than in urban and industrialized areas in other countries, especially in the locations closest to the plant. To identify source emissions responsible for air pollution we used principal component analysis (PCA) to compare the “fingerprint” of the air in Brescia with some source-related experimental and published data. This analysis showed that the PCDD/F fingerprints were more similar to steel plant emission data, while none of the PCB air patterns were comparable to emission profiles, indicating that different sources are responsible for the concentration of these two pollutants. The highest PCB concentrations detected in the areas closest to the chemical plant are indicative of its impact on the surrounding environment.     

Persistent organic pollutants in sea bass (Dicentrarchus labrax L.) in two fish farms in the Mediterranean Sea

We analyzed polychlorobiphenyls (PCBs), perfluorooctanesulfonate (PFOS) and perfluorooctanoate (PFOA) in the edible part of farmed sea bass reared in two fish farms in Liguria (Northern Italy). The aim was to determine the contamination levels and human exposure to these chemicals through fish consumption. Concentrations of “dioxin-like” PCBs (DL-PCBs) ranged from 0.033 to 0.759 pg Σ_TEQ-PCB g⁻¹ whole weight (w.w.) in fish farm 1 and from 0.032 to 1.60 pg Σ_TEQ-PCB g⁻¹ w.w. in fish farm 2, and the six indicators of “non-dioxin-like” (NDL-PCBs) from 0.538 to 9.33 ng Σ_6PCB g⁻¹ w.w. and from 1.62 to 27.6 ng Σ_6PCB g⁻¹ w.w. Concentrations were generally lower in farm 1 than in farm 2. One reason for this difference might be the proximity of farm 2 to the seaport of La Spezia, which could be a punctual source of pollutants influencing the contamination of the water in the farm. Principal component analysis (PCA) showed differences also in the congeners profiles for the two sites, with higher-chlorinated PCBs more abundant in farm 1, and lower-chlorinated PCBs were more abundant in farm 2. Most of the concentrations of PFOS and PFOA were below the limit of detection (LOD 0.05 ng g⁻¹ w.w.). Only about 10% of the samples analyzed had levels slightly higher than the LOD. Assessments of exposure using these data showed that consumption of farmed fish may contribute significantly to PCBs through the diet, whereas the contribution of PFOS and PFOA seems to be low.