Inactivation of Ascaris eggs in soil by microwave treatment compared to UV and ozone treatment

This study reports on the effect of microwave radiation for inactivation of Ascaris lumbricoides eggs in 25 g of soil compared to ultraviolet irradiation and ozone expose. Microwave radiation at 700 W with 14% water content (w/w) achieved approximately 2.5 log inactivation of eggs in soil within 60 s. On the other hand, UV irradiation at 3 mW cm⁻² with and without shaking soil for 3600 s achieved approximately 0.32 and 0.01 log inactivation of eggs, respectively. In ozone treatment, 0.13 log inactivation of eggs was achieved with 5.8 ± 0.7 mg L⁻¹ of dissolved ozone dose for 30 min in a continuous diffusion reactor. In addition, the inactivation of eggs by three disinfection techniques was conducted in water in order to compare the inactivation efficiency of eggs in soil. The inactivation efficiency of microwave radiation was found to be no significant difference between in soil and water. However, the inactivation efficiency of UV irradiation was significantly increased in water while in ozone expose there was no significant difference between in soil and water. Microwave treatment thus proved to be the most efficient method in controlling A. lumbricoides eggs in soil.     

Managing scuba divers to meet ecological goals for coral reef conservation

Marine protected areas increasingly are challenged to maintain or increase tourism benefits while adequately protecting resources. Although carrying capacity strategies can be used to cope with use-related impacts, there is little understanding of divers themselves, their management preferences, and how preferences relate to conservation goals. By using a stated preference choice modeling approach, we investigated the choices divers make in selecting diving trips to marine protected areas as defined by use level, access, level of supervision, fees, conservation education, and diving expectations. Logit models showed that divers preferred a more restrictive management scenario over the status quo. Divers favored reductions in the level of site use and increased levels of conservation education. Divers did not favor fees to access protected areas, having less access to the resource, or extensive supervision. Finally, divers were much more willing to accept increasingly restrictive management scenarios when they could expect to see increased marine life.     

Effect of amorphous silica and silica sand on removal of chromium(VI) by zero-valent iron

The effect of two surfaces (amorphous silica and silica sand) on the reduction of chromium(VI) by zero-valent iron (Fe(0)) was investigated using batch reactors. The amendment of both surfaces significantly increased the rate and extent of Cr(VI) removal. The rate enhancement by amended surfaces is presumed to result from scavenging of Fe(0)-Cr(VI) reaction products by the provided surfaces, which minimized surface deactivation of Fe(0). The rate enhancing effect was greater for silica compared to sand, and the difference is attributed to silica's higher surface area, greater affinity for reaction products and pH buffering effect. For a given mass of Fe(0), the reactivity and longevity of Fe(0) to treat Cr(VI) increased with increasing dose of silica. Elemental analyses of the reacted iron and silica revealed that chromium removed from the solution was associated with both surfaces, with its mass distribution being approximately 1:1 per mass of iron and silica. The overall result suggests reductive precipitation was a predominant Cr(VI) removal pathway, which involves initial reduction of Cr(VI) to Cr(III), followed by formation of Cr(III)/Fe(III) hydroxides precipitates.     

Lead and cadmium contaminations in feathers of heron and egret chicks

In birds, concentrations of heavy metal contaminants were associated with their diet and environmental quality. This study presents concentrations of lead and cadmium in feathers and the relationship between concentrations in the feather and stomach content of three species of heron and egret chicks. Cadmium concentrations were higher in the Little Egret (geomean 0.75 μg/g dry weight) and Black-crowned Night Heron (geomean 0.88 μg/g dry weight) chicks than in Grey Heron chicks (geomean 0.48 μg/g dry weight). Lead and cadmium concentrations had significant correlations between feathers and stomach contents of heron and egret chicks. The mean lead and cadmium concentrations in feathers were within the background levels for wild birds. Heron and egret species forage around breeding colony (4–7 km). Lead and cadmium concentrations in heron and egret chicks were moderately associated with those of prey concentrations. These results suggest that contaminant concentrations such as lead and cadmium in feathers of heron and egret chicks can reflect local heavy metal contaminations and serve as a great biological indicator for monitoring heavy metal contamination. In addition, the feathers can be a routine monitoring tool over time and space without harming the wild birds.     

Biological monitoring of heavy metal contaminations using owls

Iron, manganese, copper, lead and cadmium were measured in the livers, muscles, kidneys and bones of Eurasian Eagle Owls (Bubo bubo), Brown Hawk Owls (Nixos scutulata) and Collared Scops Owls (Otus lempiji) from Korea. Iron concentrations by tissue within species did not differ, but there were significant differences among tissues across all species. Manganese and copper concentrations in muscles, kidneys and bones, but not livers, differed among species and also differed among tissues in the three owl species. We suggest that manganese and copper concentrations from this study were far below the level associated with their toxicity. Lead concentrations significantly differed among all species for livers and bones, and among tissues for each species. Cadmium concentrations were significantly different among species for all tissues and among tissues in Eurasian Eagle Owls and Collared Scops Owls. For most samples, lead concentrations in livers and bones, and cadmium in livers and kidneys, were within the background levels for wild birds. For some Eurasian Eagle Owls and Collared Scops Owls, lead concentrations were at an acute exposure level, whilst lead concentrations were at a chronic exposure level in Brown Hawk Owls. Cadmium concentrations were at a chronic exposure level in all three owl species. Acute and chronic poisoning was significantly correlated between indicator tissues. We suggest that lead and cadmium contamination in Eurasian Eagle Owls may reflect a Korean source, Brown Hawk Owls may reflect Korean and wintering sites, and Collared Scops Owls may reflect breeding and/or wintering sites.     

