基于BP神经网络的垃圾焚烧过程故障诊断

应用BP神经网络方法,建立了垃圾焚烧过程故障诊断的模型.该方法采用梯度下降法训练网络权值,利用最优停止法对网络进行了优化,避免了过拟合现象.提高了BP神经网络的训练速度和泛化能力.并以实际焚烧过程工况数据进行性能检验,检验结果表明了该BP网络具有较高的诊断精度.     

碱熔融法合成NaA和NaX型粉煤灰沸石的品质表征

以粉煤灰为原料采用碱熔融法合成了2种单一沸石矿物种的NaA和NaX型沸石,并对产物的结构、性能和应用指标进行了详细表征.经x射线衍射和IR光谱分析,表明合成产物是无杂晶生成的NaA和NaX型沸石相;在扫描电镜观察下,产物分别具有NaA和NaX型沸石的立方体和八面体晶体骨架结构.DTA分析表明了合成产物中沸石水的存在,且产物热稳定性较好.通过对比,粉煤灰合成的NaA和NaX型沸石的比表面积达到了相应商品沸石的66.9%和83.6%;孔容为41.1%和70.2%;阳离子交换容量(CEC,cation exchange capacity)为82.93%和84.31%.通过比较化学组成表明,大规模应用合成产物不会对环境造成危害.     

应用陶粒过滤-陶瓷膜组合对止咳糖浆制药废水深度处理的试验研究

止咳精浆制药废水经生物接触氧化一体化废水处理装置处理后,其出水中COD、BOD和氨氮等主要污染物质均不能达标排放.在实验室中采用陶粒过滤-陶瓷膜组合对经一体化处理装置处理后的制药废水进行深度处理,在陶粒柱反应器选用粒径为1～2 mm的陶粒滤料,陶瓷膜反应器选用孔径为2～3/μm陶瓷膜的条件下对水样进行测试.废水经陶粒过滤-陶瓷膜组合处理后,其BOD、COD、SS和氨氮指标均可稳定达标排放.     

由粉煤灰合成单一的沸石及其对Cr(Ⅵ)的吸附研究

以粉煤厌为原料采用两步法合成了2种单一沸石矿物种的NaA和NaX型沸石,并对产物的结构和性能进行了详细表征.2种沸石产物的吸附性能比较结果表明,NaA型沸石优于NaX型沸石.在静态吸附条件下,研究了NaA型沸石吸附水溶液中Cr(Ⅵ)的相关参数(溶液pH值、吸附温度和吸附时间),并用Langmuir和Freundlich等温吸附线对吸附结果进行拟和.结果表明:Cr(Ⅵ)的吸附行为符合Langmuir方程;饱和吸附量为47.78 mg/g.NaA型沸石对Cr(Ⅵ)的吸附是物理和化学吸附两种行为共同作用的结果.     

Enhanced sludge solubilization by microbubble ozonation

A microbubble ozonation process for enhancing sludge solubilization was proposed and its performance was evaluated in comparison to a conventional ozone bubble contactor. Microbubbles are defined as bubbles with diameters less than several tens of micrometers. Previous studies have demonstrated that microbubbles could accelerate the formation of hydroxyl radicals and hence improve the ozonation of dyestuff wastewater. The results of this study showed that microbubble ozonation was effective in increasing ozone utilization and improving sludge solubilization. For a contact time of 80 min, an ozone utilization efficiency of more than 99% was obtained using the microbubble system, while it gradually decreased from 94% to 72% for the bubble contactor. The rate of microbial inactivation was obviously faster in the microbubble system. At an ozone dose of 0.02 g O₃ g⁻¹ TSS, about 80% of microorganisms were inactivated in the microbubble system, compared with about 50% inactivation for the bubble contactor. Compared to the bubble contactor, more than two times of COD and total nitrogen, and eight times of total phosphorus content were released from the sludge into the supernatant by using the microbubble system at the same ozone dosage. The application of microbubble technology in ozonation processes may provide an effective and low cost approach for sludge reduction.     

Seasonal and particle size-dependent variations in gas/particle partitioning of PCDD/Fs

This study monitored particle size-dependent variations in atmospheric polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs). Two gas/particle partitioning models, the subcooled liquid vapor pressure (P(L)(0)) and the octanol-air partition coefficient (K(OA)) model, were applied to each particle sizes. The regression coefficients of each fraction against the gas/particle partition coefficient (K(P)) were similar for separated particles within the same sample set but differed for particles collected during different periods. Gas/particle partitioning calculated from the integral of fractions was similar to that of size-segregated particles and previously measured bulk values. Despite the different behaviors and production mechanisms of atmospheric particles of different sizes, PCDD/F partitioning of each size range was controlled by meteorological conditions such as atmospheric temperature, O(3) and UV, which reflects no source related with certain particle size ranges but mixed urban sources within this city. Our observations emphasize that when assessing environmental and health effects, the movement of PCDD/Fs in air should be considered in conjunction with particle size in addition to the bulk aerosol.     

利用市场机制的作用实现劳动安全监察任务

提出利用市场机制的作用，实现劳动安全监察任务的观点。简析计划经济体制下实现劳动安全监察任务的模式；利用市场机制的功能和特性，分析判别计划经济体制下形成的实现劳动安全监察任务途径及其手段、有效性和必然性；提出了具体进行工作的思路、方法。     

中国煤矿工人体能负荷、疲劳与工伤事故

煤矿井下事故对矿工威胁很大，体力负荷过重而导致疲劳是引起事故不可忽视的原因。测定不同工种井下矿工的体能负荷情况，并根据ＦＩＸ疲劳指数的测定，分析矿工劳动负荷与工伤事故发生之间的关系。研究表明，在疲劳状态下事故发生的危险性增加；劳动负荷越重，疲劳越重相对的事故发生率也越高。减轻疲劳对预防事故发生与保证工作安全具有很重要的意义     

龙门式高压水射流快速洗消装置的研究

介绍了龙门式高压水射流快速洗消装置的系统组成、系统主要参数的确定,系统的工作过程;计算分析了系统水力特性、工作参数与应用。     

减速机齿轮表面探伤优化选择

采用模糊集的贴近度计算对齿轮表面探伤方法进行了优化选择,表明旋转磁场探伤是齿轮表面探伤的最佳方法,在实用中检测出大量的正在延伸扩展的表面疲劳裂纹.