Removal of sulfamethoxazole and sulfapyridine by carbon nanotubes in fixed-bed columns

Sulfamethoxazole (SMX) and sulfapyridine (SPY), two representative sulfonamide antibiotics, have gained increasing attention because of the ecological risks these substances pose to plants, animals, and humans. This work systematically investigated the removal of SMX and SPY by carbon nanotubes (CNTs) in fixed-bed columns under a broad range of conditions including: CNT incorporation method, solution pH, bed depth, adsorbent dosage, adsorbate initial concentration, and flow rate. Fixed-bed experiments showed that pH is a key factor that affects the adsorption capacity of antibiotics to CNTs. The Bed Depth Service Time model describes well the relationship between service time and bed depth and can be used to design appropriate column parameters. During fixed-bed regeneration, small amounts of SMX (3%) and SPY (9%) were irreversibly bonded to the CNT/sand porous media, thus reducing the column capacity for subsequent reuse from 67.9 to 50.4 mg g^?1 for SMX and from 91.9 to 72.9 mg g^?1 for SPY. The reduced column capacity resulted from the decrease in available adsorption sites and resulting repulsion (i.e., blocking) of incoming antibiotics from those previously adsorbed. Findings from this study demonstrate that fixed-bed columns packed with CNTs can be efficiently used and regenerated to remove antibiotics from water.     

人工浮床技术开发与应用研究进展

人工浮床作为一种新型的生态修复技术,主要依靠植物、微生物和水生动物的共同作用实现对水体的净化,具有不占用土地、不消耗能源、成本低、管理简单等优点,在地表水修复和污水净化中得到了越来越多的应用.然而,受植物生长速度和温度的影响,其在应用中仍存在净化能力差、适用范围有限等缺陷.优势植物筛选与植物刈割、微生物强化技术和水生动物强化法等途径可以在一定程度上解决这些问题.人工浮床中植物、微生物和水生动物在污染物去除中的耦合过程、微生物活性及影响因素和人工浮床的设计、构建及日常管理标准的制定等研究尚不深入,是限制人工浮床技术进一步推广的主要因素,也是未来研究的重点和难点.     

六氯苯微生物降解研究进展

微生物降解已经成为当前六氯苯环境污染治理研究的重点和前沿。介绍了六氯苯的结构、物理化学性质、来源及其危害,分析了其微生物降解的可行性,从降解菌群的来源、降解途径及降解的影响因素等方面,对六氯苯的微生物好氧降解和厌氧降解进行了系统地归纳和总结,同时对今后六氯苯微生物降解的研究方向进行了展望。     

天然和CPB改性沸石对Hg^2＋的吸附特征

通过静态实验研究溴代十六烷基吡啶（CPB）改性沸石和天然沸石对废水中Hg^2＋的吸附特性,探讨了吸附动力学、吸附平衡和吸附热力学机制。研究表明：Langmuir方程能较好地描述2种沸石对Hg^2＋的吸附,CPB改性沸石对Hg^2＋的吸附率得到显著提高。实验条件下,改性沸石对Hg^2＋的吸附率从67．5％提高到98．9％,吸附容量从0．521mg／g提高到3．07mg／g。利用准一级动力学方程、假二级动力学方程、颗粒内扩散模型和Elovich方程分别对动力学过程进行拟合,发现2种沸石对Hg^2＋的吸附均满足假二级动力学方程,且离子的颗粒内扩散对整个吸附过程有影响。动力学拟合、D-R方程拟合和热力学研究综合表明：2种沸石对Hg^2＋的吸附既存在化学吸附又存在物理吸附,吸附吉布斯自由能变（△G^0）、焓变（△H^0）、熵变（△S^0）均小于0,反应为自发的放热反应,低温有利于吸附的进行。     

微电解预处理靛蓝牛仔布印染废水

靛蓝牛仔布印染废水组分复杂,浓度高、水量大,属于难处理的工业废水,为了有效降低后续生物处理单元的负荷,采用铁炭微电解工艺对该废水进行预处理;通过正交实验考察pH、反应时间及铁炭比处理效果的影响规律及COD去除反应动力学,并对各因素作了单因素影响实验,确定了最佳工艺条件.结果表明,铁炭微电解法是预处理靛蓝牛仔布印染废水的一种有效方法,在Fe/C为2:1、pH为3的条件下反应90 min,铁炭微电解出水COD的去除率在49.2％,色度去除率达到80％,该印染废水经微电解处理后,BOD5/COD比值可从原来的0.248上升至0.436,可生化性明显提高.此外,微电解预处理靛蓝牛仔布印染废水中COD的去除反应符合二级反应动力学规律.     

