Molecular and physiological characterization of fluoroquinolone resistance in relation to uropathogenicity among Escherichia coli isolates isolated from Wenyu River, China

Increasing antibacterial resistance and pathogenicity in the environment is of growing concern due to its potential human risk. In the present study, 236 Escherichia coli isolates were collected from Wenyu River in China on drugless (48 isolates) and quinolone-containing plates (189 isolates). Their minimum inhibitory concentrations (MICs) were determined ranging from 0.125 μg mL⁻¹ to 128 μg mL⁻¹. Mutation points related to fluoroquinolone resistance were observed at S83 to L and D87 to N or Y in the GyrA subunit and S80 to R or I and E84 to G in the ParC subunit. Generally, MICs of LEV and GAT are dependent on the patterns of these mutation points. The profile with three mutation points was related to LEV-resistant E. coli isolates, and the (S83L, D87N + S80I) mutation profile was most prevalent (65.7%) in LEV-resistant isolates, while a large proportion of isolates, even those with three mutation points, were susceptive to GAT. The incidence of virulence factors in LEV-resistant isolates (44.7%, 59/132) was much higher than in nonresistant isolates (23.1%, 24/104) (χ² = 11.925, 1° of freedom, p < 0.001) indicating that fluoroquinolone-resistant E. coli would pose a potential risk. A similar distribution was also found in isolates resistant to GAT (χ² = 7.843, 1° of freedom, p = 0.0079).     

Properties of alkali-activated systems with stone powder sludge

This article investigates the effects of stone powder sludge on the microstructure and strength development of alkali-activated fly ash and blast furnace slag mixes. Stone powder sludge produced from a crushed aggregate factory was used to replace fly ash and granulated blast furnace slag at replacement ratios of 0%, 10%, 20%, and 30% by mass. The unit weight and compressive strength of the samples were measured, and scanning electron microscopy/energy dispersive spectroscopy and X-ray diffraction (XRD) analyses were performed. The test results indicated that the compressive strength of alkali-activated blast furnace slag mixes using stone powder sludge was higher than that of the alkali-activated blast furnace slag control mix, but the compressive strength of alkali-activated fly ash mixes decreased with increasing replacement ratio of stone powder sludge. Microscopy results indicated that for alkaliactivated blast furnace slag samples, broken surfaces were more evident than for the alkali-activated fly ash samples. For all XRD diagrams, broad and diffuse peaks were observed around 2θ = 35° (d = 2.96–3.03 Å), implying amorphous or short-ordering structure phases.     

Comparison of semi-aerobic and anaerobic degradation of refuse with recirculation after leachate treatment by aged refuse bioreactor

Two fresh refuse bioreactors (F1 and F2) were operated under semi-aerobic and anaerobic conditions, respectively. The leachate from the bioreactors F1 and F2 was introduced into the aged refuse bioreactors (A1 and A2), and the effluent from A1 and A2 was subsequently recirculated into F1 and F2, respectively. The effect of the semi-aerobic recirculation process on refuse degradation was investigated, comparing it with that of the anaerobic recirculation process. Results indicate that the semi-aerobic recirculation process can increase the accumulated net production of leachate and promote evaporation. The accumulated net production of refuse in F1 is 320 mL/kg and that of F2 is 248 mL/kg, with leachate reduction amounting to 315 and 244 mL/kg refuse, respectively. The leachate quantity reduction of semi-aerobic and anaerobic leachate recirculation process accounted for 98.4% and 98.3% of the accumulated net production of leachate, respectively. The semi-aerobic leachate recirculation process can improve the biodegradation of organic matter from fresh refuse and the reduction rate of the pollutant concentration in leachate. This should shorten considerably the time required to meet the discharge standard and the time of stabilization of the refuse as observed in the anaerobic recirculation process. It was predicted that the COD concentration of leachate from the anaerobic recirculation process would reach 1000 mg/L in the anaerobic recirculation process after 2.2 years, as for semi-aerobic leachate recirculation process it is about 100 days. Compared with anaerobic recirculation process, the semi-aerobic recirculation process is more effective on NH₃-N transformation and TN removal. The NH₃-N and TN concentration of F1 is far below those of F2 at the end of our experiment. Refuse settlement in the semi-aerobic recirculation process was faster than that in the anaerobic recirculation process. At the end of the experiment, refuse settlement ratios in the semi-aerobic and anaerobic bioreactors were 33.5% and 18%, respectively.     

