Influence of hydraulic retention time in a two-phase upflow anaerobic sludge blanket reactor treating textile dyeing effluent using sago effluent as the co-substrate

Purpose  

Textile dyeing and sago industries are the most polluting industries in South India, especially in industrial cities like Salem, Tamil Nadu, where textile dyeing and sago industries are clumped together geographically. Conventional physicochemical treatment followed by biological processes for the effluent generated from these industries are ineffective, costlier and produce huge quantities of hazardous sludge and harmful by-products which requires further treatment and safe disposal. Hence, the development of an alternative treatment method will become important. The main objective of this investigation is to establish a sustainable biotreatment technology for the treatment of textile dyeing effluent using sago effluent as co-substrate in a two-phase upflow anaerobic sludge blanket (UASB) reactor.     

Estimating contaminant mass discharge: a field comparison of the multilevel point measurement and the integral pumping investigation approaches and their uncertainties

In this field study, two approaches to assess contaminant mass discharge were compared: the sampling of multilevel wells (MLS) and the integral groundwater investigation (or integral pumping test, IPT) that makes use of the concentration-time series obtained from pumping wells. The MLS approached used concentrations, hydraulic conductivity and gradient rather than direct chemical flux measurements, while the IPT made use of a simplified analytical inversion. The two approaches were applied at a control plane located approximately 40m downgradient of a gasoline source at Canadian Forces Base Borden, Ontario, Canada. The methods yielded similar estimates of the mass discharging across the control plane. The sources of uncertainties in the mass discharge in each approach were evaluated, including the uncertainties inherent in the underlying assumptions and procedures. The maximum uncertainty of the MLS method was about 67%, and about 28% for the IPT method in this specific field situation. For the MLS method, the largest relative uncertainty (62%) was attributed to the limited sampling density (0.63 points/m(2)), through a novel comparison with a denser sampling grid nearby. A five-fold increase of the sampling grid density would have been required to reduce the overall relative uncertainty for the MLS method to about the same level as that for the IPT method. Uncertainty in the complete coverage of the control plane provided the largest relative uncertainty (37%) in the IPT method. While MLS or IPT methods to assess contaminant mass discharge are attractive assessment tools, the large relative uncertainty in either method found for this reasonable well monitored and simple aquifer suggests that results in more complex plumes in more heterogeneous aquifers should be viewed with caution.     

Antiradical activity of natural honeys and antifungal effect against Penicillium genera

The purpose of the study was to examine the antiradical activity of 11 natural honeys and to evaluate the antifungal properties of honey. Honey samples (10) were collected from different locations of Slovak Republic. Honeys were native to different plant species of Robinia pseudoacaccia, Brassica napus subs. napus, Castanea sativa Mill. Thymus serpyllum vulgaris and the other samples had multifloral origin. The low antiradical activitity in honey samples was determined. The best results were found in thyme honey from Rhodos (11.84 %) and Castanea honey from Nitra (10.61 %). The lowest antiradical activity was found in Acacia honey and determined to be 7.62 %. Statistically significant differences (P< 0.001) were found among thyme/Rhodos and Castanea/Nitra. The antifungal activities of honey samples were tested by 10 %, 25 % and 50 % (by mass per volume) concentration against fungi Penicillium crustosum, P. expansum, P. griseofulvum, P. raistrickii and P. verrucosum and by the agar well diffusion method. The solutions containing 10 % (by mass per volume) of honey did not have any effect on the growth of fungi. The strongest antifungal effect was shown by 50 % honey concentration against P. raistrickii.     

Temporal variations of atmospheric aerosol in four European urban areas

Purpose

The concentrations of PM₁₀ mass, PM_2.5 mass and particle number were continuously measured for 18 months in urban background locations across Europe to determine the spatial and temporal variability of particulate matter.

Methods

Daily PM₁₀ and PM_2.5 samples were continuously collected from October 2002 to April 2004 in background areas in Helsinki, Athens, Amsterdam and Birmingham. Particle mass was determined using analytical microbalances with precision of 1 ??g. Pre- and post-reflectance measurements were taken using smoke-stain reflectometers. One-minute measurements of particle number were obtained using condensation particle counters.

Results

The 18-month mean PM₁₀ and PM_2.5 mass concentrations ranged from 15.4 ??g/m³ in Helsinki to 56.7 ??g/m³ in Athens and from 9.0 ??g/m³ in Helsinki to 25.0 ??g/m³ in Athens, respectively. Particle number concentrations ranged from 10,091 part/cm³ in Helsinki to 24,180 part/cm³ in Athens with highest levels being measured in winter. Fine particles accounted for more than 60% of PM₁₀ with the exception of Athens where PM_2.5 comprised 43% of PM₁₀. Higher PM mass and number concentrations were measured in winter as compared to summer in all urban areas at a significance level p?Conclusions Significant quantitative and qualitative differences for particle mass across the four urban areas in Europe were observed. These were due to strong local and regional characteristics of particulate pollution sources which contribute to the heterogeneity of health responses. In addition, these findings also bear on the ability of different countries to comply with existing directives and the effectiveness of mitigation policies.     

