露天铁矿分区爆破振动监测与安全分析

对放马峪铁矿三个采矿场分区爆破的振动速度进行了监测,在剔除异常值后得到了106组三向振动的峰值速度,然后对三向振动速度分别进行回归分析。分析结果表明:放马峪铁矿采取的爆破分区方案是安全可行的,符合《爆破安全规程》(GB6722-2003)的规定;爆破振动的三相回归公式中K值较小、α值较大,说明了毫秒延时爆破能够加快地震波的能量耗散,从而起到干扰降振的作用;同一次爆破中,爆破振动速度的垂直向分量不一定总是最大,在评价爆破振动产生的破坏时,不应单一选取爆破振动速度的垂直分量作为评判标准,而应选择建构筑物所处位置振动速度分量中的最大值。     

1982-2003年中国草地生物量时空格局变化研究

论文结合草地生物量调查资料、对应时段NDVI数据,分析了1982-2003年不同时期我国草地生物量空间格局变化特征及其与气候变化的关系。结果表明：20世纪80年代初期到末期,全国大部分地区草地生物量增加或基本持平;80年代末期到90年代初,大面积范围内草地生物量降低,热性草丛、温性草甸草原、山地草甸、低地草甸下降幅度分别为10.86%、4.96%、4.86%、3.49%;90年代末期后,北方大部分地区草地生物量上升到80年代的水平,南方草地生物量略有上升;1982-2003年草原区平均气温上升0.6~1.5℃,降雨量减少23.3%,草地生物量变化与降水量变化有弱相关关系（相关系数0.29）,与气温变化无关。     

絮凝剂用壳聚糖的中试生产研究

在实验室制备絮凝剂用壳聚糖的基础上,按工业化生产的要求对壳聚糖进行了中试生产研究.经正交试验确定了生产过程中脱钙、脱蛋白、脱乙酰等3步反应的最佳工艺参数. 由此中试工艺生产的壳聚糖的生产成本比国内同类产品下降了22%,生产周期缩短了66%,且主要性能指标均达到或超过国内外同类产品的水平.     

生态系统健康与环境管理

环境管理和生态系统健康是密不可分的,生态系统健康是环境管理的目的,生态系统健康为环境管理提供了新的思路、新的方法,健康的生态系统为实现区域可持续发展提供技术支撑和发展基础.生态系统健康的发展演替过程是优化环境管理的步骤.优化的环境管理为生态系统健康发展提供宏观决策和社会经济保障.本文从学科发展的角度论述了生态系统健康产生的背景、理论基础和应用途径;从学科交叉的角度论述了生态系统健康的评价和与环境管理的关系.提出了环境管理的目标:健康的生态系统→健康的环境→健康的食品→健康的人类生态系统→健康的社会发展.     

Recovery of Ni(II) from real electroplating wastewater using fixed-bed resin adsorption and subsequent electrodeposition

Resin adsorption and subsequent electrodeposition were used for nickel recovery. Treated wastewater can meet the Electroplating Pollutant Discharge Standard. The spent resin is completely regenerated by 3 BV of 4% HCl solution. 95.6% of nickel in concentrated eluent was recovered by electrodeposition. Effective recovery of high-value heavy metals from electroplating wastewater is of great significance, but recovering nickel ions from real electroplating wastewater as nickel sheet has not been reported. In this study, the pilot-scale fixed-bed resin adsorption was conducted to recover Ni(II) ions from real nickel plating wastewater, and then the concentrated Ni(II) ions in the regenerated solution were reduced to nickel sheet via electrodeposition. A commercial cation-exchange resin was selected and the optimal resin adsorption and regeneration conditions were investigated. The resin exhibited an adsorption capacity of 63 mg/g for Ni(II) ions, and the average amount of treated water was 84.6 bed volumes (BV) in the pilot-scale experiments. After the adsorption by two ion-exchange resin columns in series and one chelating resin column, the concentrations of Ni(II) in the treated wastewater were below 0.1 mg/L. After the regeneration of the spent resin using 3 BV of 4% (w/w) HCl solution, 1.5 BV of concentrated neutral nickel solution (>30 g/L) was obtained and used in the subsequent electrodeposition process. Using the aeration method, alkali and water required in resin activation process were greatly reduced to 2 BV and 3 BV, respectively. Under the optimal electrodeposition conditions, 95.6% of Ni(II) in desorption eluent could be recovered as the elemental nickel on the cathode. The total treatment cost for the resin adsorption and regeneration as well as the electrodeposition was calculated.     