不同培养条件下锰过氧化物酶(MnP)的合成及其对甲基橙的降解

高效、大规模、低成本合成木质素降解酶是直接采用其降解难降解有机污染物所必须解决的问题.对锰过氧化物酶(MnP)降解甲基橙和在非灭菌的反应器中连续合成MnP的可行性进行考察.结果表明,在采用2 mmol H2O2和1.5 mmol MnSO4的降解体系中,获最大脱色效果,且100、200和300 U/L的MnP可在8h内将甲基橙分别脱色18％、23％和35％;在非灭菌的反应器水平上实现了固定化培养的P.chrysosporium连续23 d合成MnP,但MnP酶活仅为2～ 23 U/L,难以酶解甲基橙;然而,在摇瓶培养条件下固定化的P.chrysosporium合成的MnP却能达1 152 U/L.因此,直接采用MnP对污染物进行降解以及在非灭菌的反应器中持续合成MnP是可行的,但就在非灭菌条件下如何提高MnP的合成量还有待开展深入的研究.     

作业机液压系统问题调查与技改

针对油田井下作业机液压系统存在液压管钳伤人、无效功耗、污染环境等问题,通过现场调查研究,得出系统存在无效运转的相关数据,找到了液压系统存在的结构问题,制定液压泵随机驱动技术改造方案,对改造前后功耗数据进行了对比,分析了技改后的安全环保效果。     

Simultaneous adsorption and immobilization of As and Cd by birnessite-loaded biochar in water and soil

Environmental Science and Pollution Research - A novel biochar was prepared by loading birnessite to improve its capability to simultaneously adsorb As(III), As(V), and Cd(II) in water and soil....     

Effects of intercropping with floricultural accumulator plants on cadmium accumulation in grapevine

Environmental Science and Pollution Research - Grapevine (Vitis vinifera L.) intercropping with floricultural cadmium (Cd) accumulator plants (Helianthus annuus L., Cosmos sulphureus Cav., Cosmos...     

Methods for the preparation of a biodesulfurization biocatalyst using Rhodococcus sp

Several methods to prepare a biodesulfurization (BDS) biocatalyst were investigated in this study using a strain of Rhodococcus sp. 1awq. This bacterium could selectively remove sulfur from dibenzothiophene (DBT) via the "4S" pathway. DBT, dimethylsulfoxide (DMSO), sodium sulphate and mixed sulfur sources were used to study their influence on cell density, desulfurization activity, desulfurization ability, and the cost of biocatalyst production. In contrast to that observed from bacteria cultured in DBT, only partial desulfurization activity of strain 1awq was induced by DBT after cultivation in a medium containing inorganic sulfur as the sole sulfur source. The biocatalyst, prepared from culture with mixed sulfur sources, was found to possess desulfurization activity. With DMSO as the sole sulfur source, the desulfurization activity was shown to be similar to that of bacteria incubated in medium with DBT as the sole sulfur source. The biocatalyst prepared by this method with the least cost could remove sulfur from hydrodesulfurization (HDS)-treated diesel oil efficiently, providing a total desulfurization percent of 78% and suggesting its cost-effective advantage.     

催化湿式氧化处理机械加工工业废水的研究

利用担载的双金属活性组分催化剂，考察了反应温度、压力、进料空速和污水pH等条件对催化湿式氧化处理某厂机械加工废水效果的影响。对于该厂的混合废水，在反应温度260℃，反应压力6．6MPa，空速为2．0h^-1，pH为3条件下处理后的废水CODCr去除率为90．2％。考察了助剂H2O2、絮凝剂对处理废水效果的影响和各种联用技术对废水的处理效果。