Urban-Center CO Air Quality Projections

The distribution of mutagenic activity and nitroaromatic components of polycyclic organic matter (POM) in ambient air at industrial, urban, suburban, rural, and remote sites was studied using organic extracts from high volume aerosol samples. Direct-acting mutagens including 1-nitropyrene (1-NP), dinitropyrenes (DNP), and hydroxynitropyrenes (HNP) were measured by high performance liquid chromatography while the mutagenicity was determined in the Salmonella bioassay with strain TA-98. Benzo(a)pyrene (BaP), one of the possible precursors of nitroaromatic compounds in POM, was also measured. In comparing samples from a range of sites, TSP and the concentration of BaP per mass of particulate matter decreased, as expected, at greater distances from urban and industrial combustion sources. However, the concentrations of polar nitroaromatic POM compounds per mass of particles were higher at a remote site than in nonindustrial urban and suburban areas. The mutagenicity in particulate matter extracts from the remote area was predominantly (>90 percent) in the very polar fractions. There were also high atmospheric levels of nitroaromatic compounds and mutagenicity in heavily industrialized areas. These observations may reflect the influences of source emissions, atmospheric transformations of POM compounds, and ther atmospheric processes on the composition of ambient suspended particulate matter.     

Contamination of the Lake Tahoe Air Basin by High Molecular Weight Petroleum Residues

The atmosphere of the Lake Tahoe air basin is contaminated with high molecular weight (> C₁₂) petroleum hydrocarbons. Aerosol samples were collected by high-volume filtration and the solvent-soluble organic matter was analyzed. The relative concentrations of petroleum residues found were as follows: winter > summer and day > night. This contamination is primarily due to the poorer combustion of diesel and home heating fuels at that altitude and during periods of colder climate.     

Technical Aspects of Lime/Limestone Scrubbers for Coal-Fired Power Plants

This is the conclusion of a 2-part article dealing with the technical aspects of lime/limestone scrubbers for coal-fired power plants, it covers instrumentation, participate removal and sludge disposal. Part I (June JAPCA) covered process chemistry and scrubber systems     

Environmental Auditing—A Timely and Effective Tool

The requirements of environmental regulations imposed on industry are complex and expensive. As these regulations have developed, corporate compliance programs have had to become more sophisticated. For many, this means that an environmental auditing program is now timely (or overdue) for organizing their approach to meeting the constraints of these regulations. Contributing to this timeliness is a renewed emphasis by regulators on enforcement activities. This paper discusses what environmental auditing is and what it consists of, gives examples from a few approaches which are currently being used, and reviews some of its benefits and liabilities.     

Predicting and Managing the Health Risks of Sour-Gas Wells

The development of sour-gas resources in Canada and the United States has prompted concerns about the public health risks of accidental releases of gas contaminated with hydrogen sulfide (H₂S) from wells. This paper focuses on methods for improving the prediction and management of those risks. Data associated with the health effects of hydrogen sulfide are examined, and it is suggested that sublethal effects should be addressed in risk assessments of sour-gas wells along with the life-threatening effects normally considered. The demarcation of hazard zones around wells can be improved by using a statistical approach for estimating an upper-bound H₂S release rate; this rate can then be used in an atmospheric dispersion model to estimate maximum distances to downwind concentrations for lethal (300 ppmv) and sublethal (50 ppmv) effects resulting from an accidental release. A vertical release is found to have little impact, especially under stable atmospheric conditions; horizontal releases, on the other hand, result in the greatest downwind distances for health impacts. Management of health risks depends on a mix of safety technologies and contingency actions, such as well-ignition options and provision for post-release monitoring and assessment of ambient H₂S concentrations.     

Oxygen Stratification in Industrial Boiler Stacks

The DSS/2 software system was used to numerically simulate oxygen stratification effects in a typical industrial boiler stack. The model developed for the simulation involves turbulent mass transfer in a tube with a constant, high mass flux from the walls of the tube. The concentration profile is considered to be developing, but the velocity profile is assumed to be fully developed. The model is for a gaseous system at constant temperature and pressure; the transport properties are shown to be constant. The universal velocity profile for turbulent flow and von Karman’s expressions for the turbulent eddy diffusivity are incorporated in the model. An expression for a wall concentration profile corresponding to conditions of high mass flux at the wall is developed. The model is then expressed as a system of partial differential equations which are solved using the numerical method of lines together with the DSS/2 numerical integration system. The resulting concentration profiles are presented for various flux rates which might be encountered in a typical stack. These profiles indicate that a potential for oxygen stratification in stacks does exist; they also suggest that careful placement of the oxygen cell probe can help minimize such errors.     

A New Audit Technique for EPA Method 25

A simple, inexpensive, and accurate technique for evaluating or auditing the sampling, recovery, and analytical phases of EPA Source Reference Method 25 has been developed. The technique involves spiking a U-shaped stainless steel cartridge containing Tenax® with known quantities of selected organic compounds and thermally desorbing them at temperatures from 160°C to 180°C to generate organic vapors quantitatively. The major advantages of this technique are that no other measurement methods can be used to determine the generated organic concentrations in lieu of Method 25; and that the cartridge can easily be taken to the field for evaluation. The organic compounds generated in test runs are collected and analyzed using the Method 25 procedure. The generation of organics is quantitative and recoveries were found to be 100 ± 10%. The time required for desorption of the majority of organics is generally less than forty-five minutes at a flow rate of 100 mL/min; however, based on laboratory experience the recommended sampling time is sixty minutes. These spiked cartridges are stable at room temperature over a two-month period. Results of interlaboratory studies showed close agreement with the expected concentrations based on calculations from the mass loadings and sample volumes.