AOX contamination status and genotoxicity of AOX-bearing pharmaceutical wastewater

Adsorbable organic halogens(AOX) are a general indicator for the total amount of compounds containing organically bonded halogens. AOX concentrations and components were investigated along the wastewater treatment process in four large-scale pharmaceutical factories of China, and genotoxicity based on the SOS/umu test was also evaluated. The results showed that AOX concentrations in wastewater of four factories ranged from 4.6 to 619.4 mg/L, which were high but greatly different owing to differences in the raw materials and products. The wastewater treatment process removed 50.0%–89.9% of AOX, leaving 1.3–302.5 mg/L AOX in the effluents. Genotoxicity levels ranged between 2.1 and 68.0 μg 4-NQO/L in the raw wastewater and decreased to 1.2–41.2 μg 4-NQO/L in the effluents of the wastewater treatment plants(WWTPs). One of the main products of factory I, ciprofloxacin, was identified as the predominant contributor to its genotoxicity. However, for the other three factories, no significant relationship was observed between genotoxicity and detected AOX compounds.     

Determination of 15 phthalate esters in air by gas-phase and particle-phase simultaneous sampling

Based on previous research, the sampling and analysis methods for phthalate esters (PAEs) were improved by increasing the sampling flow of indoor air from 1 to 4 L/min, shortening the sampling duration from 8 to 2 hr. Meanwhile, through the optimization of chromatographic conditions, the concentrations of 9 additional PAE pollutants in indoor air were measured. The optimized chromatographic conditions required a similar amount of time for analysis as before, but gave high responsivity, the capability of simultaneously distinguishing 15 kinds of PAEs, and a high level of discrimination between individual sample peaks, as well as stable peak generation. The recovery rate of all gas-phase and particle-phase samples of the 15 kinds of PAEs ranged from 91.26% to 109.42%, meeting the quantitative analysis requirements for indoor and outdoor air sampling and analysis. For the first time, investigation of the concentration levels as well as characteristics of 15 kinds of PAEs in the indoor air from four different traffic micro-environments (private vehicles, busses, taxis and subways) was carried out, along with validation of the optimized sampling and analytical method. The results show that all the 9 additional PAEs could be detected at relatively high pollution levels in the indoor air from the four traffic micro-environments. As none of the pollution levels of the 15 kinds of PAEs in the indoor air from the 4 traffic micro-environments should be neglected, it is of great significance to increase the types of PAEs able to be detected in indoor air.     

基于环境质量管理的城市综合环境绩效评估研究

文章以26个省会城市2004~2013年的样本数据,从环境健康、生态保护、资源与能源利用、环境治理等4个方面开展研究,构建了包括4项二级指标、12项三级指标和26项四级指标在内的城市综合环境绩效指标体系。研究发现,大部分城市的综合环境绩效历年差异明显,东、中、西部的环境绩效有明显的差异。因此,文章认为应该进一步优化环境绩效指标体系,充分体现区域差异特点,通过实施城市综合环境绩效考核来提高城市环境质量管理水平。     

军绿有机涂层和金属漆涂层全浸泡下的腐蚀行为对比研究

目的针对车辆装备长期在高盐雾、高湿热、高日照等恶劣的气候环境下使用,会受到腐蚀影响的现状,探究现役军用有机涂层防护性能。方法采用电化学阻抗谱技术研究军绿有机涂层和金属漆涂层在3.5%NaCl溶液中的腐蚀电化学行为,分析这两种涂层在浸泡期间的电化学阻抗谱特征,通过拟合等效电路得到涂层电阻R_c和涂层电容C_c,并用这两个电化学参数评价军绿有机涂层和金属漆涂层的耐蚀性能。结果军绿有机涂层抗腐蚀介质渗透能力很强,而金属漆涂层抗腐蚀介质渗透能力稍弱。结论两种涂层都表现出很好的防护性能,且金属漆涂层在腐蚀后期的防护性能要优于军绿有机涂层。     

军绿有机涂层破损腐蚀行为研究

目的研究不同破损程度下军绿有机涂层的腐蚀行为,确定破损率对其防护性能变化的影响。方法通过人工制作不同的破损率,并利用电化学阻抗谱技术,研究不同破损程度下军绿有机涂层的电化学特征。结果根据不同破损程度下的军绿有机涂层的电化学特征,确定了涂层从完好到失效的四个阶段,初始完好阶段(破损率K≤0.0004%)、破损增大阶段(0.0016%K≤0.04%)、破损过大阶段(0.16%K≤1%)和失效阶段(4%K≤16%)。结论破损率K为0.04%的点是该涂层防护性能急转直下的转折点,因此破损率K大于0.04%时,应及时对车辆表面涂层进行修补和防护。     

