Advanced treatment of wet-spun acrylic fiber manufacturing wastewater using three-dimensional electrochemical oxidation

A three-dimensional electrochemical oxidation(3D-EC) reactor with introduction of activated carbon(AC) as particle micro-electrodes was applied for the advanced treatment of secondary wastewater effluent of a wet-spun acrylic fiber manufacturing plant. Under the optimized conditions(current density of 500 A/m~2, circulation rate of 5 mL/min, AC dosage of 50 g, and chloride concentration of 1.0 g/L), the average removal efficiencies of chemical oxygen demand(COD_(cr)), NH3–N, total organic carbon(TOC), and ultraviolet absorption at 254 nm(UV_(254)) of the 3D-EC reactor were 64.5%, 60.8%, 46.4%, and 64.8%, respectively; while the corresponding effluent concentrations of COD_(cr), NH_3–N, TOC, and UV_(254) were 76.6, 20.1, and42.5 mg/L, and 0.08 Abs/cm, respectively. The effluent concentration of COD_(cr) was less than 100 mg/L, which showed that the treated wastewater satisfied the demand of the integrated wastewater discharge standard(GB 8978-1996). The 3D-EC process remarkably improved the treatment efficiencies with synergistic effects for COD_(cr), NH_3–N, TOC, and UV_(254) during the stable stage of 44.5%, 38.8%, 27.2%, and 10.9%, respectively, as compared with the sum of the efficiencies of a two-dimensional electrochemical oxidation(2D-EC) reactor and an AC adsorption process, which was ascribed to the numerous micro-electrodes of AC in the 3D-EC reactor. Gas chromatography mass spectrometry(GC–MS) analysis revealed that electrochemical treatment did not generate more toxic organics, and it was proved that the increase in acute biotoxicity was caused primarily by the production of free chlorine.     

稠油污水回用锅炉处理工艺的应用

新疆油田公司稠油污水处理普遍采用成熟的离子调整旋流反应水处理技术,污水处理后达到回用锅炉水质标准SY/T 0097-2000《稠油油田采出水用于蒸汽发生器给水处理设计规范》,供给油田专用高压注汽锅炉用水。采用相同技术建成的采油一厂稠油处理站污水回用锅炉处理工艺投用后,处理后污水回用锅炉,减少了含油污水的外排,充分利用了稠油污水的热能,取得了良好的经济和社会效益。     

超细水雾抑制煤燃烧的模拟实验研究

为了研究超细水雾对煤燃烧的抑制效果,基于小尺寸空间抑制燃烧实验平台,研究了超细水雾对煤燃烧的抑制效果,计算在超细水雾作用下实验空间内部氧气、二氧化碳、一氧化碳体积分数的变化情况以及燃烧空间内不同部位的温度变化情况,并且与煤自由燃烧的情况做对比。研究表明超细水雾对煤燃烧的火灾发展过程有很好的抑制作用。研究结论对超细水雾应用于熄灭矿井煤炭火灾具有一定的指导意义     

土石坝管涌溃坝过程数学模型及应用

通过国内外土石坝管涌溃坝模型试验发现,管涌通道断面在溃坝过程中呈现城门洞形,并不断发展扩大直至坝顶发生坍塌。而目前常用的管涌溃坝过程数学模型大多假设管涌通道为圆形或矩形,与实际情况不符。基于土石坝管涌破坏机理,提出一个土石坝管涌溃坝过程数学模型,模型假设初始管涌通道断面为底部正方形顶部半圆形的城门洞形,采用基于水流剪应力的冲蚀公式模拟冲蚀过程管涌通道两侧边向外的发展,采用普罗托季亚科诺夫压力拱理论模拟管涌通道顶拱的发展;通过比较管涌通道上部坝体的重力与管涌通道两侧土体的抗剪强度判断管涌通道的垮塌,分别选择孔流和堰流公式模拟管涌通道坍塌前后的溃口流量;当管涌通道坍塌后,假设坍塌的土体立刻被溃坝水流带走,随后发生漫顶破坏,使用极限平衡法模拟漫顶溃坝过程中的溃口边坡稳定性。模型采用按时间步长迭代的数值计算方法模拟溃口的水土耦合过程,选择国内外25个具有实测资料的土石坝管涌溃坝案例对模型进行验证,比对峰值流量、溃口最终宽度及溃坝历时等参数发现,模型计算结果与实测值的相对误差可满足工程需求,验证了模型的合理性。     

