天氧污泥对问二氯苯的吸附性能

为了研究灭活厌氧污泥和活性厌氧污泥对问二氯苯（m-DCB）的吸附,考察了吸附平衡时间、吸附动力学、吸附等温线、吸附热力学、污泥投加量和pH对吸附m-DCB的影响。结果表明,2种污泥对m-DCB的吸附在1h内达到平衡。应用伪一级、伪二级反应动力学对实验数据进行验证,表明厌氧污泥吸附m-DCB更符合伪二级反应动力学模型。2种污泥对m-DCB的吸附都可以用Langmuir和Freundlich吸附模型拟合,但Langrnuir吸附模型的拟合结果要好于Freundlich模型,且活性厌氧污泥的吸附性能显著高于灭活厌氧污泥。从吸附热力学上看,该吸附为放热反应,低温有利于吸附反应的进行。pH值对2种污泥吸附m-DCB的影响很小。     

空速和二氧化碳对沼气脱硫剂硫容确定的影响

为了弄清空速与二氧化碳含量对氧化铁脱硫剂硫容确定的影响,分别在实验气源为纯硫化氢,空速为40、80、120和160 h-1以及实验气源为二氧化碳含量分别在0%、20%、40%和80%,其余为硫化氢,空速为80 h-1条件下,对T502(粗脱硫剂)和HXT-2(精脱硫剂)2种氧化铁脱硫剂进行了不同测试条件对氧化铁硫容确定影响的研究。研究结果表明,T502和HXT-2氧化铁脱硫剂硫容测试结果随着空速和二氧化碳含量增加而减少,结果显示了在空速较低条件下(120h-1),二氧化碳含量在40%以下时对氧化铁脱硫剂硫容测试结果影响不大,但二氧化碳含量在40%以上时,对氧化铁脱硫剂硫容测试结果影响显著。     

烧结机共处置过程中重金属Cd、As的挥发特性研究

选取优级纯化学试剂Cd Cl2和As2S3来模拟危险废物中的重金属,按一定比例将其与烧结矿原料均匀混合后进行共处置煅烧。主要研究了在煅烧过程中Cd和As的挥发规律,同时对煅烧所得烧结矿进行消解实验求得固化的重金属量。实验结果表明,Cd的挥发率随着温度的升高和时间的增加而不断增大,直到达到一个平衡而不再继续增大,对Cd的挥发进行动力学模拟得到挥发率α与煅烧温度T和煅烧时间t的关系式为α=1-exp(-0.669exp(-3567.6/T)t)。而As则呈现出温度越高挥发率越低的规律,当温度为1 200℃时,煅烧75 min后As的挥发率仅为9.8%,即共处置过程中As与烧结矿原料发生化学反应而固化下来,挥发较少,可认为对人体健康和环境造成的危害较小。     

广东不同环境大气污染特性比较

利用2014年广东南岭背景站、天湖郊区站、磨碟沙城区站和受体区域桃源站SO2、NO2、PM10、O3、PM2.5与CO自动监测数据,分析不同环境大气污染特性。结果表明,4个站点的SO2、NO2、PM10与CO整体平均年均值较低,分别为14,28,59μg/m3和0.7 mg/m3;PM2.5整体平均值为36μg/m3,O3日最大8 h第90百分位数平均值为172μg/m3,二者高于国家二级标准限值。磨碟沙城区站和桃源站的污染物日变化规律较为明显,NO2、PM10和PM2.5在早晚交通高峰或紧接其后的时段出现峰值区。南岭背景站PM2.5质量浓度日间略高于夜间;O3未呈典型单峰分布,而是维持在较平稳、较高浓度水平。周末与工作日O3平均值的相对高低多与NO2、PM10和PM2.5的情况相反。4个站点O3日最大8 h值第90百分位数均未达标;南岭背景站和天湖郊区站O3值尤高,除10月外,在1月或6月也易出现O3高值。区域性的O3污染控制亟须深化开展。     

超声导波技术在长输管道跨越段腐蚀检测中的应用

管道跨越段的检测一直是管道检验检测的难题之一,本文运用英国TWI集团Teletest Focus+MK4导波设备,对某在役的长输管道,综合选择了河流、沟壑、高速公路、水渠等多种不同服役环境管段,管径DN200至DN350不等6个跨越段进行检测,并进行案例分析.实践表明,导波检测技术对跨越段管道的单边检测距离在100m左...     

