H∞ loop-shaping controller design for a grid-connected single-phase photovoltaic system

This paper presents a H_∞ loop-shaping controller for controlling dc-link voltage by regulating the switching signal of the inverter associated with a grid-connected single-phase photovoltaic system. To facilitate a robust control design, state-space realisation of the system model is made with uncertainties represented by linear fractional transformation. The controller is achieved through H_∞ synthesis followed by obtaining desired loop shapes through the choice of the proper weighting functions. The controller order is reduced by Henkel-norm method for facilitating its practical implementation. Controller performance is evaluated through carrying out simulations on MATLAB/Simulink platform under standard and changing atmospheric conditions, and fault condition.     

异波折板水解酸化-A~2O一体化反应器实验研究

设计了异波折板水解酸化-A2O一体化反应器,进行生活污水处理的实验研究。10个月的实验结果表明,系统的最佳水力停留时间(HRT)为8 h时,最适COD进水浓度为240~600 mg/L,最佳混合液回流比(r)-污泥回流比(R)为250%~100%。控制反应器于以上运行参数下,25±2℃所对应的COD、TN和TP去除率分别为96.84%、67.55%和81.92%。当温度降至7℃时,其COD、TP和TN分别降至86.35%、50.25%和65.68%。基于实验分析结果,阐明了一体化反应器高效性的机理在于异波折板水解酸化段具有高效传质特性和A2O段具有复合式活性污泥-接触氧化好氧池的特点。     

垃圾炉一次风量对炉床燃烧影响的仿真研究

针对垃圾焚烧炉床层内垃圾燃烧过程复杂性及影响垃圾燃烧效率因素多的问题,运用数值仿真方法对某垃圾焚烧炉床层垃圾燃烧进行了模拟,获得了垃圾质量流失速率、水分蒸发速率、挥发分释放速率、焦炭燃烧速率和烟气的温度;并在50~1 000 Nm3/min范围内改变一次风流量,获得了床层质量流失比值、过剩空气系数和烟气中各组分的质量百分比含量。仿真结果显示,一次风流量取值517.47~6`32.09 Nm3/min时燃烧效率较高;炉排两端区域的一次风流量在50~75 Nm3/min时,可以使垃圾床表面平均温度明显提高,而且还可以提高燃烧效率,同时减少供风总量,节约能源与动力资源。本研究对优化设计垃圾焚烧炉,提高床层内垃圾的燃烧效率有一定参考价值。     

污泥含炭吸附剂对挥发性有机废气吸附实验研究

研究了污泥含炭吸附剂对挥发性有机污染物的吸附特性。结果表明,污泥含炭吸附剂对苯系物的吸附为典型的物理吸附,其吸附甲苯等温线的类型系优惠型吸附等温线,表明具有良好的吸附能力;在吸附反应温度为20℃,气体流量为500 mL/m in(停留时间为0.424 s),甲苯浓度为2 700 mg/m3时,甲苯的饱和吸附容量为150.0 mg/g;同时,研究表明污泥含炭吸附剂对苯系物的饱和吸附容量和吸附强弱次序为二甲苯甲苯苯。结果表明污泥含炭吸附剂适合对中低浓度有机废气的吸附净化。     

无碴轨列车运行引起的环境振动影响评价

对遂渝高速铁路无碴轨道试验段客车运行引起的环境振动进行了现场实测,根据实验数据分析得知:环境振动强度随距离增大而减小,随车速增大而增大,但车厢数量对环境振动强度影响不明显;环境振动主要频率范围为30～120 Hz,距轨道距离、车速、车厢数量对振动主要频率影响不显著;在轨道两侧31.9 m处,速度超过104.7 km/h列车环境振动强度超过GB 10070-1988要求,须采取措施隔振。     

改性粉煤灰协同PSFA处理高度乳化油废水

通过正交实验对改性粉煤灰协同粉煤灰基混凝剂PSFA处理高度乳化油废水的工艺条件进行了优化。实验结果表明:当处理500 mL废水,投加改性粉煤灰25 g,粉煤灰基混凝剂6～8 g,PAM6～9 mL,pH为7.0,搅拌10～15 min的优化条件下,高度乳化油废水中COD、石油类物质的去除率可分别可达85.4%及50.3%。该方法与传统CaCl2+PFS+PAM组合相比,具有处理效果好,沉降速度快,运行费用低等优点。     

