Preliminary risk analysis for LNG tankers approaching a maritime terminal

LNG ships may represent a remarkable risk source, especially when approaching a land terminal, not only due to the possible occurrence of maritime accident, but also since they may represent a suitable target for terrorist attacks. A preliminary risk analysis for LNG ships approaching the Panigaglia terminal is carried out: based on literature data and on the characteristics of the location, a spill originated from a sea accident can be excluded; on the contrary, intentional damages may cause the release of a large amount of LNG, giving rise to a pool fire. Consequence analysis shows that dangerous thermal effects are expected within a radius of 700–1500 m; in the location under exam, the impact on resident population will be negligible, for the most probable attack site, and marginal for an occasionally used anchorage, which should be no longer allowed.     

Organotins in the sediments of the Zuari estuary, west coast of India

Industrial use of organotins such as butyltins and phenyltins has increased several folds during the last two decades. Butyltins and phenyltins are synthetic, multipurpose chemicals, which have been extensively used in marine antifouling paints. They have been known to be extremely poisonous to mollusc fishery resources (oysters, clams, etc.). Contamination of Zuari estuary sediments was assessed by quantitative determination of butyltins and phenyltins by using GC-MS using the electron ionization mode. Butyltins predominated in the whole area over phenyltins. Butyltins contributed about 70-90% of the organotins in general. The concentration of butyltins in sediments ranged from 20 to 7621 ng Sn/g. The concentration of phenyltins in sediments ranged from 0 to 46 ng Sn/g. Degradation indices for butyltins and phenyltins were calculated. The Butyltin degradation index (BDI) for the Zuari sediments ranged from 0 to 2.7 indicating a lot of fresh input of butyltins in the estuary and a lower degradation rate. The phenyltin degradation index (PhDI) ranged from 1 to 10 implying that different processes were prevalent at different stations. The observed organotin levels in the Zuari estuary indicate some highly localized areas of contamination which are severe enough to cause harmful effects on marine flora and fauna. Therefore, there is a need to regulate the use of butyltins and phenyltins as biocides in marine antifouling paints.     

CO2 dispersion around two PWR nuclear power plants in Brazil

Atmospheric air samples were taken within 3 km from power plants encompassing five different distances and wind directions. Samples were taken between 2002 and 2005 aiming to evaluate the environmental ¹⁴C enrichment due to the operation of Brazilian nuclear power plants. The sampling system consisted of a pump connected to a trapping column filled with a 3 M NaOH solution. The trapped CO₂ was analyzed for ¹⁴C by using a single stage accelerator mass spectrometry (SSAMS).     

Spatial patterns and autocorrelation in the response of microarthropods to soil pollutants: The example of oribatid mites in an abandoned mining and smelting area

Although exogenous factors such as pollutants can act on endogenous drivers (e.g. dispersion) of populations and create spatially autocorrelated distributions, most statistical techniques assume independence of error terms. As there are no studies on metal soil pollutants and microarthropods that explicitly analyse this key issue, we completed a field study of the correlation between Oribatida and metal concentrations in litter, organic matter and soil in an attempt to account for spatial patterns of both metals and mites. The 50-m wide study area had homogenous macroscopic features, steep Pb and Cu gradients and high levels of Zn and Cd. Spatial models failed to detect metal–oribatid relationships because the observed latitudinal and longitudinal gradients in oribatid assemblages were independent of the collinear gradients in the concentration of metals. It is therefore hypothesised that other spatially variable factors (e.g. fungi, reduced macrofauna) affect oribatid assemblages, which may be influenced by metals only indirectly.     

