Effective adsorbent for arsenic removal: core/shell structural nano zero-valent iron/manganese oxide

Recently, nano zero-valent iron (nZVI) has emerged as an effective adsorbent for the removal of arsenic from aqueous solutions. However, its use in various applications has suffered from reactivity loss resulting in a decreased efficiency. Thus, the aim of this study was to develop an effective arsenic adsorbent as a core/shell structural nZVI/manganese oxide (or nZVI/Mn oxide) to minimize the reactivity loss of the nZVI. As the major result, the arsenic adsorption capacities of the nZVI/Mn oxide for As(V) and As(III) were approximately two and three times higher than that of the nZVI, respectively. In addition, the As(V) removal efficiency of the nZVI/Mn oxide was maintained through 4 cycles of regeneration whereas that of the nZVI was decreased significantly. The enhanced reactivity and reusability of the nZVI/Mn oxide can be successfully explained by the synergistic interaction of the nZVI core and manganese oxide shell, in which the manganese oxides participate in oxidation reactions with corroded Fe²⁺ and subsequently retard the release of aqueous iron providing additional surface sites for arsenic adsorption. In summary, this study reports the successful fabrication of a core/shell nZVI/Mn oxide as an effective adsorbent for the removal of arsenic from aqueous solutions.     

pH-gradient real-time aeration control for nitritation community selection in a non-porous hollow fiber membrane biofilm reactor (MBfR) with dilute wastewater

Nitritation (ammonium to nitrite) as a pre-treatment of Anammox (anaerobic ammonium oxidation) is a key step for an energy-efficient nitrogen-removal alternative from dilute wastewaters, e.g. anaerobically-treated sewage, with which limited study has achieved sustainable nitritation at ambient temperature and short hydraulic retention times. To this end, pH-gradient real-time aeration control in an oxygen-based membrane biofilm reactor was observed at 20 °C in the sequencing batch mode. An optimum oxygen supply via diffusion for ammonium-oxidizing bacteria (AOB) was established, but nitrite-oxidizing bacteria (NOB) could be inhibited. The system achieved nitrite accumulation efficiencies varying from 88% to 94% with the aeration control. Mass balance and rate performance analyses indicate that this aeration control is able to supply an oxygen rate of 1.5 mol O₂ mol^?1 ammonium fed, the benchmark oxygenation rate based on stoichiometry for nitritation community selection. Microbial analyses confirmed AOB prevalence with NOB inhibition under this aeration control.     

Improving the activity of Mn/TiO2 catalysts through control of the pH and valence state of Mn during their preparation

In this study, the authors investigated the influence of the valence state of Mn on the efficacy of selective catalytic reduction using a Mn-based catalyst. The nitrogen oxides (NOx) conversion rate of the catalyst was found to be dependent on the type of TiO2 support employed and on the temperature, as the catalyst showed an excellent conversion of > 80% at a space velocity of 60,000 hr(-1) when the temperature was above 200 degrees C. Brunauer-Emmett-Teller, X-ray diffraction, and X-ray photoelectron spectroscopy analyses confirmed that catalyst displaying the highest activity contained the Mn4+ species and that its valence state was highly dependent on the pH during the catalyst preparation.     

Physicochemical properties of chars at different treatment temperatures

In this study, the physicochemical properties of the char of Indonesian SM coal following heat treatment at various temperatures were evaluated using X-ray photoelectron spectroscopy (XPS), Fourier-transform infrared spectroscopy (FT-IR), scanning electron microscopy (SEM), and morphological and specific surface area analysis. Based on these analyses, heat treatment of coal was determined to be the most effective in increasing the coal rank. In the XPS analysis, the C-O and C-O-C groups and quaternary-N species were found to be of a lower grade coal when the pretreatment temperature decreased, meanwhile the C-C group and pyridinic species increased. In the FT-IR analysis, the collapse of the C-O and C-O-C group was observed due to the collapse of the ether group. In SEM and Brunauer-Emmett-Teller (BET) analysis, a decrease in the ether group was shown to be accompanied with the formation of micropores.     

Analysis of the nitrifying bacterial community in BioCube sponge media using fluorescent in situ hybridization (FISH) and microelectrodes

There is growing interest in the development of more cost-effective and retrofit technologies for the upgrade and expansion of existing wastewater treatment plants with extreme space constraints. A free-floating sponge media (BioCube) process, using a 24L lab scale reactor, was operated to study the nitrification profiles and microbial community. The COD removal efficiencies were maintained, at an average of 95%, with the mixed liquor suspended solids (MLSS) inside the BioCube sponge media maintained at 12,688mg/L. The nitrification removal efficiencies were between 92% and 100%, with an average value of 99%. From the results of microelectrode measurements, the ammonium ion concentration was found to rapidly decrease from the surface of the BioCube sponge media to a depth of 2mm due to chemical reactions carried out by ammonia oxidizing bacteria (AOB) species. Multi-fluorescence in situ hybridization (FISH) has been used to investigate the spatial distributions of various microbial activities within reactors. Microbial communities were targeted using different oligonucleotide probes specific to AOB and nitrite oxidizing bacteria (NOB). There were a large number of AOB populations, but these were not uniformly distributed in the biofilm compared to the NOB populations.     