Towards optimal sampling schedules for integral pumping tests

Ethanol use as a gasoline additive is increasing, as are the chances of groundwater contamination caused by gasoline releases involving ethanol. To evaluate the impact of ethanol on dissolved hydrocarbon plumes, a field test was performed in which three gasoline residual sources with different ethanol fractions (E0: no ethanol, E10: 10% ethanol and E95: 95% ethanol) were emplaced below the water table. Using the numerical model BIONAPL/3D, the mass discharge rates of benzene, toluene, ethylbenzene, xylenes, trimethylbenzenes and naphthalene were simulated and results compared to those obtained from sampling transects of multilevel samplers. It was shown that ethanol dissolved rapidly and migrated downgradient as a short slug. Mass discharge of the hydrocarbons from the E0 and E10 sources suggested similar first-order hydrocarbon decay rates, indicating that ethanol from E10 had no impact on hydrocarbon degradation. In contrast, the estimated hydrocarbon decay rates were significantly lower when the source was E95. For the E0 and E10 cases, the aquifer did not have enough oxygen to support complete mineralization of the hydrocarbon compounds to the extent suggested by the field-based mass discharge. Introducing a heterogeneous distribution of hydraulic conductivity did little to overcome this discrepancy. A better match between the numerical model and the field data was obtained assuming partial degradation of the hydrocarbons to intermediate compounds. Besides depending on the ethanol concentration, the impact of ethanol on hydrocarbon degradation appears to be highly dependent on the availability of electron acceptors.     

Evaluation Of Ambient Air Pollution Impact On Carrot Plants At A Sub Urban Site Using Open Top Chambers

The present experiment was done to evaluate the impact of ambient air pollution on carrot (Dacus carotavar. Pusa Kesar) plants using open top chambers (OTCs) ventilated with ambient (NFCs) or charcoal filtered air (FCs) at a suburban site of Varanasi, India. Various morphological, physiological and biochemical characteristics of the plants were studied at different growth stages. Air monitoring data clearly showed high concentrations of SO₂, NO₂and O₃in the ambient air of study site. SO₂and NO₂concentrations were higher during early growth stages of carrot, whereas O₃concentration was highest during later growth stages. Filtration of air has caused significant reductions in all the three pollutant concentrations in FCs as compared to NFCs.Plants growing in FCs showed significantly higher photosynthetic rate, stomatal conductance, water use efficiency and variable fluorescence as compared to plants growing in NFCs. Protein content also showed a similar pattern, however, lipid peroxidation, ascorbic acid content and peroxidase activity were higher in plants growing in NFCs as compared to FCs. Shoot length, number of leaves per plant, leaf area and root and shoot weight increased significantly upon filtration of ambient air. Total nitrogen decreased significantly in root, but increased significantly in shoot of plants grown in NFCs. Total P, Mg, Ca and K contents decreased significantly in plants grown in NFCs as compared to FCs. The individual pollutant concentrations were below threshold for plant injury, but the combined effect of all the three seems to act synergistically in causing greater adverse impact on dry weight and physiology of carrot plants. The study clearly indicates that air pollutants are high enough in the ambient air to cause significant unfavorable impact on carrot plants. The work further supports the usefulness of OTCs for assessing air pollution damage under field conditions in developing countries.     

Metal Fractionation Studies in Surfacial and Core Sediments in the Achankovil River Basin in India

The Fractionation of Fe, Zn, Cu, Pb, Mn and Cd in the sediments of the Achankovil River, Western Ghats, India using a sequential extraction method was carried out to understand the metal availability in the basin for biotic and abiotic activities. Spatial distribution of heavy metals has been studied. Sediment grain size has significant control over the heavy metal distribution. The fluctuations in their concentration partly depend upon the lithology of the river basin and partly the anthropogenic activities. The sediments are dominated by sand and are moderately to strongly positively skewed and are very leptokurtotic in nature. The quartzite and feldspars are abundant minerals along with significant amount of mica with low clay content. The core sediments show increasing trend of heavy metal concentration with depth due to the recent addition of anthropogenic sources and post-diagenic activities. Significant amount of Cd (18%) was found in carbonate fraction, which may pose environmental problems due to its toxic nature. Small concentrations of metals, except Cd and Cu, are in exchangeable fraction, which indicate low bio-availability. Enrichment Factor (EF) for individual metals shows the contribution from terrregious and in part from anthropogenic sources. Selective Sequential Extraction (SSE) study shows the variation in specific metal distribution pattern, their distribution in different phases and their bio-availability. Maximum amount of the metals were bound to the non-residual fractions (mainly Fe-oxides). Overall, bio-availability of these micronutrients from sediments seems to be very less. Non-residual phase is the most important phase for majority of heavy metals studied. Among the non-residual fraction, maximum amount of the heavy metals bound to Fe-oxides. The study high lights the need for in-depth study of heavy metals distribution and fractionation in the smaller river basins to get precise information on the behavior and transport of heavy metals in the fluvial environment and their contribution to the world ocean.     