Black layers on historical architecture

Background, aim and scope

The external surface of any building in urban polluted environment is unavoidably destined to be covered with layers that assume a grey to black colour and are generally called ‘black crusts’. These, according to standard protocols and glossary, are deteriorated surface layers of stone material; they can have variable thickness, are hard and fragile and can detach spontaneously from the substrate, which, in general, is quite decayed. Plain visual examination may lead to consider ‘black crusts’ all similar, whilst only a careful diagnostic investigation can distinguish ‘black crusts’ and the consequences of their formation on stone substrates. In this paper, various black layers on marble are studied and compared and the morphological and compositional characteristics discussed according to the related mechanisms of formation. Differences between old (hundred years) and recent crusts (30 years) are investigated and pointed out.

Materials and methods

Samples of black crusts collected from the Milan Cathedral façade (Candoglia Marble) have been studied and compared with the careful and synergic employ of traditional techniques: optical (transmission and reflected VIS light) and electron microscopy, X-ray spectrometry and micro-Fourier transform infrared spectroscopy.

Results

Visual examination of loose fragments does not allow to point out outstanding differences amongst the various samples; black layers have similar main mineral components, gypsum and airborne particles, with different spatial distribution. The microscopic studies allowed to point out the porosity differences, the gypsum crystallisation habit, different amount of embedded particles, level and progress of marble decay.

Discussion

The observations lead to define three main types of black crusts: black crust deriving from marble sulphation, compact deposit and encrustation due to exogenic materials deposition. Black crusts show evidence of sulphation in progress, without a clear continuity solution between crust and marble; the lack of separation is particularly evident in ‘recent’ crust, where the sulphation process is more active. Black compact deposits show a higher porosity than black crusts because gypsum is not coming from the chemical corrosion of the substrate but from outside; actually, in the former case, the substrate is sound. Encrustations show a highly regular crystal organisation of gypsum (close packed tabular crystals) that cannot be traced back to casual atmospheric deposit or to corrosion of the substrate but rather to the crystallisation of a solution coming from an external source. Also in this case, the marble is sound; evidence of the effect of some protection treatment is pointed out.

Conclusions

In spite of the apparent similarity of the examined samples, analytical results have evidenced three main types of black crusts: black crust with decayed substrate, compact deposit and black encrustation showing a sound substrate underneath. Experimental evidence of calcite grains sulphation in progress, taking place according to a model recently proposed, has been observed. Sulphation process is prevented where particular conservation treatments had been applied in the past.

Recommendations and perspectives

New experimental studies can be focussed to understand the specific conditions (measurements of micro-climatic and thermodynamic parameters) and mechanisms for black crusts formation in situ. The problem of the kinetic of the sulphation process of marble, the assessment of black layers formation in the case of different carbonate stone materials and the study of acid attack in presence of surface protecting layers deserve further investigation.     

Heat stress and crop yields in the Mediterranean basin: impact on expected insurance payouts

Insurance programmes have been indicated as a tool to reduce the economic risk associated with climate change, and crop growth simulation models can be used effectively to assess future trends in crop insurance payouts. This paper assesses the economic role of increasing weather extremes under future climate change on the expected insurance payouts for durum wheat (Triticum turgidum L. spp. durum) over the Mediterranean basin, focusing attention on the effects of heat stresses (HSs). A crop growth simulation, Sirius Quality version 2 (SQ2), calibrated for three varieties (long, medium and short growth cycle) was applied on seven sites under present (1975–1990) and future climate conditions (2030–2050) obtained from five regional circulation models under SRES scenario A1b. The intensity of HSs at anthesis was included as reducing factor of yield originally simulated by SQ2 calculated according to a specific empirical model. Simulated yields were then fitted to the most appropriate distribution, which was used to calculate the expected payouts according to the probability of yields being below a guaranteed level. We found that the simulated crop yields were, in general, negatively skewed and that Weibull probability density function (PDF), admitting negative skewing, provided the best performances in their fitting. The simulation of HSs modified the original shape of the Weibull PDF by increasing the skewness of the distribution. The results of the insurance model indicated that the modification of crop PDFs induced by HSs led to a general increase in payouts with respect to unstressed conditions, with a marked difference between present (+11 %, on average for the selected sites) and future periods (+25 %). When compared to the present, a general decrease in payouts (?1.1 %) was observed when HSs were not included in the simulations. Conversely, HSs impact resulted in a general increase in payouts (+10.3 %) where the highest increase was detected for the long growth cycle variety (+16.6 %) and the lowest for that with short growth cycle (?1.6 %). These results emphasize the importance of the appropriate characterization of crop yield distribution, the economic implications of HSs in a risk management context and a possible strategy to cope with climate change and variability.     