Emission factors and particulate matter size distribution of polycyclic aromatic hydrocarbons from residential coal combustions in rural Northern China

Coal consumption is one important contributor to energy production, and is regarded as one of the most important sources of air pollutants that have considerable impacts on human health and climate change. Emissions of polycyclic aromatic hydrocarbons (PAHs) from coal combustion were studied in a typical stove. Emission factors (EFs) of 16 EPA priority PAHs from tested coals ranged from 6.25 ± 1.16 mg kg^?1 (anthracite) to 253 ± 170 mg kg^?1 (bituminous), with NAP and PHE dominated in gaseous and particulate phases, respectively. Size distributions of particulate phase PAHs from tested coals showed that they were mostly associated with particulate matter (PM) with size either between 0.7 and 2.1 μm or less than 0.4 μm (PM_0.4). In the latter category, not only were more PAHs present in PM_0.4, but also contained higher fractions of high molecular weight PAHs. Generally, there were more than 89% of total particulate phase PAHs associated with PM_2.5. Gas-particle partitioning of freshly emitted PAHs from residential coal combustions were thought to be mainly controlled by absorption rather than adsorption, which is similar to those from other sources. Besides, the influence of fuel properties and combustion conditions was further investigated by using stepwise regression analysis, which indicated that almost 57 ± 10% of total variations in PAH EFs can be accounted for by moisture and volatile matter content of coal in residential combustion.     

基于响应曲面法优化烧结烟气脱硫灰改性工艺

采用BOX-Behnken的中心组合实验设计及响应面分析方法对半干法烧结烟气脱硫灰进行改性研究,得到脱硫灰转化率的预测模型。结果表明:通过该预测模型可以很好地描述脱硫灰的转化率与反应温度、反应时间和气固比等重要操作参数之间的关系,R2=0.9903。因素分析表明,反应温度对脱硫灰的转化率影响最大,同时反应温度和气固比的交互作用与反应温度和时间的交互作用对脱硫灰的转化率的影响作用相同。利用得到的改进预测模型可以计算脱硫灰的转化率。     

新型活性炭固定化产品的制备及其处理焦化废水的特性

为解决优势菌种工程应用,研究不同固定化方法、载体和结构的固定化产品对焦化废水的降解特性。用活性炭粉末吸附菌种后,与聚乙烯醇和海藻酸钠混合制备了新型固定化球;用聚乙烯醇和海藻酸钠包埋吸附菌种的活性炭纤维毡,与立体弹性塑料填料连用,制备出3种不同形状的活性炭纤维膜片固定化产品复合填料。将游离菌和制备的4种活性炭固定化产品投入A/A/O工艺系统平行实验,考察处理焦化废水的效果。结果表明,活性炭纤维膜片固定化产品复合填料对焦化废水的降解能力优于其他固定化产品:缺氧池出水硝酸盐氮和亚硝酸盐氮浓度分别稳定在1.96 mg/L和0.49 mg/L,未产生氮的累积现象,COD去除率可达到60.92%。好氧池COD和氨氮降解效率分别为78.83%和85.52%,苯酚、氰化物降解效率均为97%以上。     

混凝沉淀-高级氧化联合处理垃圾转运站污水的实验研究

城市生活垃圾转运站污水具有水质水量变化大、有机污染负荷高、具有强烈恶臭、色度高等显著特点,已成为城市重要的点源污染。为有效消减转运站污水有机负荷,探讨了混凝沉淀-高级氧化联合使用的物化处理方法,考察了联合处理过程中双氧水/亚铁、亚铁投加量、酸化后pH值、混凝剂投加量、中和后pH值等因素对处理效果的影响。小试研究结果表明,在混凝剂投加400 mg/L,亚铁0.06 mol/L,酸化后pH为3,双氧水/亚铁=4∶1,中和后pH为7.5的条件下,污水COD消减量达到60%以上,色度去除率98%,恶臭基本消除。