Selection of sorption material for tests of pesticide permeation through protective clothing fabrics.

The paper presents the results of studies on selecting a solid sorption material for absorbing liquid crop protection agents which permeate samples of protective clothing fabrics. The sorption materials were investigated and selected with an assumption that they should have a high recovery coefficient for biologically active substances, used as active ingredients in crop protection agents, at a presumed, acceptably high level. The selected substances were determined with a gas chromatograph equipped with an electron capture detector (dichlorvos, cypermethrin and 2,4-D) and a nitrogen-phosphorus detector (carbofuran). The tests demonstrated that polypropylene melt-blown type unwoven cloth had high recovery coefficients for all 4 active ingredients proposed for the study. The highest recovery coefficient, -.97, was obtained for carbofuran. The recovery coefficients obtained for the 3 remaining substances were lower: .89 for cypermethrin and 2,4-D, and .84 for dichlorvos.     

Necessity of Toxicity Assessment in Turkish Industrial Discharges (Examples from Metal and Textile Industry Effluents)

Toxicity of some organic and inorganic chemicals to microorganisms is an important consideration in assessingtheir environmental impact against their economic benefits.Microorganisms play an important role in several environmentalprocesses, both natural and engineered. Some organic and inorganics at toxic levels have been detected in industrial discharges resulting in plant upsets and discharge permit violations. In addition to this, even though in some cases the effluent wastewater does not exceed the discharge limits,the results of toxicity tests show potential toxicity. Toxicityknowledge of effluents can benefit treatment plant operators inoptimising plant operation, setting pre-treatment standards, and protecting receiving water quality and in establishing sewer discharge permits to safeguard the plant. In the Turkish regulations only toxicity dilution factor (TDF) with fish is part of the toxicity monitoring program of permissible wastewater discharge. In various countries, laboratory studiesinvolving the use of different organisms and protocol for toxicity assessment was conducted involving a number of discharges.In this study, it was aimed to investigate the acute toxicity of textile and metal industry wastewaters by traditional and enrichment toxicity tests and emphasize the importance of toxicity tests in wastewater discharge regulations. The enrichment toxicity tests are novel applications and give anidea whether there is potential toxicity or growth limiting and stimulation conditions. Different organisms were used suchas bacteria (Floc and Coliform bacteria) algae (Chlorella sp.), fish (Lepistes sp.) and protozoan (Vorticella sp.) to represent four tropic levels. The textile industry results showed acute toxicity for at least one organism in 8 out of 23 effluent samples. Acute toxicity for at least two organisms in 7 out of 23 effluent sampling was observed for the metal industry. The toxicity test results were assessed with chemical analyses such as COD, BOD, color and heavy metals. It was observed that the toxicity of the effluents could not be explained by using physicochemical analyses in 5 cases for metal and 4 cases for the textile industries. The results clearly showed that the useof bioassay tests produce additional information about the toxicity potential of industrial discharges and effluents.     

Potential use of composts and vermicomposts as low-cost adsorbents for dye removal: an overlooked application

Environmental Science and Pollution Research - The use of composts and vermicomposts as adsorbents is an important topic of study in the field of environmental remediation. These materials are rich...     

Assessing the socio-economic impacts of green/blue space,urban residential and road infrastructure projects in the Confluence (Lyon): a hedonic pricing simulation approach

Urban green/blue spaces are put under pressure as urban areas grow, develop and evolve. It is increasingly recognized, however, that green/blue spaces provide important ecosystem services, stimulate higher real estate prices and prevent flooding problems. This paper aims to assess and compare the socio-economic impacts of potential green/blue space, urban residential and road infrastructure development scenarios in the Lyon Confluence project area (France), using the Sustainable Urbanizing Landscape Development (SULD) hedonic pricing simulation model. Results show four major tendencies regarding the value-added of green/blue spaces in urban landscapes: (1) cities become more compact; (2) population densities increase; (3) real estate values rise; and (4) demographic distribution patterns change. The magnitude of these impacts depends, however, on the quality and size of the intervention, the social classes attracted to the intervention area and on the location of the intervention relative to existing residential areas, urban centres, road infrastructure and environmental amenities.     

