多孔聚合物载体与活性炭载体用于厌氧流化床处理有机废水的比较

比较了多孔聚合物载体 (HP)与颗粒活性炭载体 (GAC)厌氧流化床处理合成废水与造纸废水时的性能 .研究表明 ,HP载体反应器处理合成废水时 ,进料COD容积负荷最大 65.6kg/(m³·d)时 ,COD去除率为 84% ,沼气容积产气率为 16.5m³/(m³·d) ;GAC载体反应器最大进料COD负荷 63.26kg/(m³·d)时 ,COD去除率为74.2% ,沼气容积产气率为 14.5m³/(m³·d) .HP载体处理造纸废水 ,反应器进料COD容积负荷为 14.5～36.15kg/(m³·d)时 ,COD去除率为 64.7%～54.5% ,沼气产气率为 1.89～2.7m³/(m³·d) ;GAC载体进料COD容积负荷为 9.16～19.06kg/(m³·d)时 ,COD去除率为 61.0 %～52.1% ,沼气产气率为 0.73～2.01m³/(m³·d) .微生物固定化效果、废水处理效率及综合经济性HP载体反应器明显优于GAC载体反应器 .     

防范化解区域生态环境风险的技术支撑及研究展望

生态环境安全是国家安全的重要组成部分.当前,生态环境风险已经成为社会主要风险源之一,为做好生态环境风险防范化解工作,着力打造"山清水秀、美丽宜居"的生态环境,文章在识别区域生态环境问题的基础上,提出了通过建立环境风险防控重点实验室,系统研究区域环境风险防控技术体系的构想,以期为防范化解区域生态环境风险提供技术支撑.     

福州CRT产业集群废物产生特征及管理模式研究

根据对福州开发区阴离子射线管(CRT)产业集群进行调查、访谈和统计分析,实证研究了该产业集群的废物产生特征和管理模式.结果发现,福州CRT产业集群在不断发展壮大的同时,随着主导产品生产规模的扩大以及配套企业的进入,废物的产生总量不断增加,单位主导产品的废物产生强度持续上升,废物种类也逐渐丰富,给区域环境带来的压力不断增大;但同时,产业集群借助其规模和集聚效应,不仅为废物交换和工业共生体系的构建提供了基础平台,而且为专营性废物回收组织和处理处置设施的良好运转营造了外部环境.     

聚合铝铁对A2/O系统 EPS及生物絮凝性能的影响

通过向实验室构建的A2/O模型好氧池末端投加聚合铝铁(PAFC)来强化系统的生物除磷,使得出水总磷达到《城市污水处理厂污染物排放标准GB 18918-2002》中的一级A标准,并重点分析投加的PAFC对A2/O系统中活性污泥胞外聚合物(EPS)和活性污泥生物絮凝性能的影响.结果表明,随着PAFC投药量的增加,A2/O系统活性污泥EPS总量变化不大,但EPS组分中蛋白/多糖含量的比值逐渐降低,由投药前的3.30降低至投药后的2.30;EPS中金属离子含量逐渐增加,在厌氧-缺氧-好氧的运行周期内,各处理单元污泥的EPS中金属铝离子含量增加.投加PAFC后,活性污泥颗粒变大,二沉池出水的Zeta电位明显降低,由投药前-15.83 mV降低至-21.20 mV,污泥产量增加.因此,适量投加PAFC后,生物絮凝性能得到改善,出水中悬浊颗粒减少,出水水质变好.     

制药废水处理生物技术的有效性

制药废水处理生物技术有效性的研究结果表明,XZEH公司原有处理方法的出水COD不能达到国家一级排放标准,其原因是缺少28%的曝气反应池体积.如果应用工程菌株Xhhh和Ebis信息软件的双重优化技术,可使生物负荷效率提高128%,所需曝气池体积可降低51%.对于提高制药废水的生物处理技术有效性和实现达标排放具有技术潜力.     

Ni2+改性的Cu-ZSM-5催化分解NO的性能

研究 Ni²⁺改性的 Cu^- ZSM-5催化剂在无氧和有氧气氛下的 NO分解反应性能 ,考察 Ni²⁺的加入量及加入方式对 Cu-ZSM-5催化剂 NO分解活性的影响 .结果表明 ,先交换适量 Ni²⁺再交换 Cu²⁺的 Ni-Cu-ZSM-5催化剂较单组分 Cu-ZSM-5催化剂有较高的高温 (500℃～600℃) NO分解活性 .在含 5.5% O₂ 的反应气氛中 ,Ni-Cu-ZSM-5在 500℃下的 NO分解率较之 Cu-ZSM-5高出约 20% ,Ni²⁺的引入显著提高了催化剂的抗氧活性 .就 Ni²⁺对 Cu-ZSM-5催化剂的可能改性机制进行了讨论 .     