The importance of achieving a high customer satisfaction with recycling services in communities

Some studies show that there are external, infrastructural, and economic factors that enable individuals and communities to act ecologically. A variable associated with sustainable behavior is the level of satisfaction with infrastructural and economic factors, which in turn relates to recycling behavior. The main aim of this study was to assess the reliability and validity of the customer satisfaction with recycling scale and to analyze its relationship with sociodemographic variables (age and gender), house location (in the center or the suburbs, population size of), and psychological variables (self-reported individual recycling behaviors, general satisfaction with recycling service companies, and the perception of costs and the quality of service). A total of 1498 individuals responded to the in-home questionnaire related to these variables. Exploratory and confirmatory factorial analyses confirm a good fit for a four-dimensional model: assurance, tangibles, empathy, and communication. Results show that those individuals who live in town centers tend to self-report higher levels of satisfaction with tangibles than those living in the suburbs. Population sizes correlate significantly and negatively with the four dimensions of service satisfaction, while age seems to relate significantly and negatively to all the studied variables. Finally, we discuss the implications regarding the importance of customer satisfaction in facilitating the environmentally responsible behavior.     

Toxicity of mixtures of perfluorooctane sulphonic acid with chlorinated chemicals and lipid regulators

The toxicological interaction of perfluorooctane sulphonic acid (PFOS) with the chlorinated pollutants triclosan and 2,4,6-trichlorophenol and the lipid regulators gemfibrozil and bezafibrate was evaluated using the combination index-isobologram equation. The endpoint for bioassays was the growth rate inhibition of the green alga Pseudokirchneriella subcapitata. The results showed that most of the binary combinations assayed exhibited antagonism at all effect levels. The addition of a third component induced a less antagonistic or even synergistic behaviour. This was particularly marked for the ternary mixture of triclosan and 2,4,6-trichlorophenol with PFOS, for which synergism was very strong at all effect levels, with a combination index as low as 0.034 ± 0.002 at EC₅₀ for the mixture. The results obtained indicate that the evaluation of mixture toxicity from single component data using the concentration addition approach could severely underestimate combined toxicity.     

Estimation of measurement uncertainty associated to the determination of pesticide residues: a case study

In the analytical analysis the measurement uncertainty is a quantitative indicator of the confidence describing the range around a reported or experimental result within which the true value can be expected. Several approaches can be used to estimate the measurement uncertainty associated to the analysis of pesticide residues: a) the top-down, the estimation can be referred to default values; b) the bottom-up the estimation is related to the uncertainty sources. Concerning the bottom-up approach, the following contributions have been investigated: weight of sample, calibration solutions, final volume of sample and intermediate repeatability studies. The commodity/residue combination selected in this study was celery/tau-fluvalinate pesticide. Tau-fluvalinate is a broad-spectrum insecticide in the pyrethroid class of pesticides. The Maximum Residue Limit (MRL) of tau-fluvalinate in celery has been set at 0.01 mg/kg. The tau- Fluvalinate showed two chromatographic peaks. Since the individual standards are not available, the two peaks were integrated separately and the instrumental responses were added. The total residue was calculated on the basis of resulted peaks. The present work aims to compare the uncertainty estimated by experimental data using repeated analysis (n = 12) of a real sample and a spiked sample. The relative expanded uncertainty for two data set, incurred and spiked, was 22 % and 20 %, respectively. No differences were observed from repeated determinations of real samples and spiked samples.