垃圾渗滤液中典型内分泌干扰物质(EDCs)细胞毒性分析

垃圾渗滤液的人类健康风险评估日益受到人们重视,也成为研究热点。本文采用一种新型高级氧化技术UV-Fenton处理渗滤液,并用人体乳腺癌细胞(MCF-7)评估处理过程中渗滤液原液以及渗滤液中典型内分泌干扰物质(EDCs)的细胞毒性,对垃圾渗滤液中EDCs的细胞毒性和变化规律进行了研究。结果表明渗滤液中的邻苯二甲酸二丁酯(DBP)、双酚A(BPA)、壬基酚(NP)是产生细胞毒性的主要物质,其毒性大小为DBPBPANP。在同样的氧化降解过程中显示出不同毒性变化规律,通过GC-MS分析,结果显示UV-Fenton过程中产生了大量的中间产物,这也是引起毒性变化的主要原因。实验结果也说明垃圾渗滤液细胞毒性可以通过UV-Fenton过程有效去除。     

De novo formation of dioxins from milled model fly ash

Environmental Science and Pollution Research - Municipal solid waste incineration (MSWI) fly ash has been classified as hazardous waste and needs treatment in an environmentally safe manner....     

Distribution and controls of heavy metals and organic matter in the surface sediments of the Southern Yellow Sea,China

Environmental Science and Pollution Research - Accurate and effective determination of the source of heavy metals is essential for the treatment of marine ecological environments. This article...     

Environmental monitoring of alcohol sulfates and alcohol ethoxysulfates in marine sediments

The study describes the environmental monitoring of anionic surfactants―alcohol sulfates (AS) and alcohol ethoxysulfates (AES)—in marine sediments. Concentration values were obtained after pressurised liquid extraction (PLE) and liquid chromatography–tandem mass spectrometry analysis (LC–MS/MS). Samples were collected from a range of wastewater discharge points along the coast of the provinces of Huelva, Málaga, Granada and Almería. Urban, agricultural and industrial wastewaters are discharged at the selected 38 sampling sites. Principal component analysis was carried out in order to evaluate the distribution and behaviour of these compounds in these coastal environments. Evaluation of the data revealed that the behaviour and sources of AS and AES in marine sediments are different, and that the distribution of AES depends on the length of the alkyl chain, while the number of ethoxylated units is not relevant. Additionally, the 38 sampling sites can be grouped into only two types of outfalls according to their AS distribution. The concentration of compounds in sediment samples ranged from 7.52 to 13.50 mg kg^?1 for AS, from 3.04 to 10.68 mg kg^?1 for AES–C₁₂E_x and from 3.83 to 11.56 mg kg^?1 for AES–C₁₄E_x.     

The adsorption process during inorganic phosphorus removal by cultured periphyton

To explain the detailed process involved in phosphorus removal by periphyton, the periphyton dominated by photoautotrophic microorganisms was employed in this study to remove inorganic phosphorus (P _i ) from wastewater, and the removal kinetics and isotherms were then evaluated for the P _i removal process. Results showed that the periphyton was capable of effectively removing P _i that could completely remove the P _i in 24 h at an initial P _i concentration of 13 mg P L^?1. Furthermore, the P _i removal process by the periphyton was dominated by adsorption at initial stage (~24 h), which involved physical mechanistic process. However, this P _i adsorption process was significantly influenced by environmental conditions. This work provides an insight into the understanding of phosphorus adsorption by periphyton or similar microbial aggregates.

溴酸钾对二茂铁(Fc)非均相Fenton效能的影响

研究了KBrO3对二茂铁(Fc)非均相Fenton效能的影响,深入考察了KBrO3对体系中Fc溶解、H2O2分解和羟基自由基(·OH)生成的影响。结果表明,KBrO3的加入对不同反应阶段Fc/Fenton体系的效能均有明显的促进作用,初始阶段主要是由于KBrO3对·OH产生的促进作用所致,后期主要是由于KBrO3促进了体系中Fc的溶解,使得体系中溶解态的Fc催化的均相Fenton反应的比例增加,体系中H2O2的分解加快,·OH的表观生成率增加,进而促进了反应的进行。无KBrO3添加,pH=4,MB初始浓度为10 mg/L,Fc的量为1.6×10-3mol/L,[H2O2]/[MB]=3.14时,45 min时,MB的剩余率为9.1%,105 min时为0。当KBrO3的用量为3×10-4mol/L时,反应45 min后MB的去除率即可达到100%。随着KBrO3浓度的增加,其对Fc/Fenton效能的促进作用增强。     

