悬挂链生物接触氧化工艺处理河道污水

采用悬挂链曝气式接触氧化工艺在3个时段内处理城市河道污水,通过采用磷脂法、TTC-脱氢酶活性法和MPN法研究载体表面生物膜特性,来验证装置的水质净化效果。结果表明,进水水质变化幅度较大的时段1内,水质对缺氧区和好氧区内生物膜量及活性有很大冲击,对污染物的去除效果影响不大,COD、NH+4-N、TN和TP的平均去除率分别达到75.9%、80.8%、64.6%和78.3%;进水水质稳定的时段2内,缺氧区和好氧区内生物膜量和活性要高于其他时段,COD、NH+4-N、TN和TP的平均去除率分别达到77.0%、80.6%、69.4%和55.3%;低温运行的时段3内,缺氧区和好氧区内生物膜量和活性都低于其他时段,水质净化效果明显下降,COD、NH+4-N、TN和TP的平均去除率分别为71.1%、68.5%、48.9%和46.6%。     

Simulating Land-Cover Change in Montane Mainland Southeast Asia

We used the conversion of land use and its effects (CLUE-s) model to simulate scenarios of land-cover change in Montane mainland southeast Asia (MMSEA), a region in the midst of transformation due to rapid intensification of agriculture and expansion of regional trade markets. Simulated changes affected approximately 10 % of the MMSEA landscape between 2001 and 2025 and 16 % between 2001 and 2050. Roughly 9 % of the current vegetation, which consists of native species of trees, shrubs, and grasses, is projected to be replaced by tree plantations, tea, and other evergreen shrubs during the 50 years period. Importantly, 4 % of this transition is expected to be due to the expansion of rubber (Hevea brasiliensis), a tree plantation crop that may have important implications for local-to-regional scale hydrology because of its potentially high water consumption in the dry season.     

Immobilization of Pb(II), Cd(II) and Ni(II) ions on kaolinite and montmorillonite surfaces from aqueous medium

The present study investigates the immobilization of Pb(II), Cd(II) and Ni(II) on clays (kaolinite and montmorillonite) in aqueous medium through the process of adsorption under a set of variables (concentration of metal ion, amount of clay, pH, time and temperature of interaction). Increasing pH favours the removal of metal ions till they are precipitated as the insoluble hydroxides. The uptake is rapid with maximum adsorption being observed within 180 min for Pb(II) and Ni(II) and 240 min for Cd(II). A number of available models like the Lagergren pseudo first-order kinetics, second-order kinetics, Elovich equation, liquid film diffusion and intra-particle diffusion are utilized to evaluate the kinetics and the mechanism of the immobilization interactions. Two isotherm equations due to Langmuir and Freundlich showed good fits with the experimental data. Kaolinite and montmorillonite have considerable Langmuir monolayer capacity with respect to Pb(II), Cd(II) and Ni(II), the values being in the range of 6.8-11.5mg/g (kaolinite) and 21.1-31.1mg/g (montmorillonite). The Freundlich adsorption capacity follows a similar order. The thermodynamics of the immobilization process indicates the same to be exothermic with Pb(II) and Ni(II), but endothermic with Cd(II). The interactions with Pb(II) and Ni(II) are accompanied by decrease in entropy and Gibbs energy while the endothermic immobilization of Cd(II) is supported by an increase in entropy and an appreciable decrease in Gibbs energy. The results have established good potentiality for kaolinite and montmorillonite to remove heavy metals like Pb(II), Cd(II) and Ni(II) from aqueous medium through adsorption-mediated immobilization.     