辛置煤矿水力压裂卸压增透影响半径数值模拟研究

随着开采深度的增加,辛置煤矿瓦斯涌出量显著增大。为了提高瓦斯抽采效率,拟采用水力压裂卸压增透技术。理论分析了水力压裂对煤层的卸压增透作用,基于此利用RFPA模拟软件对辛置煤矿2-559回采工作面水力压裂卸压增透进行了数值模拟。研究表明,水力压裂主要在以下3个方面对煤体起到增透作用:使煤体卸压、提高煤层透气性;湿润煤体,增加塑性;改善瓦斯抽放环境。辛置煤矿2-559回采工作面水力压裂所需压力约为15MPa,压裂半径为5-6m,以此可以初步确定现场施工过程中水力压裂钻孔间距以不大于10m为宜。     

NOx attenuation in flue gas by •OH/SO4•--based advanced oxidation processes

Environmental Science and Pollution Research - The combustion of fossil fuels has resulted in rapidly increasing emissions of nitrogen oxide (NOx), which has caused serious human health and...     

用环己烷氧化副产物制备浮选剂

在固体酸催化剂作用下,用环己烷氧化制备环己酮的副产物——酸性油和轻质油进行酯化反应,制备了羧酸混合酯,酯化反应的最佳工艺条件：n（C4-C5醇）：n（有机羧酸）=1．2：1,催化剂质量分数为1．5％,反应温度为110-160℃,反应时间为5h。经应用评价结果表明,该羧酸混合酯是一种性能优异的选煤浮选剂。     

流化催化裂化烟气脱硫助剂的制备及其脱硫活性

采用溶胶-凝胶法制备锌铝助剂,该助剂于700℃焙烧后与流化催化裂化（FCC）催化剂进行机械混合,制得混合催化剂;在FCC烟气工业模拟装置上考察混合催化剂的脱硫活性,用混合催化剂的脱硫活性来反映锌铝助剂的脱硫性能。实验结果表明,氧化锌质量分数为10％的锌铝助剂的脱硫活性最佳,脱硫率达62．5％。采用红外光谱和X射线衍射（XRD）对锌铝助剂的脱硫机理进行了研究,红外分析结果表明,弱的L酸中心有利于锌铝助剂脱硫,XRD分析结果表明,锌铝助剂在锌铝尖晶石结构尚未完全形成时,存在较多的晶格缺陷,能够有效地吸附烟气中的SOx,将其转化为H2S。     

Future of global governance and climate change action in a changing political landscape

<正>1.Editor's note On 30 November 2016,the Brookings-Tsinghua Center for Public Policy(BTC),Caixin Video,and Columbia Global Centers(Beijing)jointly hosted a Seminar on the Future of Global Governance and Climate Change Action in a Changing Political Landscape.Leading experts on China's environmental policy and climate     

Molecular and physiological characterization of fluoroquinolone resistance in relation to uropathogenicity among Escherichia coli isolates isolated from Wenyu River, China

Increasing antibacterial resistance and pathogenicity in the environment is of growing concern due to its potential human risk. In the present study, 236 Escherichia coli isolates were collected from Wenyu River in China on drugless (48 isolates) and quinolone-containing plates (189 isolates). Their minimum inhibitory concentrations (MICs) were determined ranging from 0.125 μg mL⁻¹ to 128 μg mL⁻¹. Mutation points related to fluoroquinolone resistance were observed at S83 to L and D87 to N or Y in the GyrA subunit and S80 to R or I and E84 to G in the ParC subunit. Generally, MICs of LEV and GAT are dependent on the patterns of these mutation points. The profile with three mutation points was related to LEV-resistant E. coli isolates, and the (S83L, D87N + S80I) mutation profile was most prevalent (65.7%) in LEV-resistant isolates, while a large proportion of isolates, even those with three mutation points, were susceptive to GAT. The incidence of virulence factors in LEV-resistant isolates (44.7%, 59/132) was much higher than in nonresistant isolates (23.1%, 24/104) (χ² = 11.925, 1° of freedom, p < 0.001) indicating that fluoroquinolone-resistant E. coli would pose a potential risk. A similar distribution was also found in isolates resistant to GAT (χ² = 7.843, 1° of freedom, p = 0.0079).