Surfactant enhanced recovery of tetrachloroethylene from a porous medium containing low permeability lenses. 1. Experimental studies

A matrix of batch, column and two-dimensional (2-D) box experiments was conducted to investigate the coupled effects of rate-limited solubilization and layering on the entrapment and subsequent recovery of a representative dense NAPL, tetrachloroethylene (PCE), during surfactant flushing. Batch experiments were performed to determine the equilibrium solubilization capacity of the surfactant, polyoxyethylene (20) sorbitan monooleate (Tween 80), and to measure fluid viscosity, density and interfacial tension. Results of one-dimensional column studies indicated that micellar solubilization of residual PCE was rate-limited at Darcy velocities ranging from 0.8 to 8.2 cm/h and during periods of flow interruption. Effluent concentration data were used to develop effective mass transfer coefficient (Ke) expressions that were dependent upon the Darcy velocity and duration of flow interruption. To simulate subsurface heterogeneity, 2-D boxes were packed with layers of F-70 Ottawa sand and Wurtsmith aquifer material within 20-30 mesh Ottawa sand. A 4% Tween 80 solution was then flushed through PCE-contaminated boxes at several flow velocities, with periods of flow interruption. Effluent concentration data and visual observations indicated that both rate-limited solubilization and pooling of PCE above the fine layers reduced PCE recovery to levels below those anticipated from batch and column measurements. These experimental results demonstrate the potential impact of both mass transfer limitations and subsurface layering on the recovery of PCE during surfactant enhanced aquifer remediation.     

ESF Workshop

Dioxin and PCB monitoring programs for food and feeding stuff in most countries of the world, including many European Countries are currently inadequate. Better control of food production lines and food processing procedures is needed to minimize entry of dioxin to the food chain and will help to avoid dioxin contamination accidents. This would also improve the ability to trace back a possible contamination to its source. European guidelines for monitoring programs should be established to ensure comparable and meaningful results. These guidelines should define the minimum requirements for the design of monitoring programs, analytical methods, and quality assurance. Though data from Northern Europe shows that the general population exposure to dioxin and PCB has decreased during the last ten years these compounds continue to be a risk of accidental contamination of the food chain. The most prominent recent example is the Belgian dioxin contamination of feeding stuff in 1999. The Belgian dioxin contamination was not detected due to dioxin monitoring programs but by their direct biological effects seen in animals. Four other cases of dioxin contamination have been detected in Europe since 1997 due to local monitoring programs. One of them (citrus pulp pellets 1998) was in a much larger scale than the Belgian dioxin contamination. The general population's exposure to dioxins and PCBs is still in the same range (1-4 pg WHO-TEQ/kg body weight and day) as the recently revised WHO tolerable daily intake (TDI). There is concern that short-term high level exposure to dioxins, furans, and PCB may cause biological effects on the human fetal development and further research is required. Further actions to control sources building on considerable advances already made in many countries may need to be supplemented by measures to prevent direct contamination of feeding stuff or food to reduce general population exposure further.     

Formation of PCDDs and PCDFs during the combustion of polyvinylidene chloride

In laboratory-scale combustion of polyvinylidene chloride (PVDC) with a quartz tubular furnace designed and fabricated to provide the desired combustion temperature and mixing state of combustion gas with air, it was found that at 800 degrees C or higher the level of polychlorinated dibenzo-p-dioxins/polychlorinated dibenzofurans [corrected] (PCDDs/PCDFs) resulting from PVDC combustion was no higher than that from heating air alone, and thus far below the levels which resulted from PVDC combustion at 750 degrees C or lower. The results provide the first laboratory confirmation of the relation between PVDC incineration temperature and PCDD/PCDF formation, and of the primary importance of high temperature, turbulence for mixing between air and combustion gas, and sufficient residence time, as governing factors for the minimization of PCDD/PCDF formation in municipal solid waste incinerators.     

Disinfection by-products in Finnish drinking waters

Disinfection by-products (DBPs) were measured in plant effluents of 35 Finnish waterworks, which utilized different treatment processes and raw water sources. DBPs were measured also from the distribution systems of three waterworks. Di- and trichloroacetic acids, and chloroform were the major DBPs found in treated water samples. The concentration of six haloacetic acids (HAA6) exceeded the concentrations of trihalomethanes (THMs). Chlorinated drinking waters (DWs) originating from surface waters contained the highest concentration of HAA6 and THMs: 108 and 26 microg/l, respectively. The lowest concentrations of DBPs were measured from ozonated and/or activated carbon filtrated and chloraminated DWs. Higher concentrations of HAA6, THMs, and adsorbable organic halogens were measured in summer compared to winter. The levels of chlorinated acetic acids, chloroform, and bromodichloromethane correlated positively with mutagenicity. Past mutagenicity levels of DWs were examined. A major reduction in the use of prechlorination, increased use of chloramine disinfection, and better removal of organic carbon were the most important reasons for the 69% decrease in mutagenicity from 1985 to 1994.     

