文思湖底泥COD释放规律模拟研究

采用室内模拟实验方法,研究环境因子（温度、pH、扰动强度、供气量）对底泥释放COD的影响。结果表明,水温升高能加速底泥中有机质的释放;上覆水在弱酸至中性条件下底泥释放有机质最低;扰动上覆水体会加快有机质的释放。     

Degradation of o-toluidine by fluidized-bed Fenton process: statistical and kinetic study

Background, aim, and scope  

The optimal conditions of o-toluidine degradation by fluidized-bed Fenton process were determined using Box–Behnken designs (BBD). The BBD can be used to find the optimal conditions in multivariable systems. The optimal conditions obtained by the design were further applied in the kinetic analysis of o-toluidine oxidation in fluidized-bed Fenton process.     

不同粒径零价铁（ZVI）对污水污泥H_2S和CH_4释放速率的影响

考察了不同粒径零价铁（ZVI）,包括200目普通铁粉（200m-ZVI）、800目超细铁粉（800m-ZVI）和纳米铁粉（nZVI,粒径=20 nm）,对污水污泥的硫化氢和甲烷释放速率的影响。研究发现：（1）在22 d内,添加0.1%的200m-ZVI使污泥的硫化氢释放速率提高48.0%,而添加0.1%的800-ZVI和nZVI,则使污泥的硫化氢释放速率分别降低33.1%和77.1%;（2）不同粒径ZVI均可以提高污泥沼气中的甲烷浓度,且依次为nZVI〉800m-ZVI〉200m-ZVI;（3）在23 d内,添加0.1%的200m-ZVI和nZVI使污泥的甲烷累计产生量分别提高了15.5%和40.6%,而添加0.1%800m-ZVI则使甲烷产生量降低了12.5%。nZVI可以有效控制污泥的硫化氢释放,并显著提升污泥在厌氧发酵过程的产甲烷速率。     

Improving the activity of Mn/TiO2 catalysts through control of the pH and valence state of Mn during their preparation

In this study, the authors investigated the influence of the valence state of Mn on the efficacy of selective catalytic reduction using a Mn-based catalyst. The nitrogen oxides (NOx) conversion rate of the catalyst was found to be dependent on the type of TiO2 support employed and on the temperature, as the catalyst showed an excellent conversion of > 80% at a space velocity of 60,000 hr(-1) when the temperature was above 200 degrees C. Brunauer-Emmett-Teller, X-ray diffraction, and X-ray photoelectron spectroscopy analyses confirmed that catalyst displaying the highest activity contained the Mn4+ species and that its valence state was highly dependent on the pH during the catalyst preparation.     

Physicochemical properties of chars at different treatment temperatures

In this study, the physicochemical properties of the char of Indonesian SM coal following heat treatment at various temperatures were evaluated using X-ray photoelectron spectroscopy (XPS), Fourier-transform infrared spectroscopy (FT-IR), scanning electron microscopy (SEM), and morphological and specific surface area analysis. Based on these analyses, heat treatment of coal was determined to be the most effective in increasing the coal rank. In the XPS analysis, the C-O and C-O-C groups and quaternary-N species were found to be of a lower grade coal when the pretreatment temperature decreased, meanwhile the C-C group and pyridinic species increased. In the FT-IR analysis, the collapse of the C-O and C-O-C group was observed due to the collapse of the ether group. In SEM and Brunauer-Emmett-Teller (BET) analysis, a decrease in the ether group was shown to be accompanied with the formation of micropores.     

阴极液及底物浓度对AFB-MFC同步废水处理及产电性能影响

为了提高厌氧流化床微生物燃料电池（AFB-MFC）的性能,并为双室MFC寻找价廉、易得、无污染的阴极液,在曝气量16～24 L/h、温度（35±2）℃、回流量10.2 L/h、阴极底边距阴极室内底部17.3 cm、外电阻250 Ω、水力停留时间（HRT）14.0～14.9 h以及进水pH 7.81～8.37下,研究了阴极液及底物浓度对系统产电及废水处理性能的影响。结果表明,使用缓冲溶液、阳极室出水和自来水作阴极液时,自来水的产电性能最佳,阴极液种类不影响系统有机基质的去除。以自来水为阴极液时,阴极液pH及电导率随运行时间增加而增加,COD去除率为80.11%～89.29%,输出电压及功率密度开始随运行时间增加而增加,之后稳定在440～452 mV和48.40～51.08 mW/m²之间。增加底物浓度对COD去除率影响不大,而输出电压及功率密度随底物浓度增加而下降;底物COD浓度由3 307.09 mg/L增至9 520 mg/L时,COD去除率在85.77%～94.44%之间,输出电压及功率密度则分别由449 mV和50.40 mW/m²下降至406 mV和41.21 mW/m²。自来水作阴极液可避免二次污染及阴极液对阳极室微生物的影响,并得到高的产电能力。     

基于人工蜂群算法与BP神经网络的水质评价模型

针对BP网络水质评价模型的不足,引入人工蜂群(ABC)算法,将求解BP神经网络各层权值、阀值的过程转化为蜜蜂寻找最佳蜜源的过程,提出了一种新的结合人工蜂群算法的BP网络水质评价方法(ABC-BP)。并以2000—2006年渭河监测断面的10组实测数据作为测试样本对其水质进行了评价,实验结果表明该方法得到的水质评价结果准确,并具有很强的稳定性和鲁棒性。     

以羟胺为底物的自养脱氮微量热研究

羟胺（NH₂OH）是单级自养脱氮系统物质转化的重要中间产物。从稳定运行（氨氮去除率维持90%以上,总氮去除率维持在80%以上）的单级自养脱氮工艺（SBBR）取活性污泥放入量热池,加入不同浓度N-NH₂OH（40～200 mg/L）进行量热实验研究。结果表明,用Boltzmann模型可以很好地表达量热值与NH₂OH浓度的关系,超过一定浓度的羟胺会抑制微生物活性,自营养脱氮过程的产热增量降低。     

应用表面活性剂-生物柴油微乳液去除污染土壤中多环芳烃

针对修复焦化厂高浓度多环芳烃污染土壤高成本的现实,采用以非食用性植物油、生物柴油、表面活性剂及其乳化合成的微乳液为淋洗剂,比较不同淋洗剂的淋洗效果。结果表明乳化合成的微乳液对焦化厂土壤中多环芳烃的总去除率高于单独使用表面活性剂为淋洗剂对土壤中多环芳烃的总去除率,说明生物柴油及植物油与表面活性剂乳化形成的微乳液对原污染土壤中的多环芳烃具有显著的增溶作用。1%TW-80和2.5%TW-80对土壤中多环芳烃总去除率分别为11%和14%;以2.5%TW-80为原料乳化合成的微乳液的淋洗去除率较以1%TW-80为原料乳化合成的微乳液高,总去除率分别为15%～30%和11%～18%;以生物柴油为原料乳化合成的微乳液的淋洗去除率较以植物油为原料乳化合成的微乳液高,分别为17%～30%和15%～23%,且对多环芳烃的去除率与其辛醇水分配系数(logKow)呈线性相关关系。