Enzymatic treatment of sulfonated aromatic amines generated from reductive degradation of reactive azo dyes.

Anaerobic degradation, an effective treatment process of textile industry effluent, generates sulfonated aromatic amines, which are carcinogenic, mutagenic, and resistant to microbial degradation. These aromatic amines can be effectively removed by oxidative polymerization catalyzed by peroxidase enzyme. The amines, generated in this study from the anaerobic reduction by zero-valent iron of two reactive azo dyes (Reactive Red 2 [RR2] and Reactive Black 5 [RB5]), were successfully removed (90%) by Arthromyces ramosus peroxidase (ARP). For better understanding of the process, enzymatic treatment of two model compounds, diphenylamine (DPA) and 2-amino-8-naphthol-3,6-disulfonic acid (ANDSA), were also studied. Diphenylamine has a similar diarylamine bond as RR2. The ANDSA has a similar structure as the dye reduction products. The secondary amine bond in DPA and RR2 were oxidized by ARP. Enzymatic reaction of sulfonated aromatic amines generated soluble colored compounds, which were removed by coagulant. Optimum reaction parameters were also determined.     

Pilot-Scale Evaluation of an Incinerability Ranking System for Hazardous Organic Compounds

The U.S. Environmental Protection Agency’s (EPA) hazardous waste incinerator performance standards specify a minimum destruction and removal efficiency (DRE) for principal organic hazardous constituents (POHCs) designated in the incinerator waste feed. In the past, selection of appropriate POHCs for incinerator trial burns has been based largely on their heats of combustion. Attempting to improve upon this approach, the University of Dayton Research Institute (UDRI), under contract to the EPA Risk Reduction Engineering Laboratory, has developed a thermal stability-based ranking of compound "incinerability". The subject study was conducted to evaluate the laboratory-developed ranking system in a pilot-scale incinerator.

Mixtures of POHCs, spanning the ranking scale from most- to least-difficult to destroy (Class 1 to Class 7, respectively), were prepared and combined with a clay-based sorbent matrix. These mixtures were then fed into the rotary kiln incineration system at the U.S. EPA Incineration Research Facility (IRF). In a series of five tests, the following conditions were evaluated: baseline/ typical operation; thermal failure (quenching); mixing failure (overcharging); matrix failure (low feed H/CI ratio); and a worst-case combination of the three failure modes.

Under baseline conditions, mixing failure, and matrix failure, kiln-exit DREs for each compound were comparable from test to test. Operating conditions in these 3 modes appeared to be sufficient to effect considerable destruction (greater than 99.99 percent DRE) of all compounds. As a result, separation of the highest-ranked POHCs from the lowest-ranked POHCs according to observed DRE was not possible; a correlation between POHC ranking and DRE could not be confirmed.

A correlation between predicted and observed incinerability was more evident for the thermal failure and worst-case conditions. Kiln-exit DREs for the four POHCs predicted to be most stable (those in Classes 1 and 2) ranged from 99% to 99.99% under these conditions, and were generally lower than DREs for the POHCs predicted to be more easily destroyed. Statistically significant correlations above the 99 percent and 93 percent confidence intervals were identified for the thermal-failure and worst-case tests, respectively.     

Recording the Response of Plants to Various Air Pollutants

A discussion of the methods used to determine the most economic design of chimney for a new thermal power station or large industrial plant is presented, with the objective that ground level concentration of pollutants will be kept at a minimum. Attention is paid to the geography and climatology of the site, with special reference to the frequency and height of inversions and the prevailing wind direction and speed.

A method is illustrated in using a large thermal power station as an example. The maximum sulfur dioxide concentrations at ground level are computed for several chimney heights and gas exit velocities. The values of these sulfur dioxide concentrations, the capital cost of the chimney, the pumping costs, and the gas pressures within the chimney are considered in selecting a suitable chimney height and a gas exit velocity which will meet most economically the stated objective.