Selecting Species for Marine Assessment of Radionuclides Around Amchitka: Planning for Diverse Goals and Interests

Considerable attention has been devoted to selecting bioindicator species as part of monitoring programs for exposure and effects from contaminants in the environment. Yet the rationale for selection of bioindicators is often literature-based, rather than developed with a firm site-specific base of data on contaminant levels in a diverse range of organisms at different trophic levels in the same ecosystem. We suggest that this latter step is an important phase in the environmental assessment process that is often missing. In this paper we address the problem of how to select a wide range of species representing different trophic levels that serve as a basis for selecting a few species suitable as bioindicators. We illustrate this with our assessment of radionuclides on Amchitka Island, Alaska. We propose a multi-stage process for arriving at the list of available species that includes review of literature, review by experts experienced in the area, review by interested and affected parties, selection of trophic levels or groups for analysis, arraying of possible species, and selection of species within each trophic level group for sample collection. We first had to identify all likely species, then narrow our focus to those we could collect and analyze. In all cases, review includes suggestions for possible target species with justifications. While this method increases the up-front costs of developing bioindicators for an ecosystem, it has the advantage of providing information for selection of species that will be most informative in the long run, including those that are the best bioaccumulators, thus providing the earliest warning of any potential environmental consequences. Further, the recognition that a range of stakeholder's needs and interests should be included increases the utility for public-policy makers, and the potential for continued usage to establish long-term trends.     

Little Egrets (Egretta Garzetta) and Trace-Metal Contamination in Wetlands of China

The rapidly developing Asian countries may face threatening environmental contamination, that however remains largely unassessed. We studied persistent trace elements in three wetlands, Poyang Lake, relatively unpolluted, and Tai Lake, and Pearl River Delta, selected as hotspots of pollution in Central China. We adopted as indicator the Little Egret, a widespread colonial waterbird, and during 1999 and 2000 we collected and analysed the same samples as for a parallel study we conducted in Pakistan, e.g. eggs, body feathers of chicks, prey spontaneously regurgitated by the chicks, and sediments at the areas most used by foraging egrets. The levels of trace-metals at our three study areas were similar, or within the range, of those found in the few other studies for East Asia, with few exceptions. The concentrations of the various elements were below the threshold that may affect the survival or reproduction of the birds, and even the highest concentrations relative to background, i.e. Se in eggs, and Hg in feathers at Pearl Delta, do not pose toxic hazards. In sediments, the levels of trace elements were lower than the critical levels assumed for contaminated soil, except for alarming high levels of As at Poyang. These results do not confirm our expectation, that Poyang was relatively uncontaminated, while Tai and Pearl were polluted. Although trace metal concentration differed significantly among the three study areas, these differences were minor and were not consistent among elements and samples. The bioaccumulation ratios from sediments through prey, feather and egg, were consistent with our previous findings for Pakistan. Only Hg exhibited high bioaccumulation, while Se and Zn had low accumulation, and the other elements no accumulation. This reasserts that feathers of predators such as egrets, may be more sensitive indicators of environmental contamination for the elements subject to bioaccumulation, whereas the sediments or the organisms low in the food chain are better indicators for the other elements.     

Chlorination Byproducts in Drinking Water Produced from Thermal Desalination in United Arab Emirates

Oil activities in the Arabian Gulf can potentially affect the quality of the intake water available for coastal desalination plants. This paper addresses such situation by investigating the quality of intake water and desalinated water produced by a desalination plant located near a coastal industrial complex in United Arab Emirates (UAE). Analyses of the organic compounds on the intake seawater reported non-detected levels in most samples for the three tested organic groups; namely Polyaromatic Hydrocarbons (PAHs), Phenols, and Polychlorinated Biphenyls (PCBs). Trihalomethanes (THMs) and Haloacetic Acids (HAAs) were also tracked in the intake sea water, throughout the desalination processes, and in the final produced drinking water, to evaluate the undertaken pre- and post chlorination practices. The levels of considered Chlorination Byproducts (CBPs) were mostly found below the permissible international limits with few exceptions showing tangible levels of bromoform in the intake seawater and in the final produced drinking water as well. Lab-controlled experiments on the final produced distillate showed little contribution of its blending with small percentage of seawater upon the formation of trihalomethane and in particular, bromoform. Such results indicate that the organic precursors originated in the seawater are responsible for bromoform formation in the final distillate.