不同运行模式对同步脱氮除磷CAST工艺快速启动及其稳定维持的影响

以实际生活污水为处理对象,考察了传统进水/曝气和改良型分段进水的交替缺氧-好氧(A/O)2种运行模式对CAST工艺的快速启动及脱氮除磷性能稳定维持的影响。结果表明,传统进水/曝气运行模式下,系统达到最佳营养物去除性能所需启动时间30 d,稳定运行阶段TN平均去除80.66%,磷的去除率维持在66.30%左右;采用改良型交替运行模式,反应器达到稳定运行状态仅需18 d,系统稳定运行时TN平均去除81.36%,磷去除率稳定维持在90%以上,出水磷浓度在0.3 mg/L以下,出水水质达到国家污水综合排放标准一级A(GB8978-2002)。研究还发现,传统运行模式下,由低温引起的污泥沉降性能变差导致系统污泥严重流失,反应器几乎丧失污染物去除性能;而低温对交替运行模式下的反应器除磷性能几乎没有影响,总氮去除则因氨氮不完全硝化而大大降低。     

电镀污泥的热处理特性以及对金属回收的影响

焙烧-酸浸法可有效回收电镀污泥中的有价金属,而污泥的热处理特性是决定能否采用焙烧预处理的重要因素。研究了氧化焙烧和还原焙烧对污泥成分和金属浸出性的影响,并对焙烧前后的污泥进行了金属形态分析和X射线衍射(XRD)分析。结果表明,焙烧预处理实现了污泥减量和金属富集;ES1经氧化焙烧后金属浸出率接近原泥,Cu的浸出率达99%;ES2的还原焙烧效果优于氧化焙烧,特别是Cu的浸出率超过97%,XRD分析发现,还原焙烧过程中金属Cu被还原为铁铜合金;2种焙烧均造成了ES3中目标金属Ni的浸出率的降低;金属浸出性的下降与残渣态的形成有关。     

Treatment of 1,3-Butadiene in an Air Stream by a Biotrickling Filter and a Biofilter

ABSTRACT

This paper presents results obtained from a performance study on the biotreatment of 1,3-butadiene in an air stream using a reactor that consisted of a two-stage, in-series biotrickling filter connected with a three-stage, in-series biofilter. Slags and pig manure-based media were used as packing materials for the biotrickling filter and the biofilter, respectively. Experimental results indicated that, for the biotrickling filter portion, the butadiene elimination capacities were below 5 g/m³/hr for loadings of less than 25 g/m³/hr, and the butadiene removal efficiency was only around 17%. For the biofilter portion, the elimination capacities ranged from 10 to 107 g/m³/hr for loadings of less than 148 g/m³/hr. The average butadiene removal efficiency was 75–84% for superficial gas velocities of 53–142 m/hr and a loading range of 10–120 g/m³/hr. The elimination capacity approached a maximum of 108 g/m³/hr for a loading of 150 g/m³/hr. The elimination rates of butadiene in both the biotrickling filter and biofilter were mass-transfer controlled for influent butadiene concentrations below about 600 ppm for superficial gas velocities of 29–142 m/hr. The elimination capacity was significantly higher in the biofilter than in the biotrickling filter. This discrepancy may be attributed to the higher mass-transfer coefficient and gas-solid interfacial area offered for transferring the gaseous butadiene in the biofilter.     

Fingerprinting of High Boiling Hydrocarbon Fuels,Asphalts and Lubricants

Fingerprinting of hydrocarbon products requires high resolution differentiation of individual hydrocarbon compounds in any mixture. This requires the applications of various measuring techniques. In this paper, we have chosen the heavy hydrocarbons in fuels, lubricants and paving material as examples to discuss the methods for chemical characterization and differentiation. In the category most frequently termed "semi-volatile hydrocarbons" with boiling points from about 500°F to 1200°F or higher, there are several families of hydrocarbons, both natural and refined that are not easily distinguished by conventional EPA tests. Among the groups which we will use as examples are asphalts, hydraulic fluid, transmission oil, motor lubricating oils, heating oils, crude oil and coal. These hydrocarbon families are best studied using combined gas chromatography-mass spectrometry in full scan mode and characterizing various homologous series of hydrocarbons at known fragment ions. The hydrocarbon series providing the best information are: (1) N -alkanes; (2) iso-alkanes; (3) steranes; (4) terpanes; (5) polynuclear aromatic hydrocarbons; (6) aromatic steranes; and (7) specific polycyclic compounds.