The ability of biological and organic synthetic materials to accumulate atmospheric particulates containing copper, lead, nickel and strontium

This work was aimed at finding materials that could be used as alternatives to lichens as air quality monitors since the high natural variability and the large amount of lichen collected are two drawbacks of the use of these organisms. Lichen Flavoparmelia caperata(L.) Hale was exposed in three different forms (transplant, detached from the substratum and as a biomass-ground and homogeneized) and compared to the planetree bark (Platanus hybrida Brot.), exposed as a biomass, and two organic synthetic materials (Chelex(R) 100 resin and cellulose acetate). Materials were exposed for two months in the winter, spring and summer, at three Portuguese coastal cities. The results showed that the airborne accumulations of Cu, Ni, Pb and Sr were partially dependent on the meteorological conditions but mainly dependent on the nature of the exposed material. The standard deviations of the synthetic materials or homogenized biomass were the same or greater than lichen transplants or detached. The accumulation by biological materials, of the four studied elements, was comparable to the lichen transplant accumulation. The replacement of the traditional transplants by the biomass was not considered advantageous, since their preparation is time-consuming. Therefore lichens remain the most suitable in biomonitoring studies. The exposure of detached lichen allows the accurate measurement of the exposed area/volume so it can be useful to relate atmospheric deposition rates with the lichen metal content. The synthetic materials accumulated Cu and Ni and should only be used as an alternative to traditional transplants when these are the elements of interest.     

Recycling extruded polystyrene by dissolution with suitable solvents

The amount of extruded polystyrene (XPS) waste has increased in recent years due to the increase of its use in the thermal insulation of buildings, transport vehicles, and refrigerators, among others. Dissolution with suitable solvents to achieve a volume reduction of more than 100 times without degradation of polymer chains is one of the cheapest and most efficient methods of recycling XPS. Several environmentally friendly solvents have been tested as dissolution agents for XPS volume reduction; the action of these solvents does not produce any degradation of polymer chains. The solubility of the polymer in such solvents at different temperatures was investigated. The solvent can be easily recycled by distillation, obtaining a high-quality recycled polymer. Chemical Feedstock Recycling & Other Innovative Recycling Techniques 6     

Plant uptake of radiocaesium from artificially contaminated soil monoliths covering major European soil types

Uptake of ¹³⁷Cs was measured in different agricultural plant species (beans, lettuce, barley and ryegrass) grown in 5 undisturbed soil monoliths covering major European soil types. The first cultivation was made three years after soil contamination and plants were grown during 3 successive years. The plant–soil ¹³⁷Cs transfer factors varied maximally 12-fold among soils and 35-fold among species when grown on the same soil. Single correlations between transfer factors and soil properties were found, but they varied widely with plant type and can hardly be used as a predictive tool because of the few soils used. The variation of ¹³⁷Cs concentrations in plants among soils was related to differences in soil solution ¹³⁷Cs and K concentrations, consistent with previous observations in hydroponics and pot trials. Absolute values of transfer factors could not be predicted based on a model validated for pot trials. The ¹³⁷Cs activity concentration in soil solution decreased significantly (11- to 250-fold) for most soils in the 1997–1999 period and is partly explained by decreasing K in soil solution. Transfer factors of lettuce showed both increasing and decreasing trends between 2 consecutive years depending on soil type. The trends could be explained by the variation in ¹³⁷Cs and K concentrations in soil solution. It is concluded that differences in ¹³⁷Cs transfer factors among soils and trends in transfer factors as a function of time can be explained from soil solution composition, as shown previously for pot trials, although absolute values of transfer factors could not be predicted.     

Satellite observations of Mexico City pollution outflow from the Tropospheric Emissions Spectrometer (TES)

Concurrent tropospheric O₃ and CO vertical profiles from the Tropospheric Emission Spectrometer (TES) during the MILAGRO/INTEX-B aircraft campaigns over the Mexico City Metropolitan Area (MCMA) and its surrounding regions were used to examine Mexico City pollution outflow on a regional scale. The pollution outflow from the MCMA occurred predominantly at 600–800 hPa as evident in O₃, CO, and NO_x enhancements in the in situ aircraft observations. TES O₃ and CO are sensitive to the MCMA pollution outflow due to their relatively high sensitivities at 600–800 hPa. We examined O₃, CO, and their correlation at 600–800 hPa from TES retrievals, aircraft measurements, and GEOS-Chem model results. TES captures much of the spatial and day-to-day variability of O₃ seen in the in situ data. TES CO, however, shows much less spatial and day-to-day variability compared with the in situ observations. The ΔO₃/ΔCO slope is significantly higher in the TES data (0.43) than the in situ data (0.28) due partly to the lack of variability in TES CO. Extraordinarily high ΔO₃/ΔCO slope (0.81) from TES observations at 618 hPa over the Eastern U.S. was previously reported by Zhang et al. [Zhang, L., Jacob, D.J., Bowman, K.W., et al., 2006. Ozone–CO correlations determined by the TES satellite instrument in continental outflow regions. Geophys. Res. Lett. 33, L18804. 10.1029/2006GL026399.]. Thus the application of TES CO–O₃ correlation to map continental pollution outflow needs further examination.