The paper deals primarily with chimneys for industrial or power boiler plant of maximum continuous rating greater than 450 million Btu/hr (about 450,000 lbs of steam/hr), or to chimneys serving furnaces burning fuel at a maximum rate greater than 50,000 lbs/hr of coal, or 80,000 lbs/hr of oil. For chimneys serving plant with smaller heat inputs, chimney selection by reference to Clean Air Act 1956, Memorandum on Chimney Heights is suggested.     

Interpreting seawater temperature range using oxygen isotopes and zooid size variation in Pentapora foliacea (Bryozoa)

This is the first investigation of how two independent proxies for seawater temperature inference (zooid size variation and oxygen isotope ratios of skeletal carbonate) relate to the actual measured ranges of temperature experienced by cheilostome bryozoan colonies. Nine specimens of the bimineralic marine cheilostome bryozoan Pentapora foliacea (Ellis and Solander, 1786) were analysed, collected from ~18-m depth at two localities in Wales, UK—four from Skomer Island (51°42′510″N, 5°13′42.60″W) and five from Porth Ysgaden, Lleyn Peninsula (52°54′6.75″N, 4°38′47.34″W). The annual range of temperature implied by zooid size variability provides a good approximation of the actual range of temperature recorded by a datalogger. However, annual ranges of temperature reconstructed from skeletal oxygen isotope ratios were narrower, typically not showing the lowest temperatures experienced by the colonies. This can be explained by progressive thickening of zooid skeletal walls during the life of the colony that homogenises the temperature signal by time-averaging over the lifetime of the colonies. Our study provides evidence that a combined morphological isotope approach has great potential in the reconstruction of annual ranges in seawater temperatures from historical and fossil bryozoans, particularly for species that lack ontogenetic skeletal wall thickening and bimineralic skeletal composition. As cheilostome bryozoans have been common in benthic communities since the Late Cretaceous, they represent a valuable and underutilised resource for the interpretation of environmental regimes.     

Maintenance of intact sediment box cores as laboratory mesocosms.

Mesocosms consisting of physically and biologically intact segments of natural communities are an ideal compromise between single species tests and ecosystem experiments in the assessment of sediment contamination. Therefore, large intact sediment cores, as mesocosms with naturally co-adapted communities, would allow sediment contamination to be assessed using the replicability and statistical power of laboratory techniques, while retaining much of the ecological realism of field studies. This study investigates the collection and maintenance of such cores, collected from an unimpacted site in Lake Erie. It demonstrates that box cores containing relatively undisturbed freshwater sediments can be brought back to the laboratory and maintained for up to 8 weeks with little change in the resident benthic fauna. Feeding the systems is not required, nor is it deleterious to the indigenous fauna.     

一株异养脱氮菌的脱氮性能及其影响因素研究

研究异养硝化过程中分离得到一株具有异养脱氮性能的菌株,经16S rRNA鉴定后为Providencia rettgeri菌属,命名为Providencia rettgeri strain YL。在实验室条件下,初步探讨了不同碳氮源、温度、pH值、摇床转速和微量元素对Providencia rettgeri strain YL菌株脱氮作用的影响,研究结果显示,Providencia rettgeri strain YL菌株在葡萄糖和氯化铵为碳氮源的培养基中生长最好,温度为30℃、pH值为7、摇床转速为120 r/min时具有最佳的脱氮效果,微量元素Mg²⁺最有利于Providencia rettgeri strain YL菌株的生长和脱氮。     

Quantification and composition of pharmaceutical waste in New Zealand

Journal of Material Cycles and Waste Management - This study aimed to quantify the amount of pharmaceutical waste produced in New Zealand, and determine the composition of pharmaceutical waste from...     