无机陶瓷膜处理油田采出水

针对陶瓷膜在油田采出水处理过程中操作参数的选择及污染机理进行了研究。通过现场实验,分析了不同的操作参数对膜通量的影响,陶瓷膜对含油量及悬浮物的去除效果,膜阻力组成及膜污染清洗方法。实验结果表明,在确定出水水质达到低渗透油田注水水质A1级标准条件下,陶瓷膜过滤最佳操作条件为:跨膜压差0.16 MPa、温度50℃、膜面流速5.0 m/s。同时发现,NaOH和HNO3联合清洗有助于恢复膜通量。     

MFC-MBR耦合系统运行效果

膜生物反应器(MBR)是一种高效的污水处理工艺,而微生物燃料电池(MFC)能有效降解污泥中的胞外生物有机质(EBOM)并回收电能.将MFC与MBR联用,建立了一套能够有效抑制膜污染同时回收电能的新系统——MFC-MBR耦合系统,MBR的剩余污泥经MFC处理后回流.以传统MBR为对照,对耦合系统中污水处理效果、膜污染情况和污泥混合液的性质进行研究.研究表明,耦合系统的污水处理效果没有明显恶化,COD去除率为94％,NH4+-N的去除率为92％.耦合系统能够有效减缓膜污染的发生,清洗周期延长了28％.污泥混合液的MLVSS/MLSS稳定在80％ ～ 88％,系统内几乎没有无机颗粒积累.松散结合态胞外聚合物(LB-EPS)降低了48％,使污泥混合液性质得到改善.较低的污泥比阻(2.69×1012m/kg)和标准化毛细吸水时间(1.67 s·L/g MLSS),证明耦合系统污泥混合液脱水性能提高了.     

钙对李氏禾富集和耐受铬的调控作用

通过水培实验,研究钙对铬胁迫下李氏禾幼苗生理生化、草酸分泌及铬吸收量的影响,考察钙对李氏禾体内草酸合成的调控,进而促进李氏禾的铬耐性富集能力的作用。结果显示,不同浓度Cr³⁺胁迫下缺钙处理,李氏禾生长受抑制及质膜过氧化作用加剧,体内总草酸含量为对照处理的113%~169%,且主要表现为水溶性草酸含量显著高于对照,水溶性草酸含量为对照处理的135%~197%;高钙处理,李氏禾细胞膜透性、丙二醛（MDA）含量低于对照,李氏禾叶部总草酸含量为对照处理的125%~155%,且主要表现为不溶性草酸含量显著高于对照,其含量为对照处理的181%~270%。低浓度（0.2、0.4 mmol/L）铬胁迫下,高钙处理总铬含量分别为对照处理的175%和215%,高浓度（0.8、1.0 mmol/L）铬胁迫下,总铬含量与对照处理无显著差异（P>0.05）。可见,添加Ca²⁺能在一定Cr³⁺浓度胁迫下,有效缓解铬对李氏禾的毒害,且能通过提高植物体内不溶性草酸含量达到促进植物富集和耐受铬的能力。     

Effects of pH and ionic strength on sulfamethoxazole and ciprofloxacin transport in saturated porous media

Many antibiotics regarded as emerging contaminants have been frequently detected in soils and groundwater; however, their transport behaviors in soils remain largely unknown. This study examined the transport of two antibiotics, sulfamethoxazole (SMZ) and ciprofloxacin (CIP), in saturated porous media. Laboratory columns packed with quartz sand was used to test the effects of solution pH and ionic strength (IS) on their retention and transport. The results showed that these two antibiotics behaved differently in the saturated sand columns. In general, SMZ manifested a much higher mobility than CIP for all experimental conditions tested. Almost all SMZ transported through the columns within one pore volume in deionized water (i.e., pH=5.6, IS=0), but no CIP was detected in the effluents under the same condition after extended column flushing. Perturbations in solution pH (5.6 and 9.5) and IS (0 and 0.1M) showed no effect on SMZ transport in the saturated columns. When pH increased to 9.5, however, ~93% of CIP was eluted from the sand columns. Increase of IS from 0 to 0.1M also slightly changed the distribution of adsorbed CIP within the sand column at pH 5.6, but still no CIP was detected in the effluents. A mathematical model based on advection-dispersion equation coupled with equilibrium and kinetic reactions successfully simulated the transport of the antibiotics in water-saturated porous media with R(2)=0.99.     

Investigation of solution chemistry effects on sorption behavior of Cu(II) on ZSM-5 zeolite

The sorption of Cu(II) from an aqueous solution using ZSM-5 zeolite was investigated by batch technique under ambient conditions. Sorption was investigated as a function of pH, ionic strength, foreign ions, humic substances, and temperature. The results indicate that the sorption of Cu(II) on ZSM-5 zeolite is strongly dependent on pH. Sorption is dependent on ionic strength at low pH, but independent of ionic strength at high pH values. The presence of humic/fluvic acid (HA/FA) enhances the sorption of Cu(II) on ZSM-5 zeolite at low pH values, and reduces Cu(II) sorption at high pH values. Sorption isotherms were well simulated by the Langmuir model. Thermodynamic parameters (i.e., deltaH0, deltaS0 and deltaG0) for the sorption of Cu(II) were determined from temperature-dependent sorption isotherms at 293.15, 313.15, and 333.15 K, respectively. Results indicate that the sorption process of Cu(II) on ZSM-5 zeolite is spontaneous and endothermic.