Comparison of CNT-PVA membrane and commercial polymeric membranes in treatment of emulsified oily wastewater

CNT-PVA membrane was fabricated and compared with polymeric membranes. The separation performance was evaluated by homemade and cutting fluid emulsions. The three membranes show similar oil retention rates. CNT-PVA membranes have higher permeation fluxes compared with polymeric membranes. CNT-PVA membrane shows higher fouling resistance. Membrane separation is an attractive technique for removal of emulsified oily wastewater. However, polymeric membranes which dominate the current market usually suffer from severe membrane fouling. Therefore, membranes with high fouling resistance are imperative to treat emulsified oily wastewater. In this study, carbon nanotube-polyvinyl alcohol (CNT-PVA) membrane was fabricated. And its separation performance for emulsified oily wastewater was compared with two commercial polymeric membranes (PVDF membrane and PES membrane) by filtration of two homemade emulsions and one cutting fluid emulsion. The results show that these membranes have similar oil retention efficiencies for the three emulsions. Whereas, the permeation flux of CNT-PVA membrane is 1.60 to 3.09 times of PVDF membrane and 1.41 to 11.4 times of PES membrane, respectively. Moreover, after five consecutive operation circles of filtration process and back flush, CNT-PVA membrane can recover 62.3% to 72.9% of its initial pure water flux. However, the pure water flux recovery rates are only 24.1% to 35.3% for PVDF membrane and 6.0% to 26.3% for PES membrane, respectively. Therefore, CNT-PVA membrane are more resistant to oil fouling compared with the two polymeric membranes, showing superior potential in treatment of emulsified oily wastewater.     

In situ electron-induced reduction of NOx via CNTs activated by DBD at low temperature

• An in situ electron-induced deNO_x process with CNT activated by DBD was achieved. • Carbon atoms on CNT surface were verified to be excited by plasma in DBD-CNT system. • Reactions between NO_x and excited C result in synergistic effect of DBD-CNT system. In this study, a new in situ electron-induced process is presented with carbon nanotubes (CNTs) as a reduction agent activated by dielectric barrier discharge (DBD) for nitrogen oxide (NO_x) abatement at low temperature (<407 K). Compared with a single DBD system and a DBD system with activated carbon (DBD-AC), a DBD system with carbon nanotubes (DBD-CNT) showed a significant promotion of NO_x removal efficiency and N₂ selectivity. Although the O₂ content was 10%, the NO_x conversion and N₂ selectivity in the DBD-CNT system still reached 64.9% and 81.9% at a specific input energy (SIE) of 1424 J/L, and these values decreased to 16.8%, 31.9% and 43.2%, 62.3% in the single DBD system and the DBD-AC system, respectively. X-ray photoelectron spectroscopy (XPS) and scanning electron microscopy (SEM) were utilized to investigate surface changes in the CNTs after activation by DBD to explore the NO_x reduction abatement mechanism of this new process. Furthermore, the outlet gas components were also observed via Fourier transform infrared spectroscopy (FTIR) to help reveal the NO_x reduction mechanism. Experimental results verified that carbon atoms excited by DBD and the structure of CNTs contributed to the synergistic activity of the DBD-CNT system. The new deNO_x process was accomplished through in situ heterogenetic reduction reactions between the NO_x and carbon atoms activated by the plasma on the CNTs. In addition, further results indicated that the new deNO_x process exhibited acceptable SO₂ tolerance and water resistance.     

空区处理与残矿回采对围岩及地表影响的数值模拟分析

为了提高矿山企业开采的生产效益及确保施工中设备人员的生命财产安全,采用现场声波测试试验与室内物理力学试验得出的力学参数,应用FLAC3D数值模拟软件,在空区顶板-矿柱体系简化为弹性矩形薄板-H-K体流变力学模型的基础上,分析空区处理与残矿回采对围岩及地表的影响规律。结果表明:矿区三中段充填回采过程中压应力最大值出现在Ⅲ-10开采之后,右帮壁形成了9. 8 MPa的压应力集中区;拉应力区域主要存在于充填体内,且大部分拉应力超过了充填体抗拉强度幅值0. 12 MPa;地表移动带范围内垂直方向位移保持在0～1 mm。实际施工中应采取加强充填体强度达0. 27 MPa以上或保留部分矿体支撑顶板等措施确保回采安全。     

Capacity estimation and preliminary strategy for reducing the release of dioxins in China

As a party of the Stockholm Convention on Persistent Organic Pollutants, China must submit its national implementation plan (NIP) for this convention. The strategy and action plan for reducing the release of dioxins in China are the most important components of the NIP. Three problems are key points for developing such strategy and action plan—what are the key sources for applying the best available technology/best environmental practice (BAT/BEP) to reduce the release of dioxins? How about the capacity for reducing the dioxins release from the key sources? Where are the areas of priority for applying BAT/BEP? This paper shows the efforts towards the solution of these problems. The list of key sources covering about half of the total dioxins release was determined considering four criteria. The capacity of key sources were estimated based on the difference between the emission factor corresponding to the actual situation in 2004 and that corresponding to the scenario that all key sources have been applied BAT/BEP to reduce the dioxins release. The priority analysis using the geographical information system (GIS) tool has revealed that castern provinces should be of high priority in the future reduction activities of dioxins release in China.