Performance assessment of NAPL remediation in heterogeneous alluvium

Over the last few years, more than 40 partitioning interwell tracer tests (PITTs) have been conducted at many different sites to measure nonaqueous phase liquid (NAPL) saturations in the subsurface. While the main goal of these PITTs was to estimate the NAPL volume in the subsurface, some were specifically conducted to assess the performance of remedial actions involving NAPL removal. In this paper, we present a quantitative approach to assess the performance of remedial actions to recover NAPL that can be used to assess any NAPL removal technology. It combines the use of PITTs (to estimate the NAPL volume in the swept pore volume between injection and extraction wells of a test area) with the use of several cores to determine the vertical NAPL distribution in the subsurface. We illustrate the effectiveness of such an approach by assessing the performance of a surfactant/foam flood conducted at Hill Air Force Base, UT, to remove a TCE-rich NAPL from alluvium with permeability contrasts as high as one order of magnitude. In addition, we compare the NAPL volumes determined by the PITTs with volumes estimated through geostatistical interpolation of aquifer sediment core data collected with a vertical frequency of 5-10 cm and a lateral borehole spacing of 0.15 m. We demonstrate the use of several innovations including the explicit estimation of not only the errors associated with NAPL volumes and saturations derived from PITTs but also the heterogeneity of the aquifer sediments based upon permeability estimates. Most importantly, we demonstrate the reliability of the     

Induction of PAH-catabolism in mushroom compost and its use in the biodegradation of soil-associated phenanthrene

This paper describes the induction of phenanthrene-catabolism within Phase II mushroom compost resulting from its incubation with (1) phenanthrene, and (2) PAH-contaminated soil. Respirometers measuring mineralization of freshly added 14C-9-phenanthere were used to evaluate induction of phenanthrene-catabolism. Where pure phenanthrene (spiked at a concentration of 400 mg kg(-1) wet wt.) was used to induce phenanthrene-catabolism in compost, induction was measurable, with maximal mineralization observed after 7 weeks phenanthrene-compost contact time. Where PAH-contaminated soil was used to induce phenanthrene-catabolism in un-induced compost, induction was observed after 5 weeks soil-compost contact time. Microcosm-scale amelioration of soil contaminated with 14C-phenanthrene (aged in soil for 516 days prior to incubation with compost) indicated that both induced (using pure phenanthrene) and uninduced Phase II mushroom composts were equally able to promote degradation of this soil-associated contaminant. After 111 days incubation time, 42.7 +/- 6.3% loss of soil-associated phenanthrene was observed in the induced-compost soil mixture, while 36.7 +/- 2.9% loss of soil-associated phenanthrene was observed in the uninduced-compost soil mixture. These results are notable as they indicate that while pre-induction of phenanthrene-catabolism within compost is possible, it does not significantly increase the extent of degradation when the compost is used to ameliorate phenanthrene-contaminated soil. Thus, compost could be used directly in the amelioration of contaminated land i.e. without pre-induction of catabolism.     

Potential role of fire retardant-treated polyurethane foam as a source of brominated diphenyl ethers to the US environment

Five tetra- to hexabrominated diphenyl ether (BDE) congeners (BDE-47, -99, -100, -153 and -154) are the most frequently reported in wildlife and humans. The commercial penta-BDE product, used predominantly to flame-retard polyurethane foam, consists primarily of these same congeners. In 1999, North American demand accounted for 98% of the total global penta-market of 8500 metric tons. Frogs, housed with flame retardant-treated polyurethane foam as a dry substrate, accumulated 10,100 microg/kg (wet weight) of the above BDEs. Crickets kept therein as food contained 14,400 microg/kg. The crickets are believed to have browsed directly on the foam and, in turn, were consumed by the frogs. BDE congener composition in all three matrices matched that of the penta-commercial product. Similar congeners were also observed in soil and stream sediments collected near a polyurethane foam manufacturing plant. Summed concentrations of BDE-47, -99 and -100, the dominant congeners observed in these samples, ranged from < 1 to 132 microg/kg (dry weight basis). Sunfish fillets obtained from a nearby, off-site pond contained a total of 624 microg/kg (lipid basis). Sewage treatment plant (STP) sludge exhibited these same congeners at 1370 microg/kg (dry weight). BDE-209, the fully brominated congener predominant in the commercial deca-BDE product, was also present at 1470 microg/kg. While no known polyurethane foam manufacturers discharged to this plant, the distribution pattern of the low brominated congeners in the sludge matched that of the penta-product. After four weeks of exposure to ambient outdoor conditions, the surface of flame-retarded polyurethane foam became brittle and began to disintegrate. Subsequent dispersal of these penta-containing foam fragments may be one mechanism by which these BDEs reach the environment.     