Fungal flora in indoor and outdoor air of different residential houses in Tekirdag City (Turkey): Seasonal distribution and relationship with climatic factors

This study was investigated the density and monthly distribution of indoor and outdoor microfungi in six different residential houses in Tekirdag City through the exposure of Petri dishes containing Rose-Bengal Streptomycin Agar media. Samples were collected in 1-month intervals over a period of 12 months between March, 2001, and February, 2002. We used 432 Petri dishes and counted a total of 4,205 microfungi colonies, 1,790 from indoor air and 2,415 from outdoor air. As a result, 42 species belonging to 12 genera were identified. The most frequent fungal genera were Penicillium (28.61%), Cladosporium (16.08%) and Alternaria (15.98%). While Penicillium (40.61%) and Cladosporium (15.92%) were the dominant genera of indoor air, Alternaria (20.62%) and Penicillium (19.71%) were isolated most frequently from outdoor air (Table 3). Alternaria citri (10.15%) and Penicillium brevicompactum (10.15%) were found to be the most frequent among the 42 identified species. While P. brevicompactum (19.55%) and Aspergillus niger (6.37%) were the most frequent indoor species, A. citri (13.37%) and Cladosporium cladosporioides (8.20%) were the most frequent outdoor species. Linear Regression Analysis was applied to determine whether or not there was a relationship between the number of colonies of isolated fungal genera and meteorological factors during the research period. Correlations between the presence of Aspergillus and temperature, relative humidity, duration of sunny periods and agents of air pollution such as SO(2) and PM were statistically significant. No significant correlations, however, were found between other fungal genera and environmental variables.     

Season-dependent mineral accumulation in fruits of Okra (Abelmoschus esculentus) and Tomato (Lycopersicon esculentum)

Season-dependent mineral accumulation was recorded in fruits of Okra and Tomato. The highest concentration was in summer in Okra and in winter in Tomato. Lowest concentrations were in winter in Okra and rainy in Tomato. Both crop plants indicated that the mineral contents were in the order of P > K > Ca > Mg > Na > Fe which also signify their relative functional importance in growth and metabolism.     

基于野外数据建立大型底栖动物电导率水质基准的可行性探讨

科学合理地设定水质基准是水生生物保护和水生态系统恢复的基础。水体电导率数值的高低由溶解于其中的各种阴阳离子的浓度所决定,而较多的研究也证明电导率能够显著地影响水生生物类群,特别是大型底栖动物物种存活和群落结构的稳定性。离子组成的复杂性,导致无法开展基于室内实验的水生生物电导率基准值的推导。本文借鉴美国环境保护局基于野外调查数据建立电导率基准值的方法,采用流行病学打分方法,分别从电导率是否对大型底栖动物敏感物种存在毒性效应、人为干扰的增强是否会通过电导率产生毒性作用,以及其他环境因子是否对电导率基准值的制定产生影响3个方面,探讨了基于野外数据建立我国电导率基准的可行性。研究区域为辽河流域的浑河及太子河,野外调查数据采集于2009年8月至2010年5月。研究结果表明,电导率的升高显著降低了大型底栖动物敏感物种的出现频率。通过分析研究区域土地利用方式同电导率之间的相关性,证明了农业和城镇建设用地比例的增加显著地增加了水体中电导率的数值。对有可能引起物种消失的其他环境因子进行分析,结果表明电导率是引起大型底栖动物消失的主要原因。综合以上结果,基于野外调查数据来建立大型底栖动物电导率基准值是可行的,为我国水质基准的研究提供了新的思路和方法。     

Occurrence and migration of microplastics and plasticizers in different wastewater and sludge treatment units in municipal wastewater treatment plant

