Effects of solution conditions on the precipitation of phosphate for recovery. A thermodynamic evaluation

To understand the effects of solution conditions on the precipitation of calcium phosphates from wastewater for recovery, a computer programme PHREEQC was employed to calculate the speciation and saturation-index (SI) with respect to hydroxyapatite of a chemically defined precipitation system, which contains phosphate of 1–200 mg P/l, with Ca/P molar ratios of one to 10 times of the stoichiometric calcium to phosphorus molar ratio of hydroxyapatite, at a pH range of 7.0–11.0. The results show that the SI is respectively the logarithmic function of the phosphate concentration and the calcium concentration, increasing with the increase of either of them; the SI is a polynomial function of the solution pH value and increases with its increase, and the effect of solution pH value is due to its influence on base uptake of the precipitation reaction and the speciation of phosphate and calcium ions; the SI is also a logarithmic function of the solution ionic strength but decreases with its increase; at the temperature range of 5–30 °C the SI increases linearly with solution temperature and the effect of temperature is also due to its influence on the speciation of phosphate and calcium ions.     

一体化间歇曝气完全混合活性污泥法

一体化间歇曝气完全混合活性污泥法处理装置采取特殊的沉淀区构造,改变了活性污泥的循环流动方式,通过间歇曝气,反应区交替处于好氧/缺氧状态,达到了有机物高效去除、高效硝化反硝化及控制污泥膨胀的效果.该方法具有出水水质好、运行稳定、能耗低、流程简洁和操作管理方便的特点,是一种很有发展潜力的一体化中小型生活污水、城市污水处理系统.     

Comparative study of extraction methods for the determination of PAHs from contaminated soils and sediments

The following four methods were compared on the extraction efficiency of 16 EPA (US Environmental Protection Agency) polycyclic aromatic hydrocarbons (PAHs): German method of the Verband Deutscher Landwirtschaftlicher Untersuchungs und Forschungsanstalten (VDLUFA), two methods of the International Organization for Standardization using shaking (ISO A) and Soxhlet extraction (ISO B) and an ultrasonic method. Recovery rates of 16 PAHs were determined in two soils. Extraction efficiency was evaluated in five soils and three sediments. Effect of drying soils and sediments on extraction efficiency was tested using the VDLUFA and the ultrasonic methods. Our study shows that the number of aromatic rings, rather than extraction procedures, significantly influenced recovery rates of individual PAHs. No significant differences in extraction efficiency of the four methods were observed for less polluted samples. For highly polluted soils, extraction efficiency decreased in the following order: VDLUFA method > ISO A > ultrasonic method > ISO B. Influence of soil moisture on extraction efficiency depended to some extent on both solvent used and content of PAHs in samples. A mixture of dichloromethane/acetone (5:1) is recommended for PAH extraction from moist samples when the ultrasonic method is used.     

Distribution of polycyclic aromatic hydrocarbons in agricultural soils in South Korea

The content and type of polycyclic aromatic hydrocarbons (PAH) in soils from paddy fields and upland areas in South Korea were determined using gas chromatography linked to mass spectrometry (GC–MS). The distribution map of total PAH content was obtained as a contour plot using a geographical information system. The overall distribution of PAH was found to be closely related to the pollution sources, the size of city and the type of industry. The average content of total PAH in all samples was 236 μg kg⁻¹, and the range was from 23.3 to 2834 μg kg⁻¹. The highest concentrations were found in soils sampled near iron processing plants. The concentration of PAH decreased in the order fluoroanthene>benzo(b)fluoroanthene>pyrene. Special PAH compound ratios, such as phenanthrene/anthracene and fluoroanthene/pyrene, were calculated to evaluate the origin. The collected data suggested that the pyrogenic origins such as motor vehicle exhaust and heavy industry emission were the dominant source of PAH in Korean soils.     