金属尖化前缘模型主动式热疏导性能试验研究

目的为了更好地解决高超声速飞行器舵、翼前缘及头锥等气动热环境恶劣区域的热防护问题。方法采用主动式热疏导技术,以高温液态合金为工质,设计并制作具有主动式热疏导功能的尖化前缘金属试验模型(R=5 mm)。根据模型外尺寸设计加工一套石英灯仿形加热器和热流测试模型,开展地面热环境模拟试验。结果试件在前缘中心温度530℃左右时具有瞬态启动特性。前缘中心和大面积中心最大辐射热流密度分别为1000 kw/m^2和580 kw/m^2,试件在该环境中长时间受热状态下仍具有较好的热疏导能力。试验后试件无工质泄漏和结构破坏,具有一定的可重复使用性。结论可以此热疏导方式结合现有成熟热防护技术进一步开展工程设计与应用。     

间歇曝气SBR与传统SBR处理养猪沼液的比较研究

采用间歇曝气序批式反应器(intermittently aerated sequencing batch reactor,IASBR)和传统序批式反应器(SBR)处理养猪沼液,研究进水中化学需氧量(COD)与总氮(TN)比值(COD/TN)和运行负荷对污染物去除效果的影响.结果表明,在进水COD/TN约为2.2、氨氮负荷为(0.12±0.04)kg·(m3·d)-1时,IASBR中的氨氮、TN和有机物去除率分别为97.2%±4.4%、81.5%±7.5%、88.5%±2.4%,优于SBR的78.3%±19.6%、79.8%±4.9%、86.6%±3.2%;当氨氮负荷提高至(0.18±0.02)kg·(m3·d)-1时,IASBR中的氨氮、TN和有机物去除率略有降低,分别为92.4%±7.3%、77.5%±5.3%、86.4%±2.2%,但仍然优于SBR中的相应去除率78.1%±15.4%、61.8%±11.2%、81.8%±5.6%.在氨氮负荷为(0.20±0.01)kg·(m3·d)-1下,提高进水COD/TN至约3.0,则IASBR和SBR的污染物去除能力较进水COD/TN为2.2时有显著提升,IASBR中氨氮、TN和有机物去除率分别达到99.6%±0.2%、91.5%±2.9%和92.0%±0.9%,仍然高于SBR的90.2%±1.4%、83.0%±1.9%、90.2%±0.5%.总体而言,相较SBR,IASBR对TN和氨氮的去除更高效、耐冲击负荷能力更强,因此对养猪沼液等低碳氮比的废水更为适用.     

一株降解邻苯二甲酸酯真菌的筛选及其降解特性研究

采用富集培养法,从PAEs污染的农田土壤中筛选出1株邻苯二甲酸酯类化合物(PAEs)降解真菌F9,经形态学特征及18S rDNA序列分析,初步鉴定为爪哇正青霉(Eupenicillum javanicun).通过正交试验研究,得出菌株F9的最优降解条件是:C:N为20:1、pH为7.0、最佳PAEs初始浓度为50 mg·L^-1.菌株F9对土壤中复合PAEs(DMP、DEP和DOP)有良好的降解效果.在30 d培养期内,可将灭菌土壤中300 mg·kg^-1的PAEs降解65.2%,且培养第一阶段(0~15 d)的降解率远高于第二阶段(16~30 d).     

电子供体对地下水中高氯酸盐生物去除的影响研究

通过静态实验,考察了电子供体类型及用量对厌氧条件下微生物去除地下水中高氯酸盐的影响.结果表明,电子供体醋酸盐和H₂的加入,可以明显提高ClO₄^-的去除率,驯化后的微生物去除ClO₄^-的速率比未加入电子供体时提高约1.4~3倍.Monod动态模型能很好地拟合两种电子供体环境下ClO₄^-的微生物去除过程,分别以醋酸盐和H₂作为电子供体时,基质半饱和常数K_s为12.6 mg·L^-1和2.2 mg·L^-1,最大比基质消耗速率V_m为0.45 d^-1和0.08 d^-1.动力学参数表明,本实验条件下,异养型混合菌去除ClO₄^-的效果明显优于自养型混合菌;在少数受高浓度ClO₄^-污染的地下水环境中,为了提高ClO₄^-的去除速率只有通过增加菌体浓度或提高微生物酶的活性来实现.随着电子供体醋酸盐用量增加,ClO₄^-的(比)消耗速率逐渐增大.当初始CH₃COO^-与ClO₄^-的比例为3.80 mg(COD)/mg(ClO₄^-)时,比消耗速率v最大(0.27 d^-1).     

生活垃圾填埋过程含水率变化研究

为分析垃圾在好氧和厌氧条件下降解过程中含水率变化的规律,采用时域反射测量(time domain reflectometry,TDR)技术监测了垃圾填埋过程中含水率的变化情况.结果表明,填埋过程中垃圾体积含水率随时间逐渐增大,垃圾持水性能不断提高.好氧初期垃圾内水量变化与含水率变化正相关,好氧后期则为负相关;厌氧填埋过程中,垃圾沉降压缩是含水率变化的主要原因.垃圾TDR读数与基于物质衡算的垃圾体积含水率计算值之间有较好的相关性,好氧填埋过程两者最大偏差约为±5%,厌氧填埋过程两者最大偏差约为±2%,TDR技术适用于实际填埋工程的含水率测量.