Simulating chemistry–aerosol–cloud–radiation–climate feedbacks over the continental U.S. using the online-coupled Weather Research Forecasting Model with chemistry (WRF/Chem)

The chemistry–aerosol–cloud–radiation–climate feedbacks are simulated using WRF/Chem over the continental U.S. in January and July 2001. Aerosols can reduce incoming solar radiation by up to ?9% in January and ?16% in July and 2-m temperatures by up to 0.16 °C in January and 0.37 °C in July over most of the continental U.S. The NO₂ photolysis rates decrease in July by up to ?8% over the central and eastern U.S. where aerosol concentrations are high but increase by up to 7% over the western U.S. in July and up to 13% over the entire domain in January. Planetary boundary layer (PBL) height reduces by up to ?23% in January and ?24% in July. Temperatures and wind speeds in July in big cities such as Atlanta and New York City reduce at/near surface but increase at higher altitudes. The changes in PBL height, temperatures, and wind speed indicate a more stable atmospheric stability of the PBL and further exacerbate air pollution over areas where air pollution is already severe. Aerosols can increase cloud optical depths in big cities in July, and can lead to 500–5000 cm^?3 cloud condensation nuclei (CCN) at a supersaturation of 1% over most land areas and 10–500 cm^?3 CCN over ocean in both months with higher values over most areas in July than in January, particularly in the eastern U.S. The total column cloud droplet number concentrations are up to 4.9 × 10⁶ cm^?2 in January and up to 11.8 × 10⁶ cm^?2 in July, with higher values over regions with high CCN concentrations and sufficient cloud coverage. Aerosols can reduce daily precipitation by up to 1.1 mm day^?1 in January and 19.4 mm day^?1 in July thus the wet removal rates over most of the land areas due to the formation of small CCNs, but they can increase precipitation over regions with the formation of large/giant CCN. These results indicate potential importance of the aerosol feedbacks and an urgent need for their accurate representations in current atmospheric models to reduce uncertainties associated with climate change predictions.     

Emission factors and particulate matter size distribution of polycyclic aromatic hydrocarbons from residential coal combustions in rural Northern China

Coal consumption is one important contributor to energy production, and is regarded as one of the most important sources of air pollutants that have considerable impacts on human health and climate change. Emissions of polycyclic aromatic hydrocarbons (PAHs) from coal combustion were studied in a typical stove. Emission factors (EFs) of 16 EPA priority PAHs from tested coals ranged from 6.25 ± 1.16 mg kg^?1 (anthracite) to 253 ± 170 mg kg^?1 (bituminous), with NAP and PHE dominated in gaseous and particulate phases, respectively. Size distributions of particulate phase PAHs from tested coals showed that they were mostly associated with particulate matter (PM) with size either between 0.7 and 2.1 μm or less than 0.4 μm (PM_0.4). In the latter category, not only were more PAHs present in PM_0.4, but also contained higher fractions of high molecular weight PAHs. Generally, there were more than 89% of total particulate phase PAHs associated with PM_2.5. Gas-particle partitioning of freshly emitted PAHs from residential coal combustions were thought to be mainly controlled by absorption rather than adsorption, which is similar to those from other sources. Besides, the influence of fuel properties and combustion conditions was further investigated by using stepwise regression analysis, which indicated that almost 57 ± 10% of total variations in PAH EFs can be accounted for by moisture and volatile matter content of coal in residential combustion.     

钢渣吸附处理苯酚废水的研究

采用恒温振荡的方法,考察了钢渣粒径、吸附温度、振荡速度、溶液pH值、溶液初始浓度对苯酚去除率的影响。结果表明,在粒径为120~180目、pH=4.0、苯酚溶液浓度在500 mg/L以内、苯酚/钢渣质量比为1∶1 000时吸附效果最好。钢渣对苯酚的吸附能较好地符合Langmuir和Freundlich吸附等温线,线性相关系数分别为0.9971和0.9916,吸附机理为表面吸附。     

固定化包埋亚硝酸菌短程脱氮与同步除磷工艺研究

为实现常温下低碳源城市生活污水的低能耗脱氮除磷,采用固定化技术和厌氧/好氧/缺氧(AOA)工艺耦合与游离组进行了对比实验研究。在温度为25±1℃、pH为8.0±1、DO为1±0.5 mg/L和HRT为9 h的条件下,两组运行结果表明,固定组具有较高的硝化效率和较强的适应能力,亚硝氮的积累率可以稳定维持在70%以上,对NH4+-N、COD和TP的去除率分别为92.2%、87.2%和81.3%,明显优于游离组。     