3种不同基质潜流湿地对磷的去除效果

基质是潜流式人工湿地污水处理系统的重要组成部分，直接影响到系统的处理效果。本文研究了由沸石、页岩陶粒和碎石3种不同基质构建的潜流式人工湿地对磷的去除效果。结果表明，在设计水力停留时间3d，连续进出水情况下，碎石单元对磷的去除效果最好，页岩陶粒单元次之，沸石单元效果最差，平均去除率分别为95％、60％和35％。在潜流式人工湿地污水处理系统运行初期观察到磷释放现象，沸石单元最为明显。进水磷浓度较低时，磷的去除率随浓度升高而升高，当正磷、总磷浓度分别升高到2．4—2．5和3．1～3．3mg／L时，正磷、总磷的去除率开始迅速下降。     

厌氧氨氧化（ANAMMOX）生物滤池反应器的启动特性

采用平行对比实验,讨论不同实验条件下上向流厌氧氨氧化（ANAMMOX）滤池反应器的启动特性。对比条件为温度、接种污泥、联氨和羟胺。结果表明：温度是影响厌氧氨氧化细菌活性的主要因素;接种200mL具有活性的厌氧氨氧化污泥后,在避光、加热38℃、不控制联氨和羟氨的条件下,45d可成功启动厌氧氨氧化滤池反应器;反应过程NH4^＋N：NO2^-·N：NO3-N的化学计量摩尔比为1：1．17：0．30,其总氮去除率达到87．38％,总氮容积去除负荷可达到1．41kg／（m^3·d）。     

碳酸根对磷酸钙沉淀反应回收磷的影响简

以模拟的厌氧消化液为处理对象,通过小试实验,考察不同初始磷浓度C_P、Ca/P物质的量比、pH和温度下,碳酸根（CO₃^2-）对磷酸钙沉淀反应回收磷的影响;利用扫描电镜（SEM）、X射线衍射仪（XRD）和傅里叶变换红外光谱（FTIR）对沉淀产物进行表征。结果表明,高浓度的CO₃^2-对以磷酸钙沉淀反应去除和回收磷的效率影响较大;C_P相同时,CO₃^2-浓度（C_CO3^2-）越大,P的去除率越低,低C_P（20 mg/L）时尤为显著;当C_CO3^2-相同时,随着C_P的增大,反应速率加快,P的去除率逐渐升高,但升高幅度越来越小;增大Ca/P比和pH能提高P的去除率,降低CO₃^2-对磷酸钙沉淀反应的抑制作用,综合考虑实际效果,应选择Ca/P比为3.33,pH为9.0作为适宜的反应条件;升高温度对降低CO₃^2-对磷酸钙沉淀反应的抑制作用贡献不大。在C_P为60 mg/L,Ca/P比为1.67,pH为9.0,温度为20℃的条件下,当C _CO3^2-为0时,得到的沉淀产物主要为羟基磷灰石HAP;当C _CO3^2-为30 mmol/L时,得到的沉淀产物为磷酸钙和碳酸合磷灰石的混合物。     

基于DFTA的电梯制动器可靠性分析

电梯制动器是电梯最重要的安全部件之一,故研究其可靠性具有重要意义.首先分析了电梯制动器的故障机理并建立了动态故障树模型,其次利用二元决策图和马尔科夫方法对故障树进行了分析计算,得到了影响系统可靠性的相关指标以及制动器的薄弱环节,最后提出了改进措施和建议,为电梯制动器的设计、维修保养及检验提供了科学依据.     

高活性萘降解细菌Hydrogenophaga Palleronii LHJ38的研究

为了研究微生物对多环芳烃的降解和转化规律,以萘作为研究对象,从餐厨油烟污染土壤中筛选到一株萘降解活性较高的细菌菌株,经菌种鉴定,定名为帕氏氢噬胞菌(H ydrogenophaga Palleronii)LH J38。测定了该菌的生长曲线和萘降解曲线,建立了菌株对萘的降解活性的定量测定方法,并研究了其最适生长条件。结果表明,在28℃、初始pH6.6、碳氮摩尔比为4的最适培养条件下,LH J38对初始质量浓度为2 000m g/L的萘在96h内的降解率可达98%以上;处于对数生长期的LH J38对萘的降解活性可达47.3nm o l/(m g.m in)。     

螯合树脂去除丙烯酸丁酯废水中的二价阳离子

采用氨基膦酸螯合树脂C-900去除丙烯酸丁酯废水中的二价阳离子,考察了吸附温度和废水流量对树脂动态吸附性能的影响,并用Thomas模型进行动态吸附数据的拟合分析。实验结果表明,在吸附温度为35℃、废水流量为15SV的条件下,处理后出水中3种二价阳离子总质量浓度为1.0mg/L时的穿透体积为240BV,达到穿透体积时树脂对Ca²⁺,Mg²⁺,Cu²⁺的去除率分别为100%,99.2%,99.8%。