Social desirability effects in driver behavior inventories

Problem

The use of lie scales to control for common method variance in driver behavior inventories has been very limited. Given that such questionnaires often use self-reported safety variables as criteria, and have social implications, the risk of artefactual associations is high.

Method

A questionnaire containing scales from several well known driver inventories that have been claimed to predict traffic accident involvement was distributed three times to a group of young drivers in a driver education program, as well as a random group twice. The Driver Impression Management scale (DIM) was used to control for socially desirable responding.

Results

For all behavior scales, the correlation with the DIM scale was substantial. If a scale correlated with self-reported crashes, the amount of predictive power was more than halved when social desirability was controlled for. Results were similar for both samples and all waves. The predictive power of the behavior scales was not increased when values were averaged over questionnaire waves, as should have been the case if the measurement and predictive power were valid. Results were similar for self-reported penalty points. The present results indicate that even the most well-known and accepted psychometric scales used in driver research are susceptible to social desirability bias.

Discussion

As social desirability is only one of a number of common method variance mechanisms that can create artefactual associations, and the great popularity of the self-report methodology, the problem for traffic research is grave.

Impact on industry

Organizations that fund traffic safety research need to re-evaluate their policies regarding what methods are acceptable. The use of self-reported independent and dependent variables can lead to directly misleading results, with negative effects on traffic safety.     

Fall arrest characteristics of a scissor lift

Problem

Census of Fatal Occupational Injuries (CFOI) data indicate 306 aerial lift fatalities between 1992-2003. Seventy-eight of these fatalities specifically involved scissor lifts. Members of standards committees have requested that NIOSH conduct research to determine the effects of safety-control practices related to using fall-protection systems for scissor lifts.

Method

This research examined the structural and dynamic stability of a scissor lift subjected to fall arrest forces. This was accomplished by conducting drop tests from a scissor lift. Anchorage locations evaluated included manufacturer-supplied anchorage points on the scissor lift platform as well as mid-rail and top-rail locations.

Results

Preliminary drop tests determined that a 2400 lb maximum arrest force (MAF) could be generated by dropping 169 lb through a fall height of 36” using Nystron® rope as a lanyard. The scissor lift maintained structural and dynamic stability for all drop tests when fully extended and on an incline.

Discussion

Anchoring a fall arrest system to either the mid-rail or top-rail is not a recommended practice by the scissor lift manufacturer. Anchor points are provided on the platform floor of the scissor lift for this purpose. However, our results demonstrate that the mid-rail and top-rail absorb substantial energy from an arrested fall and may have potential as appropriate anchorage points.

Impact to Industry

Employers and workers should consider implementing fall arrest systems when using scissor lifts as part of their overall risk mitigation plan for fall injury prevention.     

The impact of a peer-led participatory health and safety training program for Latino day laborers in construction

Background

Immigrant Latino day laborers working in residential construction are at particularly high risk of fatal and non-fatal traumatic injury and benefit from targeted training.

Objective

To understand the impact of a participatory, peer-facilitated health and safety awareness training customized to the needs of Latino day laborers.

Methods

Baseline surveys exploring exposures, PPE use, attitudes, work practices and work-related injuries were collected from more than 300 New Jersey Latino day laborers in construction prior to their participation in a one day (minimum of six hour) Spanish language health and safety training class. The classes, led by trained worker trainers, engaged participants in a series of tasks requiring teamwork and active problem solving focused on applying safe practices to situations they encounter at their worksites. Follow-up surveys were difficult to obtain among mobile day laborers, and were collected from 70 men (22% response rate) 2-6 months following training. Chi-square analysis was used to compare pre- and post-intervention PPE use, self protective actions, and self-reported injury rates. Focus groups and in-depth interviews addressing similar issues provided a context for discussing the survey findings.

Results

At baseline, the majority of day laborers who participated in this study reported great concern about the hazards of their work and were receptive to learning about health and safety despite limited influence over employers. Changes from baseline to follow-up revealed statistically significant differences in the use of certain types of PPE (hard hats, work boots with steel toes, safety harnesses, and visible safety vests), and in the frequency of self-protective work practices (e.g., trying to find out more about job hazards on your own). There was also a suggestive decrease in self-reported injuries (receiving an injury at work serious enough that you had to stop working for the rest of the day) post-training based on small numbers. Sixty-six percent of workers surveyed post-training reported sharing information from their safety workbook with friends and co-workers. Focus groups and interview results generally confirmed the quantitative findings.

Conclusions

Participatory, peer led training tailored to the needs of construction day laborers may have a positive effect on Latino immigrant workers’ attitudes, work practices, and self reported injury rates, but major changes would require employer engagement.

Impact on Industry

Health and safety researchers have identified reducing the number of traumatic injuries among the immigrant construction workforce as an increasingly important priority. This project provides one model for collaboration between university-based researchers, a union, and a community-based organization. The specific elements of this project—participatory curriculum customized to the needs of day laborers in residential construction, training day laborers to facilitate training classes, and involving peer leaders in outreach and research—could be adapted by other organizations. The findings of this study suggest that the Latino day laborers have a strong interest in and some ability to act on health and safety information. Widespread implementation of this type of training, especially if supported with cooperation from residential contractors, could lead to reduced rates of traumatic injury in the residential construction industry.     

