甲苯对UASB反应器中溶解性微生物产物的影响

以乙酸钠为外加碳源,考察了UASB反应器内甲苯对可溶性微生物产物（SMP）的影响。实验结果表明：低质量浓度（20~70 mg/L）的甲苯对微生物有刺激作用,使得污泥增殖速率变小,SMP的质量浓度也逐渐减少,经过一段时间的驯化后,系统COD和TOC的去除率分别达到93%和94%以上,下降趋势较小;较高质量浓度（70~200 mg/L）的甲苯对微生物有抑制作用,污泥活性下降,反应器运行状况开始恶化,SMP的质量浓度也逐渐增大,经过一段时间的驯化后,系统COD和TOC的去除率分别维持在81%和83%以上;当甲苯质量浓度超过200 mg/L时,表现为污泥活性严重下降,对COD的去除效果极差。     

钛基金属氧化物电极的制备及性能

采用聚合物前驱体法制备了Ti/SnO₂-Sb₂O₃电极,再通过恒电流电沉积法制备了 Ti/SnO₂-Sb₂O₃/PbO₂和Ti/SnO₂-Sb₂O₃/MnO₂电极。采用SEM技术对3种金属氧化物电极表面的形貌进行了表征,并分别以3种电极为阳极进行了苯酚的电催化氧化实验。实验结果表明：电解时间为2.5 h时,Ti/SnO₂-Sb₂O₃电极、Ti/SnO₂-Sb₂O₃/PbO₂电极和Ti/SnO₂-Sb₂O₃/MnO₂电极对苯酚的降解率分别为85.9%,83.2%,44.6%;苯酚在3种电极上的电催化氧化反应均遵循一级反应动力学方程;苯酚在Ti/SnO₂-Sb₂O₃ 电极和Ti/SnO₂-Sb₂O₃/PbO₂电极上的反应速率较快,并具有较高的析氧电位;Ti/SnO₂-Sb₂O₃/PbO₂电极具有更好的耐腐蚀性和更长的使用寿命。     

石化行业的VOCs排放控制管理

概述了我国挥发性有机化合物（VOCs）的排放情况。介绍了国内外VOCs的管理现状。分析了国内石化行业VOCs排放控制管理中存在的主要问题以及污染物排放过程的类别。提出了明确定义、制定相关标准、完善分类管理体系、研究最佳的可行性控制技术等加强VOCs排放控制管理的对策和建议。     

微波再生载苯酚活性炭过程中再生产物分析

研究了载氮气和无载气2种条件下,微波再生载苯酚活性炭过程中再生产物的成分和苯酚随再生过程的去向分布。结果表明,无载气时,微波功率越高,再生反应器内温度越高,吸附质的高温裂解反应越彻底,再生产物以挥发性气体为主,有机质种类很少;而当微波功率较低或载氮气再生时,反应器内温度相对较低,苯酚难以被彻底分解,再生产物中含多种复杂的链状或环状有机物。此外,载氮气时,经气提、挥发而去除的苯酚量约占总吸附量的一半,再生炭上无苯酚残留,活性炭吸附性能可完全恢复乃至优化;无载气时,经挥发而去除的苯酚量只有19.9%,其余大量苯酚则在微波作用下裂解或缩合为其他物质随尾气而去除,且再生炭上仍有少量苯酚未被解吸出来。因此,前者活性炭再生的效果优于后者。     

酸性矿井水中和沉淀法除铁优化

针对山西某煤矿高矿化度、高铁酸性矿井水除铁效果差、出水容易返色等问题,采用NaOH中和调pH、曝气及化学氧化等处理工艺进行酸性矿井水中和沉淀法除铁优化实验研究。结果表明,采用NaOH中和沉淀法除铁时,投加中和剂使出水pH达6.7以上时,出水中铁含量低于10 mg/L,满足排放要求。对于本实验废水NaOH所需投加量为2.8 g/L,铁的去除率可达到99.75%;以H2O2对原水进行氧化处理,可迅速将Fe(Ⅱ)氧化成Fe(Ⅲ),其用量与原水中Fe(Ⅱ)的含量成正比。当其用量为1.6 mL/L时,可将原水中的Fe(Ⅱ)完全转化为Fe(Ⅲ),投加中和剂使出水pH达到4.5以上时,能使出水中铁含量满足排放要求。对于实验废水所需的NaOH投加量为2.0 g/L,比直接中和沉淀所需的NaOH用量要节省28.6%。曝气处理对原水中Fe(Ⅱ)的氧化效果不明显。     