Effects of Acidification and its Mitigation with Lime and Wood Ash on Forest Soil Processes in Southern Sweden. A Joint Multidisciplinary Study

A joint multidisciplinary investigation was undertaken to studythe effects of lime and wood ash applications on two Norway spruce forest Spodosolic soils. The two sites, typical for southern Sweden, were treated in 1994 with either 3.25 t ha^-1 dolomite or 4.28 t ha^-1 wood ash (Horröd site) or in 1984 with either 3.45 or 8.75 t ha^-1 dolomite (Hasslöv site). Both sites show signs of acidification by atmospheric anthropogenic deposition and possessed low soil pH(4.3) and high concentrations of inorganic Al (35 M) in theupper illuvial soil solution. The prevailing soil conditions indicated perturbed soil processes. Following treatment with lime or wood ash, the soil conditions were dramatically altered. Cation exchange capacity (CEC) and base saturation (BS) was considerable increased after addition. Four years after application most of the added Ca and Mg was still present in the mor layer. Fifteen years after application,Mg in particular, became integrated deeper in the soil profile with a greater proportion lost by leaching incomparison to Ca. The concentrations of these ions were greatestin the mor layer soil solutions and Mg had higher mobility givinghigher concentrations also deeper in the profile. Four years after treatment, the application of wood ash and limeresulted in lower pH values and higher inorganic Al in mineral subsoil solutions compared to the untreated soil. We hypothesize that this was probably due to an increased flow of hydrogen ionsfrom the upper soil as a result of displacement by Ca and Mg ionsin the enlarged exchangeable pool. In contrast, fifteen years after lime and wood ash application, the mineral subsoil horizonspossessed a higher pH and lower soil solution Al content than theuntreated plots.Liming promoted soil microbial activity increasing soil respiration 10 to 36%. This is in the same range as net carbon exchange for forests in northern Sweden and could potentially have a climatological impact. The turnover of low molecularweight organic acids (LMWOA) by the soil microbial biomass werecalculated to contribute 6 to 20% to this CO₂ evolution.At Horröd, citrate and fumarate were the predominant LMWOAs with lowest concentrations found in the treated areas. In contrast, at the Hasslöv site, propionate and malonate were the most abundant LMWOAs. Higher microbial activity in the upper soil horizons was also theprobable cause of the considerably higher DOC concentrations observed in the soil solution of ash and lime treated areas. Thelime-induced increase in DOC levels at Hasslöv could be attributed to increases in the 3–10 kDa hydrophobic size fraction. Liming also promoted nitrification with high liming doses leading to extreme concentrations of NO₃ ^- (1 mM) in soil solution.At Hasslöv the community of mycorrhizal fungi was dramatically changed by the addition of lime, with only four of 24 species recorded being common to both control and treated areas.Many of the observed effects of lime and ash treatment can be viewed as negative in terms of forest sustainability. After fouryears of treatment, there was a decrease in the pH of the soil solution and higher concentrations of inorganic Al and DOC. Increased organic matter turnover, nitrification and NO₃ ^-leakage were found at Hasslöv. Considering that the weathering rate and the mineral nutrient uptake by trees is mostprobably governed by mycorrhizal hyphae etchingmineral grains in the soil, it is important to maintain this ability of the mycorrhizal fungi. The lime and ash-induced changed mycorrhizal community structure may significantly affect this capability. In light of this investigation and others, as reviewed by Lundström et al. (2003), the implications ofliming on forest health are multifaceted with complex relationships occurring over both space and time.     

Adjusting to new work teams: Testing work experience as a multidimensional resource for newcomers

The successful performance adjustment of team newcomers is an increasingly important consideration given the prevalence of job‐changing and the uncertainty associated with starting work in a new team setting. Consequently, using sensemaking and uncertainty reduction theories as a conceptual basis, the present study tested work experience as a potential resource for newcomer performance adjustment in teams. Specifically, we tested work experience as a multidimensional predictor of both initial newcomer performance and the rate of performance change after team entry. We tested hypotheses using longitudinal newcomer performance data in the context of professional basketball teams. Although the traditional quantitative indicators of the length and amount of work experience were not meaningfully associated with newcomer performance adjustment, their interaction was. In addition, the qualitative indicator of newcomers' past transition experience revealed a significant, positive association with the rate of newcomer performance improvement following team entry. These results suggest that work experience is a meaningful facilitator of newcomer adjustment in teams and emphasize the dual consideration of both quantitative and qualitative work experiences. The theoretical and practical implications of these findings are discussed. Copyright © 2013 John Wiley & Sons, Ltd.