Changes in the sorption and rate of 17β-estradiol biodegradation by dissolved organic matter collected from different water sources

The potential biodegradation and subsequent transformation of 17β-estradiol (E2) to estrone (E1) were examined in the presence of various dissolved organic matter (DOM) isolated from effluent, river and lake waters. In addition, estrogenicity was estimated in association with the removal of E2 via its sorption onto DOM and biodegradation. The more biodegradable lake-derived DOM promoted more extensive transformation of E2 into E1 than the effluent organic matter through a biodegradation process. Overall, under all conditions, biodegradation dominated the removal of E2 in water. The increased dissolved organic carbon (DOC) concentrations in river and lake-derived DOM (e.g. 6.5 mg C L(-1)) reduced the removal of E2 by decreasing its biodegradation due to the moderate sorption of E2 onto DOM. The effluent organic matter showed greater removal of E2 via biodegradation, as well as significantly high sorption. This was associated with a large amount of hydrophobic fulvic acid (FA)- and humic acid (HA)-like organic components, as shown by the small increase in the specific UV absorbance at 254 nm (SUVA(254)). An increase in the DOC concentration reduced the removal of E2, resulting in high estrogenicity. The present study suggests that both organic composition and DOC concentration influenced the removal of E2 and, therefore, should be fully considered when assessing estrogenicity and its impacts on the aquatic environment.     

Hydro-thermal reaction according to the CaO/SiO2 mole-ratio in silico-manganese slag

Journal of Material Cycles and Waste Management - SiMn slag is a by-product of the production of ferroalloy, and has a chemical composition that could be used as a cement admixture. It is not...     

A real-time monitoring and assessment method for calculation of total amounts of indoor air pollutants emitted in subway stations

Subway systems are considered as main public transportation facility in developed countries. Time spent by people in indoors, such as underground spaces, subway stations, and indoor buildings, has gradually increased in the recent past. Especially, operators or old persons who stay in indoor environments more than 15 hr per day usually influenced a greater extent by indoor air pollutants. Hence, regulations on indoor air pollutants are needed to ensure good health of people. Therefore, in this study, a new cumulative calculation method for the estimation of total amounts of indoor air pollutants emitted inside the subway station is proposed by taking cumulative amounts of indoor air pollutants based on integration concept. Minimum concentration of individual air pollutants which naturally exist in indoor space is referred as base concentration of air pollutants and can be found from the data collected. After subtracting the value of base concentration from data point of each data set of indoor air pollutant, the primary quantity of emitted air pollutant is calculated. After integration is carried out with these values, adding the base concentration to the integration quantity gives the total amount of indoor air pollutant emitted. Moreover, the values of new index for cumulative indoor air quality obtained for 1 day are calculated using the values of cumulative air quality index (CAI). Cumulative comprehensive indoor air quality index (CCIAI) is also proposed to compare the values of cumulative concentrations of indoor air pollutants. From the results, it is clear that the cumulative assessment approach of indoor air quality (IAQ) is useful for monitoring the values of total amounts of indoor air pollutants emitted, in case of exposure to indoor air pollutants for a long time. Also, the values of CCIAI are influenced more by the values of concentration of NO₂, which is released due to the use of air conditioners and combustion of the fuel. The results obtained in this study confirm that the proposed method can be applied to monitor total amounts of indoor air pollutants emitted, inside apartments and hospitals as well.

Implications: Nowadays, subway systems are considered as main public transportation facility in developed countries. Time spent by people in indoors, such as underground spaces, subway stations, and indoor buildings, has gradually increased in the recent past. Especially, operators or old persons who stay in the indoor environments more than 15 hr per day usually influenced a greater extent by indoor air pollutants. Hence, regulations on indoor air pollutants are needed to ensure good health of people. Therefore, this paper presents a new methodology for monitoring and assessing total amounts of indoor air pollutants emitted inside underground spaces and subway stations. A new methodology for the calculation of cumulative amounts of indoor air pollutants based on integration concept is proposed. The results suggest that the cumulative assessment approach of IAQ is useful for monitoring the values of total amounts of indoor air pollutants, if indoor air pollutants accumulated for a long time, especially NO₂ pollutants. The results obtained here confirm that the proposed method can be applied to monitor total amounts of indoor air pollutants emitted, inside apartments and hospitals as well.     

Properties of alkali-activated systems with stone powder sludge

This article investigates the effects of stone powder sludge on the microstructure and strength development of alkali-activated fly ash and blast furnace slag mixes. Stone powder sludge produced from a crushed aggregate factory was used to replace fly ash and granulated blast furnace slag at replacement ratios of 0%, 10%, 20%, and 30% by mass. The unit weight and compressive strength of the samples were measured, and scanning electron microscopy/energy dispersive spectroscopy and X-ray diffraction (XRD) analyses were performed. The test results indicated that the compressive strength of alkali-activated blast furnace slag mixes using stone powder sludge was higher than that of the alkali-activated blast furnace slag control mix, but the compressive strength of alkali-activated fly ash mixes decreased with increasing replacement ratio of stone powder sludge. Microscopy results indicated that for alkaliactivated blast furnace slag samples, broken surfaces were more evident than for the alkali-activated fly ash samples. For all XRD diagrams, broad and diffuse peaks were observed around 2θ = 35° (d = 2.96–3.03 Å), implying amorphous or short-ordering structure phases.