Ozonation of pentachlorophenol in unsaturated soils

A heterogeneous model was developed to describe interactions between ozone and hydrophobic organic compounds, exemplified by pentachlorophenol, in highly gas-saturated vadose zones where water moisture was limited to a thin film on soil particle surfaces. The soil was assumed to be free of soil organic matter. The model included a set of transient equations considering diffusion with simultaneous chemical reaction and hydrophobic partitioning. From dimensionless analysis, it was found that the film concentrations of ozone and the hydrophobic organic component were dependent on the Damk?hler numbers. Effects of Damk?hler numbers on the film profiles of components were examined. With the interfacial flux of ozone calculated from film profiles, dimensionless governing equations of ozone transport and contaminant removal across an experimental column were established. These equations were dependent on the Stanton number. One-dimensional column experiments were conducted to test the model. The optimal time for flow rate adjustment during the process was approximated. Finally, effects of ozone velocity and ozone gas concentration on the Stanton number were evaluated.     

Characterization of the monthly variation in (1 → 3)-β-d-glucan concentrations in university laboratories

We characterize the monthly variation in (1 → 3)-β-d-glucan concentration measured over the course of 1 year, and we evaluate the characteristics of size selection using a two-stage cyclone sampler. The (1 → 3)-β-d-glucan concentrations were measured in four bio-related laboratories. A total of 156 samples were collected using a new two-stage cyclone sampler. Analysis of (1 → 3)-β-d-glucan was performed using the kinetic Limulus amebocyte lysate assay. The study showed that airborne (1 → 3)-β-d-glucan concentrations were significantly higher in laboratory D (mean ± SD 1,105?±?1,893 pg/m³) and in the spring (5,458 pg/m³). The highest concentration of (1 → 3)-β-d-glucan occurred in the spring, particularly in May.     

Natural and anthropogenic influences on heavy metals in airborne particles over the Korean Peninsula

Six monitoring stations were selected to characterize the variations in airborne concentrations of heavy metals in South Korea between 1999 and 2012. Three stations represented higher concentrations, and three represented lower concentrations. The heavy metals monitored at these stations include cadmium, chromium, copper, iron (Fe), lead, manganese (Mn), and nickel. During the study period, concentrations of heavy metals at many stations, including those around the Seoul metropolitan area, showed a decreasing trend. However, concentrations of Mn and Fe that are primarily of crustal origin increased at four of the six stations. Some stations were significantly affected by emissions from the local industrial complex (IC), and heavy metal concentrations at those stations were relatively high even in summer. Many heavy metal concentrations were higher in spring than in winter, but wintertime concentrations of Cr and Pb were higher at the stations representing lower concentrations due to the dominant influence of combustion emissions. At stations less affected by emissions from the IC, concentrations of Fe and Mn that are predominantly crustal in origin were higher in spring, when Asian dust (AD) events are most frequent. Although Mn concentrations were also high at stations within the steelmaking IC during AD periods, they were much higher during non-AD periods due to local emissions. Variations in heavy metal concentrations, which are heavily influenced by emissions from the IC, warrant individual analysis because their emission characteristics differ from those of typical cases.     

Selective leaching of valuable metals from waste printed circuit boards

This study was carried out to recover valuable metals from the printed circuit boards (PCBs) of waste computers. PCB samples were crushed to smaller than 1 mm by a shredder and initially separated into 30% conducting and 70% nonconducting materials by an electrostatic separator. The conducting materials, which contained the valuable metals, were then used as the feed material for magnetic separation, where it was found that 42% of the conducting materials were magnetic and 58% were nonmagnetic. Leaching of the nonmagnetic component using 2 M H2SO4 and 0.2 M H2O2 at 85 degrees C for 12 hr resulted in greater than 95% extraction of Cu, Fe, Zn, Ni, and Al. Au and Ag were extracted at 40 degrees C with a leaching solution of 0.2 M (NH4)2S2O3, 0.02 M CuSO4, and 0.4 M NH4OH, which resulted in recovery of more than 95% of the Au within 48 hr and 100% of the Ag within 24 hr. The residues were next reacted with a 2 M NaCl solution to leach out Pb, which took place within 2 hr at room temperature.     

Seasonal characteristics of chemically apportioned aerosol optical properties at Seoul and Gosan,Korea

Seasonal variations of aerosol optical properties in Seoul (polluted urban site) and Gosan (coastal background site), Korea, with an emphasis on the relative humidity were investigated using ground-based aerosol measurements and optical model calculations. The mass fraction of elemental carbon was 9–20%, but the optical contribution of these particles to light extinction was higher, up to 33–55% in Seoul. In Gosan, the contribution of non-sea-salt water-soluble aerosols on extinction was 81–93% due to the high mass fraction of these particles. Based on daily MODIS datasets, our analysis showed that the aerosol optical depths at Seoul and Gosan were highest in spring due to the influence of dust particles. The aerosol water content at Gosan, calculated using a thermodynamic equilibrium model, was higher than that at Seoul; this was attributed to the high relative humidity and high fraction of water-soluble aerosols at Gosan. At Seoul, despite abundant water vapors in summer, the possibility of hygroscopic growth of water-soluble aerosols was not more significant than that at Gosan.