Revealing the changes of bacterial community from water source to consumers tap: A full-scale investigation in eastern city of China

This study profiled the bacterial community variations of water from four water treatment systems, including coagulation, sedimentation, sand filtration, ozonation-biological activated carbon filtration (O₃-BAC), disinfection, and the tap water after the distribution process in eastern China. The results showed that different water treatment processes affected the bacterial community structure in different ways. The traditional treatment processes, including coagulation, sedimentation and sand filtration, reduced the total bacterial count, while they had little effect on the bacterial community structure in the treated water (before disinfection). Compared to the traditional treatment process, O₃-BAC reduced the relative abundance of Sphingomonas in the finished water. In addition, ozonation may play a role in reducing the relative abundance of Mycobacterium. NaClO and ClO₂ had different effects on the bacterial community in the finished water. The relative abundance of some bacteria (e.g. Flavobacterium, Phreatobacter and Porphyrobacter) increased in the finished water after ClO₂ disinfection. The relative abundance of Mycobacterium and Legionella, which have been widely reported as waterborne opportunistic pathogens, increased after NaClO disinfection. In addition, some microorganisms proliferated and grew in the distribution system, which could lead to turbidity increases in the tap water. Compared to those in the finished water, the relative abundance of Sphingomonas, Hyphomicrobium, Phreatobacter, Rheinheimera, Pseudomonas and Acinetobacter increased in the tap water disinfected with NaClO, while the relative abundance of Mycobacterium increased in the tap water disinfected with ClO₂. Overall, this study provided the detailed variation in the bacterial community in the drinking water system.     

Improved source assessment of Si, Al and related mineral components to PM10 based on a daily sampling procedure

Samples obtained from an industrialized valley in the East Alpine region were collected daily for a half year and analyzed using X-ray fluorescence to examine the elements Si,Al,Fe,Ca,Mg,Na,K,Zn,P,S and Cl.Some factors affecting the changes of these elements were considered,including time,elemental correlations,weekday,weekend and seasonal changes.Diagnostic analysis provided an insight into a decoupling behavior that occursin siliceous and carbonates minerals.A decrease in Si and Al and an increase in carbonates,Na,K,Zn and P were observed during the cold season.However,a consistently high correlation of Si and Al was observed in all seasons.It was established that such high levels originated from street surface abrasion.The increase in variability and absolute levels of carbonates during the cold season was demonstrated by adding carbonates to the street surface as gritting material to increase the grip on snowy surfaces.A marked increase in Na and Cl was observed in winter which may have been caused by thaw salt that is widely used in winter in Austria.This was associated with a significant increase in K,Zn,and P in the cold season that was the result of domestic space heating with wood.PM10 levels in December were 12 μg/m3 and were higher than levels detected in July.It was established that such high levels originated from mineral oxides,wood smoke,and inorganic ionic material(s).     

油烟净化器使用过程中的问题及处理方法

随着人民环保意识的提高,国家法律、法规要求的加强,饭馆、餐厅均对油烟采取了治理措施;在日常工作中对饭馆、餐厅油烟净化器使用进行调查发现,油烟净化器使用过程中存在二次污染及闲置的问题。本文通过调查分析查找到了原因,并提出应对措施。这对改善油烟净化器使用现状、提高环境质量、促进社会和谐具有建设性意义。     

石期河流域地下水化学特征及物质来源分析

为明确典型岩溶溶丘洼(谷)地区域地下水化学特征及其成因,以石期河流域为研究对象,运用Gibbs图、Piper图、端元分析及离子比例系数等方法,对地下水水化学特征及物质来源进行了定性和定量分析.结果表明,研究区内地下水pH值介于6.06～8.07之间,Ca~(2+)、 Mg~(2+)和HCO~-_3是地下水中的主要离子,其质量浓度范围分别为2.61～108.7、 0.54～27.61和8.1～370.74mg·L~(-1),符合岩溶水高钙弱碱性特征;地下水物质成分中, Ca~(2+)和Mg~(2+)主要受到碳酸参与的灰岩和白云岩风化作用的控制, Na~+主要来源于硅酸盐岩的溶解,同时, Ca~(2+)和Na~+在地下水流动过程中进行阳离子交替吸附作用; K~+、 Cl~-和NO~-_3主要受到农业化肥施放和生活废水排放的影响.此外,大气降水作为该区域地下水的主要补给来源,对当地地下水化学特征和物质来源也有一定的影响.