● Reduce the quantifying MPs time by using Nile red staining. ● The removal rate of MPs and PAEs in wastewater and sludge were investigated. ● MPs and PAEs were firstly analyzed during thermal hydrolysis treatment. ● The removal of PAEs from wastewater and sludge was mainly biodegradation. Microplastics (MPs) and plasticizers, such as phthalate esters (PAEs), were frequently detected in municipal wastewater treatment plants (MWTP). Previous research mainly studied the removal of MPs and PAEs in wastewater. However, the occurrence of MPs and PAEs in the sludge was generally ignored. To comprehensively investigate the occurrence and the migration behaviors of MPs and PAEs in MWTP, a series of representative parameters including the number, size, color, shape of MPs, and the concentrations of PAEs in wastewater and sludge were systematically investigated. In this study, the concentrations of MPs in the influent and effluent were 15.46±0.37 and 0.30±0.14 particles/L. The MP removal efficiency of 98.1% was achieved and about 73.8% of MPs were accumulated in the sludge in the MWTP. The numbers of MPs in the sludge before and after digestion were 4.40±0.14 and 0.31±0.01 particles/g (dry sludge), respectively. Fourier Transform Infrared Spectroscopy (ATR FT-IR) analysis showed that the main types of MPs were polyethylene terephthalate (PET), polypropylene (PP), polyethylene (PE), and polystyrene (PS). Six PAEs, including phthalate (DMP), diethyl phthalate (DEP), diisobutyl phthalate (DIBP), ortho dibutyl phthalate (DBP), butyl benzyl phthalate (BBP), and bis(2-ethyl) hexyl phthalate (DEHP), were detected in the MWTP. The concentrations of total PAEs (ΣPAEs) in the influent and effluent were 76.66 and 6.28 µg/L, respectively. The concentrations of ΣPAEs in the sludge before and after digestion were 152.64 and 31.70 µg/g, respectively. In the process of thermal hydrolysis, the number and size of MPs decreased accompanied by the increase of the plasticizer concentration.     

电子废弃物聚丙烯制备木塑复合材的研究

探讨了电子废弃物聚丙烯(PP)制备木塑复合材料(WPC)的可行性及其主要影响因子。研究结果表明:电子废弃物PP具备制备木塑复合材料的可行性,PP和木纤维混合比例是影响WPC性能的关键因子之一,加入适量的PPg-MAH有利于提高WPC的力学性能,并大幅度降低其吸水性,当PP与木纤维比例为60∶40,PP-g-MAH使用量为10%时,WPC可获得较好的综合性能指标。     

In vitro biotransformation of PBDEs by root crude enzyme extracts: Potential role of nitrate reductase (NaR) and glutathione S-transferase (GST) in their debromination

In order to investigate the enzyme transformation of PBDEs and to track the key enzymes involved in PBDE degradation in plants, in vivo exposure of plants of ryegrass, pumpkin and maize and in vitro exposure of their root crude enzyme extracts to PBDEs were conducted. Degradation of PBDEs in the root crude enzyme solutions fit well with the first order kinetics (R² = 0.52–0.97, P < 0.05), and higher PBDEs degraded faster than the lower ones. PBDEs could be transformed to lower brominated PBDEs and hydroxylated-PBDEs by the root crude enzyme extracts with debromination as the main pathway which contributed over 90% of PBDE depletion. In vitro and in vivo exposure to PBDEs produced similar responses in root enzyme activities of which the nitroreductase (NaR) and glutathione-transferase (GST) activities decreased significantly, while the peroxidase, catalase and cytochrome P-450 activities had no significant changes. Furthermore, higher enzyme concentrations of NaR and GST led to higher PBDE debromination rates, and the time-dependent activities of NaR and GST in the root crude enzyme extracts were similar to the trends of PBDE depletion. All these results suggest that NaR and GST were the key enzymes responsible for PBDE degradation. This conclusion was further confirmed by the in vitro debromination of PBDEs with the commercial pure NaR and GST.     

基于BDPs的多级土壤渗滤系统处理受污染河水的试验研究

针对受污染的流入滇池的河流河水,采用具有曝气段和缺氧段的两段式多级土壤渗滤(multi-soil-layering,MSL)系统,开展了在缺氧段添加非水溶性可生物降解多聚物(BDPs)材料PBS颗粒的强化脱氮除磷研究.结果表明,添加PBS碳源可有效解决传统MSL系统因碳源不足而导致的脱氮效果不理想的问题.在河水污染较轻及较重两种情况下,系统对TN的平均去除率分别达到78%、85%,平均单位表面去除负荷分别为9.09g·m-·2d-1、24.55g·m-·2d-1;TP平均去除率分别达到92%、98%,平均单位表面去除负荷分别为0.76g·m-·2d-1、2.02g·m-·2d-1.此外,系统对COD的平均去除率可达到75%以上.