The monitoring results of electromagnetic radiation of 110-kV high-voltage lines in one urban location in Chongqing P.R. China

To understand electromagnetic radiation field strength and its influencing factors of certain 110-kV high-voltage lines in one urban area of Chongqing by measuring 110-kV high-voltage line’s electromagnetic radiation level. According to the methodology as determined by the National Hygienic Standards, we selected certain adjacent residential buildings, high-voltage lines along a specific street and selected different distances around its vertical projection point as monitoring points. The levels of electromagnetic radiations were measured respectively. In this investigation within the frequency of 5–1,000 Hz both the electric field strength and magnetic field strength of each monitoring sites were lower than the public exposure standards as determined by the International Commission on Non-Ionizing Radiation Protection. However, the electrical field strength on the roof adjacent to the high-voltage lines was significantly higher than that as measured on the other floors in the same buildings (p < 0.05). The electromagnetic radiation measurements of different monitoring points, under the same high-voltage lines, showed the location which is nearer the high-voltage line maintain a consistently higher level of radiation than the more distant locations (p < 0.05). Electromagnetic radiation generated by high-voltage lines decreases proportionally to the distance from the lines. The buildings can to some extent shield (or absorb) the electric fields generated by high-voltage lines nearby. The electromagnetic radiation intensity near high-voltage lines may be mitigated or intensified by the manner in which the high-voltage lines are set up, and it merits attention for the potential impact on human health.     

Bioaccumulation characterization of uranium by a novel Streptomyces sporoverrucosus dwc-3

The biosorption mechanisms of uranium on an aerobic bacterial strain Streptomyces sporoverrucosus dwc-3, isolated from a potential disposal site for (ultra-)low uraniferous radioactive waste in Southwest China, were evaluated by using transmission electron microscopy (TEM), energy dispersive X-ray (EDX) analysis, Fourier transform infrared spectroscopy (FT-IR), X-ray photoelectron spectroscopy (XPS), proton induced X-ray emission (PIXE) and enhanced proton backscattering spectrometry (EPBS). Approximately 60% of total uranium at an initial concentration of 10 mg/L uranium nitrate solution could be absorbed on 100 mg S. sporoverrucosus dwc-3 with an adsorption capacity of more than 3.0 mg/g (wet weight) after 12 hr at room temperature at pH 3.0. The dynamic biosorption process of S. sporoverrucosus dwc-3 for uranyl ions was well described by a pseudo second-order model. S. sporoverrucosus dwc-3 could accumulate uranium on cell walls and within the cell, as revealed by SEM and TEM analysis as well as EDX spectra. XPS and FT-IR analysis further suggested that the absorbed uranium was bound to amino, phosphate and carboxyl groups of the cells. Additionally, PIXE and EPBS results confirmed that ion exchange also contributed to the adsorption process of uranium.     

污水芦苇湿地处理系统示范工程的研究

该示范工程处理水量500m~3/d,在水力负荷为5cm/d条件下,BOD~5、SS、总氮和大肠杆菌的去除率分别为85.8％、93.8％、64.6％和99.9％。出水平均值分别为17.8mg/L、17.0mg/L、5.1mg/L和<8.1个/100ml。系统运行稳定,抗冲击负荷能力较强,投资和运行费用仅是常规二级处理的1/2—1/5。本文还研究了该系统对污水中主要污染物的去除机理和反应动力学。对工程的设计参数和技术参数进行了优化筛选,建立了湿地生态模式。     

Design and demonstration of a next-generation air quality attainment assessment system for PM2.5 and O3

Due to the increasingly stringent standards, it is important to assess whether the proposed emission reduction will result in ambient concentrations that meet the standards. The Software for Model Attainment Test—Community Edition (SMAT-CE) is developed for demonstrating attainment of air quality standards of O₃ and PM_2.5. SMAT-CE improves computational efficiency and provides a number of advanced visualization and analytical functionalities on an integrated GIS platform. SMAT-CE incorporates historical measurements of air quality parameters and simulated air pollutant concentrations under a number of emission inventory scenarios to project the level of compliance to air quality standards in a targeted future year. An application case study of the software based on the U.S. National Ambient Air Quality Standards (NAAQS) shows that SMAT-CE is capable of demonstrating the air quality attainment of annual PM_2.5 and 8-hour O₃ for a proposed emission control policy.