Variation in CO2 assimilation rate induced by simulated dew waters with different sources of hydroxyl radical (*OH) on the needle surfaces of Japanese red pine (Pinus densifora Sieb. et Zucc.)

The hydroxyl radical (*OH) is generated in polluted dew on the needle surfaces of Japanese red pine (Pinus densiflora Sieb. et Zucc.). This free radical, which is a potent oxidant, is assumed to be a cause of ecophysiological disorders of declining trees on the urban-facing side of Mt. Gokurakuji, western Japan. Mists of *OH-generating N(III) (HNO2 and NO2-) and HOOH + Fe + oxalate solutions (50 and 100 microM, pH 5.1-5.4) simulating the dew water were applied to the foliage of pine seedlings grown in open-top chambers in the early morning. Needles treated with 100 microM N(III) tended to have a greater maximum CO2 assimilation rate (Amax), a greater stomatal conductance (g(s)) and a greater needle nitrogen content (Nneedle), suggesting that N(III) mist acts as a fertilizer rather than as a phytotoxin. On the other hand, needles treated with 100 microM HOOH + Fe + oxalate solution showed the smallest Amax, g(s), and Nneedle, suggesting that the combination of HOOH + Fe + oxalate caused a decrease in needle productivity. The effects of HOOH + Fe + oxalate mist on pine needles were very similar to the symptoms of declining trees at Mt. Gokurakuji.     

Interaction webs in arctic ecosystems: Determinants of arctic change?

How species interact modulate their dynamics, their response to environmental change, and ultimately the functioning and stability of entire communities. Work conducted at Zackenberg, Northeast Greenland, has changed our view on how networks of arctic biotic interactions are structured, how they vary in time, and how they are changing with current environmental change: firstly, the high arctic interaction webs are much more complex than previously envisaged, and with a structure mainly dictated by its arthropod component. Secondly, the dynamics of species within these webs reflect changes in environmental conditions. Thirdly, biotic interactions within a trophic level may affect other trophic levels, in some cases ultimately affecting land–atmosphere feedbacks. Finally, differential responses to environmental change may decouple interacting species. These insights form Zackenberg emphasize that the combination of long-term, ecosystem-based monitoring, and targeted research projects offers the most fruitful basis for understanding and predicting the future of arctic ecosystems.     

High-level arsenite removal from groundwater by zero-valent iron

The objectives of this study were to conduct batch and column studies to (i) assess the effectiveness of zero-valent iron for arsenic remediation in groundwater, (ii) determine removal mechanisms of arsenic, and (iii) evaluate implications of these processes with regard to the stability of arsenic and long-term remedial performance of the permeable reactive barrier (PRB) technology. A high concentration arsenic solution (50 mg l(-1)) was prepared by using sodium arsenite (arsenic (III)) to simulate groundwater at a heavily contaminated Superfund site in the USA. Batch studies indicate that the removal of arsenic is a two-step reaction with fast initial disappearance of arsenite followed by a slow subsequent removal process. Flow-through columns were conducted at a flow rate of 17 ml h(-1) under reducing conditions for 6.6 mo. Kinetic analysis suggested that arsenic removal behaves as a zero-order reaction at high arsenic concentrations. Arsenic removal rate constants decreased with time and arsenic breakthrough was observed in the column study. Arsenic removal capacity of zero-valent iron was determined to be approximately 7.5 mg As/g Fe. Carbonate green rust was identified from the analysis of surface precipitates; arsenite uptake by green rust may be a major mechanism responsible for arsenic remediation by zero-valent iron. Analysis of HCl-extractable arsenic from iron samples indicated that approximately 28% of arsenic was in the form of arsenate suggesting that a surface oxidation process was involved in the arsenic removal with zero-valent iron.