铈改性Al_2O_3担载Pd催化剂的CO氧化性能研究

浸渍法制备了Al2O3+CeO2为载体的Pd催化剂,对制备中各因素对催化剂效果的影响作了初步研究.考察了活性组分含量与催化荆性能的关系以及焙烧温度、水蒸气对催化剂活性的影响.结果表明,稀土Ce元素的存在使催化剂的性能得到明显改善.制备过程中焙烧步骤对催化剂的活性影响很大,催化剂制备必须高于600 ℃焙烧.     

木棉基活性炭纤维吸附性能的研究

采用浸渍(NH₄)₂HPO₄化学活化法650℃时制备得到3种新型木棉基活性炭纤维,即只浸渍不预氧化方法处理的AK1(activated kapok),先浸渍后预氧化的AK-2和先预氧化后浸渍的AK-3。利用制备得到的活性炭纤维处理苯酚和亚甲基蓝的模拟废水,AK-2具有苯酚最大吸附量(137.00 mg/g),AK-1具有亚甲基蓝最大吸附量(274.11 mg/g)。吸附苯酚时,在静态平衡实验中,更符合Freundlich吸附等温线;在动力学实验中,更符合准一级反应。吸附亚甲基蓝时,在静态平衡实验中,AK-1更符合Langmuir模型,AK-2 、AK-3更符合Freundlich吸附等温线;在动力学实验中,更符合准二级反应。     

反渗透处理稀土氨氮废水试验研究

根据稀土冶炼厂排放的碳铵沉淀洗涤废水的水质情况,采用NH4Cl和 NaCl模拟废水进行了反渗透可行性对比实验。模拟实验发现,在相同条件下反渗透对NaCl 较NH₄Cl 有着更高的去除率,而NH₄Cl 相对NaCl则有着更高的产水速率。实际废水试验结果表明,在恒定操作压力范围内回收率为65%的条件下,NH₄Cl浓度为2.85 g/L的碳铵沉淀洗涤废水经反渗透处理其NH₄Cl去除率为77.3%,可作为氨氮废水的预处理。对该废水处理成本进行了分析,得出其约为2.7元/m³,比相近浓度氨氮废水的氨吹脱处理成本节省约26%。     

Cu~(2+)、Zn~(2+)对生物脱氮系统的影响

Cu2+和Zn2+是污水处理工艺中经常遇到的金属离子.在驯化好的活性污泥系统中,研究了金属离子Cu2+和Zn2+在0～100 mg/L浓度下对活性污泥牛物脱氮系统的影响.试验发现Cu2+＞5 mg/L、Zn2+＞30 ms/L时,对硝化过程具有明显的抑制作用,在同样浓度的试验条件下Cu2+对硝化过程的抑制作用比Zn2+大.Cu2+≤0.5 mg/L时对反硝化过程具有一定的促进作用,有助于提高TN的去除效果;Cu2+＞0.5 mg/L时,对反硝化产牛抑制作用,随着浓度的增加,TN去除率逐渐下降.Zn2+不影响反硝化过程,仅在大于30 mg/L时,对硝化过程产生抑制作用.重金属Cu2+对生物脱氮系统的影响明显强于Zn2+.     

壳聚糖复合絮凝剂处理造纸废水的实验研究

研究并考察了壳聚糖复合絮凝剂对造纸污水中COD和SS的絮凝效果,结果表明,当复合絮凝剂的配方和处理条件为：聚合硫酸铁（PFS）60 mg/L聚丙烯酰胺（PAM）2 mg/L壳聚糖（CTS）0.4 mg/L,pH为7.5时,其絮凝效果最佳,此时它对水中COD与SS的去除率分别达到57.4%和97.6%, 与传统絮凝剂PAC/PAM相比,COD与SS的去除率分别提高了10.1%和5.2%,药剂成本下降了21.1%,具有明显的经济效益与环境效益。     

TR-01稠油乳化降粘剂研究

针对河南油田井楼区块稠油,自制TR-01乳化降粘剂,通过实验研究了其降粘性能、稳定性,确定了降粘剂TR-01最佳浓度为0.3%、最佳油水比为70∶30。实验结果表明:TR-01乳化降粘剂对井楼区块油井的普遍适用性较强,具有较好的乳化降粘作用(降粘率达到99%以上),地层水对其降粘效果影响不大。其中的纳米成分能增加对污水中悬浮物的吸附能力和絮凝能力,对油田污水处理起到积极作用。     

CASS处理技术的原理和应用

介绍了CASS工艺的原理、特点、核心构筑物和设计、运行中应注意的主要问题以及常见故障的排除方法。     

青海省生态环境监测现状与建议

3C章阐述了青海省生态环境监测的现状分析了存在的问题提出了改进的建议。     

Biofiltration treatment of odors from municipal solid waste treatment plants

An in situ compost biofilter was established for the treatment of odors from biostabilization processing of municipal solid waste. The concentrations of total volatile organic compounds (VOCs) in odors and their components were measured. Biofilter media was characterized in terms of total carbon (TC), total nitrogen (TN), total phosphorus (TP), organic matter (OM), pH value and determination of bacterial colony structure. Gas chromatography–mass spectrometry (GC–MS) analysis showed that the main components of the produced gas were benzene, toluene, ethylbenzene and xylene (BTEX) along with other alkanes, alkenes, terpenes, and sulphur compounds. The compost biofilter had remarkable removal ability for alkylated benzenes (>80%), but poor removal for terpenes (～30%). Total VOC concentrations in odors during the biostabilization process period ranged from 0.7 to 87 ppmv, and the VOC removal efficiency of the biofilter varied from 20% to 95%. After about 140 days operation, TN, TC, TP and OM in compost were kept almost stable, but the dissolved N, NH₄–N and NO₃–N experienced an increase of 44.5%, 56.2% and 76.3%, respectively. Dissolved P decreased by 27.3%. The pH value experienced an increase in the early period and finally varied from 7.38 to 8.08. Results of bacterial colony in packing material indicated that bacteria and mold colony counts increased, but yeasts and actinomyces decreased along with biofilter operation, which were respectively, 3.7, 3.4, 0.04 and 0.07 times of their initial values.     

废聚碳酸酯水解法制双酚A

以1,4-二氧六环为溶剂、NaOH为催化剂,采用废聚碳酸酯(PC)常压水解法制双酚A(BPA).对反应影响因素进行了研究.实验结果表明,在反应温度为100℃、反应时间为8h、m(NaOH):m(水+溶剂)=1:33、m(溶剂):m(PC)=4:1、m(水):m(PC)=1:1的最佳反应条件下,PC水解率大于98%,BPA收率大于95%.