PUMP-CTD-System for trace metal sampling with a high vertical resolution. A test in the Gotland Basin, Baltic Sea

It is a great challenge to sample seawater across interfaces, for example the halocline or the redoxcline, to investigate trace metal distribution. With the use of 10l sampling bottles mounted to a wire or a CTD-Rosette it is possible to obtain a maximum vertical resolution of 5m. For the detection of small vertical structures in the vertical distribution of trace metals across the redoxcline, the CTD-Bottle-Rosette is not sufficient. Therefore, a PUMP-CTD-System was developed, which enables water sampling with high resolution (1m maximum) along a vertical profile. To investigate the suitability and possible contamination sources of this device two experiments were carried out in the Gotland Basin. The first experiment consisted of two separate profiles. The first profile was obtained with the CTD-Bottle-Rosette and the second with the PUMP-CTD-System. Both were taken from the bottom to the surface water layer. The second experiment was a combined profile obtained from the surface to the bottom with the PUMP-CTD-System attached to the CTD-Bottle-Rosette. Concentrations of dissolved Pb, Cd, Cu, Zn, Fe, Mn, Co and Ni from the "Niskin Bottles" and from the PUMP were measured and compared for each investigation. We demonstrate that it is useful to perform vertical sampling from lower to higher concentrations, e.g. surface to bottom in this environment, and that a longer flushing is required for sampling seawater in the anoxic bottom water. A comparison of the two systems for oxygen and hydrogen sulphide measurements showed an improvement of the precision and the quality of the sampling when using the PUMP. Thus, metal speciation at the oxic-anoxic gradient zone and on a high vertical resolution will be accessible. As concentrations of dissolved Pb, Cd, Cu, Zn, Co, Ni, Fe and Mn in seawater sampled with both devices were in the same range, we conclude that the PUMP-CTD-System is well suited to sample seawater for trace metal analyses.     

Cytotoxicity of TBBPA and effects on proliferation, cell cycle and MAPK pathways in mammalian cells

Poly-brominated flame retardants are ecotoxicologically relevant chemicals that can show high persistency in environmental samples and bioaccumulation in marine and fresh water animals. One of the most widely used compound is tetrabromobisphenol A (TBBPA). Until today, the toxicological data are rather fragmentary. Our studies on acute and sub-acute toxic effects with established cell lines demonstrate that TBBPA interferes with cellular signaling pathways. Cell viability is significantly reduced in a time- and concentration-dependent manner. The observed EC50 for rat kidney cells (NRK) was 52 microM (27 mg/l), 168 microM (90 mg/l) for A549 human lung cells, and 200 microM (108 mg/l) for Cal-62 human thyroid cells, respectively. The comparison of TBBPA with the non-brominated substance bisphenol A (BPA) clearly demonstrates that only the brominated compound exerts these effects on proliferation and cell viability. Cell cycle regulation was influenced considerably in Cal-62 cells, showing an explicit G2/M arrest in the cell cycle at TBBPA concentrations higher than 75 microM. Cellular signaling pathways directly connected to these affected parameters, e.g. the mitogen activated protein kinase (MAPK) cascades, are partly influenced in a cell specific and dose dependent manner. The extracellular-signal regulated kinase (ERK) is deactivated in NRK and A549 cells and activated in Cal-62 cells with increasing TBBPA concentrations.