生物法-人工湿地组合工艺处理小城镇混合污水研究

为适应小城镇污水处理高效、低耗、管理简单的要求,开展了生物法(水解酸化/生物接触氧化)-人工湿地组合工艺(A/BCO-CW)处理小城镇片区混合污水的研究。结果表明,A/BCO系统在停留时间为3～6 h条件下,对悬浮物和有机物有高的去除效率,COD、BOD5和TSS去除率分别达到63.1%、67.7%和66.2%,避免了人工湿地堵塞和提高处理效率,减少了所需湿地面积44%。全年运行结果表明,在0.30～0.59 m/d水力负荷率下,垂直流-表面流-水平潜流人工湿地组合系统对COD、BOD5和TSS平均去除负荷达9.4、5.1和7.2 g/(m2.d)(42%、71.2%和85.2%);COD、BOD5去除速率常数为74.6±12.1 m/y、166±30.5 m/y,这些数值均处于文献中k值范围的高量程内。A/BCO-人工湿地系统对COD、BOD5和TSS具有好的处理效果,出水水质能够稳定达到《地表水环境质量标准》(GB 3838-2002)的IV类水标准,2种处理方法有效组合起来,所开发的低成本、高效率、可持续运行的城镇废水处理组合系统,将会在实际应用尤其是高有机负荷污水处理中发挥良好效用。     

石膏浆液旋流器的分离性能实验研究

通过理论分析及工程经验对石灰石/石膏法烟气脱硫工艺中石膏浆液脱水系统的旋流器进行优化设计,在与工业实际相近的操作条件下,优选出了一根综合性能较好的旋流器。考察了该旋流器的压力、流量与分离效率之间相互关系,与常规石膏浆液旋流器的分级效率进行了比较,确定了最佳操作条件。结果表明,旋流器的进口流量随着进出口压力差的增大而增大,分离效率随着流量增加先上升后下降。在进口硫石膏颗粒平均粒径为24μm,流量为11.8~14.8 m3/h时,分离效率在85%以上,底流出口10μm、15μm以下的颗粒分别占底流出口颗粒总体积的1%、10%左右,起到了很明显的分级浓缩作用,分离性能也优于常规使用的石膏浆液旋流器。     

非水相硝基苯在含水层中的迁移释放规律

通过室内模拟实验,探讨了在非水相硝基苯污染含水层的条件下,其在含水层中的迁移及释放规律。迁移规律表明,非水相硝基苯并非在含水层中直接进行垂向迁移,而是一方面在自身重力作用下向含水层下部迁移,另一方面在地下水流的作用下随地下水同向运移,整体表现为随地下水流的侧向运移,并最终迁移至含水层底部。释放规律表明,非水相硝基苯在含水层迁移的过程中会向地下水大量释放,释放出的硝基苯在水流的作用下随地下水同向运移,污染源及迁移至含水层底部的非水相硝基苯均存在再次释放。     

介质阻挡放电联合催化臭氧化降解甲苯

采用介质阻挡放电区后结合MnOx/Al2O3/发泡镍去除甲苯,考察甲苯进气方式、臭氧产生方法及湿度对甲苯与O3同时去除的影响。结果表明,O3是等离子体区后催化降解甲苯的主要物种,介质阻挡放电联合催化臭氧化可实现甲苯及O3的同时高效去除。输入电压为9.0 kV时,甲苯的去除效率达92.8%,在80 min内O3的去除效率维持在99%以上。水蒸气对催化剂催化分解臭氧的活性没有直接的影响,O3浓度较高时湿度对甲苯降解效率的影响很小。GC-MS分析结果表明,甲苯降解的主要气相副产物有烷烃、酸、酮和含苯环有机物,提出了甲苯的降解途径。     

烟草下脚料发酵制取乙醇

通过单因素实验考察了硫酸浓度、固液比和水解时间对硫酸水解的影响。结果显示最优条件为:硫酸浓度为50%(w/w),固液比为10%(w/v),时间为100 min。烟草下脚料在最佳硫酸水解条件下,经5倍稀释,中和pH值至5～6。取经过滤后的水解液(FH)用酿酒酵母(Sacchharomyces cerevisiae)发酵产生乙醇,最大的乙醇浓度和乙醇产量分别为1.09g/L和54.5 g/kg。未过滤水解液(UFH,包括水解残渣)加入纤维素酶(70 U/100 mL)和酿酒酵母(Sacchharomyces cerevisiae)进行发酵,最大的乙醇浓度和乙醇产量分别为1.23 g/L和61.5 g/kg。     

两阶段曝气生物滤池的硝化性能

曝气生物滤池(BAF)是近年来受到广泛关注的一种新型污水处理技术,具有占地面积少、投资费用低、处理效率高、出水水质好等优点。现已被应用于许多污水处理厂的二级处理、深度处理以及污水的回用。实验以陶粒为填料,自行设计了升流式两阶段BAFs(UBAFs)处理模拟生活污水,考察了反应器运行条件对COD与氨氮去除影响,并探讨了UBAFs反应器内氮流失及同步硝化反硝化情况。结果表明,UBAFs对生活污水处理具有良好的净化效果。在进水COD和氨氮浓度分别为200~363 mg/L和16.8~31.3 mg/L条件下,UBAFs处理出水水质均达到《城市污水再生利用城市杂用水水质》(GB/T 18920-2002)标准,能够满足回用要求。通过采用氮平衡分析方法和借助电子扫描电镜技术,初步认为UBAFs反应器脱氮方式是由于在UBAFs第一阶段局部厌氧环境中以传统方式进行硝化反硝化脱氮,第二阶段是在好氧条件下,异养好氧硝化菌的同步硝化反硝化脱氮。