Removal of SO2 from smelting flue gas by using copper tailings with MnSO4: factors optimization by response surface methodology

Environmental Science and Pollution Research - The abatement of SO2 and the utilization of copper tailings are identified as two attention-attracting environmental issues in the copper smelter. In...     

Investigating global surface temperature from the perspectives of environmental,demographic, and economic indicators: current status and future temperature trend

Environmental Science and Pollution Research - Anthropogenic activities have increased atmospheric concentrations of greenhouse gas emissions, which have observably increased global temperature....     

Simultaneous nitrification and denitrification in a PCL-supported constructed wetland with limited aeration

Environmental Science and Pollution Research - Considerable advances have been made in the substrate design and operation strategies of constructed wetlands to facilitate nitrogen elimination....     

Numerical modeling of changes in groundwater storage and nitrate load in the unconfined aquifer near a river receiving reclaimed water

Environmental Science and Pollution Research - Reclaimed water (RW) has been widely used as an alternative water resource to recharge rivers in mega-city Beijing. At the same time, the RW also...     

A review of the global climate change impacts,adaptation, and sustainable mitigation measures

Environmental Science and Pollution Research - Climate change is a long-lasting change in the weather arrays across tropics to polls. It is a global threat that has embarked on to put stress on...     

仲钨酸铵生产中钨渣的污染特性分析

采集了14家仲钨酸铵（APT）生产企业生产过程中产生的钨渣,分别采用HJ/T299—2007《固体废物 浸出毒性浸出方法 硫酸硝酸法》和GB 5085.3—2007《危险废物鉴别标准 浸出毒性鉴别》附录S推荐的方法分析了钨渣中重金属的浓度及浸出浓度,并研究了钨渣的污染特征。结果表明,钨渣中重金属浓度服从正态分布,浓度较高的重金属为Cu、Zn和类金属As,其最大值分别为6 260、25 000和26 900 mg/kg,平均值分别为3 510、4 560和5 640 mg/kg;浸出浓度较大的是Pb、As和Hg,其最大值分别为33.6、26.2和0.85 mg/L,超出GB 5085.3—2007中规定的相应限值的6.72、5.24和8.5倍,超标率分别为14.3%、21.4%和42.9%;钨渣中As、Mo和Hg是特征污染物,应作为危险废物进行管理。     

Trametes sp.LS-10C漆酶对直接类偶氮染料的脱色作用

利用栓菌（Trametes sp.LS-10C）漆酶在单酶和漆酶-介体体系2种情况下对3种直接类偶氮染料进行脱色。结果表明,在给酶量为10 U·mL-1、染料浓度为100 mg·mL-1条件下反应24 h后,直接蓝86在非介体体系中脱色率达到71.2%,其最适脱色温度和pH范围分别为45~60℃和3.5~5.0;直接橙26在介体体系（10 μmol·L-1 ABTS）中脱色率达到78.7%,其最适脱色温度和pH范围分别为35~45℃和4.5~6.5;直接红31在介体体系（10 μmol·L-1 ABTS）中脱色率达到90.7%,其最适脱色温度和pH范围分别为35~45℃和3.5~5.0。     

臭氧活性炭-后置砂滤工艺对水中农药的控制效能

选择我国饮用水水质标准中有相关规定,以及部分用量较大或虽被禁用但仍有残留的农药共25种,对黄浦江水源水以及采用臭氧活性炭-后置砂滤工艺的某水厂工艺段出水中的浓度分布进行了调查,评估了砂滤后置工艺条件下相应农药的实际处理效果。结果表明:原水中有包括莠去津、乐果、六氯苯、敌敌畏、乙草胺、丁草胺、仲丁威和p,p'-DDT的8种农药检出,且总浓度较高达到760 ng/L,其中莠去津和乙草胺含量较高,最高浓度分别达到531 ng/L和277 ng/L;从季节性分布来看,春季总农药浓度最高达760 ng/L,秋季最低为175 ng/L。从工艺去除效果来看,臭氧活性炭砂滤后置工艺对农药的总体去除率为62%~78%,与冬春季相比,夏秋季节的农药的去除率提高约10%左右,这可能与高温期微生物活性较高有关。值得关注的是,砂滤后置工艺与同期常规臭氧活性炭工艺相比农药的总去除率要低10%左右,应结合总体出水水质情况对其进一步评估。     

裹包青贮提高玉米秸秆厌氧消化效率的实验研究

秸秆是重要的沼气工程原料,秸秆预处理对其后续厌氧消化效率影响巨大。采用田间裹包青贮方法,设计3因素正交实验,考察了秸秆含水率、压缩比和添加剂对玉米秸秆发酵时间和厌氧消化产沼气的影响。结果表明:秸秆经过裹包青贮,发酵总时间(total fermentation time,TFT)减少1~2 d,累积产气量达到总产气量的90%所用时间(TFT90%)减少了40%~50%,消化效率明显提高;秸秆含水率对产气效果有明显影响,随着含水率增加,单位总固体(total solid,TS)累计产气量(cumulative biogas yields per TS,CBYT)和沼气日产率(biogas yields rate average day,BYR)由高到低排序为:35%~40%,40%~45%,30%~35%;秸秆压缩比对产气效果有明显影响,随着压缩比的增加,其对CBY和BYR的效应由高到低排序为:185、143与138 kg/m3;添加剂类型对产气效果亦有明显影响,在不同添加剂处理下,其对CBYT和BYR的效应由高到低排序为:尿素处理>甲酸处理>无添加剂处理;正交实验极差分析表明,对CBYT和BYR的影响排序为:含水率﹥压缩比﹥添加剂,其田间裹包青贮进行厌氧发酵的优化组合为:青贮秸秆含水率为35%~40%,压缩比为185 kg/m3,添加剂为营养型,青贮20 d,CBYT和BYR达到最大,分别为646.57 mL/g和173.25 mL/(d·g)。