改性活性炭对水中铬离子(Ⅵ)的吸附性能

为了研究改性前后活性炭对水中铬离子(Ⅵ)的吸附效果,以磷酸活性炭(PAC)为原料,用10%硝酸改性得到硝酸改性活性炭(N-PAC)及直接蒸发法载铁改性得到载铁活性炭(Fe-PAC)。通过静态吸附研究表明,改性后活性炭对Cr(Ⅵ)的吸附率有较大提高。在常温、自然pH条件下,0.2 g活性炭处理50 mL浓度为100 mg/L的含Cr(Ⅵ)溶液,N-PAC和Fe-PAC对Cr(Ⅵ)的吸附率分别为79.21%和90.59%,都高于原PAC对Cr(Ⅵ)的吸附率49.58%。pH从2.2升高到11.92,Fe-PAC对Cr(Ⅵ)的吸附率从99.86%降低到14.77%,N-PAC则从99.86%降低到3.23%,PAC从97.05%降低到2.53%。温度从25℃升高到70℃,3种活性炭对Cr(Ⅵ)吸附率都有较大提高,都增加到98%以上。且吸附过程较符合Langmuir等温吸附模型。     

假单胞菌好氧降解四溴双酚A的特性

为了解四溴双酚A(TBBPA)的好氧降解特性,采用选择富集法从活性污泥中分离出一株能够高效降解四溴双酚A的菌株。根据其形态、生理生化特性及16S rDNA核苷酸序列分析,该菌株被鉴定为假单胞菌属(Pseudomonas sp.)。研究结果表明,该菌株可通过好氧共代谢方式实现四溴双酚A的降解,葡萄糖是四溴双酚A降解的最佳碳源,其最优降解条件为葡萄糖8 g/L,牛肉膏0.5 g/L,pH值为7.0,培养温度为35℃,摇床转速为150 r/min。在该条件下其生物降解过程符合一级动力学模型,6 d后的降解率高达95.6%。LC-MS结果表明,四溴双酚A在好氧降解过程中会生成异丙苯酚类物质。     

水泥窑共处置过程中水泥生料对砷的吸附/冷凝特性

针对水泥生料开展了氮吸附与SEM测试分析,研究了水泥生料的比表面积,孔径结构和微观表面积。同时,利用管式回转炉和控温立式炉联用装置研究了砷元素在水泥生料上的吸附冷凝特性。结果表明,水泥生料的比表面积很小,微观表面结构致密无孔,砷元素主要是冷凝在生料表面上。进入吸附冷凝炉的重金属可以分为3部分,第1部分冷凝在管壁上,占80%左右;第2部分吸附/冷凝在生料上,占10%左右;第3部分随烟气释放到空气中,不到10%。水泥生料对砷的吸附冷凝量随时间的增加而增加,随温度的升高而降低。水泥生料对砷的吸附冷凝特性可用双常数速率方程拟合,拟合效果较好,计算得表观活化能在6~7 kJ/mol之间。此外,砷的初始浓度对水泥生料的吸附冷凝特性影响很小。     

Acute and chronic toxicity of organophosphate monocrotophos to Daphnia magna

The acute and chronic toxicity of monocrotophos (MCP), the binary joint toxicity of MCP and bifenthrin (BF), and sodium dodecyl benzene sulfonate (SDBS) to Daphnia magna (D. magna) was evaluated. The 24 h-median effective concentration (24 h-EC₅₀) and 48 h-median lethal concentration (48 h-LC₅₀) of MCP towards D. magna were 161 and 388 μ g/L, respectively. In addition, the lowest-observed effective concentration (LOEC) and non-observed effective concentration (NOEC) of MCP to D. magna were 10 and 5 μ g/L, respectively. Furthermore, the chronic value (ChV) of MCP against D. magna was 7 μ g/L and the acute chronic ratio (ACR) was 55. The number of offspring per female and the intrinsic rate of natural increase (r) were identified as the parameters that were most sensitive to MCP. In addition, toxic unit (TU) analysis was employed to evaluate the joint toxicities. The calculated TU_mix values of binary equitoxic mixtures of MCP + BF and MCP + SDBS were 1.47 and 1.63, respectively, which suggests that both equitoxic mixtures exert a limited antagonistic effect. The results of this study revealed that the toxic threshold of MCP towards D. magna is higher than its reported highest residue (4 μ g/L) in the ordinary aquatic environment, and that concurrent exposure to BF or SDBS may exert a slight antagonistic effect.     

Chemical oxidation of sulfadiazine by the Fenton process: Kinetics,pathways, toxicity evaluation

This paper investigated sulfadiazine oxidation by the Fenton process under various reaction conditions. The reaction conditions tested in the experiments included the initial pH value of reaction solutions, and the dosages of ferrous ions and hydrogen peroxide. Under the reaction conditions with pH 3, 0.25 mM of ferrous ion and 2 mM of hydrogen peroxide, a removal efficiency of nearly 100% was achieved for sulfadiazine. A series of intermediate products including 4-OH-sulfadiazine/or 5-OH-sulfadiazine, 2-aminopyrimidine, sulfanilamide, formic acid, and oxalic acid were identified. Based on these products, the possible oxidation pathway of sulfadiazine by Fenton's reagent was proposed. The toxicity evaluation of reaction solutions showed increased antimicrobial effects following the Fenton oxidation process. The results from this study suggest that the Fenton oxidation process could remove sulfadiazine, but also increase solution toxicity due to the presence of more toxic products.