A traffic safety evaluation of California's traffic violator school citation dismissal policy

Introduction

This study evaluated California's traffic violator school (TVS) citation dismissal policy.

Method

This study identified and compared two large samples of drivers either completing a TVS (N = 210,015) or convicted of a traffic citation (N = 168,563).

Results

Prior to adjudication, the TVS group had characteristics (e.g., lower prior conviction rate and smaller proportion of males) that were predictive of a lower subsequent crash risk. However, the TVS group exhibited significantly more crashes than did the convicted group in the subsequent one-year period. The difference (4.83%) increased to 10% after adjusting for the more favorable characteristics of the TVS group. The TVS group also had a higher adjusted subsequent crash rate at each prior driver record entry level, reflecting a loss in the general and specific deterrence of the non-conviction masked status of TVS dismissed citations. It was reported that the TVS dismissal policy results in approximately 12,300 additional crashes annually with economic costs of approximately $398,000,000.

Conclusions

The avoidance of licensing actions resulting from the dismissal policy assists in explaining why the driving public is exposed to an increased crash risk. A number of recommendations are offered to reduce the negative traffic safety impact of the TVS citation dismissal policy.     

[Case Study] CityCenter and Cosmopolitan Construction Projects, Las Vegas, Nevada: Lessons learned from the use of multiple sources and mixed methods in a safety needs assessment

Problem

The present study describes a response to eight tragic deaths over an eighteen month times span on a fast track construction project on the largest commercial development project in U.S. history.

Methods

Four versions of a survey were distributed to workers, foremen, superintendents, and senior management. In addition to standard Likert-scale safety climate scale items, an open-ended item was included at the end of the survey.

Results

Safety climate perceptions differed by job level. Specifically, management perceived a more positive safety climate as compared to workers. Content analysis of the open-ended item was used to identify important safety and health concerns which might have been overlooked with the qualitative portion of the survey.

Discussion

The surveys were conducted to understand workforce issues of concern with the aim of improving site safety conditions. Such efforts can require minimal investment of resources and time and result in critical feedback for developing interventions affecting organizational structure, management processes, and communication.

Summary

The most important lesson learned was that gauging differences in perception about site safety can provide critical feedback at all levels of a construction organization.

Impact on the Industry

Implementation of multi-level organizational perception surveys can identify major safety issues of concern. Feedback, if acted upon, can potentially result in fewer injuries and fatal events.     

Increasing self-awareness among older drivers: The role of self-screening

Introduction

Self-screening by older drivers has shown considerable promise for increasing self-awareness about functional abilities associated with safe driving. The purpose of this study was to improve upon existing self-screening instruments by focusing entirely on “health concerns” that affect driving - that is, the symptoms that people experience due to medical conditions and the medications used to treat them - rather than the medical conditions or medications themselves.

Method

A computer-based, easy-to-use self-screening instrument for older drivers was developed to provide individualized feedback intended to increase self-awareness about declines in driving-related abilities, as well as suggestions for behavioral changes or safety tips to maintain safe driving, further evaluation from a physician/health professional, and vehicle modifications to help compensate for driving-related declines.

Results

This paper describes the development of the self-screening instrument and summarizes findings relative to increasing self-awareness among older drivers. This research represents an important first step in improving self-awareness among older drivers through self-screening.     

Assessment of perceived injury risks and priorities among truck drivers and trucking companies in Washington State

Problem

The trucking industry experiences one of the highest work-related injury rates. Little work has been conducted previously in the United States to assess the hazards, needs, and injury prevention priorities in trucking. Method: Two separate industry-wide surveys of 359 trucking companies and 397 commercial truck drivers were conducted in Washington State. Results: Trucking companies and drivers both ranked musculoskeletal and slip, trip, fall injuries as the top two priorities. Controlling heavy lifting, using appropriate equipment, and addressing slippery surfaces were frequently listed as solutions. There appears to be a gap in safety climate perception between workers and employers. However, driver and company priorities agreed with industry workers' compensation claims. There is room for safety program management improvement in the industry. The study findings detail opportunities for prioritizing and reducing injuries. Impact on Industry: This information can be used to focus and design interventions for the prevention of work-related injuries while improving industry competitiveness.     

Improving traffic safety: Conceptual considerations for successful action

Introduction

In the early stages of motorization, it did not take rigorous scientific research to achieve major improvements in traffic safety. Instead, early traffic-safety countermeasures were often based exclusively on common sense. Since then, scientific research has gradually increased in importance as the basis for developing successful interventions. This shift was not made by choice but mostly by necessity: Many of the “easy” problems have already been addressed, and the remaining problems are generally too complex for an approach based solely on common sense. Fortunately, our understanding of the complexities involved in traffic safety has recently made major gains, and common sense can now be supplemented, to some degree, by valid technical analysis.

Approach

This article discusses major conceptual issues that should be considered in guiding the future development of effective, science-based traffic-safety countermeasures.

Impact on industry

After briefly discussing the conceptual issues, the article offers a list of implications for action.